scholarly journals Simulation Studies to Quantify the Impact of Demand Side Management on Environmental Footprint

2021 ◽  
Vol 13 (17) ◽  
pp. 9504
Author(s):  
Sulaiman A. Almohaimeed ◽  
Siddharth Suryanarayanan ◽  
Peter O’Neill

The increased use of energy leads to increased energy-related emissions. Demand side management (DSM) is a potential means of mitigating these emissions from electric utility generating units. DSM can significantly reduce emissions and provide economic and reliability benefits. This work presents some DSM techniques, such as load shifting, energy conservation, and valley filling. Furthermore, this work explains the most common DSM programs. To quantify the effect of DSM in diminishing carbon footprint, this paper performs power flow analysis on a yearly load profile corresponding to Fort Collins, Colorado, U.S. This work used the IEEE 13-node test system to simulate several scenarios from the multi-criteria decision-making (MCDM) alternatives, both individually and integrated. For the base case, emissions decrease by 16% from the 2005 level. The “energy conservation” option achieved a 20% reduction in emissions, integrating both alternatives increased the emissions mitigation up to 22%. Simulation of the residential sector shows the “communication and intelligence” option reduces emissions about 14% from the 2005 level. A scenario that combines “electric stationary storage” with “communication and intelligence” diminishes the emissions by more than 15%. The last scenario examined all MCDM alternatives combined into one option, resulting in a 20% emissions reduction. We also conducted a cost benefit analysis (CBA) to investigate economic, technical, and environmental costs and benefits associated with each alternative. The economic evaluation shows that “electric stationary storage” is the best option since it charges during lower electricity prices and discharges during peaking demand. The economic analysis presents a trade-off chart, so the decision maker can select the alternative based on their preference.

Author(s):  
Genís Majoral ◽  
Francesc Gasparín ◽  
Sergi Saurí

The number of e-commerce transactions is increasing worldwide. Deliveries of goods purchased online generate externalities throughout the whole supply chain and, particularly, the increasing concern about the last-mile distribution of goods. The escalating presence of vans in cities contributes to poor air quality, climate change, noise, and congestion. So far, the majority of solutions to address this issue are based on the supply side, such as electric vans, optimizing the routing and pick-up-points, and so forth. Even in other transport sectors, pricing solutions are well known, yet they have not been extended to e-commerce delivery. This paper aims to propose an environmental tax falling on the demand side and equaling the externalities from this activity. The analysis has been particularized for the case of Barcelona. A cost–benefit analysis to assess the impact of such a tax has been carried out. When revenue collection is reinvested in the logistics sector, and for subsidizing electric distribution vehicles, the results indicate that the levying of the tax can generate positive outcomes.


2015 ◽  
Vol 737 ◽  
pp. 260-268
Author(s):  
Qiu Hua Liu ◽  
Kun Xu ◽  
Hao Min Wang

Electric power supply is one of the most important aspects of China’s national energy development strategy (NEDS). As major economic unit as well as major energy consumer, Jiangsu province is facing serious energy supply challenges. Under such circumstances, positive actions are taken by local government in respond to NEDS which put energy saving in the first place, and demand side management (DSM) is implemented. DSM is an important measure which can release rush hour electric supply pressure, enhance energy efficiency, optimize electric power utilization, and it is beneficial for sustainable development. This paper is based on the analysis of the current DSM situation of Nanjing, and green lighting is taken as an example. An empirical analysis is given to cost-effectiveness of the implementation of green lighting. Finally, the conclusion that the cost-effectiveness of the implementation of green lighting is economically viable to power supply companies, electric customers and the whole society is drawn.


2016 ◽  
Vol 23 ◽  
pp. 20
Author(s):  
Odia Bintou Cissé

On June 27, 2013, the Senate passed the Border Security, Economic Opportunity, and Immigration Modernization Act of 2013 (referred to as S.744). The bill addresses key elements of the immigration process through five sections. This analysis serves as an ex-ante Cost-Benefit Analysis (CBA) of the proposed Registered Provisional Immigrant (RPI) program under Section II of S.744, which would allow undocumented immigrants in the US to obtain legal status. The CBA looks at a 10-year timeframe from 2015 through 2025 and estimates the costs and benefits to four groups: undocumented immigrants, US taxpayers, employers of undocumented immigrants, and the United States Citizenship and Immigration Services (USCIS) under a base case scenario, a distributional weight scenario, and a worst-case scenario. Given the positive net benefits observed under the three scenarios, significant evidence recommends the implementation of the RPI program.


Energies ◽  
2021 ◽  
Vol 14 (14) ◽  
pp. 4179
Author(s):  
Maria Dicorato ◽  
Gioacchino Tricarico ◽  
Giuseppe Forte ◽  
Francesca Marasciuolo

The problem of electric network expansion has different implications concerning the definition of criteria for the comparison of different candidate projects. Transmission expansion planning usually involves a set of economic and technical influences on market framework and on network operation over defined scenario evolutions, or even combining generation and transmission planning, although the application to real-sized networks usually implies cost-benefit analysis. In this paper, a methodology for performance analysis of a set of network development projects is proposed, including zonal market framework and load flow analysis, in order to individuate possible candidate projects and their influence on active power losses, admissible load increase and admissible renewable generation increase. Those merit indicators are compared among candidate projects by means of Analytic Hierarchy Process (AHP) method, aiming at determining the most promising solution under different weights of criteria. Moreover, the influence of network development investment cost on project selection is assessed by means of an extension of AHP. The procedure is applied to yearly operation of NREL-118 test system.


2020 ◽  
pp. 50-64
Author(s):  
Kuladeep Kumar Sadevi ◽  
Avlokita Agrawal

With the rise in awareness of energy efficient buildings and adoption of mandatory energy conservation codes across the globe, significant change is being observed in the way the buildings are designed. With the launch of Energy Conservation Building Code (ECBC) in India, climate responsive designs and passive cooling techniques are being explored increasingly in building designs. Of all the building envelope components, roof surface has been identified as the most significant with respect to the heat gain due to the incident solar radiation on buildings, especially in tropical climatic conditions. Since ECBC specifies stringent U-Values for roof assembly, use of insulating materials is becoming popular. Along with insulation, the shading of the roof is also observed to be an important strategy for improving thermal performance of the building, especially in Warm and humid climatic conditions. This study intends to assess the impact of roof shading on building’s energy performance in comparison to that of exposed roof with insulation. A typical office building with specific geometry and schedules has been identified as base case model for this study. This building is simulated using energy modelling software ‘Design Builder’ with base case parameters as prescribed in ECBC. Further, the same building has been simulated parametrically adjusting the amount of roof insulation and roof shading simultaneously. The overall energy consumption and the envelope performance of the top floor are extracted for analysis. The results indicate that the roof shading is an effective passive cooling strategy for both naturally ventilated and air conditioned buildings in Warm and humid climates of India. It is also observed that a fully shaded roof outperforms the insulated roof as per ECBC prescription. Provision of shading over roof reduces the annual energy consumption of building in case of both insulated and uninsulated roofs. However, the impact is higher for uninsulated roofs (U-Value of 3.933 W/m2K), being 4.18% as compared to 0.59% for insulated roofs (U-Value of 0.33 W/m2K).While the general assumption is that roof insulation helps in reducing the energy consumption in tropical buildings, it is observed to be the other way when insulation is provided with roof shading. It is due to restricted heat loss during night.


2021 ◽  
Vol 6 (2) ◽  
pp. e004292
Author(s):  
Jung Ho Kim ◽  
Jiyeon Suh ◽  
Woon Ji Lee ◽  
Heun Choi ◽  
Jong-Dae Kim ◽  
...  

BackgroundRapid diagnostic tests (RDTs) are widely used for diagnosing Plasmodium vivax malaria, especially in resource-limited countries. However, the impact of RDTs on P. vivax malaria incidence and national medical costs has not been evaluated. We assessed the impact of RDT implementation on P. vivax malaria incidence and overall medical expenditures in South Korea and performed a cost–benefit analysis from the payer’s perspective.MethodsWe developed a dynamic compartmental model for P. vivax malaria transmission in South Korea using delay differential equations. Long latency and seasonality were incorporated into the model, which was calibrated to civilian malaria incidences during 2014–2018. We then estimated averted malaria cases and total medical costs from two diagnostic scenarios: microscopy only and both microscopy and RDTs. Medical costs were extracted based on data from a hospital in an at-risk area for P. vivax malaria and were validated using Health Insurance Review and Assessment Service data. We conducted a cost–benefit analysis of RDTs using the incremental benefit:cost ratio (IBCR) considering only medical costs and performed a probabilistic sensitivity analysis to reflect the uncertainties of model parameters, costs and benefits.ResultsThe results showed that 55.3% of new P. vivax malaria cases were averted, and $696 214 in medical costs was saved over 10 years after RDT introduction. The estimated IBCR was 2.5, indicating that RDT implementation was beneficial, compared with microscopy alone. The IBCR was sensitive to the diagnosis time reduction, infectious period and short latency period, and provided beneficial results in a benefit over $10.6 or RDT cost under $39.7.ConclusionsThe model simulation suggested that RDTs could significantly reduce P. vivax malaria incidence and medical costs. Moreover, cost–benefit analysis demonstrated that the introduction of RDTs was beneficial over microscopy alone. These results support the need for widespread adoption of RDTs.


2015 ◽  
Vol 17 (01) ◽  
pp. 1550003 ◽  
Author(s):  
FRANK VANCLAY

Over 150 forms of impact assessment can be identified using Google searches, with several new forms appearing since 2003. Since then, the popularity of the various members of the impact assessment family has changed, partly in response to legislative and regulatory changes, and general trends in society. The information explosion and expansion of the internet has resulted in a 32 fold increase in the number of hits for "impact assessment", now over 12 million. The conventional methods most frequently mentioned in 2003 had relatively low proportional change over the last 10 years but remain amongst the most frequently mentioned in 2014: risk assessment, public participation, cost-benefit analysis, public involvement, environmental monitoring, and project evaluation. The terms with highest proportional change (i.e. the super-hot topics) were primarily social concerns, including: equality impact assessment, welfare impact assessment, mental health impact assessment, disability impact assessment, human impact assessment, social impact assessment, and social risk assessment. Other terms that had high proportional change included life cycle impact assessment. Information about the relative popularity of the various forms of impact assessment is used in this paper to discuss issues and trends in the broad field of impact assessment.


2021 ◽  
pp. 1-10
Author(s):  
Ankit Srivastava ◽  
Prathna T.C.

Water is indispensable to sustain life and livelihood, and rivers serve as major reservoirs of water in manyparts of the world. River Yamuna is the major tributary of the River Ganges in India and is considered to be among the most polluted rivers of the world. The Yamuna Action Plan (YAP) is one of the largest river restoration projects in India and is initiated to clean the river. YAP is a bilateral arrangement between the governments of India and Japan, and consists of three Actions Plans-I, II and III. YAP-III is currently under execution with some of the major projects being the construction of the new Wastewater Treatment Plant (WWTP) at Okhla, rehabilitation and upgrading of WWTPs at Kondli and Rithala in the Delhi region. The impact of YAP-III with regard to these major projects on the reduction of the pollutant load reaching the river and cost-benefit has been evaluated in the current study. Findings from the study indicated that major projects such as construction of a new WWTP at Okhla (124 MGD) can effectively reduce the pollutant load by 283 kg/MGD of wastewater at a cost of Rs. 1161 crores while the rehabilitation project at Rithala (Phase I) can reduce the pollutant load by 92.5 kg/MGD wastewater at a cost of Rs. 300 crores. The present study indicates the need to evaluate projects in terms of cost-benefit analysis in addition to the economic and environmental evaluation for effective action. A holistic approach towards treatment of pollutant load in the river and prevention of further pollutants from reaching the river is required in addition to community awareness and participation for sustainable river water management.


2013 ◽  
Vol 216 ◽  
pp. 02-24
Author(s):  
PAULUS KURNIAWAN ◽  
KEMBAR SRI BUDHI ◽  
SUYANA UTAMA ◽  
MAHAENDRA YASA

massive, advanced and integrated railroad system for coal transportation (referred to hereafter as ?Project?) from Muara Enim, Sumatra Selatan Province to the new coal port at Pulau Baai, Bengkulu Province, Indonesia is developed by a private investor together with the local government (PEMDA) of Bengkulu Province to make the best use of abundant coal resources in the region. This paper analyzes the impact of this Project on the Bengkulu economy, which is currently considered low. The Gross Domestic Product (GDP) is adopted as the economic indicator. The study combines the theories of export base and economic base, economic and regional developments, cost-benefit analysis and economic impact study with the empirical data. The results show the Project?s financial feasibility with Cost-Benefit Ratio of 1.61, Internal Rate of Return of 21.1% and Payback Period of 5 years, which will provide a significant contribution to the Bengkulu GDP growth and a decrease of 821,600 people among the unemployed.


Sign in / Sign up

Export Citation Format

Share Document