scholarly journals Intravaginal Devices and GNSS Collars with Satellite Communication to Detect Calving Events in Extensive Beef Production in Northern Australia

2020 ◽  
Vol 12 (23) ◽  
pp. 3963
Author(s):  
Christie Pearson ◽  
Lucy Lush ◽  
Luciano A. González
Keyword(s):  
High Frequency ◽  
Satellite Communication ◽  
Satellite System ◽  
Behavioral Changes ◽  
Very High Frequency ◽  
Average Activity ◽  
Newborn Calves ◽  
Global Navigation Satellite ◽  
Further Development ◽  
Very High

Observing calves at birth may help to identify risk factors for, and reduce, calf loss in extensive beef systems. The objectives of this study were to: (1) evaluate two commercial satellite birth alert systems to enable the observation of newborn calves and (2) assess behavioral changes of cows around calving. Vaginal Implant Transmitters (VIT) paired with Global Navigation Satellite System (GNSS) collars were worn by 20 cows in Trial 1 and 10 cows in Trial 2 to identify birthing events. The VIT and GNSS collars contained a temperature sensor, accelerometer, and very high frequency (VHF) to communicate with a handheld tracker, and ultra-high frequency (UHF) for communication between the VIT and GNSS collar, which had two-way communication using Iridium satellites. A change (Brand 1) or drop (Brand 2) in temperature of more than 3 °C and inactivity triggered the VIT to communicate an expelled alert to the collar, which transmitted the birth alert information via Iridium (device ID, date, time and geolocation of the GNSS collar at expulsion). Cows and calves were tracked in the paddock following a birth alert to assess their health and status. Overall, true birth alerts occurred in only 27.6% of devices. Cows remained active on the day of calving travelling 5.54 ± 4.11 and 5.00 ± 2.80 km/day compared to 6.45 ± 2.79 and 6.12 ± 2.30 km/d on days when calving did not occur for Trial 1 and 2, respectively (mean ± SD). Average activity of the accelerometer X- and Y-axis on calving day was reduced by 15%–20% compared to other days in Trial 1 (p < 0.05) but not in Trial 2 (p > 0.05). Results suggest that these two birth alert systems are not suitable for use in extensive systems and the further development of the technology is required. Cows in the current trials remained active on the day of, and after, calving, indicating that a faster, real-time alert system and communication protocol would be required to achieve the aim of finding newborn calves.

Experimental Investigation of very High Frequency Slot Antenna on M-60A-1 Tank

1977 ◽  
Author(s):  
D. V. Campbell ◽  
William Kennebeck ◽  
A. Zanella ◽  
Paul Sexton
Keyword(s):  
Experimental Investigation ◽  
High Frequency ◽  
Slot Antenna ◽  
Very High Frequency ◽  
Very High

scholarly journals Galileo L10 Satellites: Orbit, Clock and Signal-in-Space Performance Analysis

Sensors ◽  
2021 ◽  
Vol 21 (5) ◽  
pp. 1695
Author(s):  
Constantin-Octavian Andrei ◽  
Sonja Lahtinen ◽  
Markku Poutanen ◽  
Hannu Koivula ◽  
Jan Johansson
Keyword(s):  
Performance Indicators ◽  
Satellite System ◽  
Short Term ◽  
Orbital Inclination ◽  
Navigation Data ◽  
Periodic Signals ◽  
Global Navigation Satellite ◽  
Minor Correction ◽  
Very High

The tenth launch (L10) of the European Global Navigation Satellite System Galileo filled in all orbital slots in the constellation. The launch carried four Galileo satellites and took place in July 2018. The satellites were declared operational in February 2019. In this study, we report on the performance of the Galileo L10 satellites in terms of orbital inclination and repeat period parameters, broadcast satellite clocks and signal in space (SiS) performance indicators. We used all available broadcast navigation data from the IGS consolidated navigation files. These satellites have not been reported in the previous studies. First, the orbital inclination (56.7±0.15°) and repeat period (50680.7±0.22 s) for all four satellites are within the nominal values. The data analysis reveals also 13.5-, 27-, 177- and 354-days periodic signals. Second, the broadcast satellite clocks show different correction magnitude due to different trends in the bias component. One clock switch and several other minor correction jumps have occurred since the satellites were declared operational. Short-term discontinuities are within ±1 ps/s, whereas clock accuracy values are constantly below 0.20 m (root-mean-square—rms). Finally, the SiS performance has been very high in terms of availability and accuracy. Monthly SiS availability has been constantly above the target value of 87% and much higher in 2020 as compared to 2019. Monthly SiS accuracy has been below 0.20 m (95th percentile) and below 0.40 m (99th percentile). The performance figures depend on the content and quality of the consolidated navigation files as well as the precise reference products. Nevertheless, these levels of accuracy are well below the 7 m threshold (95th percentile) specified in the Galileo service definition document.

A collision feedback based multiple access control protocol for very high frequency data exchange system in E-navigation

2021 ◽  
pp. 1-16
Author(s):  
Xu Hu ◽  
Bin Lin ◽  
Ping Wang ◽  
Hongguang Lyu ◽  
Tie-Shan Li
Keyword(s):  
Access Control ◽  
High Frequency ◽  
Multiple Access ◽  
Data Exchange ◽  
High Frequency Data ◽  
Frequency Data ◽  
Exchange System ◽  
Very High Frequency ◽  
Time Division ◽  
Very High

Abstract The very high frequency data exchange system (VDES) is promising in promoting electronic navigation (E-navigation) and improving navigation safety. The multiple access control (MAC) protocol is crucial to the transmission performance of VDES. The self-organising time division multiple access (SOTDMA) protocol, as the only access mode given by current recommendations, leads to a high rate of transmission collisions in the traditional automatic identification system (AIS), especially with heavy traffic loads. This paper proposes a novel feedback based time division multiple access (FBTDMA) protocol to address the problems caused by SOTDMA, such that collision of transmissions can be avoided in information transmission among vessels. Simulation results demonstrate that the proposed FBTDMA outperforms the traditional SOTDMA in terms of channel utilisation and throughput, and significantly reduces the transmission collision rate. The study is expected to provide insights into VDES standardisation and E-navigation modernisation.

scholarly journals Measurement of Electrical Properties of Superconducting YBCO Thin Films in the VHF Range

Materials ◽  
2021 ◽  
Vol 14 (12) ◽  
pp. 3360
Author(s):  
Yakir Dahan ◽  
Eldad Holdengreber ◽  
Elichai Glassner ◽  
Oz Sorkin ◽  
Shmuel E. Schacham ◽  
...  
Keyword(s):  
Thin Films ◽  
Theoretical Model ◽  
Quality Factor ◽  
High Frequency ◽  
Unit Length ◽  
Superconducting Thin Films ◽  
Electrical Parameters ◽  
Very High Frequency ◽  
Production Constraints ◽  
Very High

A new measurement technique of electrical parameters of superconducting thin films at the Very High Frequency (VHF) range is described, based on resonators with microstrip (MS) structures. The design of an optimal resonator was achieved, based on a thorough theoretical analysis, which is required for derivation of the exact configuration of the MS. A theoretical model is presented, from which an expression for the attenuation of a MS line can be derived. Accordingly, simulations were performed, and an optimal resonator for the VHF range was designed and implemented. Production constraints of YBa2Cu3O7 (YBCO) limited the diameter of the sapphire substrate to 3″. Therefore, a meander configuration was formed to fit the long λ/4 MS line on the wafer. By measuring the complex input reflection coefficients of a λ/4 resonator, we extracted the quality factor, which is mainly affected by the dielectric and conductor attenuations. The experimental results are well fitted by the theoretical model. The dielectric attenuation was calculated using the quasi-static analysis of the MS line. An identical copper resonator was produced and measured to compare the properties of the YBCO resonator in reference to the copper one. A quality factor of ~6·105 was calculated for the YBCO resonator, three orders of magnitude larger than that of the copper resonator. The attenuation per unit length of the YBCO layer was smaller by more than five orders of magnitude than that of the copper.

Da eine oder mehrere betroffen …

2020 ◽  
Vol 48 (1) ◽  
pp. 47-100
Author(s):  
Melitta Gillmann
Keyword(s):  
High Frequency ◽  
Formal Language ◽  
Subordinate Clause ◽  
Matrix Clause ◽  
Very High Frequency ◽  
Corpus Study ◽  
Causal Relations ◽  
Legal Texts ◽  
The Matrix ◽  
Very High

AbstractBased on a corpus study conducted using the GerManC corpus (1650–1800), the paper sketches the functional and sociosymbolic development of subordinate clause constructions introduced by the subjunctor da ‘since’ in different text genres. In the second half of the 17th and the first half of the 18th century, the da clauses were characterized by semantic vagueness: Besides temporal, spatial and causal relations, the subjunctor established conditional, concessive, and adversative links between clauses. The corpus study reveals that different genres are crucial to the readings of da clauses. Spatial and temporal usages, for example, occur more often in sermons than in other genres. The conditional reading, in contrast, strongly tends to occur in legal texts, where it displays very high frequency. This could be the reason why da clauses carry indexical meaning in contemporary German and are associated with formal language. Over the course of the 18th century, the causal usages increase in all genres. Surprisingly, these causal da clauses tend to be placed in front of the matrix clause despite the overall tendency of causal clauses to follow the matrix clause.

scholarly journals Sintering, Microstructure, and Dielectric Properties of Copper Borates for High Frequency LTCC Applications

Materials ◽  
2021 ◽  
Vol 14 (14) ◽  
pp. 4017
Author(s):  
Dorota Szwagierczak ◽  
Beata Synkiewicz-Musialska ◽  
Jan Kulawik ◽  
Norbert Pałka
Keyword(s):  
Dielectric Properties ◽  
Dielectric Permittivity ◽  
High Frequency ◽  
Ceramic Materials ◽  
Sintering Behavior ◽  
Terahertz Time Domain Spectroscopy ◽  
Very High Frequency ◽  
X Ray ◽  
Low Dielectric ◽  
Very High

New ceramic materials based on two copper borates, CuB2O4 and Cu3B2O6, were prepared via solid state synthesis and sintering, and characterized as promising candidates for low dielectric permittivity substrates for very high frequency circuits. The sintering behavior, composition, microstructure, and dielectric properties of the ceramics were investigated using a heating microscope, X-ray diffractometry, scanning electron microscopy, energy dispersive spectroscopy, and terahertz time domain spectroscopy. The studies revealed a low dielectric permittivity of 5.1–6.7 and low dielectric loss in the frequency range 0.14–0.7 THz. The copper borate-based materials, owing to a low sintering temperature of 900–960 °C, are suitable for LTCC (low temperature cofired ceramics) applications.

Sign in / Sign up

Export Citation Format

Share Document