scholarly journals Development of resistive random access memory for next-generation embedded non-volatile memory application

2020 ◽  
Author(s):  
◽  
Jianxun Sun
2017 ◽  
Vol 32 (4) ◽  
pp. 381-392
Author(s):  
Irfan Fetahovic ◽  
Edin Dolicanin ◽  
Djordje Lazarevic ◽  
Boris Loncar

In this paper we give an overview of radiation effects in emergent, non-volatile memory technologies. Investigations into radiation hardness of resistive random access memory, ferroelectric random access memory, magneto-resistive random access memory, and phase change memory are presented in cases where these memory devices were subjected to different types of radiation. The obtained results proved high radiation tolerance of studied devices making them good candidates for application in radiation-intensive environments.


2014 ◽  
Vol 602-603 ◽  
pp. 1056-1059 ◽  
Author(s):  
Min Chang Kuan ◽  
Fann Wei Yang ◽  
Chien Min Cheng ◽  
Kai Huang Chen ◽  
Jian Tz Lee

Up to now, the various non-volatile memory devices such as, ferroelectric random access memory (FeRAM), magnetron random access memory (MRAM), and resistance random access memory (RRAM) were widely discussed and investigated. For these nonvolatile memory devices, the resistance random access memory (RRAM) devices will play an important role because of its non-destructive readout, low operation voltage, high operation speed, long retention time, and simple structure. The resistance random access memory (RRAM) devices were only consisting of one resistor and one corresponding transistor. The subject of this work was to study the characteristics of manganese oxide (MnO) thin films deposited on transparent conductive thin film using the rf magnetron sputtering method. The optimal sputtering conditions of as-deposited manganese oxide (MnO) thin films were the rf power of 80 W, chamber pressure of 20 mTorr, substrate temperature of 580°C, and an oxygen concentration of 40%. The basic mechanisms for the bistable resistance switching were observed. In which, the non-volatile memory and switching properties of the manganese oxide (MnO) thin film structures were reported and the relationship between the memory windows and electrical properties was investigated.


IEEE Access ◽  
2021 ◽  
Vol 9 ◽  
pp. 105012-105047
Author(s):  
Usman Bature Isyaku ◽  
Mohd Haris Bin Md Khir ◽  
I. Md Nawi ◽  
M. A. Zakariya ◽  
Furqan Zahoor

2020 ◽  
Vol 12 (2) ◽  
pp. 02008-1-02008-4
Author(s):  
Pramod J. Patil ◽  
◽  
Namita A. Ahir ◽  
Suhas Yadav ◽  
Chetan C. Revadekar ◽  
...  

Nanomaterials ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 1401
Author(s):  
Te Jui Yen ◽  
Albert Chin ◽  
Vladimir Gritsenko

Large device variation is a fundamental challenge for resistive random access memory (RRAM) array circuit. Improved device-to-device distributions of set and reset voltages in a SiNx RRAM device is realized via arsenic ion (As+) implantation. Besides, the As+-implanted SiNx RRAM device exhibits much tighter cycle-to-cycle distribution than the nonimplanted device. The As+-implanted SiNx device further exhibits excellent performance, which shows high stability and a large 1.73 × 103 resistance window at 85 °C retention for 104 s, and a large 103 resistance window after 105 cycles of the pulsed endurance test. The current–voltage characteristics of high- and low-resistance states were both analyzed as space-charge-limited conduction mechanism. From the simulated defect distribution in the SiNx layer, a microscopic model was established, and the formation and rupture of defect-conductive paths were proposed for the resistance switching behavior. Therefore, the reason for such high device performance can be attributed to the sufficient defects created by As+ implantation that leads to low forming and operation power.


Sign in / Sign up

Export Citation Format

Share Document