scholarly journals Environmental Performance of Diesel Engines Running on Motor Fuel With Microalgae Bio-additives

Author(s):  
S.A. Nagornov ◽  
◽  
A.N. Zazulya ◽  
Yu.V. Meshcheryakov ◽  
I.G. Golubev ◽  
...  

The prospects of using blended motor fuel with bioadditives from microalgae in diesel engines are shown. It has been proven that the composition of microalgae lipids is similar to that of vegetable oils. It was revealed that the density, viscosity and cetane number of the dietary supplements are higher and the sulfur content is lower in comparison with diesel fuel. It has been experimentally established that with an increase in the content of bioadditives in mixed motor fuel the smoke and toxicity of diesel exhaust gases decrease.

2020 ◽  
pp. 22-30
Author(s):  
SERGEY N. DEVYANIN ◽  
◽  
VLADIMIR A. MARKOV ◽  
ALEKSANDR G. LEVSHIN ◽  
TAMARA P. KOBOZEVA ◽  
...  

The paper presents the results of long-term research on the oil productivity and chemical composition of soybean oil of the Northern ecotype varieties in the Central Non-Black Earth Region. The authors consider its possible use for biodiesel production. Experiments on growing soybeans were carried out on the experimental fi eld of Russian State Agrarian University –Moscow Timiryazev Agricultural Academy (2008-2019) on recognized ultra-early ripening varieties of the Northern ecotype Mageva, Svetlaya, Okskaya (ripeness group 000). Tests were set and the research results were analyzed using standard approved methods. It has been shown that in conditions of high latitudes (57°N), limited thermal resources of the Non-Chernozem zone of Russia (the sum of active temperatures of the growing season not exceeding 2000°С), the yield and productivity of soybeans depend on the variety and moisture supply. Over the years, the average yield of soybeans amounted to 1.94 … 2.62 t/ha, oil productivity – 388 … 544 kg/ha, oil content – 19…20%, the content of oleic and linoleic fatty acids in oil – 60%, and their output from seeds harvested – 300 kg/ha. It has been established that as soybean oil and diesel fuel have similar properties,they can be mixed by conventional methods in any proportions and form stable blends that can be stored for a long time. Experimental studies on the use of soybean oil for biodiesel production were carried out on a D-245 diesel engine (4 ChN11/12.5). The concentrations of toxic components (CO, CHx, and NOx) in the diesel exhaust gases were determined using the SAE-7532 gas analyzer. The smoke content of the exhaust gases was measured with an MK-3 Hartridge opacimeter. It has been experimentally established that the transfer of a diesel engine from diesel fuel to a blend of 80% diesel fuel and 20% lubrication oil leads to a change in the integral emissions per test cycle: nitrogen oxides in 0.81 times, carbon monoxide in 0.89 times and unburned hydrocarbons in 0.91 times, i.e. when biodiesel as used as a motor fuel in a serial diesel engine, emissions of all gaseous toxic components are reduced. The study has confi rmed the expediency of using soybeans of the Northern ecotype for biofuel production.


Author(s):  
M M Roy

This study investigated the effect of n-heptane and n-decane on exhaust odour in direct injection (DI) diesel engines. The prospect of these alternative fuels to reduce wall adherence and overleaning, major sources of incomplete combustion, as well as odorous emissions has been investigated. The n-heptane was tested as a low boiling point fuel that can improve evaporation as well as wall adherence. However, the odour is a little worse with n-heptane and blends than that of diesel fuel due to overleaning of the mixture. Also, formaldehyde (HCHO) and total hydrocarbon (THC) in the exhaust increase with increasing n-heptane content. The n-decane was tested as a fuel with a high cetane number that can improve ignition delay, which has a direct effect on wall adherence and overleaning. However, with n-decane and blends, the odour rating is about 0.5-1 point lower than for diesel fuel. Moreover, the aldehydes and THC are significantly reduced. This is due to less wall adherence and proper mixture formation.


2019 ◽  
Vol 179 (4) ◽  
pp. 204-209
Author(s):  
Winicjusz STANIK ◽  
Jerzy CISEK

To avoid the negative effects of increasing the amount of RME in the diesel fuel (to 10%), three different additive packages were used: stabilising, cleaning, and increasing the cetane number with different concentrations. The tests were carried out using a 4-cylinder, turbocharged 1.9 TDI engine from VW. The tests were carried out for 4 fuels (comparative fuel with a content of 7% RME and 3 test fuels with a content of 10% RME, differing in the content of the additive package.It was found that each of the 3 additive packages used does not have a significant impact on fuel consumption. However, a different effect of the tested additives on the composition of exhaust gases was observed. The first package had a slight effect on reducing the NOx concentration in the exhaust, but only for small engine loads. On the other hand, the second additive pack worked more effectively only at higher engine loads (in relation to the reduction of NOx concentration in the exhaust gases). In the third packet, the amount of the cetane additive was doubled (compared to the second packet). Then, the reduction in the NOx concentration in the exhaust gas by 3–8% was obtained with reference to the comparative fuel.


Nukleonika ◽  
2015 ◽  
Vol 60 (3) ◽  
pp. 689-695 ◽  
Author(s):  
Janusz Licki ◽  
Andrzej Pawelec ◽  
Zbigniew Zimek ◽  
Sylwia Witman-Zając

Abstract The exhaust gases from marine diesel engines contain high SO2 and NOx concentration. The applicability of the electron beam flue gas treatment technology for purification of marine diesel exhaust gases containing high SO2 and NOx concentration gases was the main goal of this paper. The study was performed in the laboratory plant with NOx concentration up to 1700 ppmv and SO2 concentration up to 1000 ppmv. Such high NOx and SO2 concentrations were observed in the exhaust gases from marine high-power diesel engines fuelled with different heavy fuel oils. In the first part of study the simulated exhaust gases were irradiated by the electron beam from accelerator. The simultaneous removal of SO2 and NOx were obtained and their removal efficiencies strongly depend on irradiation dose and inlet NOx concentration. For NOx concentrations above 800 ppmv low removal efficiencies were obtained even if applied high doses. In the second part of study the irradiated gases were directed to the seawater scrubber for further purification. The scrubbing process enhances removal efficiencies of both pollutants. The SO2 removal efficiencies above 98.5% were obtained with irradiation dose greater than 5.3 kGy. For inlet NOx concentrations of 1700 ppmv the NOx removal efficiency about 51% was obtained with dose greater than 8.8 kGy. Methods for further increase of NOx removal efficiency are presented in the paper.


The actuality of the article is due to the need to improve the toxicity indicators of dieselengines exhaust gases. One of the modern ways to achieve the required indicators of exhaustgas toxicity is to add eco-friendly additives to the fuel. An opportunity of using carbonnanotubes as eco-friendly additives to petroleum diesel fuel is considered. Experimentalstudies of the D-243 diesel engine running on petroleum diesel fuel with the addition of 125,250 and 500 mg/l nanotubes were carried out. Mixing of petroleum diesel fuel with nanotubeswas performed with the usage of an ultrasonic apparatus. A possibility of improving theenvironmental performance of a diesel engine when adding nanotubes to the fuel is shown. Ina full-load mode, the addition of 500 mg/l carbon nanotubes to the fuel reduced the exhaustsmoke from 26.0 % to 11.2 % according to the Hartridge scale. Keywords diesel engine; petroleum diesel fuel; carbon nanotubes; exhaust gas toxicity indicators; exhaust gas smokiness


Author(s):  
V.A. Markov ◽  
N.D. Chainov ◽  
V.V. Neverova

The paper deals with a topical issue of using biofuels in internal combustion engines. Promising biofuels may be derived from vegetable oils. In agriculture, using blends of petroleum fuel and a moderate amount of vegetable oil is economically feasible. We consider rapeseed oil and sunflower oil as these possible additives. We list physical and chemical properties of vegetable oils and blends of vegetable oils and diesel fuel. We analysed the experimental investigation results concerning the D-245.12S diesel engine running on petroleum fuel and its blends with vegetable oil additives specified above. We demonstrate that it is possible to improve environmental performance of a diesel by using these biofuel blends. We present a method for optimising the composition of petroleum fuel blends with vegetable oil additives that is based on determining a generalised optimality criterion as a sum of partial optimality criteria characterising regulated toxic component content in diesel exhaust gas emissions. We used the method presented to perform optimisation calculations and determine the optimum composition for biofuel blends with vegetable oil additives. We developed a method for estimating environmental safety of diesel power plants that takes into account the concentration of polycyclic aromatic hydrocarbons in the diesel exhaust gases. We show that knowing benzo[a]pyrene emission levels of a diesel running on a specific type of fuel is enough to estimate the degree of environmental threat of its exhaust gases


Author(s):  
A. K. Babu ◽  
G. Devaradjane

The intent of this paper is to summarize the state of knowledge on use of vegetable oils as diesel fuels. Fuel related properties are reviewed and compared with conventional diesel fuel. The use of neat vegetable oil (edible and/or nonedible), biodiesel and its blends in a diesel engine has been discussed. Performance and emission characteristics are highlighted. Suitability of different combustion chambers for diesel engine operation with vegetable oils is outlined. Techniques to decrease viscosities are discussed. An overview on current developments on the use of vegetable oils directly and indirectly in diesel engines is presented.


2018 ◽  
Vol 22 (Suppl. 5) ◽  
pp. 1483-1498 ◽  
Author(s):  
Boban Nikolic ◽  
Breda Kegl ◽  
Sasa Milanovic ◽  
Milos Jovanovic ◽  
Zivan Spasic

Extensive research has been carried out with regard to the composition of the exhaust gases of Diesel engines in operation with biodiesel in relation to the operation with the conventional diesel fuel. Producing biodiesel from different raw materials and different technological biodiesel production processes can result in different individual physical and chemical characteristics of fuel. Generally, it can be said that the use of biodiesel (and mixtures) reduces the overall toxicity of the exhaust gases in relation to the operation of the engine with diesel fuel, and this is a significant environmental potential of biodiesel as a fuel for Diesel engines. However, there is a diversity of research results, due to different factors. The paper reviews and summarizes the relevant literature on the mentioned research that can contribute to the explanation of these effects. It also points to the need for a very careful selection of biodiesel for use as a Diesel engine fuel.


2016 ◽  
Vol 5 (5) ◽  
pp. 8-21
Author(s):  
Неверова ◽  
V. Neverova ◽  
Марков ◽  
V. Markov ◽  
Бовэнь ◽  
...  

The depletion of oil fields and the deteriorating environmental situation leads to the need for the search of new alternative sources of energy. Actuality of the article due to the need for greater use of the alternative fuels in internal combustion engines is necessary. Fuels produced from vegetable oils and animal fats as advanced alternative fuels for diesel engines are considered. These fuels are produced from renewable raw materials and are characterized by good environmental qualities. Advantages of using fuels of vegetable origin as motor fuels are shown. Experimental research of diesel engine D-245.12S functioning on mixtures of diesel fuel and mustard oil of various percentage is given. One of the most wide spread vegetable oils in Russia is mustard oil. Possible ways of using mustard oil as fuel for a diesel engine are considered. An opportunity of improving characteristics of exhaust gases toxicity by using these mixtures as a fuel for automobile and tractor diesel engines is demonstrated.


Sign in / Sign up

Export Citation Format

Share Document