scholarly journals Effects of Agronomic Practices on the Severity of Sweet Basil Downy Mildew (Peronospora belbahrii)

Plants ◽  
2021 ◽  
Vol 10 (5) ◽  
pp. 907
Author(s):  
Chen Omer ◽  
Ziv Nisan ◽  
Dalia Rav-David ◽  
Yigal Elad

Downy mildew (caused by Peronospora belbahrii) is a severe disease of sweet basil (Ocimum basilicum) crops around the world. We examined cultural methods for reducing the severity of sweet basil downy mildew (SBDM) under commercial conditions in greenhouses and walk-in tunnels. The effects of the orientation of walk-in tunnels, air circulation in greenhouses, plant density, and soil mulch were tested. SBDM was less severe in the tunnels that were oriented north-south than in those oriented east-west, but the yields in both types of tunnels were similar. Increased air circulation reduced SBDM severity, but did not affect yield. Gray or transparent polyethylene mulch reduced SBDM severity and, in most cases, increased yield relative to bare soil/growth medium. Yellow polyethylene mulch provided a smaller amount of control. The combination of increased air circulation and yellow polyethylene mulch provided synergistic SBDM control, whereas no synergism was observed when we combined increased air circulation with the other two types of mulch. Planting at half the usual density reduced disease severity. The reduced plant density was associated with reduced yield in the greenhouses, but not in the tunnels. All of the tested methods provided an intermediate level of SBDM control that varied among the different experiments.

HortScience ◽  
1991 ◽  
Vol 26 (5) ◽  
pp. 496f-496 ◽  
Author(s):  
Vincent M. Russo

The effects of planting date and plant density on total and marketable yield were examined for the edible dry beans `Aurora' and `Fleetwood', erect type I geneotype cultivars, over three years. For `Fleetwood' alone, fertilizer levels and application of a spray-on-soil polymer mulching material were examined for effects on yield. The mulching material was degraded by rain prior to canopy closure but patches were present at harvest. Using continous recording thermometers, temperatures over two week periods following sowing of `Fleetwood', from 23 cm below the surface of mulched and bare soil were converted to soil degree days (SDD). `Fleetwood' generally had higher yields than `Aurora'. Earlier planting improved yields. In one of three years increasing plant density increased yields. Increased fertilization did not affect yield. Application of mulch did not affect yield. However, spray-on-mulch did increase SDD after the earliest planting date. Cultural systems for existing production, or potential production areas, must be developed for the conditions of each location.


2019 ◽  
Vol 109 (5) ◽  
pp. 787-795 ◽  
Author(s):  
Mathilde Chen ◽  
François Brun ◽  
Marc Raynal ◽  
David Makowski

Grapevine downy mildew (GDM) is a severe disease of grapevines. Because of the lack of reliable information about the dates of GDM symptom onset, many vine growers begin fungicide treatments early in the season. We evaluate the extent to which such preventive treatments are justified. Observational data for 266 untreated sites for the years between 2010 and 2017 were used to estimate the timing of GDM onset on vines and bunches of grapes in South West France (Bordeaux region) through survival analyses. The onset of GDM was not apparent on vines and bunches before early to mid-May, and the rate of GDM symptom appearance was highly variable across years. Depending on the year, 50% of the plots displayed symptoms between mid-May and late June for vines. For several years, our statistical analysis revealed that the proportion of plots with no symptoms was high in early August on vines (27.5 and 43.7% in 2013 and 2016) and on bunches (between 23 and 79% in 2011, 2013, and 2016). We found a significant effect of the amount of rainfall in spring on the date of symptom appearance. These results indicate that preventive fungicide application is unjustified in many vineyards, and that regional disease surveys should be used to adjust fungicide treatment dates according to local characteristics, in particular according to rainfall conditions in spring.


Plant Disease ◽  
2014 ◽  
Vol 98 (11) ◽  
pp. 1579-1579 ◽  
Author(s):  
I. Šafránková ◽  
L. Holková

Sweet basil (Ocimum basilicum L.) is an aromatic plant that is cultivated as a pot plant in greenhouses or in fields in the Czech Republic. The plants are intended for direct consumption or for drying. In April of 2012, the first large chlorotic from the middle necrotic spots occurred gradually on leaves of pot plants O. basilicum cv. Genovese in greenhouses in Central Bohemia. The characteristic gray to brown furry growth of downy mildew appeared on abaxial surfaces of leaves in the place of chlorotic spots within 3 to 4 days. The infested leaves fell off in the late stages of pathogenesis. The infestation gradually manifested itself in ever-younger plants and in July, cotyledons and possibly the first true leaves were already heavily infected and damaged and these plants rapidly died. The plant damage reached 80 to 100%, so it was necessary to stop growing the plants in the greenhouse at the end of July. The causal agent was isolated and identified as Peronospora belbahrii Thines by means of morphological and molecular characters (2,3). Conidiophores were hyaline, straight, monopodial, 280 to 460 μm, branched three to five times, ended with two slightly curved branchlets with a single conidia on each branchled tip. The longer branchlets measured 13 to 24 μm (average 18.2 μm), the shorter one 4 to 15 μm (average 9.7 μm). Conidia were rounded or slightly ovoid, from brownish to dark brownish, measured 22 to 31 × 20 to 28 μm (length/width ratio 1.2). A pathogen-specific sequence was detected with the help of the pathogen ITS rDNA specific primers in symptomatic leaves (1). DNA from plant tissues was isolated using the DNeasy plant Mini Kit (Qiagen, Germany) following the standard protocol. PCR was performed using KAPA2G Robust HotStar kit (Kapa Biosystems, United States) according to the conditions recommended in Belbahri et al. (1). The specific products were visualized by electrophoresis through 1.5% agarose gels. Leaves of 20-day-old potted plants O. basilicum ‘Genovese’ were inoculated by spraying with 5 × 105 conidia/ml of the pathogen. Each pot contained 10 plants. Sterilized distilled water was applied to control plants. Plants were covered with polyethylene bags during the entire incubation period to maintain high humidity, and kept at a temperature of 22 to 24°C. Typical disease symptoms appeared on leaves 5 to 9 days after inoculation. Control plants were symptomless. P. belbahrii was re-isolated from the lesions of inoculated plants, thus fulfilling Koch's postulates. Downy mildew on sweet basil was reported in countries in Africa, Europe, and South and North America (4). To our knowledge, this is the first report of downy mildew on sweet basil in the Czech Republic. References: (1) L. Belbahri et al. Mycol. Res. 109:1276, 2005. (2) Y.-J. Choi et al. Mycol. Res. 113:1340, 2009. (3) M. Thines et al. Mycol. Res. 113:532, 2009. (4) C. A. Wyenandt et al. HortScience 45:1416, 2010.


Plant Disease ◽  
2020 ◽  
Author(s):  
Martin John BARBETTI ◽  
Tanveer N Khan ◽  
Ian Pritchard ◽  
Jay Ram Lamichhane ◽  
Jean-Noël Aubertot ◽  
...  

Studies were undertaken across five field locations in Western Australia to determine the relative changes in disease severity and subsequent field pea yield from up to four foliar pathogens associated with a field pea foliar disease complex (viz. Didymella, Phoma, Peronospora, Septoria), across four different pea varieties sown at three different times and at three different densities. Delaying sowing of field pea significantly (P<0.05) reduced severity of Ascochyta blight (all five locations) and Septoria blight (1 location), increased severity of downy mildew (4 locations), but had no effect on seed yield. In relation to Ascochyta blight severity at 80 days after sowing, at all locations the early time of sowing had significantly (P<0.05) more severe Ascochyta blight than the mid and late times of sowing. Increasing actual plant density from 20-25 plants m-2 to 58-78 plants m-2 significantly (P<0.05) increased the severity of the Ascochyta blight (4 locations) and downy mildew (1 location), and increased seed yield at four locations irrespective of sowing date and three locations irrespective of variety. Compared with varieties Dundale, Wirrega and Pennant, variety Alma showed significantly (P<0.05) less severe Ascochyta blight (1 location), downy mildew (1 location) and Septoria blight (1 location). Grain yield was highest for the early time of sowing at three locations. Varieties Alma, Dundale and Wirrega significantly (P<0.05) out yielded Pennant at four locations. The percentage of isolations of individual Ascochyta blight pathogens at 80 days after the first time of sowing varied greatly, with Didymella ranging 25-93% and Phoma from 6- 23% across the five field locations. This fluctuating nature of individual pathogen types and proportions within the Ascochyta blight complex, along with variation in occurrence of Peronospora and Septoria, highlights the challenges to understand and manage the complexities of co-occurring different foliar pathogens of field pea. While the search for more effective host resistance continues, there is a need for and opportunities from further exploring and exploiting cultural management approaches focussing on crop sequence diversification, intercropping, manipulating time of sowing and stand density, and application of improved seed sanitation and residue/inoculum management practices. We discuss the constraints and opportunities towards overcoming the challenges associated with managing foliar disease complexes in field pea.


2004 ◽  
Vol 44 (1) ◽  
pp. 91 ◽  
Author(s):  
L. Ibarra-Jiménez ◽  
M. R. Quezada-Martín ◽  
M. de la Rosa-Ibarra

To determine the effectiveness of black plastic mulch alone and in combination with row covers, on growth and physiological changes of cucumber plants, 6 treatments were established in a randomised complete block design with 4 replications: bare soil (control); black polyethylene mulch alone (B); B plus a clear cover of perforated polyethylene (BRCP); B plus a white cover of perforated polyethylene (BRWP); B plus an Agribon cover of polypropylene (BRA); and B plus a Kimberly farm row cover (BRK). For the plants grown with mulch or mulch combined with row covers, the dry weight of leaves 50 days after seeding (DAS), and the dry weight of whole plants (at 50 and 110 DAS) were significantly (P<0.05) different from the control. Early yields of treatments B, BRCP, BRWP, BRA and BRK were 2.1, 1.9, 2.6, 1.9 and 2.4 times higher than the control, which yielded 10 t/ha. Total yields were increased by 9.7, 15.4, 19.8, 14.9 and 20 t/ha, over the control which yielded 104 t/ha. Increases in plant dry weight explained the changes in yield. Stomatal conductance may explain in part, the increase in photosynthetic rate, but may not explain yield increase.


2007 ◽  
Vol 47 (7) ◽  
pp. 844 ◽  
Author(s):  
H. S. Sidhu ◽  
Manpreet-Singh ◽  
E. Humphreys ◽  
Yadvinder-Singh ◽  
Balwinder-Singh ◽  
...  

Lack of suitable machinery is a major constraint to direct drilling into combine-harvested rice residues due to the heavy straw load, and the presence of loose tough straw deposited by the harvester. Therefore, most rice stubbles are burnt in the mechanised rice–wheat systems of south Asia and Australia, as this is a rapid and cheap option, and allows for quick turn around between crops. As well as loss of organic matter and nutrients, rice stubble burning causes very serious and widespread air pollution in the north-west Indo-Gangetic Plains, where rice–wheat systems predominate. A novel approach with much promise is the Happy Seeder, which combines the stubble mulching and seed drilling functions in the one machine. The stubble is cut and picked up in front of the sowing tynes, which engage bare soil, and deposited behind the seed drill as mulch. Evaluation of the technology over 3 years in replicated experiments and farmers’ fields in Punjab, India, showed that establishment of wheat sown into rice residues with the Happy Seeder was comparable with establishment using conventional methods (straw burnt followed by direct drilling or cultivation before sowing) for sowings around the optimum time into stubbles up to 7.5 t/ha. For late sowings, plant density declined significantly at straw loads above 5 t/ha. The mulch also reduced weed biomass by ~60%, and reduced soil evaporation. Yield of wheat sown around the optimum time into rice residues, using the Happy Seeder, was comparable with or higher than yield after straw removal or burning, in replicated experiments and farmers’ fields, for straw loads up to 9 t/ha. In farmers’ fields there was an average yield increase of 9 and 11% in 2004–05 and 2005–06, respectively, compared with farmer practice. For sowings after the optimum time, yield declined significantly at straw loads greater than 7.5 t/ha. The Happy Seeder offers the means of drilling wheat into rice stubble without burning, eliminating air pollution and loss of nutrients and organic carbon due to burning, at the same time as maintaining or increasing yield.


EDIS ◽  
2009 ◽  
Vol 2009 (2) ◽  
Author(s):  
Shouan Zhang ◽  
Pamela D. Roberts

Revised! PP-113, a 2-page fact sheet by Shoan Zhang and Pamela D. Roberts, describes the symptoms and cultural controls for four plant diseases common to Sweet Basil in Florida — downy mildew, leaf spot, bacterial leaf spot, and fusarium wilt. Published by the UF Department of Plant Pathology, March 2009. PP-113/PP113: Florida Plant Disease Management Guide: Sweet Basil (ufl.edu)


Sign in / Sign up

Export Citation Format

Share Document