Internal Stress Change of Phosphorus-Doped Amorphous Silicon Thin Films During Crystallization

1994 ◽  
Vol 343 ◽  
Author(s):  
Hideo Miura ◽  
Asao Nishimura
Keyword(s):  
Thin Films ◽  
Tensile Stress ◽  
Internal Stress ◽  
Crystallization Process ◽  
Chemical Vapor ◽  
Stress Change ◽  
Silicon Thin Films ◽  
Stress Changes ◽  
Phosphorus Doped ◽  
Deposited Films

ABSTRACTInternal stress change of phosphorus-doped silicon thin films during crystallization is measured by detecting substrate curvature change using a scanning laser microscope. The films are deposited in an amorphous phase by chemical vapor deposition using Si2H6 gas. The deposited films have compressive stress of about 200 MPa. The internal stress changes significantly to a tensile stress of about 800 MPa at about 600 °C due to shrinkage of the films during crystallization. The high tensile stress can be relaxed by annealing above 800 °C. The phosphorus doping changes the crystallization process of the films and their final residual stress.

Experimental Investigation of Microstructure and Piezoresistive Properties of Phosphorus-Doped Hydrogenated Nanocrystalline Silicon Thin Films Prepared by PECVD

2014 ◽  
Vol 609-610 ◽  
pp. 208-217 ◽  
Author(s):  
Hai Bin Pan ◽  
Jian Ning Ding ◽  
Guang Gui Cheng ◽  
Bao Guo Cao
Keyword(s):  
Thin Films ◽  
Experimental Investigation ◽  
Evaluation System ◽  
Room Temperature ◽  
Chemical Vapor ◽  
Nanocrystalline Silicon ◽  
Two Phase ◽  
Good Thermal Stability ◽  
Silicon Thin Films ◽  
Phosphorus Doped

This paper presents an experimental investigation of microstructure and piezoresistive properties of phosphorus-doped hydrogenated nanocrystalline silicon (nc-Si:H) thin films. The phosphorus-doped nc-Si:H thin films (5% doping ratio of PH3 to SiH4) were deposited by plasma enhanced chemical vapor deposition (PECVD) technique. The microstructure and surface morphology of the deposited thin films was characterized and analyzed with Raman spectroscopy and atomic force microscopy (AFM), respectively. The piezoresistive properties of the deposited thin films were investigated with a designed four-point bending-based evaluation system. In addition, the influence of temperature on the piezoresistive properties of these thin films was evaluated with the temperature coefficient of resistance (TCR) measurements from room temperature up to 80°C. The experimental results show that phosphorus-doped nc-Si:H thin films prepared by PECVD technique are a two-phase material that constitutes of nanocrystalline silicon and amorphous silicon, and they present a granular structure composed of homogeneously scattered nanoclusters formed by nanocrystalline silicon grains (6nm). Moreover, phosphorus-doped nc-Si:H thin films exhibit negative GF at room temperature and show good thermal stability from room temperature up to 80°C, and the value of GF and TCR is about-31 and-509ppm/°C, respectively. These features could make phosphorus-doped nc-Si:H thin films act as a promising material for piezoresistive-based MEMS sensor.

INVESTIGATION OF THE Si:H FILMS DEPOSITED NEAR THE TRANSITION REGION FOR APPLICATION IN SOLAR CELLS

2006 ◽  
Vol 20 (27) ◽  
pp. 1739-1747 ◽  
Author(s):  
QINGSONG LEI ◽  
ZHIMENG WU ◽  
XINHUA GENG ◽  
YING ZHAO ◽  
JIANPING XI
Keyword(s):  
Thin Films ◽  
Solar Cells ◽  
Transition Region ◽  
Chemical Vapor ◽  
Transition Process ◽  
Very High Frequency ◽  
Working Pressure ◽  
Hydrogenated Silicon ◽  
Silicon Thin Films ◽  
Narrow Region

Hydrogenated silicon thin films (Si:H) have been deposited by using very high-frequency plasma-enhanced chemical vapor deposition (VHF PECVD). The structural, electrical and optical properties of the films were characterized. The transition process and the effect of pressure were studied. Results suggest that a narrow region, in which the transition from microcrystalline to amorphous growth takes place, exists in the regime of silane concentration (SC). This region is influenced by the working pressure (P). At lower pressure, the transition region is shifted to higher SC. Microcrystalline silicon (μ c-Si:H ) thin films deposited near transition region was applied as i-layer to the p-i-n solar cells. An efficiency of about 5.30% was obtained.

Effect of Nitrogen Doping on the Structure and Optical Properties of N-Type Hydrogenated Amorphous Silicon Thin Films

2011 ◽  
Vol 383-390 ◽  
pp. 6980-6985
Author(s):  
Mao Yang Wu ◽  
Wei Li ◽  
Jun Wei Fu ◽  
Yi Jiao Qiu ◽  
Ya Dong Jiang
Keyword(s):  
Thin Films ◽  
Optical Properties ◽  
Amorphous Silicon ◽  
Photoelectron Spectroscopy ◽  
Gas Flow ◽  
Hydrogenated Amorphous Silicon ◽  
Chemical Vapor ◽  
Silicon Thin Films ◽  
Frequency Plasma ◽  
Hydrogenated Amorphous

Hydrogenated amorphous silicon (a-Si:H) thin films doped with both Phosphor and Nitrogen are deposited by ratio frequency plasma enhanced chemical vapor deposition (PECVD). The effect of gas flow rate of ammonia (FrNH3) on the composition, microstructure and optical properties of the films has been investigated by X-ray photoelectron spectroscopy, Raman spectroscopy and ellipsometric spectra, respectively. The results show that with the increase of FrNH3, Si-N bonds appear while the short-range order deteriorate in the films. Besides, the optical properties of N-doped n-type a-Si:H thin films can be easily controlled in a PECVD system.

Metal-organic chemical vapor deposition of ZrO2 films using Zr(thd)4 as precursors

1994 ◽  
Vol 9 (7) ◽  
pp. 1721-1727 ◽  
Author(s):  
Jie Si ◽  
Seshu B. Desu ◽  
Ching-Yi Tsai
Keyword(s):  
Thin Films ◽  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Film Deposition ◽  
Organic Chemical ◽  
Deposition Rates ◽  
Metal Organic ◽  
Organic Chemical Vapor Deposition ◽  
Deposited Films

Synthesis of zirconium tetramethylheptanedione [Zr(thd)4] was optimized. Purity of Zr(thd)4 was confirmed by melting point determination, carbon, and hydrogen elemental analysis and proton nuclear magnetic resonance spectrometer (NMR). By using Zr(thd)4, excellent quality ZrO2 thin films were successfully deposited on single-crystal silicon wafers by metal-organic chemical vapor deposition (MOCVD) at reduced pressures. For substrate temperatures below 530 °C, the film deposition rates were very small (⋚1 nm/min). The film deposition rates were significantly affected by (i) source temperature, (ii) substrate temperature, and (iii) total pressure. As-deposited films are carbon free. Furthermore, only the tetragonal ZrO2 phase was identified in as-deposited films. The tetragonal phase transformed progressively into the monoclinic phase as the films were subjected to a high-temperature post-deposition annealing. The optical properties of the ZrO2 thin films as a function of wavelength, in the range of 200 nm to 2000 nm, were also reported. In addition, a simplified theoretical model which considers only a surface reaction was used to analyze the deposition of ZrO2 films. The model predicated the deposition rates well for various conditions in the hot wall reactor.

Boron- and phosphorus-doped polycrystalline silicon thin films prepared by silver-induced layer exchange

2013 ◽  
Vol 102 (21) ◽  
pp. 212102 ◽  
Author(s):  
T. Antesberger ◽  
T. A. Wassner ◽  
C. Jaeger ◽  
M. Algasinger ◽  
M. Kashani ◽  
...  
Keyword(s):  
Thin Films ◽  
Polycrystalline Silicon ◽  
Silicon Thin Films ◽  
Phosphorus Doped
Sign in / Sign up

Export Citation Format

Share Document