Characterization of Copper-Ceramic Interfaces

1984 ◽  
Vol 40 ◽  
Author(s):  
W. M. Kriven ◽  
S. H. Risbud
Keyword(s):  
Electron Probe ◽  
Interfacial Microstructure ◽  
Oxidation States ◽  
Thermodynamics And Kinetics ◽  
Specific Goal ◽  
Reaction Zones ◽  
Ceramic Interfaces ◽  
Kinetics Of ◽  
Oxidation State Of Copper

AbstractThe interfacial zones in copper-magnesium aluminosilicate materials were characterized by several microscopic and microchemical techniques. Interfaces between copper-glass, copper-partially crystallized glass, and copper-fully crystallized glass were studied with the specific goal of determining the oxidation state of copper in various locations in the microstructure of the reaction zones. Optical microscopy, cathodoluminescence, electron probe microanalysis (EPMA), SEM, TEM, and other microtechniques were used. The presence of copper in various oxidation states can be attributed to the thermodynamics and kinetics of the system. Results correlating the observed interfacial microstructure and the thermochemistry of the system are presented.

Irradiation behavior of pyrolytic silicon carbide

1983 ◽  
Vol 41 ◽  
pp. 72-73
Author(s):  
R. J. Lauf
Keyword(s):  
Silicon Carbide ◽  
Fission Products ◽  
Thermodynamics And Kinetics ◽  
Neutron Fluences ◽  
Fuel Particles ◽  
Sic Coatings ◽  
Irradiation Behavior ◽  
Kinetics Of ◽  
Htgr Fuel

Fuel particles for the High-Temperature Gas-Cooled Reactor (HTGR) contain a layer of pyrolytic silicon carbide to act as a miniature pressure vessel and primary fission product barrier. Optimization of the SiC with respect to fuel performance involves four areas of study: (a) characterization of as-deposited SiC coatings; (b) thermodynamics and kinetics of chemical reactions between SiC and fission products; (c) irradiation behavior of SiC in the absence of fission products; and (d) combined effects of irradiation and fission products. This paper reports the behavior of SiC deposited on inert microspheres and irradiated to fast neutron fluences typical of HTGR fuel at end-of-life.

Microstructural characterization of CoPtCr/Cr thin film disks by cross-section TEM and elongated probe micro-diffraction

1991 ◽  
Vol 49 ◽  
pp. 762-763
Author(s):  
M.A. Parker ◽  
K.E. Johnson ◽  
C. Hwang ◽  
A. Bermea
Keyword(s):  
Magnetic Recording ◽  
Electron Probe ◽  
Microstructural Characterization ◽  
Crystallographic Structure ◽  
Recording Media ◽  
Layer By Layer ◽  
Cross Sectional ◽  
New Techniques ◽  
Polished Side

We have reported the dependence of the magnetic and recording properties of CoPtCr recording media on the thickness of the Cr underlayer. It was inferred from XRD data that grain-to-grain epitaxy of the Cr with the CoPtCr was responsible for the interaction observed between these layers. However, no cross-sectional TEM (XTEM) work was performed to confirm this inference. In this paper, we report the application of new techniques for preparing XTEM specimens from actual magnetic recording disks, and for layer-by-layer micro-diffraction with an electron probe elongated parallel to the surface of the deposited structure which elucidate the effect of the crystallographic structure of the Cr on that of the CoPtCr.XTEM specimens were prepared from magnetic recording disks by modifying a technique used to prepare semiconductor specimens. After 3mm disks were prepared per the standard XTEM procedure, these disks were then lapped using a tripod polishing device. A grid with a single 1mmx2mm hole was then glued with M-bond 610 to the polished side of the disk.

Catalytic Fluorination of Boron Compounds at a Bismuth Redox Platform

2019 ◽  
Author(s):  
Oriol Planas ◽  
Feng Wang ◽  
Markus Leutzsch ◽  
Josep Cornella
Keyword(s):  
Transition Metal ◽  
Main Group ◽  
Group Element ◽  
Oxidation States ◽  
Boron Compounds ◽  
Main Text ◽  
Main Group Element ◽  
Rational Ligand Design ◽  
Supplementary Material

The ability of bismuth to maneuver between different oxidation states in a catalytic redox cycle, mimicking the canonical organometallic steps associated to a transition metal, is an elusive and unprecedented approach in the field of homogeneous catalysis. Herein we present a catalytic protocol based on bismuth, a benign and sustainable main-group element, capable of performing every organometallic step in the context of oxidative fluorination of boron compounds; a territory reserved to transition metals. A rational ligand design featuring hypervalent coordination together with a mechanistic understanding of the fundamental steps, permitted a catalytic fluorination protocol based on a Bi(III)/Bi(V) redox couple, which represents a unique example where a main-group element is capable of outperforming its transition metal counterparts.<br>A main text and supplementary material have been attached as pdf files containing all the methodology, techniques and characterization of the compounds reported.<br>

Thermodynamics and kinetics of hydriding of the Zr(Ni0.75V0.25)2 laves phase

2004 ◽  
Vol 29 (2) ◽  
pp. 1-9
Author(s):  
Mustapha Boulghallat ◽  
Ahmed Jouaiti ◽  
Norbert Gérard
Keyword(s):  
Laves Phase ◽  
Thermodynamics And Kinetics ◽  
Kinetics Of

Elaboration and Characterization of the Properties of Refractory Cr Base Alloys

2010 ◽  
Vol 72 ◽  
pp. 46-52 ◽  
Author(s):  
Laurent Royer ◽  
Stéphane Mathieu ◽  
Christophe Liebaut ◽  
Pierre Steinmetz
Keyword(s):  
Mechanical Properties ◽  
Melting Point ◽  
Molten Glass ◽  
Energy Production ◽  
Creep Properties ◽  
Refractory Alloys ◽  
Industrial Use ◽  
Kinetics Of ◽  
Selection Of

For energy production and also for the glass industry, finding new refractory alloys which could permit to increase the process temperatures to 1200°C or more is a permanent challenge. Chromium base alloys can be good candidates, considering the melting point of Cr itself, and also its low corrosion rate in molten glass. Two families of alloys have been studied for this purpose, Cr-Mo-W and Cr-Ta-X alloys (X= Mo, Si..). A finer selection of compositions has been done, to optimize their chemical and mechanical properties. Kinetics of HT oxidation by air, of corrosion by molten glass and also creep properties of several alloys have been measured up to 1250°C. The results obtained with the best alloys (Cr-Ta base) give positive indications as regards the possibility of their industrial use.

scholarly journals New Trimethoprim-Like Molecules: Bacteriological Evaluation and Insights into Their Action

Antibiotics ◽  
2021 ◽  
Vol 10 (6) ◽  
pp. 709
Author(s):  
Marta Jorba ◽  
Marina Pedrola ◽  
Ouldouz Ghashghaei ◽  
Rocío Herráez ◽  
Lluis Campos-Vicens ◽  
...  
Keyword(s):  
Inhibitory Concentration ◽  
Efflux Pump ◽  
Synergistic Effects ◽  
Nicotinamide Adenine Dinucleotide Phosphate ◽  
Detailed Characterization ◽  
Low Concentrations ◽  
Pump Activity ◽  
Bacteriological Evaluation ◽  
Kinetics Of

This work reports a detailed characterization of the antimicrobial profile of two trimethoprim-like molecules (compounds 1a and 1b) identified in previous studies. Both molecules displayed remarkable antimicrobial activity, particularly when combined with sulfamethoxazole. In disk diffusion assays on Petri dishes, compounds 1a and 1b showed synergistic effects with colistin. Specifically, in combinations with low concentrations of colistin, very large increases in the activities of compounds 1a and 1b were determined, as demonstrated by alterations in the kinetics of bacterial growth despite only slight changes in the fractional inhibitory concentration index. The effect of colistin may be to increase the rate of antibiotic entry while reducing efflux pump activity. Compounds 1a and 1b were susceptible to extrusion by efflux pumps, whereas the inhibitor phenylalanine arginyl β-naphthylamide (PAβN) exerted effects similar to those of colistin. The interactions between the target enzyme (dihydrofolate reductase), the coenzyme nicotinamide adenine dinucleotide phosphate (NADPH), and the studied molecules were explored using enzymology tools and computational chemistry. A model based on docking results is reported.

scholarly journals Simultaneous Kinetics of Selenite Oxidation and Sorption on δ-MnO2 in Stirred-Flow Reactors

2021 ◽  
Vol 18 (6) ◽  
pp. 2902
Author(s):  
Zheyong Li ◽  
Yajun Yuan ◽  
Lin Ma ◽  
Yihui Zhang ◽  
Hongwei Jiang ◽  
...  
Keyword(s):  
Rate Constant ◽  
Photoelectron Spectroscopy ◽  
Oxide Surfaces ◽  
Kinetic Rate Constant ◽  
Flow Reactors ◽  
Mn Oxide ◽  
Remediation Strategies ◽  
Process Of Se ◽  
Kinetics Of

Selenium (Se) is an essential and crucial micronutrient for humans and animals, but excessive Se brings negativity and toxicity. The adsorption and oxidation of Se(IV) on Mn-oxide surfaces are important processes for understanding the geochemical fate of Se and developing engineered remediation strategies. In this study, the characterization of simultaneous adsorption, oxidation, and desorption of Se(IV) on δ-MnO2 mineral was carried out using stirred-flow reactors. About 9.5% to 25.3% of Se(IV) was oxidized to Se(VI) in the stirred-flow system in a continuous and slow process, with the kinetic rate constant k of 0.032 h−1, which was significantly higher than the apparent rate constant of 0.0014 h−1 obtained by the quasi-level kinetic fit of the batch method. The oxidation reaction was driven by proton concentration, and its rate also depended on the Se(IV) influent concentration, flow rate, and δ-MnO2 dosage. During the reaction of Se(IV) and δ-MnO2, Mn(II) was produced and adsorbed strongly on Mn oxide surfaces, which was evidenced by the total reflectance Fourier transform infrared (ATR-FTIR) results. The X-ray photoelectron spectroscopy (XPS) data indicated that the reaction of Se(VI) on δ-MnO2 produced Mn(III) as the main product. These results contribute to a deeper understanding of the interface chemical process of Se(IV) with δ-MnO2 in the environment.

Sign in / Sign up

Export Citation Format

Share Document