scholarly journals Water Injection for Oil Recovery in Mishrif Formation for Amarah Oil Field

2020 ◽  
Vol 21 (1) ◽  
pp. 39-44
Author(s):  
Ayat Ahmed Jassim ◽  
Abdul Aali Al-dabaj ◽  
Aqeel S. AL-Adili

The water injection of the most important technologies to increase oil production from petroleum reservoirs. In this research, we developed a model for oil tank using the software RUBIS for reservoir simulation. This model was used to make comparison in the production of oil and the reservoir pressure for two case studies where the water was not injected in the first case study but adding new vertical wells while, later, it was injected in the second case study. It represents the results of this work that if the water is not injected, the reservoir model that has been upgraded can produce only 2.9% of the original oil in the tank. This case study also represents a drop in reservoir pressure, which was not enough to support oil production. Thus, the implementation of water injection in the second case study of the average reservoir pressure may support, which led to an increase in oil production by up to 5.5% of the original oil in the tank. so that, the use of water injection is a useful way to increase oil production. Therefore, many of the issues related to this subject valuable of study where the development of new ideas and techniques.

2021 ◽  
Vol 11 (3) ◽  
pp. 1339-1352
Author(s):  
Mahamat Tahir Abdramane Mahamat Zene ◽  
Nurul Hasan ◽  
Ruizhong Jiang ◽  
Guan Zhenliang ◽  
Nurafiqah Abdullah

AbstractThe research of the current study is primarily focused on evaluating the reservoir performance by utilizing waterflood technique, based on a case study at Lanea oil field located in Chad; various mechanisms along with approaches were used in considering the best suitable pattern for waterflooding. All the simulation work was compared against a base case, where there was no involvement of water injection. Moreover, for the base case, a significant amount of oil left behind and cannot be swept, because of lower reservoir pressure at the downhill. The recovery factor obtained was in the range of 14.5–15% since 2010, and in order to enhance the oil production, an injection well was applied to boost the reservoir pressure; oil recovery is improved. In addition, sensitivity analysis study was performed to reach the optimum production behavior achieved by possible EOR method. Parameters, such as grid test, injection position, proper selection production location, permeability, and voidage substitution, were defined in the simulation study.


2020 ◽  
Vol 194 ◽  
pp. 04046
Author(s):  
Xiulan Zhu ◽  
Yanlong Ran ◽  
Wenjie Guo ◽  
Ke Gai ◽  
Yanju Li ◽  
...  

With the long-term water injection development of Longdong oilfields, most of the oilfield blocks have been fully in the mid-high water cut period, and the amount of oil production wastewater is increasing year by year. In order to prevent the waste of resources and energy of oil production sewage, the oil production sewage after reaching the standard is treated for reinjection, which will ensure the sustainable development of the oil field. Oil production wastewater contains crude oil, solid-phase suspended solids and other pollutants, with high salinity, and problems such as difficulty in oil-water separation, sludge, scaling and corrosion. The sewage treatment system uses a multifunctional water treatment device to effectively remove oil and filter through the “special microorganism + air flotation + filtration” process, and build a sludge sewage tank for sludge discharge and backwashing. The reformed oil recovery wastewater reinjection treatment technology turns “sewage” into “clear flow”, reduces operating costs, improves wastewater treatment efficiency, and meets the water quality requirements of oilfield reinjection water.


2021 ◽  
Author(s):  
Chaitanya Behera ◽  
Sandip Mahajan ◽  
Carlos Annia ◽  
Mahmood Harthi ◽  
Jane-Frances Obilaja ◽  
...  

Abstract This paper presents the results of a comprehensive study carried out to improve the understanding of deep bottom-up water injection, which enabled optimizing the recovery of a heavy oil field in South Oman. Understanding the variable water injection response and the scale of impact on oil recovery due to reservoir heterogeneity, operating reservoir pressure and liquid offtake management are the main challenges of deep bottoms-up water injection in heavy oil fields. The offtake and throughput management philosophy for heavy oil waterflood is not same as classical light oil. Due to unclear understanding of water injection response, sometimes the operators are tempted to implement alternative water injection trials leading to increase in the risk of losing reserves and unwarranted CAPEX sink. There are several examples of waterflood in heavy oil fields; however, very few examples of deep bottom water injection cases are available globally. The field G is one of the large heavy oil fields in South Oman; the oil viscosity varies between 250cp to 1500cp. The field came on-stream in 1989, but bottoms-up water-injection started in 2015, mainly to supplement the aquifer influx after 40% decline of reservoir pressure. After three years of water injection, the field liquid production was substantially lower than predicted, which implied risk on the incremental reserves. Alternative water injection concepts were tested by implementing multiple water injection trials apprehending the effectiveness of the bottoms-up water injection concept. A comprehensive integrated study including update of geocellular model, full field dynamic simulation, produced water re-injection (PWRI) model and conventional field performance analysis was undertaken for optimizing the field recovery. The Root Cause Analysis (RCA) revealed many reasons for suboptimal field performance including water injection management, productivity impairment due to near wellbore damage, well completion issues, and more importantly the variable water injection response in the field. The dynamic simulation study indicated negligible oil bank development due to frontal displacement and no water cut reversal as initial response to the water injection. Nevertheless, the significance of operating reservoir pressure, liquid offtake and throughput management impact on oil recovery cann't be precluded. The work concludes that the well reservoir management (WRM) strategy for heavy oil field is not same as the classical light oil waterflood. Nevertheless, the reservoir heterogeneity, oil column thickness and saturation history are also important influencing factors for variable water injection response in heavy oil field.


2002 ◽  
Vol 5 (01) ◽  
pp. 33-41 ◽  
Author(s):  
L.R. Brown ◽  
A.A. Vadie ◽  
J.O. Stephens

Summary This project demonstrated the effectiveness of a microbial permeability profile modification (MPPM) technology for enhancing oil recovery by adding nitrogenous and phosphorus-containing nutrients to the injection water of a conventional waterflooding operation. The MPPM technology extended the economic life of the field by 60 to 137 months, with an expected recovery of 63 600 to 95 400 m3 (400,000 to 600,000 bbl) of additional oil. Chemical changes in the composition of the produced fluids proved the presence of oil from unswept areas of the reservoir. Proof of microbial involvement was shown by increased numbers of microbes in cores of wells drilled within the field 22 months after nutrient injection began. Introduction The target for enhanced oil recovery processes is the tremendous quantity of unrecoverable oil in known deposits. Roughly two thirds [approximately 55.6×109 m3 (350 billion bbl)] of all of the oil discovered in the U.S. is economically unrecoverable with current technology. Because the microbial enhanced oil recovery (MEOR) technology in this report differs in several ways from other MEOR technologies, it is important that these differences be delineated clearly. In the first place, the present project is designed to enhance oil recovery from an entire oil reservoir, rather than treat single wells. Even more important is the fact that this technology relies on the action of the in-situ microflora, not microorganisms injected into the reservoir. It is important to note that MPPM technology does not interfere with the normal waterflood operation and is environmentally friendly in that neither microorganisms nor hazardous chemicals are introduced into the environment. Description of the Oil Reservoir. The North Blowhorn Creek Oil Unit (NBCU) is located in Lamar County, Alabama, approximately 75 miles west of Birmingham. This field is in what is known geologically as the Black Warrior basin. The producing formation is the Carter sandstone of Mississippian Age at a depth of approximately 700 m (2,300 ft). The Carter reservoir is a northwest/ southeast trending deltaic sand body, approximately 5 km (3 miles) long and 1 to 1.7 km (1/2 to 1 mile) wide. Sand thickness varies from only 1 m up to approximately 12 m (40 ft). The sand is relatively clean (greater than 90% quartz), with no swelling clays. The field was discovered in 1979 and initially developed on 80-acre spacing. Waterflooding of the reservoir began in 1983. The initial oil in place in the reservoir was approximately 2.54×106 m3 (16 million bbl), of which 874 430 m3 (5.5 million bbl) had been recovered by the end of 1995. To date, North Blowhorn Creek is the largest oil field discovered in the Black Warrior basin. Oil production peaked at almost 475 m3/d (3,000 BOPD) in 1985 and has since declined steadily. Currently, there are 20 injection wells and 32 producing wells. Oil production at the outset of the field demonstration was approximately 46 m3/d oil (290 BOPD), 1700 m3/d gas (60 MCFD), and 493 m3/d water (3,100 BWPD), with a water-injection rate of approximately 660 m3/d (4,150 BWPD). Projections at the beginning of the project were that approximately 1.59×106 m3 oil (10 million bbl of oil) would be left unrecovered if some new method of enhanced recovery were not effective. Prefield Trial Studies The concepts of the technology described in this paper had been proven to be effective in laboratory coreflood experiments.1,2 However, it seemed advisable to conduct coreflood experiments with cores from the reservoir being used in the field demonstration. Toward this end, two wells were drilled, and cores were obtained from one for the laboratory coreflood experiments to determine the schedule and amounts of nutrients to be employed in the field trial.3


2021 ◽  
Author(s):  
Adekunle Tirimisiyu Adeniyi ◽  
Miracle Imwonsa Osatemple ◽  
Abdulwahab Giwa

Abstract There are a good numbers of brown hydrocarbon reservoirs, with a substantial amount of bypassed oil. These reservoirs are said to be brown, because a huge chunk of its recoverable oil have been produced. Since a significant number of prominent oil fields are matured and the number of new discoveries is declining, it is imperative to assess performances of waterflooding in such reservoirs; taking an undersaturated reservoir as a case study. It should be recalled that Waterflooding is widely accepted and used as a means of secondary oil recovery method, sometimes after depletion of primary energy sources. The effects of permeability distribution on flood performances is of concerns in this study. The presence of high permeability streaks could lead to an early water breakthrough at the producers, thus reducing the sweep efficiency in the field. A solution approach adopted in this study was reserve water injection. A reverse approach because, a producing well is converted to water injector while water injector well is converted to oil producing well. This optimization method was applied to a waterflood process carried out on a reservoir field developed by a two - spot recovery design in the Niger Delta area of Nigeria that is being used as a case study. Simulation runs were carried out with a commercial reservoir oil simulator. The result showed an increase in oil production with a significant reduction in water-cut. The Net Present Value, NPV, of the project was re-evaluated with present oil production. The results of the waterflood optimization revealed that an increase in the net present value of up to 20% and an increase in cumulative production of up to 27% from the base case was achieved. The cost of produced water treatment for re-injection and rated higher water pump had little impact on the overall project economy. Therefore, it can conclude that changes in well status in wells status in an heterogenous hydrocarbon reservoir will increase oil production.


2015 ◽  
Vol 33 (4) ◽  
pp. 459-470 ◽  
Author(s):  
Vahid Ghorbani Pashakolaie ◽  
Shahla Khaleghi ◽  
Teymor Mohammadi ◽  
Morteza Khorsandi

1991 ◽  
Vol 31 (1) ◽  
pp. 386 ◽  
Author(s):  
Alan J. Sheehy

For over 40 years it has been speculated that bacteria can facilitate, increase or extend oil production from petroleum reservoirs. This speculation was supported in the laboratory by dramatic increases in oil recovered from experimental systems and in the field by anecdotal accounts of improvements in oil production. Most of these studies were poorly conceived and inadequately controlled. This drew industry criticism and created an environment where proposals to implement microbiologically enhanced oil recovery (microbial EOR) were summarily dismissed. The program implemented for the Alton Field, Surat Basin, was designed to overcome industry scepticism and document unambiguously in the field the effectiveness of a new microbial EOR strategy called Biological Stimulation of Oil production (BOS). An approximate 40 per cent increase in oil production has been sustained, compared to control operations on the same well, for eighteen months.The thrust to introduce pilot and field programs of BOS is compelling. BOS shares the advantages common to all biotechnologies in exploiting the extraordinary growth potential of microorganisms, providing flexibility through the extreme diversity of microbial metabolites and using cheap feedstocks. The BOS process generates ultramicrocells from those bacteria present naturally in the reservoir to be treated. This promotes injectivity, dispersion and persistence of the BOS system in the extreme environments which characterise petroleum reservoirs. The nutrients injected with the ultramicrocells result in metabolites forming within the bacterial cell surface. These metabolites cause re-profiling of the formation through the generation of emulsions and the development of concentrated surfactants at the oil-water interface.Ecological strategies designed to negate previously documented problems in the application of microbial EOR have been shown to be effective in laboratory experiments and field applications. Overcoming environmental extremes and developing persistence of beneficial organisms have been given special attention.


2018 ◽  
Vol 785 ◽  
pp. 159-170
Author(s):  
Vadim Aleksandrov ◽  
Kirill Galinskij ◽  
Andrey Ponomarev ◽  
Vadim Golozubenko ◽  
Yuriy Sivkov

One of the most important aspects in the activities of oil companies in the Western Siberia is to improve the effectiveness of water-flooding as the main method of impact on the formation. This is due to the fact that at the present time reservoirs of a complex structure with difficult to recover reserves prevail among newly introduced development objects, the extraction of which is extremely difficult using a simple method of water injection volumes regulation. First of all, this refers to reservoirs of Jurassic deposits, which are characterized by the most complex geological structure and porosity and permeability properties. A promising direction in improving the water-flooding system at such objects is the use of physical and chemical technologies to enhance the oil recovery of formations, and primarily, referring to the diverter technology. The research objective is to evaluate the effectiveness of using “hard” type diverter compositions to enhance oil recovery of formations. With the help of detailed oil-field analysis and field-geophysical studies, the nature of the development of oil reserves for Jurassic development sites has been assessed.


Sign in / Sign up

Export Citation Format

Share Document