Изучение отклика дегидрогеназной активности ила на изменение технологических параметров работы аэротенка

Author(s):  
N. Zaletova ◽  
S. Zaletov

Биологический метод очистки сточных вод представляет собой сложный многокомпонентный процесс, ключевой составляющей которого является работа ферментной системы. Известно, что одним из важнейших ферментов, обеспечивающих биологический процесс, являются дегидрогеназы. Полностью сложнейший механизм действия ферментов до конца пока не раскрыт, однако в практике контроля процессов биологической очистки используется показатель дегидрогеназной активности ила. Результаты исследований позволили дополнить имеющуюся информацию фактическими данными о взаимообусловленности уровня дегидрогеназной активности ила и показателей отдельных технологических параметров биологической очистки. Показано, что режим работы аэротенков (нагрузка на ил, доза активного ила и др.) и величина показателей исходной дегидрогеназной активности и дегидрогеназной активности этого же образца ила со слабо концентрированным раствором (ДАИН2О) связаны между собой и зависят от нагрузки на ил по органическим веществам. Полученные результаты исследования могут быть использованы для контроля биологического процесса очистки сточных вод.The biological method of wastewater treatment is a comprehensive multicomponent process the activities of the enzyme system being the key component of it. It is known that dehydrogenases have been one of the most important enzymes the ensure the biological process. The complicated mechanism of the action of enzymes has not been fully described so far however, in the practice of monitoring biological treatment processes, an indicator of the dehydrogenase activity of sludge is used. The research results provided for supplementing the available information with actual data on the interdependence of the level of dehydrogenase activity of sludge and indicators of individual process parameters of biological treatment. It was shown that the mode of operation of aeration tanks (organic matter load on sludge, dose of activated sludge, etc.) and the values of the initial dehydrogenase activity and dehydrogenase activity of the same sludge sample with weakly concentrated solution (DASН2О) are interconnected and depend on the organic load on sludge. The results of the study can be used to control the biological process of wastewater treatment.The biological method of wastewater treatment is a comprehensive multicomponent process the activities of the enzyme system being the key component of it. It is known that dehydrogenases have been one of the most important enzymes the ensure the biological process. The complicated mechanism of the action of enzymes has not been fully described so far however, in the practice of monitoring biological treatment processes, an indicator of the dehydrogenase activity of sludge is used. The research results provided for supplementing the available information with actual data on the interdependence of the level of dehydrogenase activity of sludge and indicators of individual process parameters of biological treatment. It was shown that the mode of operation of aeration tanks (organic matter load on sludge, dose of activated sludge, etc.) and the values of the initial dehydrogenase activity and dehydrogenase activity of the same sludge sample with weakly concentrated solution (DASН2О) are interconnected and depend on the organic load on sludge. The results of the study can be used to control the biological process of wastewater treatment.

1986 ◽  
Vol 18 (6) ◽  
pp. 35-45 ◽  
Author(s):  
John C. Kissel

Parameters characterizing intrasolid, liquid/solid, and gas/liquid mass transport phenomena in biological treatment systems are required if mass transfer is to be included in process models. Estimates of such parameters are presented and discussed. Collective and individual effects of mass transfer resistances are illustrated by computer simulation of a high-rate trickling filter.


2021 ◽  
Vol 3 (2) ◽  
pp. 130-140
Author(s):  
Maria Diana Puiu ◽  

The food industry wastewater is known to present a high organic matter content, due to specific raw materials and processing activities. Even if these compounds are not directly toxic to the environment, high concentrations in effluents could represent a source of pollution as discharges of high biological oxygen demand may impact receiving river's ecosystems. Identifying the main organic contaminants in wastewater samples represents the first step in establishing the optimum treatment method. The sample analysis for the non-target compounds through the GC-MS technique highlights, along with other analytical parameters, the efficiency of the main physical and biological treatment steps of the middle-size Wastewater Treatment Plant (WWTP). Long-chain fatty acids and their esters were the main abundant classes of non-target identified compounds. The highest intensity detection signal was reached by n-hexadecanoic acid or palmitic acid, a component of palm oil, after the physical treatment processes with dissolved air flotation, and by 1-octadecanol after biological treatment.


Energies ◽  
2020 ◽  
Vol 13 (15) ◽  
pp. 3769 ◽  
Author(s):  
Radosław Żyłka ◽  
Wojciech Dąbrowski ◽  
Paweł Malinowski ◽  
Beata Karolinczak

The intensification of biological wastewater treatment requires the high usage of electric energy, mainly for aeration processes. Publications on energy consumption have been mostly related to municipal wastewater treatment plants (WWTPs). The aim of the research was to elaborate on models for the estimation of energy consumption during dairy WWTP operation. These models can be used for the optimization of electric energy consumption. The research was conducted in a dairy WWTP, operating with dissolved air flotation (DAF) and an activated sludge system. Energy consumption was measured with the help of three-phase network parameter transducers and a supervisory control and data acquisition (SCADA) system. The obtained models provided accurate predictions of DAF, biological treatment, and the overall WWTP energy consumption using chemical oxygen demand (COD), sewage flow, and air temperature. Using the energy consumption of the biological treatment as an independent variable, as well as air temperature, it is possible to estimate the variability of the total electric energy consumption. During the summer period, an increase in the organic load (expressed as COD) discharged into the biological treatment causes higher electric energy consumption in the whole dairy WWTP. Hence, it is recommended to increase the efficiency of the removal of organic pollutants in the DAF process. An application for the estimation of energy consumption was created.


2003 ◽  
Vol 47 (1) ◽  
pp. 271-276 ◽  
Author(s):  
Y. Zhang ◽  
H. Shi ◽  
Y. Qian

Printing ink wastewater is usually very difficult to treat biologically and its chemical oxygen demand (COD) far exceeds standards of discharge. The COD in wastewater is usually 3,000 to 8,000 mg/L after flocculation and sedimentation. Herein, a strain of bacterium was isolated from the sludge and identified as Bacillus sp. and utilized to treat printing ink wastewater. The application of bacteria to degrade printing ink in wastewater is discussed in this paper. The influence of N and P sources on COD removal, and COD removal in combination with glucose was also discussed. More than 85 per cent of the COD could be removed using the proposed biological process. A novel internal airlift loop bioreactor with bacteria immobilized onto ceramic honeycomb support was used for the wastewater treatment.


2012 ◽  
Vol 19 (1) ◽  
pp. 9-18 ◽  
Author(s):  
Elżbieta Hallmann ◽  
Renata Tomczak-Wandzel ◽  
Krystyna Mędrzycka

Combined Chemical-Biological Treatment of Effluents from Soil Remediation Processes by Surfactants Solutions Flushing In recent years combined chemical-biological wastewater treatment processes have received increasing interest. In the present study wastewater from soil remediation processes were treated by means of 1-step processes like Fenton, aerobic degradation and 2-steps combined method. The effluents resulting from soil remediation processes consist of high surfactant concentration solutions, mobilized oils and oil-in-water (o/w) emulsions. The effectiveness of wastewater treatment was evaluated by COD reduction and surfactant removal. The application of Fenton process alone showed around 80% of COD and surfactant removal, and in case of aerobic process only 60% of COD and 50% of surfactant removal was accomplished. However, the maximum COD reduction and surfactant removal from wastewater samples, above 90%, was obtained in aerobic degradation with Fenton process as pretreatment. Thus, the Fenton process could be effectively applied as a pretreatment step to improve the reduction of both COD and surfactant from wastewater resulting from soil remediation.


2006 ◽  
Vol 6 (4) ◽  
pp. 17-25 ◽  
Author(s):  
A. Ried ◽  
J. Mielcke

The use of ozone and/or UV for water treatment processes is often a combination of an ozone and/or UV-step with additional treatment steps, e.g. biological treatment, flocculation, filtration and activated carbon. Therefore, it is necessary to develop an optimized combination of these different steps. This article will demonstrate the advantages presenting two examples for drinking water treatment and two examples for municipal wastewater treatment.


2013 ◽  
Vol 13 (1) ◽  
pp. 225-236 ◽  
Author(s):  
Wei-Hsiang Chen ◽  
Wen-Ben Yang ◽  
Chung-Shin Yuan ◽  
Jun-Chen Yang ◽  
Qing-Liang Zhao

Author(s):  
Francisco J. Cervantes ◽  
Flor Cuervo-López ◽  
Jorge Gómez Hernández

In this chapter the fundamental aspects involved in biological treatment processes applied for the removal of nitrogen from wastewaters are described. A comprehensive review of the literature is provided including kinetic, microbiological and biochemical aspects of nitrification, denitrification and anammox, as well as key operational parameters affecting the processes. This information is relevant for designing wastewater treatment processes applied for the removal of nitrogen from wastewaters. The information is also essential for predicting and controlling the performance of these treatment processes.


Sign in / Sign up

Export Citation Format

Share Document