scholarly journals Preparation of Ti3C2Tx/NiZn Ferrite Hybrids with Improved Electromagnetic Properties

Materials ◽  
2020 ◽  
Vol 13 (4) ◽  
pp. 820
Author(s):  
Xiaobing Zhou ◽  
Youbing Li ◽  
Qing Huang
Keyword(s):  
Room Temperature ◽  
Large Family ◽  
Electromagnetic Properties ◽  
Particle Accelerators ◽  
Current Field ◽  
Ferrite Composites ◽  
Co Precipitation ◽  
Field Assisted Sintering ◽  
Kinetics Of ◽  
Multiphase Ceramics

Ti3C2Tx/NiZn ferrite composites were synthesized using a co-precipitation hydrothermal method, and further consolidated using electric current field-assisted sintering technology. Nano NiZn ferrites were inserted into the Ti3C2Tx interlayers with uniform coverage on their surfaces. The incorporation of MXenes promoted the sintering kinetics of the NiZn ferrite ceramics. The electrical conductivity increased by six orders of magnitude compared to pure NiZn ferrite ceramics at room temperature. The present work provides a potential way to develop a large family of dense MXenes/ferrite multiphase ceramics. The multiphase ceramics could be potentially used for the on-beam-line higher-order mode load in advanced particle accelerators.

Investigation of irradiation-induced nucleation processes in silicon and germanium

1995 ◽  
Vol 53 ◽  
pp. 224-225
Author(s):  
Harry A. Atwater ◽  
C.M. Yang ◽  
K.V. Shcheglov
Keyword(s):  
Room Temperature ◽  
Crystal Size ◽  
Initial Distribution ◽  
Engineering Control ◽  
Size Evolution ◽  
Silicon And Germanium ◽  
Ge Quantum Dot ◽  
And Control ◽  
Germanium Quantum Dots ◽  
Kinetics Of

Studies of the initial stages of nucleation of silicon and germanium have yielded insights that point the way to achievement of engineering control over crystal size evolution at the nanometer scale. In addition to their importance in understanding fundamental issues in nucleation, these studies are relevant to efforts to (i) control the size distributions of silicon and germanium “quantum dots𠇍, which will in turn enable control of the optical properties of these materials, (ii) and control the kinetics of crystallization of amorphous silicon and germanium films on amorphous insulating substrates so as to, e.g., produce crystalline grains of essentially arbitrary size.Ge quantum dot nanocrystals with average sizes between 2 nm and 9 nm were formed by room temperature ion implantation into SiO2, followed by precipitation during thermal anneals at temperatures between 30°C and 1200°C[1]. Surprisingly, it was found that Ge nanocrystal nucleation occurs at room temperature as shown in Fig. 1, and that subsequent microstructural evolution occurred via coarsening of the initial distribution.

Comparative Labelling and Biokinetic Studies of 99mTc-EDTA(Sn) and 99mTc-DTPA(Sn)

1977 ◽  
Vol 16 (01) ◽  
pp. 30-35 ◽  
Author(s):  
N. Agha ◽  
R. B. R. Persson
Keyword(s):  
Complex Formation ◽  
Significant Influence ◽  
Room Temperature ◽  
Ph Value ◽  
Maximum Activity ◽  
Reduction Step ◽  
Labelling Yield ◽  
Different Temperatures ◽  
Kinetics Of

SummaryGelchromatography column scanning has been used to study the fractions of 99mTc-pertechnetate, 99mTcchelate and reduced hydrolyzed 99mTc in preparations of 99mTc-EDTA(Sn) and 99mTc-DTPA(Sn). The labelling yield of 99mTc-EDTA(Sn) chelate was as high as 90—95% when 100 μmol EDTA · H4 and 0.5 (Amol SnCl2 was incubated with 10 ml 99mTceluate for 30—60 min at room temperature. The study of the influence of the pH-value on the fraction of 99mTc-EDTA shows that pH 2.8—2.9 gave the best labelling yield. In a comparative study of the labelling kinetics of 99mTc-EDTA(Sn) and 99mTc- DTPA(Sn) at different temperatures (7, 22 and 37°C), no significant influence on the reduction step was found. The rate constant for complex formation, however, increased more rapidly with increased temperature for 99mTc-DTPA(Sn). At room temperature only a few minutes was required to achieve a high labelling yield with 99mTc-DTPA(Sn) whereas about 60 min was required for 99mTc-EDTA(Sn). Comparative biokinetic studies in rabbits showed that the maximum activity in kidneys is achieved after 12 min with 99mTc-EDTA(Sn) but already after 6 min with 99mTc-DTPA(Sn). The long-term disappearance of 99mTc-DTPA(Sn) from the kidneys is about five times faster than that for 99mTc-EDTA(Sn).

Kinetics of the Thermal Disappearance of Radicals Formed During the Radiolysis of Aspartic Acid

2009 ◽  
Vol 59 (12) ◽  
Author(s):  
Mihai Contineanu ◽  
iulia Contineanu ◽  
Ana Neacsu ◽  
Stefan Perisanu
Keyword(s):  
Thermal Resistance ◽  
Aspartic Acid ◽  
Room Temperature ◽  
Esr Spectra ◽  
Complex Mechanism ◽  
Radical Species ◽  
Mechanisms Of Formation ◽  
Kinetics Of

The radiolysis of the isomers L-, D- and DL- of the aspartic acid, in solid polycrystalline state, was investigated at room temperature. The analysis of their ESR spectra indicated the formation of at least two radicalic entities. The radical, identified as R3, resulting from the deamination of the acid, exhibits the highest concentration and thermal resistance. Possible mechanisms of formation of three radical species are suggested, based also on literature data. The kinetics of the disappearance of radical R3 indicated a complex mechanism. Three possible variants were suggested for this mechanism.

The Reactivity of Different Active Forms of Sodium Carbonate with Respect to Sulfur Dioxide

1992 ◽  
Vol 57 (11) ◽  
pp. 2302-2308
Author(s):  
Karel Mocek ◽  
Erich Lippert ◽  
Emerich Erdös
Keyword(s):  
Thermal Decomposition ◽  
Liquid Phase ◽  
Sulfur Dioxide ◽  
Specific Surface ◽  
Surface Area ◽  
Sodium Carbonate ◽  
Room Temperature ◽  
Active Form ◽  
The Other ◽  
Kinetics Of

The kinetics of the reaction of solid sodium carbonate with sulfur dioxide depends on the microstructure of the solid, which in turn is affected by the way and conditions of its preparation. The active form, analogous to that obtained by thermal decomposition of NaHCO3, emerges from the dehydration of Na2CO3 . 10 H2O in a vacuum or its weathering in air at room temperature. The two active forms are porous and have approximately the same specific surface area. Partial hydration of the active Na2CO3 in air at room temperature followed by thermal dehydration does not bring about a significant decrease in reactivity. On the other hand, if the preparation of anhydrous Na2CO3 involves, partly or completely, the liquid phase, the reactivity of the product is substantially lower.

On the use of Ozawa/Flynn/Wall method to determine aging activation energy for elastomers

2021 ◽  
pp. 009524432110203
Author(s):  
Sudhir Bafna
Keyword(s):  
Mechanical Properties ◽  
Activation Energy ◽  
Weight Loss ◽  
Oxygen Consumption ◽  
Dwell Time ◽  
Room Temperature ◽  
Elevated Temperatures ◽  
Degradation Mechanism ◽  
Kinetics Of ◽  
Wall Method

It is often necessary to assess the effect of aging at room temperature over years/decades for hardware containing elastomeric components such as oring seals or shock isolators. In order to determine this effect, accelerated oven aging at elevated temperatures is pursued. When doing so, it is vital that the degradation mechanism still be representative of that prevalent at room temperature. This places an upper limit on the elevated oven temperature, which in turn, increases the dwell time in the oven. As a result, the oven dwell time can run into months, if not years, something that is not realistically feasible due to resource/schedule constraints in industry. Measuring activation energy (Ea) of elastomer aging by test methods such as tensile strength or elongation, compression set, modulus, oxygen consumption, etc. is expensive and time consuming. Use of kinetics of weight loss by ThermoGravimetric Analysis (TGA) using the Ozawa/Flynn/Wall method per ASTM E1641 is an attractive option (especially due to the availability of commercial instrumentation with software to make the required measurements and calculations) and is widely used. There is no fundamental scientific reason why the kinetics of weight loss at elevated temperatures should correlate to the kinetics of loss of mechanical properties over years/decades at room temperature. Ea obtained by high temperature weight loss is almost always significantly higher than that obtained by measurements of mechanical properties or oxygen consumption over extended periods at much lower temperatures. In this paper, data on five different elastomer types (butyl, nitrile, EPDM, polychloroprene and fluorocarbon) are presented to prove that point. Thus, use of Ea determined by weight loss by TGA tends to give unrealistically high values, which in turn, will lead to incorrectly high predictions of storage life at room temperature.

Electrochemical Kinetics of Ag|Ag+and TMPD|TMPD+•in the Room-Temperature Ionic Liquid [C4mpyrr][NTf2]; toward Optimizing Reference Electrodes for Voltammetry in RTILs

2007 ◽  
Vol 111 (37) ◽  
pp. 13957-13966 ◽  
Author(s):  
Emma I. Rogers ◽  
Debbie S. Silvester ◽  
Sarah E. Ward Jones ◽  
Leigh Aldous ◽  
Christopher Hardacre ◽  
...  
Keyword(s):  
Ionic Liquid ◽  
Room Temperature ◽  
Room Temperature Ionic Liquid ◽  
Electrochemical Kinetics ◽  
Reference Electrodes ◽  
Kinetics Of

The Spectral Dependence of the Non-Radiative Efficiency in Hydrogenated Amorphous Silicon

1992 ◽  
Vol 258 ◽  
Author(s):  
J. Fan ◽  
J. Kakalios
Keyword(s):  
Amorphous Silicon ◽  
Room Temperature ◽  
Hydrogenated Amorphous Silicon ◽  
Free Carrier ◽  
Radiative Efficiency ◽  
Sharp Minimum ◽  
Carrier Thermalization ◽  
Hydrogenated Amorphous ◽  
Kinetics Of ◽  
Heat Released

ABSTRACTThe room temperature non-radiative efficiency, defined as the ratio of the heat released per absorbed photon for doped and undoped hydrogenated amorphous silicon (a-Si:H) has been measured using photo-pyroelectric spectroscopy (PPES) for photon energies ranging from 2.5 to 1.6 eV. There is a fairly sharp minimum in the non-radiative efficiency when the a-Si:H is illuminated with near bandgap photons. We describe a model wherein this minimum arises from the variation in the amount of heat generated by free carrier thermalization as the incident photon energy is varied, and report measurements of the excitation kinetics of the non-radiative efficiency which support this proposal.

Thermal Breakdown Kinetics of 1-Ethyl-3-Methylimidazolium Ethylsulfate Measured Using Quantitative Infrared Spectroscopy

2017 ◽  
Vol 71 (12) ◽  
pp. 2626-2631 ◽  
Author(s):  
Jeffrey L. Wheeler ◽  
McKinley Pugh ◽  
S. Jake Atkins ◽  
Jason M. Porter
Keyword(s):  
Thermal Stability ◽  
Room Temperature ◽  
Computational Models ◽  
Elevated Temperatures ◽  
Molar Absorptivity ◽  
Ir Absorption ◽  
Optical Cell ◽  
Multiple Samples ◽  
Kinetics Of ◽  
Thermal Stability Of

In this work, the thermal stability of the room temperature ionic liquid (RTIL) 1-ethyl-3-methylimidazolium ethylsulfate ([EMIM][EtSO4]) is investigated using infrared (IR) spectroscopy. Quantitative IR absorption spectral data are measured for heated [EMIM][EtSO4]. Spectra have been collected between 25 ℃ and 100 ℃ using a heated optical cell. Multiple samples and cell pathlengths are used to determine quantitative values for the molar absorptivity of [EMIM][EtSO4]. These results are compared to previous computational models of the ion pair. These quantitative spectra are used to measure the rate of thermal decomposition of [EMIM][EtSO4] at elevated temperatures. The spectroscopic measurements of the rate of decomposition show that thermogravimetric methods overestimate the thermal stability of [EMIM][EtSO4].

Sign in / Sign up

Export Citation Format

Share Document