Removal of Cu2+ in Aqueous Solutions Using Sludge Incineration Slag as an Adsorbent

2011 ◽  
Vol 55-57 ◽  
pp. 308-311 ◽  
Author(s):  
Jing Yong Liu ◽  
Shui Yu Sun ◽  
Rong Xue Zhang ◽  
Sheng Zhong ◽  
Min Ting Chen

Sewage sludge incineration slag, the waste generated in sewage sludge incineration, was obtained from a sewage treatment plant in Guangzhou and used as a low-cost sorbent for removing Cu(Ⅱ) from wastewaters. The adsorption effectiveness and their factors of Cu2+ in aqueous solutions were simulated detailed using the adsorbents of the sludge incineration slag. The simulation contents and the factors included the adsorption time, the pH of solution and the dosage of adsorbents and so on. The results showed that at 30 °C, the adsorption equilibrium of Cu2+ can be achieved in 6h and the best pH value of the solution was about 4.5-5.5. The removal rates of Cu2+ were increased with the adsorbent concentration increasing and the optimal concentration of adsorbent was 20-30g/L with the initial concentration of Cu2+ less than 25mg/L.At the best adsorption conditions, the removal rate of Cu2+ reached more than 80% and the adsorption capacity was 0.83-1.25mg/g.

2011 ◽  
Vol 474-476 ◽  
pp. 158-161 ◽  
Author(s):  
Jin Yong Liu ◽  
Xu Nan Ning ◽  
Zuo Yi Yang

Sewage sludge incineration residue was obtained from a sewage treatment plant in Guangzhou and used as a low-cost sorbent for removing Ni2+ from wastewaters. The adsorption effectiveness and their factors of Ni2+ in aqueous solutions were simulated detailed using the adsorbents of the sludge incineration residue. The simulation contents and the factors included the adsorption time, the pH of solution and the dosage of adsorbents and so on. The results showed that at room temperature, the adsorption equilibrium of Ni2+ can be achieved in 6h and the best pH value of the solution was about 7.0. The removal rates of Ni2+ were increased with the adsorbent concentration increasing and the optimal concentration of adsorbent was 10g/L with the initial concentration of Ni2+ less than 30mg/L.At the best adsorption conditions, the removal rate of Ni2+ reached more than 70%.


1991 ◽  
Vol 23 (10-12) ◽  
pp. 1773-1781 ◽  
Author(s):  
Daisaku Yashiki ◽  
Tadahiro Murakami

Sludge melting furnaces have been applied recently to the treatment of a great deal of sludge generated from the sewage treatment plant. In this report, an explanation is provided of the history of system introduction, outline of treatment flow, sludge properties, operation results and effective utilization of slag generated at the reflector melting furnace, which began operation in July 1988 at the Futakami Sewage Treatment Plant in Toyama Prefecture. The melting furnace almost totally satisfies the needs of its design, and the properties of the generated melted slag exhibit the features that fully enable its effective utilization.


2013 ◽  
Vol 671-674 ◽  
pp. 2736-2741
Author(s):  
Yin An Ming ◽  
Tao Tao

To reuse municipal sewage sludge safely, experiment was carried out on grapefruit trees fertilized with composted sludge from Shiweitou Sewage Treatment Plant in Xiamen City of China, and a method was introduced of how to assess the environmental quality of grapefruit trees soil fertilized with sludge by Set Pair Analysis (SPA) model. The results showed that the soil in the surface layer (0-15cm) and the deeper layer (15-30cm) was less clean, and the environment of soil was not polluted. Thus it was feasible to use sludge as fruit fertilizer. The maximum service life of sludge for continuous land application was estimated by taking Cd as the limiting factor, which would provide scientific guide and technical support for safe land application of sludge.


Author(s):  
R. Edgecock ◽  
V. V. Bratishko ◽  
I. V. Zinchenko ◽  
S. H. Karpus ◽  
D. O. Milko ◽  
...  

Annotation Purpose. Summarize the regulatory and technological requirements for the production of organic (organo-mineral) fertilizers on the base of sewage sludge. Methods. Analysis and generalization of the requirements of regulatory documents on the management of organic waste and their use as raw materials for the production of organic fertilizers and soil improvers. Results. The current legislative, departmental and regulatory documentary base in Ukraine concerning the treatment of sediment resulting from biological sewage treatment at municipal wastewater treatment plants for its further use in agriculture as fertilizers is analysed. Indicators are identified and analysed to determine the possibility, feasibility, efficiency and scope of organic fertilizers produced using sewage sludge. The analysis of changes in the content of organic matter and total nitrogen in the sewage sludge during its storage at the sewage treatment plant sites is presented. The technological feasibility of using sludge of different shelf life in composting production has been determined. Conclusions 1. The regulatory framework of Ukraine contains a sufficiently complete list of indicators that should be met by organic raw materials (sewage sludge) for further use as organic fertilizers. Some of these indicators – bio security and heavy metals content – can be improved in the composting process of fertilizers. 2. Fresh sediment, as well as sediment accumulated in the last late autumn and winter periods, is of main value for use as a raw material in the production of organic fertilizers. 3. The use in the production of compost sludge stored on sludge sites for a period of half a year or more requires special control of the process of decontamination. In this case, it is advisable to use additional means of wastewater decontamination. Keywords: heavy metals, manure, humus, decontamination, composting, organic fertilizers, sewage sludge.


2016 ◽  
Vol 15 (3) ◽  
pp. 840-848
Author(s):  
B. Geraats ◽  
M. Parnowska ◽  
L. Kox

Abstract At Linz-Unkel (Germany) sewage treatment plant the first full scale state-of-art EloDry-Pro® plant for sewage sludge has been constructed, consisting of the PYREG® reactor and the EloDry® belt dryer. The system is characterised by small footprint, flexibility, modular design and efficient energy management. The sludge dried using an EloDry® belt dryer undergoes staged combustion using the PYREG® module at around 6,500°C. This reduces the sludge to a fraction of its original volume while disinfecting it and removing micro-pollutants such as pharmaceutical residues. The residual ash, which has a high percentage of plant-available phosphorus, is then supplied to the fertiliser industry as a recycled raw material. The working principle of EloDry-Pro® installation, including heat flows of the system, is presented. The paper describes Pyreg®'s advanced emission control systems, preventing NOx formation and removing harmful substances such as mercury and sulphur. The EloDry-Pro® technology is an innovative and cost-effective approach to decentralised thermal recycling of sewage sludge. Both sewage sludge volumes and transportation costs are reduced by up to 90%, therefore making it a low carbon cost-effective alternative to the transportation of sludge and allowing local sludge processing at plants under 100 k population.


2019 ◽  
Vol 3 (1) ◽  
pp. 27 ◽  
Author(s):  
Samir Tayar ◽  
Renata Guerrero ◽  
Leticia Hidalgo ◽  
Denise Bevilaqua

The packing material selection for a bioreactor is an important factor to consider, since the characteristics of this material can directly affect the performance of the bioprocess, as well as the investment costs. Different types of low cost packing materials were studied in columns to reduce the initial and operational costs of biogas biodesulfurization. The most prominent (PVC pieces from construction pipes) was applied in a bench-scale biotrickling filter to remove the H2S of the biogas from a real sewage treatment plant in Brazil, responsible for 90 thousand inhabitants. At the optimal experimental condition, the reactor presented a Removal Efficiency (RE) of up to 95.72% and Elimination Capacity (EC) of 98 gS·m−3·h−1, similar to open pore polyurethane foam, the traditional material widely used for H2S removal. These results demonstrated the high potential of application of this packing material in a full scale considering the robustness of the system filled with this support, even when submitted to high sulfide concentration, fluctuations in H2S content in biogas, and temperature variations.


2019 ◽  
pp. 1183-1187 ◽  
Author(s):  
Alyson Silva de Araujo ◽  
Luiz Eduardo Bassay Blum ◽  
Cícero Célio de Figueiredo

The use of sewage sludge to produce biochar is one of the best alternatives for the final destination of this material, allowing for reuse of nutrients and reducing the dependence on mineral fertilizers. Sewage sludge biochar (SSB) stands out as an enhancer of the physical, chemical and biological properties of the soil. The use of beneficial microorganisms such as Trichoderma spp. in combination with biochar may have a synergistic effect on the development of different plants and needs to be better studied. The SSB was produced from sewage sludge biomass (SS) obtained from the sewage treatment plant (STP) of the Federal District Environmental Sanitation Company (CAESB), Brasilia, DF, Brazil. The SSB was produced in an electric tubular furnace at 500 °C and showed the following characteristics: carbon (19%), nitrogen (2.3%), hydrogen (1.7%), specific surface area (52.5 m2 g-1), pore volume (0.053 ml g-1). An experiment was carried out in a greenhouse to evaluate the synergistic effect of SSB application (0.5% w/w) in combination with T. harzianum (TH) on soybean development. The treatments adopted were: (1) control – autoclaved soil, (2) TH, (3) SSB and (4) SSB + TH. The SSB was applied 15 days before soybean planting and the TH was applied to the soil two times, once at eight days before planting and the other at the time of planting. The SSB resulted in a 200% increase in the number of pods when compared to the exclusive application of T. harzianum. Application of SSB with T. harzianum increased germination by 20%, as well as a 70% increase in fresh and dry soybean mass in relation to the control. The agronomic indices evaluated in this study demonstrated that the use of SSB in conjunction with T. harzianum presents a synergistic effect, allowing for better development of the soybean plants.


2014 ◽  
Vol 522-524 ◽  
pp. 854-860
Author(s):  
Qing Tao Zhang ◽  
Zhi Jian Zhang ◽  
Jiong Ma ◽  
Jiao Xiang

The growth performance of duckweed (Spirodela polyrrhiza) and its removal rate of nitrate and phosphorus in sewages taken from sewage treatment plant with different processes were studied. The experiments were conducted in an environmentally controlled growth chamber. Three kinds of sewages were taken from a grit chamber, a sedimentation tank, and the anoxic pond in a sewage treatment plant, respectively. The fourth kind of sewage was mixed using the sedimentation tank sewage and the anoxic pond sewage in a volumetric ratio 1:1. The weight of duckweed biomass were determined with a balance. Wastewater samples taken from the media were analyzed for total nitrogen (TN), ammonium nitrogen (NH4N), total phosphorus (TP), phosphatephosphorus (PO4P) using AA3 Continous Flow Analyzer. The results showed that Spirodela polyrrhiza grew well in sewages taken from grit chamber and sedimentation tank of a sewage treatment plant, whereas a lot of duckweed fronds were dead in the sewage taken from the anoxic pond due to the high TP (higher than 7.9 mg/L) and TN (higher than 51.6 mg/L). The suitable TN concentration for Spirodela polyrrhiza growth should not be higher than 45 mg/L. Compared with the treatments without duckweed, the NH4N concentrations were reduced more than 60% in ST and GC sewages with duckweed due to the NH4N uptake by duckweed. Spirodela polyrrhiza could remove TN efficiently in sewages with relative low concentration TN (less than 20 mg/L), while duckweed could not remove TN effectively in sewages with high concentration TN (higher than 20 mg/L). The TN concentration in GC sewage decreased greatly in the first four days, which probably brought about anaerobic condition, thus P uptake switched to net release of P, which caused the increase of the TP concentration in the GC sewage without duckweed in the last six days. O2 or oxidant should be provided for sewage treatment system using duckweed to ensure that efficient removal of TN and TP meanwhile. The TP and PO4P concentrations in the mixed sewage with duckweed increased far more than those for no-duckweed treatments, which could be related that the dead duckweed released P into the sewage.


2015 ◽  
Vol 733 ◽  
pp. 334-337
Author(s):  
Ang Li ◽  
Li Na Sun

By aerobic composting bin type of sewage treatment plant sludge composting, through periodic sampling, research composting process temperature, moisture content, PH value changes and study the changes in compost maturity parameters of the DH. The results show that the compost temperature increased rapidly in the early rise in the first two days when fast to 50 degrees Celsius, in the tenth day decreased to room temperature; moisture content than the original sludge reduced by 40 percent to compost indicators; PH by reaction initial 6.2, and gradually becomes neutral and alkaline 7.8 biased. Experiments show that after aerobic sludge composting in temperature, moisture content, PH value terms have been reached sludge disposal requirements.


Sign in / Sign up

Export Citation Format

Share Document