scholarly journals Effect of Thoracic Connective Lesion on Inter-Leg Coordination in Freely Walking Stick Insects

Author(s):  
Miriam Niemeier ◽  
Manon Jeschke ◽  
Volker Dürr

Multi-legged locomotion requires appropriate coordination of all legs with coincident ground contact. Whereas behaviourally derived coordination rules can adequately describe many aspects of inter-leg coordination, the neural mechanisms underlying these rules are still not entirely clear. The fact that inter-leg coordination is strongly affected by cut thoracic connectives in tethered walking insects, shows that neural information exchange among legs is important. As yet, recent studies have shown that load transfer among legs can contribute to inter-leg coordination through mechanical coupling alone, i.e., without neural information exchange among legs. Since naturalistic load transfer among legs works only in freely walking animals but not in tethered animals, we tested the hypothesis that connective lesions have less strong effects if mechanical coupling through load transfer among legs is possible. To do so, we recorded protraction/retraction angles of all legs in unrestrained walking stick insects that either had one thoracic connective cut or had undergone a corresponding sham operation. In lesioned animals, either a pro-to-mesothorax or a meso-to-metathorax connective was cut. Overall, our results on temporal coordination were similar to published reports on tethered walking animals, in that the phase relationship of the legs immediately adjacent to the lesion was much less precise, although the effect on mean phase was relatively weak or absent. Lesioned animals could walk at the same speed as the control group, though with a significant sideward bias toward the intact side. Detailed comparison of lesion effects in free-walking and supported animals reveal that the strongest differences concern the spatial coordination among legs. In free walking, lesioned animals, touch-down and lift-off positions shifted significantly in almost all legs, including legs of the intact body side. We conclude that insects with disrupted neural information transfer through one connective adjust to this disruption differently if they experience naturalistic load distribution. While mechanical load transfer cannot compensate for lesion-induced effects on temporal inter-leg coordination, several compensatory changes in spatial coordination occur only if animals carry their own weight.

2017 ◽  
Vol 284 (1868) ◽  
pp. 20171755 ◽  
Author(s):  
Chris J. Dallmann ◽  
Thierry Hoinville ◽  
Volker Dürr ◽  
Josef Schmitz

Animals rely on an adaptive coordination of legs during walking. However, which specific mechanisms underlie coordination during natural locomotion remains largely unknown. One hypothesis is that legs can be coordinated mechanically based on a transfer of body load from one leg to another. To test this hypothesis, we simultaneously recorded leg kinematics, ground reaction forces and muscle activity in freely walking stick insects ( Carausius morosus ). Based on torque calculations, we show that load sensors (campaniform sensilla) at the proximal leg joints are well suited to encode the unloading of the leg in individual steps. The unloading coincides with a switch from stance to swing muscle activity, consistent with a load reflex promoting the stance-to-swing transition. Moreover, a mechanical simulation reveals that the unloading can be ascribed to the loading of a specific neighbouring leg, making it exploitable for inter-leg coordination. We propose that mechanically mediated load-based coordination is used across insects analogously to mammals.


2011 ◽  
Vol 86 ◽  
pp. 184-187 ◽  
Author(s):  
Huai Cheng Xia ◽  
Zuo Mei Yang ◽  
Zi Jun An

According to the structure and its transmission principle of the cycloid ball planetary drive, a thermo-mechanical coupling analysis model of non-backlash cycloid ball engagement pair is developed in this paper. The force formula is derived by using hyperstatic method. Using finite element analysis, the variation of thermo-mechanical coupling contact stress of engagement pair at maximum force position with working temperature has been obtained. The results show that maximum coupling contact stress is located at the load transfer contact points between the ball and the cycloid grooves, and it increases significantly with the increase of temperature. The results obtained offer important theoretical basses for research on reliability of precision cycloid ball engagement pair and design of non-backlash transmission performance.


1984 ◽  
Vol 110 (1) ◽  
pp. 203-216
Author(s):  
JEFFREY DEAN ◽  
GERNOT WENDLER

The relationship between standing and steady walking was investigated for stick insects walking on a wheel. Normal hexapod coordination patterns ensure that each point in the gait cycle has static stability. Nevertheless, stick insects show preferred stopping sequences: the final protraction in ipsilateral metachronal sequences is most often by a front leg and least often by a rear leg (Fig. 1, Table 1). The associated preferred stance is one in which front, middle, and rear legs are spread apart (Fig. 2). This preferred stance does not conform precisely to those of steady walking, necessitating small adjustments to the walk in the final steps. First, the final leg protraction often occurs in the absence of strong retraction by the supporting legs. Second, the insect often takes advantage of the left/right asymmetry, letting rear and middle legs on the leading side retract beyond their normal endpoints while completing the metachronal sequence on the trailing side. Walking typically resumes with an initial retraction by all legs. Stances are close enough to leg configurations of steady walking that metachronal rhythms are often continuous across pauses, a feature which suggests that leg coordination is affected by peripheral parameters, such as leg position.


1999 ◽  
Vol 599 ◽  
Author(s):  
H. Fong ◽  
M. Sarikaya ◽  
S. N White ◽  
M. L. Snead

AbstractThe structure and mechanical properties of the dentin-enamel junction (DEJ) in human teeth play a critical role in transferring stress from hard enamel to soft dentin efficiently in order to preserve the longevity of this functionally gradient biocomposite. In this investigation, nano-hardness and elastic modulus of incisor teeth were studied across the dentin-enamel junction. It was found that, over a length scale of between 15 to 25 μm, there were decreasing trends in the values of both hardness and elastic modulus across the DEJ zone profiling from enamel to dentin. Images obtained, using atomic force and scanning electron microscopy techniques, from polished surfaces of cross-sectioned teeth samples showed an interpenetrating microstructure of enamel and dentin at the DEJ zone. These results suggest that the nano-mechanical property profiles across the DEJ were due to a continuous variation in the relative amount of enamel and dentin. These characteristics of the DEJ zone could be significant for describing the structural and mechanical coupling of the two structures. By increasing the interfacial contact area across the two mineralized tissues, stresses are dissipated into the softer dentin, thus reducing interfacial stress concentrations at the DEJ. This promotes effective load transfer from the hard enamel to soft dentin.


2012 ◽  
Vol 215 (24) ◽  
pp. 4255-4266 ◽  
Author(s):  
M. Grabowska ◽  
E. Godlewska ◽  
J. Schmidt ◽  
S. Daun-Gruhn

Author(s):  
Michael Paul McGrath ◽  
Jianliang Gao ◽  
Jinghua Tang ◽  
Piotr Laszczak ◽  
Liudi Jiang ◽  
...  

Mechanical coupling at the interface between lower limb residua and prosthetic sockets plays an important role in assessing socket fitting and tissue health. However, most research lab–based lower limb prosthetic simulators to-date have implemented a rigid socket coupling. This study describes the fabrication and implementation of a lower limb residuum/socket interface simulator, designed to reproduce the forces and moments present during the key loading phases of amputee walking. An artificial residuum made with model bones encased in silicone was used, mimicking the compliant mechanical loading of a real residuum/socket interface. A 6-degree-of-freedom load cell measured the overall kinetics, having previously been incorporated into an amputee’s prosthesis to collect reference data. The developed simulator was compared to a setup where a rigid pylon replaced the artificial residuum. A maximum uniaxial load of 850 N was applied, comparable to the peak vertical ground reaction force component during amputee walking. Load cell outputs from both pylon and residuum setups were compared. During weight acceptance, when including the artificial residuum, compression decreased by 10%, while during push off, sagittal bending and anterior–posterior shear showed a 25% increase and 34% decrease, respectively. Such notable difference by including a compliant residuum further highlighted the need for such an interface simulator. Subsequently, the simulator was adjusted to produce key load cell outputs briefly aligning with those from amputee walking. Force sensing resistors were deployed at load bearing anatomic locations on the residuum/socket interface to measure pressures and were compared to those cited in the literature for similar locations. The development of such a novel simulator provides an objective adjunct, using commonly available mechanical test machines. It could potentially be used to provide further insight into socket design, fit and the complex load transfer mechanics at the residuum/socket interface, as well as to evaluate the structural performance of prostheses.


1989 ◽  
Vol 144 (1) ◽  
pp. 199-213 ◽  
Author(s):  
H. CRUSE ◽  
A. KNAUTH

Interactions between contralateral legs of stick insects during walking were examined in the absence of mechanical coupling between the legs by studying animals walking on a horizontal plane covered with a thin film of silicone oil. Investigations of undisturbed walks showed that contralateral coupling is weaker han ipsilateral coupling. Two types of influence were found, (i) For each pair of front, middle and rear legs, when one leg started a retraction movement, the probability for the contralateral leg to start a protraction was increased, (ii) For front- and hind-leg pairs, it was found that the probability of starting a protraction in one leg was also increased, the farther the other leg was moved backwards during retraction. Whether such influences exist between middle legs could not be determined. Both ‘excitatory’ mechanisms very much resemble those influences which have been found to exist between ipsilateral legs. However, in contrast to ipsilateral legs, the interaction between two contralateral legs was found to act in both directions.


1993 ◽  
Vol 183 (1) ◽  
pp. 15-33 ◽  
Author(s):  
J. Schmitz

The responses of retractor coxae and protractor coxae motoneurones and of the retractor coxae muscle to cuticular stress applied to the leg were investigated in standing and walking stick insects, Carausius morosus. The coxa of a middle or hind leg was restrained and the trochanterofemur was bent by moving the distal tip of the femur anteriorly or posteriorly, i.e. perpendicular to its normal plane of movement. The maximum amplitude used was 200 micrometre, which corresponds to a deflection of 0.95°, and the forces necessary to bend the trochanterofemur were between 0.29 and 2.91 mN. Thus, cuticular stress could be applied in particular directions and with controlled amplitudes within the physiological range. This cuticular stress induced direction- and amplitude-dependent reflex responses in excitatory retractor coxae and protractor coxae motoneurones. The reflexes clearly constitute a negative feedback system which continuously compensates cuticular stress in the legs of standing and walking animals. Two groups of trochanteral campaniform sensilla, the posterior group and the anterior ventral group, were shown to underlie this feedback loop. These results prove directly for the first time the important function of single groups of trochanteral campaniform sensilla in the control of posture and locomotion in stick insects. I discuss the importance of these results for the interpretation of previous findings on stick insects subjected to increased load during walking.


1983 ◽  
Vol 105 (1) ◽  
pp. 215-229 ◽  
Author(s):  
S. EPSTEIN ◽  
D. GRAHAM

The walking coordination and motor output of intact adult stick insects was examined when they were supported above an oiled glass surface. The viscosity of the silicone oil was adjusted so that the animal walked with either tripod or slow-walk coordination. In the absence of mechanical coupling through the substrate, the legs typically moved at different speeds in retraction. If these differences were not too large the walks were well-coordinated in the transitions from stance to swing phase. Motor output was variable and sometimes showed periods of very weak activity in depressors and retractors. Under these conditions an individual leg moved much more slowly than its neighbours, producing 2:1 coordination patterns.


Sign in / Sign up

Export Citation Format

Share Document