scholarly journals Experimental Study on Impact of Heating Temperature and Heating Rate during Carbonization of Woody Biomass

Author(s):  
Haizhen Huang ◽  
Zhenwei Jiao ◽  
Zhenyang Shu ◽  
Yaoguo Zeng
2018 ◽  
Vol 6 (1) ◽  
Author(s):  
Ni Putu Aryadnyani

AbstractBackground Ascaris lumbricoides eggs had very thick walls consisted of three layers, they were albuminoid layer, hyaline layer and vitelin layer. These layers were impermeable causing the Ascaris lumbricoides eggs resistant to less supportive environmental factors. Formalin 10% was a preservative that was often used to preserve faeces containing parasites such as protozoa and worm eggs. However, without heating, formalin 10% was not effective to preserve the Ascaris lumbricoides eggs because they would keep developing to become infective (containing larvae). Objective This study aims to prove whether there is an effect of adding 10% formalin which is heated at 60 C, 70 C and 80 C to the development of Ascaris lumbricoides eggs.Methods The design of this research was an experimental study with The Randomized Posttest Control Group Design. Result The Ascaris lumbricoides eggs were still growing into infective eggs in faeces although they were heated by formalin 10% at 60C, 70C and 80C. conclusion Based on the results of the study, there was no effect of heating temperature of formalin 10% on the development of Ascaris lumbricoides egg.Keywords: Formalin 10%, Ascaris lumbricoides, Heating, Soil Transmitted Helminth


2010 ◽  
Vol 168-170 ◽  
pp. 564-569
Author(s):  
Guang Lin Yuan ◽  
Jing Wei Zhang ◽  
Jian Wen Chen ◽  
Dan Yu Zhu

This paper makes an experimental study of mechanical properties of high-strength pumpcrete under fire, and the effects of heating rate, heating temperature and cooling mode on the residual compressive strength(RCS) of high-strength pumpcrete are investigated. The results show that under air cooling, the strength deterioration speed of high-strength concrete after high temperature increases with the increase of concrete strength grade. Also, the higher heating temperature is, the lower residual compressive strength value is. At the same heating rate (10°C/min), the residual compressive strength of C45 concrete after water cooling is a little higher than that after air cooling; but the test results are just the opposite for C55 and C65 concrete. The strength deterioration speed of high-strength concrete after high temperature increases with the increase of heating rate, but not in proportion. And when the heating temperature rises up between 200°C and 500°C, heating rate has the most remarkable effect on the residual compressive strength of concrete. These test results provide scientific proofs for further evaluation and analysis of mechanical properties of reinforced-concrete after exposure to high temperatures.


Energy ◽  
2019 ◽  
Vol 170 ◽  
pp. 497-506 ◽  
Author(s):  
Ye Shen ◽  
Xian Li ◽  
Zhiyi Yao ◽  
Xiaoqiang Cui ◽  
Chi-Hwa Wang

2016 ◽  
Vol 30 (10) ◽  
pp. 7994-8008 ◽  
Author(s):  
Liang Wang ◽  
Øyvind Skreiberg ◽  
Sam Van Wesenbeeck ◽  
Morten Grønli ◽  
Michael Jerry Antal

2015 ◽  
Vol 83 ◽  
pp. 169-182 ◽  
Author(s):  
C. Guizani ◽  
O. Louisnard ◽  
F.J. Escudero Sanz ◽  
S. Salvador

2014 ◽  
Vol 52 (2) ◽  
pp. 52-45
Author(s):  
Б. Пүрэвсүрэн ◽  
Я. Даваажав ◽  
С. Батбилэг ◽  
Ч. Ганзори

Манай орны Хангай, Хэнтийн уулын аглаг ойд ургадаг хуш модны самар нь хүнсний чухал бүтээгдэхүүн мөн хүнсний сайн чанарын тос гарган авч хэрэглэдэг. Хүмүүс жил бүр их хэмжээгээр түүж хүнсэнд хэрэглэхээс гадна нууцаар гадаад руу ихээр гаргадаг эх орны үнэт баялаг билээ. Хүмүүс самрыг ихээр цөмж ясыг нь тааралдсан газраа хаяж гудамж талбай, байгаль орчноо ихээр бохирдуулдаг.Сүүлийн жилүүдэд бидний судалгааны ажлын нэг үндсэн чиглэл болох органик түүхий эдүүдийн пиролизын судалгаа [1]-ны хүрээнд байгалийн үндсэн органик түүхий эд болох төрөл бүрийн нүүрс [2-6], занар [7-13], амьтны гаралтай цэвэр органик түүхий эд сүүний ээдэмцэр [14-23], зарим нэг хаягдал органик түүхий эдүүд болох малын яс [24-28], модны үртэс [28], нэг удаагийн хэрэглэсэн тариур[29]-ууд зэрэг түүхий эдүүдийн пиролизын туршилтуудыг хийж гарган авсан хатуу,шингэн ба хийн бүтээгдэхүүнүүдийн гарц хэмжээг тогтоож тэдгээрийн техникийн шинж чанар, химийн бүрэлдэхүүн ба хэрэглээний чиглэлийг тогтоох ажлуудыг үргэлжлүүлэн хийж байна.Иймд цөмөөд хаясан самрын яс нь органик хатуу хог хаягдал учраас түүнийг пиролзын болон хагас коксжуулалтын аргаар боловсруулж нүүрсжсэн хатуу бүтээгдэхүүн буюу хагас кокс, нефть төстэй шингэн давирхай ба шатдаг хий гарган авч болно гэж үзээд дээр дурьдсан судалгааны чиглэлд хамруулан судлахаар шийдвэрлэсэн юм. Хэрвээ хаягдал самрын ясыг ямар нэг аргаар цуглуулж чадвал энэ аргаар боловсруулж хэрэгтэй бүтээгдэхүүн болгон ашиглаж болно тухайлбал нүүрсжсэн хатуу үлдэгдэл нь нүх сүвэрхэг бүтэцтэй учир цаашид усны хэт халсан уураар нэмэлт боловсруулалт хийж нүх сүвэрхэг чанарыг нь нэмэгдүүлэн сайн чанарын шингээгч ба шүүгч материал болгон ашиглах бүрэн боложтойгоос гадна нэгэн төрлийн утаагүй шахмал түлш байдлаар ч ашиглаж болно.Самрын ясны пиролизоор үүссэн шингэн давирхай нь найрлагандаа олон янзын органик бодисуудыг агуулсан химийн үйлдвэрийн түүхий эд бөгөөд түүнээс шатахуун тослох материал ч гарган авах боломжтой ба хийг нь шатдаг хий болгон ашиглаж болно. Иймд самрын ясны пиролизын судалгааг хийж хатуу, шингэн ба хийн бүтээгдэхүүнүүдийн гарцыг нарийвчлан тогтоож нүүрсжсэн хатуу үлдэгдлийн нүх сүвэрхэг чанарыг судлах зорилтыг энэхүү ажлаараа давшүүлэн тавьж ажиллав.Түлхүүр үг самрын яс, идэвхжүүлсэн нүүрс, нүх сүвэрхэг бүтэц, давирхай, шатдаг хийINVESTIGATION ON PYROLYSIS OF WASTE OF CEDAR SHELLAbstract: The waste of cedar shell was the object of pyrolysis experiments. The technical characteristics of waste of cedar shell have been determined for first time and compared with technical characteristics of other organic raw materials such as coal, oil shall, casein, animal bone and plastic waste. Have been determined an optimal condition for pyrolysis of waste of cedar shell (heating temperature-500°C, heating rate-20°.C/min, time of pyrolysis-80 min.) and determined the yields of pyrolysis products including hard residue, tar, pyrolysis water and gases. The porosity structure of hard residue determined by the SEM analysis.DOI: http://dx.doi.org/10.5564/pmas.v52i2.359 Proceedings of the Mongolian Academy of Sciences Vol.52(2) 2012 p.45-52


Sign in / Sign up

Export Citation Format

Share Document