ON THE DIFFERENCE BETWEEN GROUND AND PIPE VIBRATION MEASUREMENTS OF LEAK NOISE FOR LEAK DETECTION PROBLEMS

Author(s):  
Fabricio Almeida ◽  
Michael Brennan ◽  
Oscar Scussel
Author(s):  
Oussama Choura ◽  
Caterina Capponi ◽  
Silvia Meniconi ◽  
Sami Elaoud ◽  
Bruno Brunone

Abstract In this paper the results of an experimental validation of a technique for leak detection in polymeric pipes based on the inverse transient analysis (ITA) are presented. In the proposed ITA the Nelder–Mead algorithm is used as a calibration tool. Experimental tests have been carried out in an intact and leaky high-density polyethylene (HDPE) single pipe installed at the Water Engineering Laboratory (WEL) of the University of Perugia, Italy. Transients have been generated by the fast and complete closure of a valve placed at the downstream end section of the pipe. In the first phase of the calibration procedure, the proposed algorithm has been used to estimate both the viscoelastic parameters of a generalized Kelvin–Voigt model and the unsteady-state friction coefficient, by minimizing the difference between the numerical and experimental results. In the second phase of the procedure, the calibrated model allowed the evaluation of leak size and location with an acceptable accuracy. Precisely, in terms of leak location the relative error was smaller than 5%.


2018 ◽  
Vol 198 ◽  
pp. 02001
Author(s):  
Shaoming Yu ◽  
Tian Lu ◽  
Guo Wei ◽  
Yanping Hu

Through the study on the vibration characteristics of the typical pipe, it tries to provide the basis for the pipe design and the pipe ground test method. A typical pipe is selected. First, modal analysis is carried out through theoretical analysis and finite element simulation. Then, pipe vibration is studied by finite element simulation and test. The results show that the theoretical results in modal analysis coincide well with those in finite element simulation. The finite element simulation and experimental results are basically consistent in vibration analysis. The reason for the difference is mainly the ideal boundary of simulation. The combination of finite element simulation and test is an important method for the research of pipe reliability and environmental adaptability.


2021 ◽  
Vol 3 (1) ◽  
pp. 15-20
Author(s):  
Bisman Perangin-Angin

This research aimed to design the air pipe leak detection using a pressure transmitter sensor with a smartphone as a display. The research produced a method that can be relied upon by pipe leaks quickly and accurately. The method was carried out by using two flowmeter sensors that are placed before and after the pipe leak point to record data on the difference between intake and exit air flow (ΔQ). The resulting data was transmitted to the computer using a TCP/IP-based network. The results obtained show that the smaller the difference in the flow of air into and out (ΔQ), the farther the pipe leak is (X).


Author(s):  
Tomohiro Furukawa ◽  
Masahiko Ohtaka ◽  
Yasushi Hirakawa

In the Japanese engineering validation activities on the target facility of the International Fusion Materials Irradiation Facility, two studies on the advanced lithium leak detection system and the fire-extinguishing behavior of lithium were performed. In the former study, the fluorescence was distinguishable from the background using the difference of decay curves from the results of the lithium fluorescence measurement under two lithium concentration (256 ng/L and 4.58 ng/L) in argon. This result shows the basic applicability of the laser based lithium measuring technique as the lithium detector could be confirmed. In the latter study, fire-extinguishing behavior of two kinds of carbon base fire extionguishishants — MITEX and GRAPHEX — to lithium was examined. The both extinguishants showed excellent fire-extinguishing performance, and there were equivalent to that of Natlex-L obtained in the previous study. Since the bulk densities of the both carbon based extinguishants were about equal to the density of lithium, the subsidence of the fire-extinguishings which was observed in the Natlex-L was not observed. In fact, it was considered that no dependency of lithium pool depth on the required thickness of the fire extinguishants was observed for the carbon based extinguishants.


2020 ◽  
Vol 22 (5) ◽  
pp. 1306-1320
Author(s):  
He Shi ◽  
Jinzhe Gong ◽  
Angus R. Simpson ◽  
Aaron C. Zecchin ◽  
Martin F. Lambert

Abstract Leak detection in complex pipeline systems is challenging due to complex wave reflections. This research proposes a new technique for leak detection in targeted pipe sections within complex water supply pipe systems using controlled hydraulic transient pressure waves. To ‘virtually isolate’ a targeted pipe section for independent analysis, a two-source-four-sensor transient testing configuration is used to extract the transfer matrix of the targeted pipe section, and it is independent of the system boundary conditions. The imaginary part of the difference between two elements in the transfer matrix is sensitive to leaks. The result should be zero if no leak is present, while a leak will introduce a sinusoidal pattern. An algorithm is developed to extract the leak information, which is applicable to multiple leaks. Two numerical case studies are conducted to validate the new leak detection technique. Case 1 is on a single pipe system with two leaks and deteriorated pipe sections, and pulse pressure waves are used as the excitation. Case 2 is on a simple pipe network with one leak, and pseudo-random binary signals are used as the excitation. The successful determination of the leak location and impedance validates the concept.


1962 ◽  
Vol 14 ◽  
pp. 149-155 ◽  
Author(s):  
E. L. Ruskol

The difference between average densities of the Moon and Earth was interpreted in the preceding report by Professor H. Urey as indicating a difference in their chemical composition. Therefore, Urey assumes the Moon's formation to have taken place far away from the Earth, under conditions differing substantially from the conditions of Earth's formation. In such a case, the Earth should have captured the Moon. As is admitted by Professor Urey himself, such a capture is a very improbable event. In addition, an assumption that the “lunar” dimensions were representative of protoplanetary bodies in the entire solar system encounters great difficulties.


1997 ◽  
Vol 161 ◽  
pp. 491-504 ◽  
Author(s):  
Frances Westall

AbstractThe oldest cell-like structures on Earth are preserved in silicified lagoonal, shallow sea or hydrothermal sediments, such as some Archean formations in Western Australia and South Africa. Previous studies concentrated on the search for organic fossils in Archean rocks. Observations of silicified bacteria (as silica minerals) are scarce for both the Precambrian and the Phanerozoic, but reports of mineral bacteria finds, in general, are increasing. The problems associated with the identification of authentic fossil bacteria and, if possible, closer identification of bacteria type can, in part, be overcome by experimental fossilisation studies. These have shown that not all bacteria fossilise in the same way and, indeed, some seem to be very resistent to fossilisation. This paper deals with a transmission electron microscope investigation of the silicification of four species of bacteria commonly found in the environment. The Gram positiveBacillus laterosporusand its spore produced a robust, durable crust upon silicification, whereas the Gram negativePseudomonas fluorescens, Ps. vesicularis, andPs. acidovoranspresented delicately preserved walls. The greater amount of peptidoglycan, containing abundant metal cation binding sites, in the cell wall of the Gram positive bacterium, probably accounts for the difference in the mode of fossilisation. The Gram positive bacteria are, therefore, probably most likely to be preserved in the terrestrial and extraterrestrial rock record.


1994 ◽  
Vol 144 ◽  
pp. 421-426
Author(s):  
N. F. Tyagun

AbstractThe interrelationship of half-widths and intensities for the red, green and yellow lines is considered. This is a direct relationship for the green and yellow line and an inverse one for the red line. The difference in the relationships of half-widths and intensities for different lines appears to be due to substantially dissimilar structuring and to a set of line-of-sight motions in ”hot“ and ”cold“ corona regions.When diagnosing the coronal plasma, one cannot neglect the filling factor - each line has such a factor of its own.


Author(s):  
Jules S. Jaffe ◽  
Robert M. Glaeser

Although difference Fourier techniques are standard in X-ray crystallography it has only been very recently that electron crystallographers have been able to take advantage of this method. We have combined a high resolution data set for frozen glucose embedded Purple Membrane (PM) with a data set collected from PM prepared in the frozen hydrated state in order to visualize any differences in structure due to the different methods of preparation. The increased contrast between protein-ice versus protein-glucose may prove to be an advantage of the frozen hydrated technique for visualizing those parts of bacteriorhodopsin that are embedded in glucose. In addition, surface groups of the protein may be disordered in glucose and ordered in the frozen state. The sensitivity of the difference Fourier technique to small changes in structure provides an ideal method for testing this hypothesis.


Author(s):  
P. Maupin-Szamier ◽  
T. D. Pollard

We have studied the destruction of rabbit muscle actin filaments by osmium tetroxide (OSO4) to develop methods which will preserve the structure of actin filaments during preparation for transmission electron microscopy.Negatively stained F-actin, which appears as smooth, gently curved filaments in control samples (Fig. 1a), acquire an angular, distorted profile and break into progressively shorter pieces after exposure to OSO4 (Fig. 1b,c). We followed the time course of the reaction with viscometry since it is a simple, quantitative method to assess filament integrity. The difference in rates of decay in viscosity of polymerized actin solutions after the addition of four concentrations of OSO4 is illustrated in Fig. 2. Viscometry indicated that the rate of actin filament destruction is also dependent upon temperature, buffer type, buffer concentration, and pH, and requires the continued presence of OSO4. The conditions most favorable to filament preservation are fixation in a low concentration of OSO4 for a short time at 0°C in 100mM sodium phosphate buffer, pH 6.0.


Sign in / Sign up

Export Citation Format

Share Document