Chemical Property of Ground Calcium Carbonate as Carbon Dioxide Absorbent

2010 ◽  
Vol 654-656 ◽  
pp. 2923-2926 ◽  
Author(s):  
Seiji Yokoyama ◽  
Nik Hisyamudin Muhd Nor ◽  
Shunsuke Hirano

Commercial sedimentation CaCO3 was ground by a vibration rod mill to investigate the physicochemical properties of mechanically activated CaCO3.When the CaCO3of the calcite structure was ground, the intensities of the crystal facesof calcite was decreased by distortions and so on, and the aragonite appeared as the grinding proceeded. The formed aragonite was transformed to the calcite when the sample was heated at 773K for3.6 ks. The dissociation pressure of CO2 of the ground CaCO3was larger than that of the non-ground CaCO3.The enthalpy; entropy and specific heat of change of the dissociation reaction were obtained. At high temperature, the emission rate of the ground CaCO3 was slightly larger than that of the non-ground CaCO3. At room temerature, the CaCO3 adsorbs CO2, and it desorbs the adsorbed CO2. The amount of adsorbed CO2 on the ground CaCO3 was larger than that of the non-ground CaCO3.

2020 ◽  
Vol 22 (22) ◽  
pp. 7946-7954
Author(s):  
Xiang Chen ◽  
Haijia Zhao ◽  
Jiakang Qu ◽  
Diyong Tang ◽  
Zhuqing Zhao ◽  
...  

High-temperature molten salts are an excellent electrolyte to bring about redox reactions at a rapid rate without using rationally designed nano-structured catalysts.


1927 ◽  
Vol 23 (8) ◽  
pp. 890-900 ◽  
Author(s):  
W. H. McCrea

SummaryTwo alternative forms of the CO2 molecule have been suggested by various authors who have discussed the band spectrum data. The specific heat curves based on these models are considered here. It is found that neither is quite satisfactory over the whole range of temperature and we discuss the difficulties for the low temperature and high temperature portions separately. In order to get agreement for low temperatures we find it necessary to introduce a further hypothesis about the molecular model which also seems to explain one or two outstanding difficulties in interpreting the fine structure of the bands. This assumption does not make any difference at higher temperatures where we show the error in one of the curves to be of the order we should expect to be accounted for by a centrifugal stretching of the molecule.


BioResources ◽  
2021 ◽  
Vol 16 (4) ◽  
pp. 7716-7728
Author(s):  
Min Woo Lee ◽  
Dong Suk Kang ◽  
Yung Bum Seo

In papermaking, pre-flocculation of fillers such as ground calcium carbonate (GCC) improves the tensile strength of paper sheets. However, the pre-flocculated fillers mostly suffer from the instability of the floc shape such as the decrease in floc diameter with time elapse after preparation and no improvement of bulk and stiffness. The addition of calcium compounds such as calcium oxide or calcium hydroxide to the pre-flocculated GCC, and injection with carbon dioxide caused pre-flocculated GCC flocs to be covered with newly formed calcium carbonate. This product, called post hybrid calcium carbonate (pHCC), was found to be more stable in size and gave better sheet strength than the pre-flocculated ones. Furthermore, pHCC gave remarkably higher bulk and stiffness than the pre-flocculated flocs did without impairing smoothness that was essential in printing paper. The proper use of pHCC in papermaking could allow the production of high loaded paper with more than 10% higher filler contents, which could reduce paper production cost and save drying energy. The proportion of the newly formed calcium carbonate in pHCC, turbulence intensity at preparation stage, and the effect of storage time were investigated.


2020 ◽  
Author(s):  
Hester E. Dijkstra ◽  
Cjestmir V. de Boer ◽  
Mariëlle Koenen ◽  
Jasper Griffioen

<p>High temperature - aquifer thermal energy storage (HT-ATES) is gaining momentum as sustainable option for the (seasonal) storage of heat, where geothermal heat may be one of the sources. To maximize the impact of geothermal systems, the heat produced in the summertime, which is not directly needed, can be temporarily stored in a groundwater aquifer for use in the winter. However, HT-ATES does not come without technical complications. One potential complication is carbonate scaling of the technical installation and/or the aquifer in the vicinity of the injection well. Precipitation of carbonates may occur when carbonate-saturated groundwater becomes heated, upon which the groundwater becomes increasingly supersaturated for carbonates. As part of the GEOTHERMICA project HEATSTORE, both a sampling method and an experimental set-up were developed. This experimental procedure enables the sampling and testing of groundwater from HT-ATES sites or else to determine the likelihood of calcium carbonate scaling in a HT-ATES system and, if so, identify the nature and extent.</p><p>For the HEATSTORE project, Groundwater was sampled at a HT-ATES test well drilled in Middenmeer, the Netherlands down to 370 meter depth. The sampling was done with a double walled vessel, which made it possible to maintain pressure on the water sample to prevent degassing of natural occurring dissolved gases like methane and carbon dioxide during sampling and storage, as well as preventing atmospheric contamination of the groundwater. The experiments were performed in two stainless steel autoclaves which were kept at 85 degrees Celsius for up to 5 days. Three types of experiments were performed to mimic the different components of the HT-ATES system: addition of a plate of stainless steel, addition of calcium carbonate crystals and addition of aquifer sediment. The first experiment did not show any carbonate precipitation, although geochemical modelling suggests oversaturation of calcite for the applied conditions. Calcite precipitation and recrystallization were observed only in the experiments with calcite crystal seeds added. The experiment with the aquifer sediment added to the reaction vessel, containing shell fractions and intact shells (e.g. Foraminifera), did not show calcite precipitation, neither showed the chemical analysis of the water at the end of the experiment a reduction in calcium concentration. Isotope analysis suggests that carbon dioxide was released by thermally enhanced degradation of sedimentary organic matter, which would have lowered the supersaturation of calcite.</p><p>These results suggest that aquifers, in which calcite is already present and limited (or no reactive) organic matter is available, could face a risk of scaling and subsequent injectivity/productivity issues when HT-ATES is applied in these aquifers. A proper water treatment, such as the addition of carbon dioxide or hydrochloric acid to the groundwater abstracted prior to heating, could be required to prevent groundwater from getting supersaturated with carbonate minerals.</p>


Author(s):  
Parisa Sadeghpour ◽  
Mohammad Haghighi ◽  
Mehrdad Esmaeili

Aim and Objective: Effect of two different modification methods for introducing Ni into ZSM-5 framework was investigated under high temperature synthesis conditions. The nickel successfully introduced into the MFI structures at different crystallization conditions to enhance the physicochemical properties and catalytic performance. Materials and Methods: A series of impregnated Ni/ZSM-5 and isomorphous substituted NiZSM-5 nanostructure catalysts were prepared hydrothermally at different high temperatures and within short times. X-ray diffraction (XRD), Field emission scanning electron microscopy (FESEM), Energy dispersive X-ray (EDX), Brunner, Emmett and Teller-Barrett, Joyner and Halenda (BET-BJH), Fourier transform infrared (FTIR) and Temperature-programmed desorption of ammonia (TPDNH3) were applied to investigate the physicochemical properties. Results: Although all the catalysts showed pure silica MFI–type nanosheets and coffin-like morphology, using the isomorphous substitution for Ni incorporation into the ZSM-5 framework led to the formation of materials with lower crystallinity, higher pore volume and stronger acidity compared to using impregnation method. Moreover, it was found that raising the hydrothermal temperature increased the crystallinity and enhanced more uniform incorporation of Ni atoms in the crystalline structure of catalysts. TPD-NH3 analysis demonstrated that high crystallization temperature and short crystallization time of NiZSM-5(350-0.5) resulted in fewer weak acid sites and medium acid strength. The MTO catalytic performance was tested in a fixed bed reactor at 460ºC and GHSV=10500 cm3 /gcat.h. A slightly different reaction pathway was proposed for the production of light olefins over impregnated Ni/ZSM-5 catalysts based on the role of NiO species. The enhanced methanol conversion for isomorphous substituted NiZSM-5 catalysts could be related to the most accessible active sites located inside the pores. Conclusion: The impregnated Ni/ZSM-5 catalyst prepared at low hydrothermal temperature showed the best catalytic performance, while the isomorphous substituted NiZSM-5 prepared at high temperature was found to be the active molecular sieve regarding the stability performance.


CrystEngComm ◽  
2021 ◽  
Vol 23 (16) ◽  
pp. 3033-3042
Author(s):  
Liubin Shi ◽  
Mingde Tang ◽  
Yaseen Muhammad ◽  
Yong Tang ◽  
Lulu He ◽  
...  

Herein, calcium carbonate hollow microspheres with a micro–nano hierarchical structure were successfully synthesized using disodium salt of ethylenediaminetetraacetic acid (EDTA-2Na) as an additive, by bubbling pressurized carbon dioxide and calcium hydroxide at 120 °C.


Sign in / Sign up

Export Citation Format

Share Document