scholarly journals Relationship between Landform Development and Lake Water Recharge in the Badain Jaran Desert, China

Water ◽  
2019 ◽  
Vol 11 (10) ◽  
pp. 1999
Author(s):  
Da-Peng Yue ◽  
Jing-Bo Zhao ◽  
Yan-Dong Ma ◽  
Xiao-Gang Huang ◽  
Tian-Jie Shao ◽  
...  

Four distinctive but poorly documented landforms in the Badain Jaran megadunes were studied: arcuate steps, multi-stage fans, depressions formed by runoff erosion, and groundwater overflow zones around lakes. The development of these four landform types indicates the following: (1) The hydrological balance in the sand layers of the megadune areas is positive; (2) After evaporation and transpiration, precipitation is able to infiltrate the deep sand layers; (3) Precipitation is a source for the groundwater and for many of the lakes of the area. The groundwater recharge mechanism is characterized by intense precipitation events that provide a water source, high infiltration rate, shallow evaporation depth, and low water retention. These factors together enable the precipitation to be transformed into groundwater. The energy of gravity water and the high water film pressure of adsorbed water together provide the forces necessary for effective water recharge.

2011 ◽  
Vol 15 (8) ◽  
pp. 2509-2518 ◽  
Author(s):  
A. Guevara-Escobar ◽  
M. Cervantes-Jiménez ◽  
H. Suzán-Azpiri ◽  
E. González-Sosa ◽  
L. Hernández-Sandoval ◽  
...  

Abstract. Interception losses are a major influence in the water yield of vegetated areas. For most storms, rain interception results in less water reaching the ground. However, fog interception can increase the overall water storage capacity of the vegetation and once the storage is exceeded, fog drip is a common hydrological input. Fog interception is disregarded in water budgets of semiarid regions, but for some plant communities, it could be a mechanism offsetting evaporation losses. Tillandsia recurvata is a cosmopolitan epiphyte adapted to arid habitats where fog may be an important water source. Therefore, the interception storage capacity by T. recurvata was measured in controlled conditions and applying simulated rain or fog. Juvenile, vegetative specimens were used to determine the potential upperbound storage capacities. The storage capacity was proportional to dry weight mass. Interception storage capacity (Cmin) was 0.19 and 0.56 mm for rainfall and fog respectively. The coefficients obtained in the laboratory were used together with biomass measurements for T. recurvata in a xeric scrub to calculate the depth of water intercepted by rain. T. recurvata contributed 20 % to the rain interception capacity of their shrub hosts: Acacia farnesiana and Prosopis laevigata and; also potentially intercepted 4.8 % of the annual rainfall. Nocturnal stomatic opening in T. recurvata is not only relevant for CO2 but for water vapor, as suggested by the higher weight change of specimens wetted with fog for 1 h at dark in comparison to those wetted during daylight (543 ± 77 vs. 325 ± 56 mg, p = 0.048). The storage capacity of T. recurvata leaf surfaces could increase the amount of water available for evaporation, but as this species colonise montane forests, the effect could be negative on water recharge, because potential storage capacity is very high, in the laboratory experiments it took up to 12 h at a rate of 0.26 l h−1 to reach saturation conditions when fog was applied.


1990 ◽  
Vol 112 (2) ◽  
pp. 217-223 ◽  
Author(s):  
B. Bhushan ◽  
M. T. Dugger

The adhesive force between magnetic-recording heads and thin film disks in a direction normal to the interface has been measured for a variety of loads, contact times, separation rates, and relative humidities with and without a layer of perfluoropolyether lubricant at the interface. At low humidities, the adhesive force due to the lubricant film alone is small for the lubricant thickness and disk surface roughness used. We find that the major component of the adhesive force between the slider and the disk in humid environments may be attributed to an adsorbed water film which can displace the lubricant (if the disk is lubricated) at sufficiently high loads, during tangential sliding, or after extended exposure to high concentrations of water vapor and create menisci around individual asperity contacts. The adhesive force was found to increase with contact duration on the unlubricated disk, but was essentially independent of contact duration on the lubricated disk. For both lubricated and unlubricated disks, the adhesive force increased with increasing relative humidity and loading rate, but was independent of applied normal load.


Telematika ◽  
2017 ◽  
Vol 13 (2) ◽  
pp. 93
Author(s):  
Bambang Yuwono ◽  
Awang Hendrianto Pratomo ◽  
Heru Cahya Rustamaji ◽  
Puji Pratiknyo ◽  
Mochammad Assofa Indera Jati

Water is a basic need for humans and other living things. Various sources of water on this earth has formed a system of close interaction with the components of living things in it. Over the years, water resources have changed in terms of both quality and quantity. This can be due to population growth in addition to the natural changes in nature. The more narrow field of water absorption followed by high water consumption causes the supply of ground water reserves can be threatened. So, we need a mapping and ground water recharge calculations to assist in the monitoring of groundwater reserves.The method used in this research is the Water Balance (keseimbangan air)method. This method is based on any incoming rain water will be equal to the output evapotranspiration and runoff hereinafter this method is applied in the application. Factors affecting groundwater recharge the water balance method is precipitation, evapotranspiration and run off. Information og groundwater recharge is also displayed on the map using Google Map function are related to the database system to produce informative mapsCalculation of groundwater recharge is applied to the daily rainfall data input into the application which then included in the water balance equation method so it can be easy to determine the value of groundwater recharge. Groundwater recharge information can be displayed in the form of mapping, making them easier to understand visually.Based on testing, the highest recharge results of this research on the Kemput station is 1119,5 mm/year with rainfall of 2750 mm/year. Seyegan and Bronggang station is 1026,25 mm/year with rainfall of 2625 mm/year. Angin-angin and Prumpung station is 933 mm/year with rainfall of 2500 mm/year. Beran and Gemawang station is 839.5 mm/year with rainfall of 2375 mm/year. Plataran station is 808.42 mm/year with rainfall of 2333 mm/year. Godean station is 699.5 mm/year with rainfall of 2187 mm/year and the lowest at Tirto Tanjungand Santan stastion 560 mm / year with rainfall of 2000 mm / year.


2006 ◽  
Vol 914 ◽  
Author(s):  
Mikhail Baklanov ◽  
David O'Dwyer ◽  
Adam M Urbanowicz ◽  
Quoc Toan Le ◽  
Steven Demuynck ◽  
...  

AbstractInteraction of moisture with porous low-k films is evaluated by using in situ ellipsometry setup. The adsorbed water amount is calculated from change of refractive index measured during the adsorption. Pristine low-k films reversibly adsorb 2 - 5% of water that reflects presence of constitutive hydrophilic centrums. Plasma and thermal treatments increase the number of hydrophilic centrums. Once the amount of these centrums has reached a certain critical value sufficient to form a continuous water film, bulk water condensation is observed. Change of properties during the water adsorption in the damaged films is not fully reversible. Each additional adsorption cycle increases the dielectric function of the film because of decreasing porosity, increasing skeleton density and shrinkage. The pressure corresponding to the bulk condensation allows us to calculate internal contact angle (internal surface energy) of low-k materials. The water molecules adsorbed on separate OH groups play the role of a catalyst that hydrolyses the siloxane bridges initially present on hydrophobic surface.


2018 ◽  
Vol 18 (6) ◽  
pp. 1946-1955 ◽  
Author(s):  
Miguel Ángel López Zavala ◽  
Mónica José Cruz Prieto ◽  
Cristina Alejandra Rojas Rojas

Abstract In this study, the reliability of using rainwater harvesting to cover the water demand of a transportation logistics company located in Mexico City was assessed. Water consumption in facilities and buildings of the company was determined. Rainwater potentially harvestable from the roofs and maneuvering yard of the company was estimated based on a statistical analysis of the rainfall. Based on these data, potential water saving was determined. Characterization of rainwater was carried out to determine the treatment necessities for each water source. Additionally, the capacity of water storage tanks was estimated. For the selected treatment systems, an economic assessment was conducted to determine the viability of the alternative proposed. Results showed that current water demand of the company can be totally covered by using rainwater. The scenario where roof and maneuvering yard rainwater was collected and treated together resulted in being more economic than the scenarios where roof and maneuvering yard rainwater was collected and treated separately. Implementation of the rainwater harvesting system will generate important economic benefits for the company. The investment will be amortized in only 5 years and the NPV will be on the order of US$ 5,048.3, the IRR of 5.7%, and the B/I of 1.9.


2005 ◽  
Vol 79 (4) ◽  
pp. 540-546 ◽  
Author(s):  
CHEN Jiansheng ◽  
ZHAO Xia ◽  
SHENG Xuefeng ◽  
ANG Jiyang ◽  
GU Weizu ◽  
...  

2020 ◽  
Author(s):  
Koen Beerten ◽  
Wouter van der Meer ◽  
Koen Hebinck ◽  
Miel Schurmans ◽  
Jan Bastiaens

<p>Palaeohydrological studies usually focus on extreme events and long-term changes as observed from floodplain archives. As a consequence, the information that is obtained inheritely reflects palaeohydrological conditions from a specific compartment of the hydrological system only, namely the discharge area which acts as a drain for runoff and groundwater. In contrast, palaeohydrological conditions in recharge areas, outside the floodplains, are less well understood and documented.</p><p>Aeolian drift sands are a typical feature in the European sand belt, and reflect phases of human induced and climatically modulated Holocene landscape instability. As the European sand belt is characterised by shallow phreatic groundwater tables in climates with a precipitation surplus, we might theoretically expect aeolian activity to interfere with a fluctuating groundwater table and/or precipitation events. The aim of this presentation is to explore the possibilities and limitations of four types of palaeohydrological proxy that were retrieved from a variety of different sites in drift sand landscapes in NE Belgium (Campine area): (1) soil horizon morphology of buried podzols, (2) deflation surfaces, (3) drift sand depositional facies and (4) palaeobotanical remains in organic-rich sediment.</p><p>The palaeohydrological information that these proxies contain will be discussed according to various characteristics. These include the continuity of the archive (continuous or discontinuous), the resolution (high resolution or integrated proxy), and whether the proxy is indicative for outcropping groundwater or precipitation events.</p><p>Podzol soil horizon morphology is an indicator of the average highest groundwater table position over a time period of several thousands of years prior to landscape instability and sand drifting, and can thus be qualified as an integrated proxy. Overblown deflation surfaces can only be used as an upper limit of the highest palaeo-groundwater table in between podzolisation and drift sand deposition, and can be qualified as a discontinuous low-resolution proxy. Drift sand depositional facies is a highly discontinuous proxy but can be used to verify whether deposition took place in dry, wet or standing water environments, with or without the influence of significant precipitation events and/or running water. Undoubtedly, palaeobotanical remains (macrobotanical and pollen) in overblown peat and peaty sand from the deepest parts of the drift sand landscape offer the highest resolution in terms of chronology (century to decades) and highest reliability in terms of water source tracing (outcropping groundwater vs precipitation).</p><p>Proxy verification mainly relies on fragmentary historical information derived from maps covering the last 250 years. Most importantly, when different proxies are available at the same site, they usually show strong internal consistency. A good example is the presence of peat with aquatic palaeobotanical remains in the deepest parts of the landscape where the underlying podzol soil also shows hydromorphic features and the overlying drift sand contains elements that are typical for deposition in wet environments.</p><p>We conclude that the above outlined complementary set of palaeohydrological proxies is a promising tool to reconstruct past hydrology in drift sand landscapes from the European sand belt.</p>


Desalination ◽  
2015 ◽  
Vol 355 ◽  
pp. 178-185 ◽  
Author(s):  
Hongxin Geng ◽  
Juan Wang ◽  
Chunyao Zhang ◽  
Pingli Li ◽  
Heying Chang

Sign in / Sign up

Export Citation Format

Share Document