scholarly journals Robust Control of a New Asymmetric Teleoperation Robot Based on a State Observer

Sensors ◽  
2021 ◽  
Vol 21 (18) ◽  
pp. 6197
Author(s):  
Baoyu Shi ◽  
Hongtao Wu ◽  
Yongfei Zhu ◽  
Mingming Shang
Keyword(s):  
Robust Control ◽  
Control Algorithm ◽  
Force Feedback ◽  
State Observer ◽  
Haptic Device ◽  
Tracking Errors ◽  
Robot System ◽  
System A ◽  
Industry Standards ◽  
Dual Arm Robot

This study is mainly about the designation of a new type of haptic device and an asymmetric teleoperation robot system. Aiming at the problems of tracking and transparency of an asymmetric teleoperation system, a robust control algorithm based on a state observer was proposed. The Haptic Device was designed and was chosen as the master-robot of the system. The Baxter dual-arm robot was chosen as the slave-robot of the system. The simulation experiment of robust control based on a state observer of the asymmetric teleoperation robot was carried out. The experiment results showed that the maximum values of displacement tracking errors in three directions x, y, and z are 0.02 m, 0.01 m, and 0.015 m, respectively. Compared with single- joint PID control, the performance of the new control algorithm is improved. The force feedback experiment on the real asymmetric teleoperation robot system was carried out. The results showed that the force feedback wave is consistent with the actual situation and showed that the robust control algorithm proposed is superior to PID. Therefore, the algorithm perfectly satisfied the system. The experiment parameters also demonstrate that the haptic device satisfies the design requirements of the asymmetric teleoperation robots system and the industry standards.

Motion Synchronization for Multi-Cylinder Electro-Hydraulic System

2001 ◽  
Author(s):  
Hong Sun ◽  
George T.-C. Chiu
Keyword(s):  
Robust Control ◽  
Hydraulic System ◽  
Control Algorithm ◽  
Control Technique ◽  
Pressure Force ◽  
Outer Loop ◽  
System A ◽  
Synchronization Problem ◽  
Loop Motion ◽  
Motion Synchronization

Abstract This paper presents a nonlinear control algorithm to address the motion synchronization problem for a multi-cylinder electro-hydraulic (EH) system. A 2-step design approach is applied such that it utilized linear MIMO robust control technique to design an outer loop motion synchronization controller. A nonlinear SISO perturbation observer based pressure/force controller is designed for each of the lift cylinder as the inner loop controller to handle the nonlinearities associated with the EH actuators. Experimental results on a 4-cylinder system are presented to verify the effectiveness of the proposed approach.

scholarly journals Magnetic Driven Two-Finger Micro-Hand with Soft Magnetic End-Effector for Force-Controlled Stable Manipulation in Microscale

Micromachines ◽  
2021 ◽  
Vol 12 (4) ◽  
pp. 410
Author(s):  
Dan Liu ◽  
Xiaoming Liu ◽  
Pengyun Li ◽  
Xiaoqing Tang ◽  
Masaru Kojima ◽  
...  
Keyword(s):  
Magnetic Force ◽  
Force Feedback ◽  
Soft Magnetic ◽  
End Effector ◽  
Force Microscopy ◽  
System A ◽  
Atomic Force ◽  
Afm Probe ◽  
End Effectors ◽  
Fixed End

In recent years, micromanipulators have provided the ability to interact with micro-objects in industrial and biomedical fields. However, traditional manipulators still encounter challenges in gaining the force feedback at the micro-scale. In this paper, we present a micronewton force-controlled two-finger microhand with a soft magnetic end-effector for stable grasping. In this system, a homemade electromagnet was used as the driving device to execute micro-objects manipulation. There were two soft end-effectors with diameters of 300 μm. One was a fixed end-effector that was only made of hydrogel, and the other one was a magnetic end-effector that contained a uniform mixture of polydimethylsiloxane (PDMS) and paramagnetic particles. The magnetic force on the soft magnetic end-effector was calibrated using an atomic force microscopy (AFM) probe. The performance tests demonstrated that the magnetically driven soft microhand had a grasping range of 0–260 μm, which allowed a clamping force with a resolution of 0.48 μN. The stable grasping capability of the magnetically driven soft microhand was validated by grasping different sized microbeads, transport under different velocities, and assembly of microbeads. The proposed system enables force-controlled manipulation, and we believe it has great potential in biological and industrial micromanipulation.

scholarly journals An extended state observer-based full-order sliding mode control for robotic joint actuated by antagonistic pneumatic artificial muscles

2021 ◽  
Vol 18 (1) ◽  
pp. 172988142098603
Author(s):  
Daoxiong Gong ◽  
Mengyao Pei ◽  
Rui He ◽  
Jianjun Yu
Keyword(s):  
Sliding Mode Control ◽  
Sliding Mode ◽  
State Observer ◽  
Extended State Observer ◽  
Artificial Muscles ◽  
Extended State ◽  
Robot System ◽  
Mode Control ◽  
Physical Experiments ◽  
Pneumatic Artificial Muscles

Pneumatic artificial muscles (PAMs) are expected to play an important role in endowing the advanced robot with the compliant manipulation, which is very important for a robot to coexist and cooperate with humans. However, the strong nonlinear characteristics of PAMs hinder its wide application in robots, and therefore, advanced control algorithms are urgently needed for making the best use of the advantages and bypassing the disadvantages of PAMs. In this article, we propose a full-order sliding mode control extended state observer (fSMC-ESO) algorithm that combines the ESO and the fSMC for a robotic joint actuated by a pair of antagonistic PAMs. The fSMC is employed to eliminate the chattering and to guarantee the finite-time convergence, and the ESO is adopted to observe both the total disturbance and the states of the robot system, so that we can inhibit the disturbance and compensate the nonlinearity efficiently. Both simulations and physical experiments are conducted to validate the proposed method. We suggest that the proposed method can be applied to the robotic systems actuated by PAMs and remarkably improve the performance of the robot system.

Research of H∞ Robust Control for the Giant Die Forging Hydraulic Press’s Synchronous Control System under the Uncertainty Coefficient

2012 ◽  
Vol 190-191 ◽  
pp. 819-824 ◽  
Author(s):  
Ying Jian Deng ◽  
Zhong Wei Liu
Keyword(s):  
Control System ◽  
Robust Control ◽  
Control Algorithm ◽  
Hydraulic Press ◽  
National Defense ◽  
Synchronous Control ◽  
Performance Quality ◽  
System Synchronization ◽  
Uncertainty Coefficient

The giant hydraulic die press is our country national defense and the infrastructure essential equipment, the synchronous control system is the essential device to the giant forging hydraulic press, its synchronization control performance quality is good or bad will directly determine the quality of the product. This article through the proof of the theorem, gives the specific steps to achieve H∞ robust control algorithm. The simulation results show that: this control strategy has good inhibition to the change of system parameters, robustness is very strong, can well eliminate the system synchronization error.

Robust Control Method Based on Machine Learning for Boiler Combustion System

2014 ◽  
Vol 685 ◽  
pp. 368-372 ◽  
Author(s):  
Hao Zhang ◽  
Ya Jie Zhang ◽  
Yan Gu Zhang
Keyword(s):  
Robust Control ◽  
Intelligent Control ◽  
Pid Control ◽  
Control Algorithm ◽  
Control Method ◽  
Support Vector ◽  
Control Performance ◽  
Fuzzy Pid Control ◽  
On Line ◽  
Control Output

In this study, we presented a boiler combustion robust control method under load changes based on the least squares support vector machine, PID parameters are on-line adjusted and identified by LSSVM, optimum control output is obtained. The simulation result shows control performance of the intelligent control algorithm is superior to traditional control algorithm and fuzzy PID control algorithm, the study provides a new control method for strong non-linear boiler combustion control system.

Study of Hydraulic Servo System Based on Fuzzy Sliding Mode Algorithm

2013 ◽  
Vol 753-755 ◽  
pp. 2674-2678
Author(s):  
Kun Yang ◽  
Cai Jun Liu ◽  
Shu Min Liu
Keyword(s):  
Control Algorithm ◽  
Sliding Mode ◽  
Servo System ◽  
Time Varying ◽  
External Interference ◽  
System A ◽  
Hydraulic Servo ◽  
Fuzzy Sliding Mode ◽  
Hydraulic Servo System ◽  
Position Servo

Based on the situation that the hydraulic position servo system is easily influenced by the external interference and the parameters of which are different with time-varying, the fuzzy control can soften the buffeting and the sliding algorithm has no the same problems as the hydraulic position servo system, a brandly-new fuzzy sliding control algorithm is designed. In the simulation process, within the parameters of simulated time-varying and outside strong interference, the results show that the hydraulic servo system based on fuzzy sliding mode control algorithm has a greater resistance to internal and external interference and time-varying parameters.

Design of a Novel Parallel Mechanism for Haptic Device

2021 ◽  
pp. 1-63
Author(s):  
Jin Lixing ◽  
Duan Xingguang ◽  
Li Changsheng ◽  
Shi Qingxin ◽  
Wen Hao ◽  
...  
Keyword(s):  
Parallel Mechanism ◽  
Degrees Of Freedom ◽  
Force Feedback ◽  
Parallel Architecture ◽  
General Purpose ◽  
Haptic Device ◽  
Haptic Devices ◽  
Modeling And Optimization ◽  
Teleoperation Systems

Abstract This paper presents a novel parallel architecture with seven active degrees of freedom (DOFs) for general-purpose haptic devices. The prime features of the proposed mechanism are partial decoupling, large dexterous working area, and fixed actuators. The detailed processes of design, modeling, and optimization are introduced and the performance is simulated. After that, a mechanical prototype is fabricated and tested. Results of the simulations and experiments reveal that the proposed mechanism possesses excellent performances on motion flexibility and force feedback. This paper aims to provide a remarkable solution of the general-purpose haptic device for teleoperation systems with uncertain mission in complex applications.

Sign in / Sign up

Export Citation Format

Share Document