Acidogenic fermentation of municipal solid waste and its application to bio-electricity production via microbial fuel cells (MFCs)

2011 ◽  
Vol 64 (4) ◽  
pp. 789-795 ◽  
Author(s):  
P. Cavdar ◽  
E. Yilmaz ◽  
A. E. Tugtas ◽  
B. Calli

Acidogenic fermentation of organic municipal solid waste (MSW) and the bio-electricity production potential from its volatile fatty acid (VFA)-rich leachate using an air-cathode microbial fuel cell (MFC) was investigated in this study. The acidogenic fermentation of 2 kg of MSW has been carried out in a 6 L anaerobic leach-bed reactor (LBR) under mesophilic conditions (30 °C). Total production of 92 g VFA expressed as chemical oxygen demand (COD) in 3 L leachate mainly containing acetic, propionic, butyric, and valeric acids has been achieved with manual leachate recirculation and without pH control in 74 days of incubation. Leachate collected on day 32 was used as a feed to an air-cathode MFC after being diluted and supplemented with NaCl or NaHCO3. The maximum power density in the diluted leachate was only 5.9 W/m3, but reached up to 8.6 W/m3 upon the addition of 7 mmol/L NaCl. Increase in coulombic efficiency from 6 to 22% was also observed as a result of NaCl supplementation. On the other hand, NaHCO3 addition did not improve the power output.

2016 ◽  
Vol 34 (7) ◽  
pp. 619-629 ◽  
Author(s):  
HY Chiu ◽  
TY Pai ◽  
MH Liu ◽  
CA Chang ◽  
FC Lo ◽  
...  

2017 ◽  
Vol 76 (3) ◽  
pp. 683-693 ◽  
Author(s):  
Edson Baltazar Estrada-Arriaga ◽  
Yvonne Guillen-Alonso ◽  
Cornelio Morales-Morales ◽  
Liliana García-Sánchez ◽  
Erick Obed Bahena-Bahena ◽  
...  

Two different air-cathode stacked microbial fuel cell (MFC) configurations were evaluated under continuous flow during the treatment of municipal wastewater and electricity production at a hydraulic retention time (HRT) of 3, 1, and 0.5 d. Stacked MFC 1 was formed by 20 individual air-cathode MFC units. The second stacked MFC (stacked MFC 2) consisted of 40 air-cathode MFC units placed in a shared reactor. The maximum voltages produced at closed circuit (1,000 Ω) were 170 mV for stacked MFC 1 and 94 mV for stacked MFC 2. Different power densities in each MFC unit were obtained due to a potential drop phenomenon and to a change in chemical oxygen demand (COD) concentrations inside reactors. The maximum power densities from individual MFC units were up to 1,107 mW/m2 for stacked MFC 1 and up to 472 mW/m2 for stacked MFC 2. The maximum power densities in stacked MFC 1 and MFC 2 connected in series were 79 mW/m2 and 4 mW/m2, respectively. Electricity generation and COD removal efficiencies were reduced when the HRT was decreased. High removal efficiencies of 84% of COD, 47% of total nitrogen, and 30% of total phosphorus were obtained during municipal wastewater treatment.


Materials ◽  
2022 ◽  
Vol 15 (1) ◽  
pp. 379
Author(s):  
Ignacio T. Vargas ◽  
Natalia Tapia ◽  
John M. Regan

During the last decade, bioprospecting for electrochemically active bacteria has included the search for new sources of inoculum for microbial fuel cells (MFCs). However, concerning power and current production, a Geobacter-dominated mixed microbial community derived from a wastewater inoculum remains the standard. On the other hand, cathode performance is still one of the main limitations for MFCs, and the enrichment of a beneficial cathodic biofilm emerges as an alternative to increase its performance. Glucose-fed air-cathode reactors inoculated with a rumen-fluid enrichment and wastewater showed higher power densities and soluble chemical oxygen demand (sCOD) removal (Pmax = 824.5 mWm−2; ΔsCOD = 96.1%) than reactors inoculated only with wastewater (Pmax = 634.1 mWm−2; ΔsCOD = 91.7%). Identical anode but different cathode potentials suggest that differences in performance were due to the cathode. Pyrosequencing analysis showed no significant differences between the anodic community structures derived from both inocula but increased relative abundances of Azoarcus and Victivallis species in the cathodic rumen enrichment. Results suggest that this rarely used inoculum for single-chamber MFCs contributed to cathodic biofilm improvements with no anodic biofilm effects.


Energies ◽  
2020 ◽  
Vol 13 (18) ◽  
pp. 4712
Author(s):  
Dawid Nosek ◽  
Agnieszka Cydzik-Kwiatkowska

Development of economical and environment-friendly Microbial Fuel Cells (MFCs) technology should be associated with waste management. However, current knowledge regarding microbiological bases of electricity production from complex waste substrates is insufficient. In the following study, microbial composition and electricity generation were investigated in MFCs powered with waste volatile fatty acids (VFAs) from anaerobic digestion of primary sludge. Two anode sizes were tested, resulting in organic loading rates (OLRs) of 69.12 and 36.21 mg chemical oxygen demand (COD)/(g MLSS∙d) in MFC1 and MFC2, respectively. Time of MFC operation affected the microbial structure and the use of waste VFAs promoted microbial diversity. High abundance of Deftia sp. and Methanobacterium sp. characterized start-up period in MFCs. During stable operation, higher OLR in MFC1 favored growth of exoelectrogens from Rhodopseudomonas sp. (13.2%) resulting in a higher and more stable electricity production in comparison with MFC2. At a lower OLR in MFC2, the percentage of exoelectrogens in biomass decreased, while the abundance of genera Leucobacter, Frigoribacterium and Phenylobacterium increased. In turn, this efficiently decomposed complex organic substances, favoring high and stable COD removal (over 85%). Independent of the anode size, Clostridium sp. and exoelectrogens belonging to genera Desulfobulbus and Acinetobacter were abundant in MFCs powered with waste VFAs.


Energies ◽  
2019 ◽  
Vol 12 (13) ◽  
pp. 2610 ◽  
Author(s):  
Jung-Chieh Su ◽  
Szu-Ching Tang ◽  
Po-Jui Su ◽  
Jung-Jeng Su

The pattern of micro-electricity production of simple two-chamber microbial fuel cells (MFC) was monitored in this study. Piggery wastewater and anaerobic sludge served as fuel and inocula for the MFC, respectively. The output power, including voltage and current generation, of triplicate MFCs was measured using an on-line monitoring system. The maximum voltage obtained among the triplicates was 0.663 V. We also found that removal efficiency of chemical oxygen demand (COD) and biochemical oxygen demand (BOD) in the piggery wastewater was 94.99 and 98.63%, respectively. Moreover, analytical results of Fast Fourier Transform (FFT) demonstrated that the output current comprised alternating current (AC) and direct current (DC) components, ranging from mA to μA.


2019 ◽  
Vol 140 ◽  
pp. 01006
Author(s):  
Olga Barysheva ◽  
Yuri Khabibullin ◽  
Aida Mukhametzianova

At present, processing and recycling of municipal solid waste (MSW) has become more relevant in our country and the world at large. This problem concerns large towns and cities, where every year millions of tons of all kinds of fractions of household waste are produced. Disposal or recycling of solid waste is an environmental issue, but it is associated with the solution of complex technical, energy and economic challenges. The purpose of this study is to identify the advantages and disadvantages of modern methods of processing and disposal of MSW with the prospect of developing and creating a device for recycling MSW taking into account modern approaches to energy saving and environmental protection. The main results of the study are to create a simple, reliable and technically sound method of MSW disposal to obtain additional energy. The significance of the results obtained for the construction industry is the design of a device for the disposal of solid waste with the production of solid combustion products and further their use as building materials and products for various purposes. Because of the technological process of MSW processing, it becomes possible to generate some returns through use of resulting thermal energy for electricity production.


2019 ◽  
Vol 37 (6) ◽  
pp. 631-642 ◽  
Author(s):  
Ana Carolina Medina Jimenez ◽  
Reynaldo Palacios- Bereche ◽  
Silvia Nebra

In Brazil, in 2016, 196,050 tonnes day-1 of municipal solid waste (MSW) were collected, which means a waste generation of 1.035 kg per capita per day. Only 59.1% of the waste has adequate destination in sanitary landfills, whereas the remaining 40.9% has inadequate destination in controlled landfills and open dumps (ABRELPE, 2018). Among all the states in the country, the State of São Paulo has the biggest per capita generation: 2.290 kg. Today, the only waste destination practiced in the country is deposition in landfills, but other possibilities can be considered. Among thermal treatment routes, the gasification of MSW is an interesting alternative to be studied, because of its versatility and relatively low emissions. The aim of this work is to evaluate the potential of electricity generation through MSW gasification in Santo André city, Brazil, comparing three waste gasification technologies: TPS Termiska Processer AB, Carbogas and Energos. These alternatives have operated commercially for a few years, and data are available. Specific characteristics of each technology were taken into account, such as the reactor type and fuel properties. For the electricity production scheme, two energy conversion systems were assumed: an internal combustion engine and a steam power cycle. From the process parameters adopted, the results showed that Carbogas technology, coupled to internal combustion engines, presents the highest efficiency of electricity generation (30%) and also the lowest cost of electrical energy produced (US$65.22 MWh-1) when Santo André’s gate fee is applied.


2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Malik Muhammad Hassan ◽  
Noor Haleem ◽  
Muhammad Anwar Baig ◽  
Yousuf Jamal

Abstract Grasses have been used widely to remediate contaminants present in domestic wastewater, but leachate generated from municipal solid waste that usually contain some concentrations of heavy metals has never been reported to be treated with grasses, especially Rhodes grass. A series of experiments was performed to investigate the contaminant uptake from municipal solid waste leachate by Chloris gayana (Rhodes grass) grown in combination with two commonly available grass varieties namely Vetiveria zizanioides (Vetiver grass) and Pennisetum purpureum (Elephant grass). Leachate used for the experiments had high values for chemical oxygen demand (5 g/L), pH (8.5), electrical conductivity (9.0 mS/cm), nitrates (182.1 mg/L), phosphates 6.4 mg/L along with heavy metals i.e. copper, zinc and manganese. Different dilutions of leachate ranging from 0 to 100% were applied in batches and their result showed that collectively all the grasses reduced overall contaminant concentrations. These were reported for chemical oxygen demand, electrical conductivity, nitrates, and phosphates reduced up to 67, 94, 94, and 73%, respectively. Metals uptake by grasses also showed a significant decrease in applied dose i.e. zinc (97%), copper (89%), and manganese (89%). Plant analysis showed that all grasses showed preference to heavy metals uptake e.g. Rhodes grass favoured up taking zinc, Elephant grass for copper and Vetiver grass preferred manganese. Overall growth performance of Rhodes grass was better in dilute leachate, whereas in more concentrated leachate, Rhodes grass did not perform better and production of biomass decreased. In Vetiver grass, root and shoot lengths decreased with increasing leachate strength, but the biomass did not change significantly.


Sign in / Sign up

Export Citation Format

Share Document