Fabrication of Highly Hydrophobic Polyurethane Foam for the Oil-Absorption Application

2014 ◽  
Vol 809-810 ◽  
pp. 169-174 ◽  
Author(s):  
Jun Liu ◽  
Meng Jie Chang ◽  
Menken Tenggeer ◽  
Hui Ling Du

Hydrophobic polyurethane (PU) sponge for oil absorption application was fabricated by ZnO nanomaterial coating and stearic acid modification on ZnO surface. The contact angle and oil absorbent capacity ability of the obtained sponge were measured. It was demonstrated that both ZnO nanoparticle and ZnO nanorod coated PU sponge (ZnO NPs-PU and ZnO NRs-PU) showed good hydrophobicity and oil absorbent ability. ZnO NPs-PU and ZnO NRs-PU sponges have absorbent capacities of 18~92 times and 20~98 times of their own weight for different organic liquids, respectively. Moreover, the absorption capacity of the ZnO NRs-PU sponge did not deteriorate over 50 cycles. Therefore, the ZnO NRs-PU sponge has excellent recyclability for future application.

2018 ◽  
Vol 89 (10) ◽  
pp. 1952-1963 ◽  
Author(s):  
Alper Gurarslan ◽  
Muhammed Erkam Narinç

The genus populus provides creamy white, lustrous, lightweight fibers that grow on seeds. Since populus fibers obtained from populus nigra italica are too short (0.25–0.42 cm) to be spun into yarns, populus fibers were spray coated with dimethylacetamide/Spandex solution in order to form non-woven structures. In this study, the oil absorption capacity of non-woven populus fiber pads was investigated and compared to non-woven long cotton fiber and non-woven short cotton fiber pads. The hollow structure and the oleophilic properties of populus fibers make them promising and sustainable oil absorbent candidates. The average short-term rose oil absorption capacity of non-woven populus fiber pads is 32.96798 g/g, while the long-term rose oil absorption capacity of non-woven populus fiber pads is 34.52854 g/g. Furthermore, the toluene absorption capacity of non-woven populus fiber pads is on average 23.16986 g/g for the short-term test and 24.01588 g/g for the long-term test. Moreover, non-woven populus fiber pads preserve 81.75% of rose oil even after remaining in water for 45 minutes.


2012 ◽  
pp. 385-388 ◽  
Author(s):  
Azadeh Saadatmandi ◽  
Mohammad Elahi ◽  
Reza Farhoosh ◽  
Mahdi Karimi

The incorporation of sugar beet fiber (0–5%) to tortilla chips and the effects on the chemical and sensory properties were studied. Addition of sugar beet fiber (SBF) led to an increasing of water absorption capacity, ash content and darkness while lowering the protein content and oil absorption. Sensory evaluation showed that the overall acceptability of tortilla chips reduces if adding more than 2% SBF.


2020 ◽  
Vol 7 (04) ◽  
Author(s):  
SATYA NARAYAN SINGH ◽  
RAJESH G BURBADE ◽  
HITESH SANCHAVAT ◽  
P S PANDIT

The cereals of today are more nutritious and healthful than ever before. Cereals processing is one of the oldest and the most essential part of all food technologies. Pasta products and noodles have been staple foods since ancient times in many countries all over the world. In this study pasta formulation was substituted with blending sapota powder in different proportions (4 levels i.e. 0%, 10%, 20%, 30%) into semolina and maida flour separately. Pasta products were prepared using eight different formulations and adding water (approximately 31% of total weight) in DOLLY pasta extruder machine. All the samples were evaluated for physical properties: specific length (mm/g), bulk density (kg/m3), specific density (kg/m3) and porosity (%); functional properties: water absorption index (%), water solubility index (%) and oil absorption capacity (ml/g) and nutritional compositions: moisture (%), crude protein (%), fat (%) and carbohydrate (%). Highest specific length 36.20 mm/g was observed for T5 treatment, low bulk density 368.10 kg/m3 was observed for T5 and highest porosity 9.24% was found for T1 treatment. The maximum WAI, WSI values 325.83%, 17.33% respectively was observed for T1 treatment and minimum value of oil absorption capacity 1.06 ml/g for T8 treatment. The moisture content of dried pasta products was found in the range of 6 to 7%. The maximum value of crude protein 13.07% was found for T5 and minimum value 8.81% for T4 treatments. The fat contents were varied from 1.02% to 1.28 %. The maximum value of carbohydrate was 76.20% for T1 and minimum value 65.41% for T8.


2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Jiaqi Wang ◽  
Yan Chen ◽  
Qinyao Xu ◽  
Miaomiao Cai ◽  
Qian Shi ◽  
...  

AbstractSuperhydrophobic sponges have considerable potential for oil/water separation. Most of the methods used for superhydrophobic modification of sponges require toxic or harmful solvents, which have the drawbacks of hazardous to environment, expensive, and complex to utilize. Moreover, the hydrophobic layer on the surface of sponge is often easily destroyed. In this paper, a highly efficient superhydrophobic sponge with excellent reusability was developed by using a facile, simple and environmentally friendly dopamine biomimetic bonding method. Different types of sponges, such as melamine, polyethylene or polyurethane sponge wastes, were used as raw materials to prepare superhydrophobic sponges, which possess the advantages of inexpensive and abundant. The effects of different dopamine polymerization time and different hydrophobic agent dosage on the hydrophobicity and oil absorption capacity of melamine sponges were optimized. The study results showed that the water contact angle of the superhydrophobic sponge could reach 153° with excellent organic solvent absorption capacity of 165.9 g/g. Furthermore, the superhydrophobic sponge retained approximately 92.1% of its initial absorption capacity after 35 reutilization cycles. More importantly, the dopamine biomimetic bonding superhydrophobic modification method can be used for different types of sponges. Therefore, a universally applicable, facile, simple and environmentally friendly superhydrophobic modification method for sponges was developed.


2016 ◽  
Vol 2016 ◽  
pp. 1-6 ◽  
Author(s):  
Daiki Itohara ◽  
Kazato Shinohara ◽  
Toshiyuki Yoshida ◽  
Yasuhisa Fujita

Both n-channel and p-channel thin-film transistors have been realized on ZnO nanoparticle (NP) layers sprayed onto quartz substrates. In this study, nitrogen-doped ZnO-NPs were synthesized using an arc-discharge-mediated gas-evaporation method that was recently developed. Sprayed NP layers were characterized by scanning electron microscopy and Hall effect measurements. It was confirmed that p-type behaving NP layers can be obtained using ZnO-NPs synthesized with lower chamber pressure, whereas n-type conductivity can be obtained with higher chamber pressure. pn-junction diodes were also tested, resulting in clear rectifying characteristics. The possibility of particle-process-based ZnO-NP electronics was confirmed.


Food Research ◽  
2021 ◽  
Vol 5 (4) ◽  
pp. 145-152
Author(s):  
M. Hasmadi ◽  
M. Merlynda ◽  
A.H. Mansoor ◽  
I. Salwa ◽  
M.K. Zainol ◽  
...  

This study aimed to determine the proximate compositions and functional properties of sweet potato flour from different varieties cultivated in Sabah, Malaysia, namely Jepun, Kairot and Kaladi. The results showed that the moisture content of all flour samples was below 14%. The fat and protein content of Jepun sweet potato variety were significantly different (p<0.05) as compared with Kairot and Kaladi sweet potato varieties. The ash and dietary fibre content of Kairot sweet potato flour were higher (p<0.05) compared to Jepun and Kaladi flours. In addition, Kaladi sweet potato had the highest carbohydrate content (82%). There were significant differences (p<0.05) in the values of L*, a* and b* for all sweet potato flours. The Jepun sweet potato flour had the highest foaming capacity, water absorption capacity, oil absorption capacity, swelling power and viscosity. Rapid Visco analyser revealed that significant differences were observed for pasting parameters such as peak viscosity, trough viscosity, breakdown viscosity, final viscosity and setback viscosity. The gelatinisation properties showed that Kairot sweet potato flour had the highest onset temperature, conclusion temperature and enthalpy while Kaladi sweet potato flour had the highest peak temperature.


2021 ◽  
Vol 3 (1) ◽  
Author(s):  
Na Thi Ty Ngo ◽  
Fereidoon Shahidi

AbstractCamelina and flixweed (sophia) seed protein isolates were prepared using both the conventional extraction and ultrasonic-assisted extraction methods at 40 kHz for 20 min, and their functional properties investigated. SDS-PAGE showed that both ultrasound-assisted and conventional extractions resulted in a similar protein profile of the extract. The application of ultrasound significantly improved protein extraction/content and functional properties (water holding capacity, oil absorption capacity, emulsifying foaming properties, and protein solubility) of camelina protein isolate and sophia protein isolate. The water-holding and oil absorption capacities of sophia protein isolate were markedly higher than those of camelina protein isolate. These results suggest that camelina protein isolate and sophia protein isolate may serve as natural functional ingredients in the food industry. Graphical Abstract


2020 ◽  
Vol 45 (3) ◽  
Author(s):  
K. O. Soetan ◽  
A. A. Adeola

Underutilized and neglected legumes have numerous nutritional potentials with great contributions to food security but they are usually excluded from research and development agenda. This study evaluates the nutritional and functional properties of six different underutilized and neglected legumes; Lima bean (LB) (Phaseolus lunatus) (2006-009), Bambara groundnut (BG) (Vigna subterranea) (TVSU- 1482), winged bean (WB) (Psophocarpus tetragonolobus) (Tpt-48), jack bean (JB) (Canavalia ensiformis) (Tce-4), sword bean (SB) (Canavalia gladiata) (Tcg-4) and African yam bean (AYB) (Sphenostylis stenocarpa) (TSS-95) from the Genetic Resources Unit (GRU), International Institute of Tropical Agriculture (IITA), Ibadan, Oyo State, Nigeria. Nutritional and functional properties were evaluated using proximate composition, mineral analyses and functional properties like bulk density, water absorption capacity, oil absorption capacity, emulsion capacity and dispersibility. All the procedures were carried out using standard protocols. Statistical analysis was done using descriptive statistics. Results of proximate analysis showed that crude protein ranged from18.88 0.15%(WB) to 26.60±0.14%(AYB), crude fat ranged from 1.84 0.02% (JB) to 6.39 0.03% (BG), crude fibre ranged from 3.70 ±0.00% (AYB) to 5.04 0.03% (SB), ash ranged from 3.10 ± 0.14% (AYB) to 4.66 0.02% (LB), nitrogen free extract ranged from 55.60 0.04% (SB) to 62.97 0.12% (WB), moisture content ranged from 5.75 0.48% (AYB) to 10.77 0.03% (JB), dry matter ranged from 89.23 0.03% (JB) to 94.25 ± 0.488% (AYB) and gross energy ranged from 4.39 0.003 kcal/g (SB) to 4.66 0.00 (BG). Mineral content results revealed that calcium varied from 0.14 0.000% (LB) to 0.23 0.0003% (AYB), phosphorus varied from 0.20 0.0001% (AYB) to 0.38 0.00% (BG), sodium varied from 0.12 0.00% (LB and WB) to 0.35 0.0006% (AYB), potassium varied from 0.69 0.00% (LB) to 1.12 0.00% (BG), magnesium varied from 0.15 0.0002% (AYB) to 0.27 0.000% (BG) and iron varied from 44.84 0.03 (mg/g) (WB) to 80.98 0.0007(mg/g) (AYB). Results of functional properties showed that bulk density ranged from 0.45±0.04 g/mL (WB) to 0.77±0.08 g/mL (SB), water absorption capacity ranged from 168.33±0.03 g/100g (LB) to 183.62±0.01 g/100g (SB), oil absorption capacity ranged from 146.54 ±0.02 g/100g (LB) to 161.55±0.02 g/100g (JB), emulsion capacity ranged from 79.67 ±0.02 g/100g (LB) to 89.46±0.02 g/100g (SB) and dispersibility ranged from81.0±1.41%(SB) to 86.5±0.71% (BG). The study concluded that all the underutilized legumes have varying nutritional and functional properties, which should be exploited for nutritional benefits and industrial applications, as a solution to the problem of food shortage, especially in the developing countries.


2017 ◽  
Vol 5 (2) ◽  
pp. 1957-1963 ◽  
Author(s):  
Yubo Cheng ◽  
Pei Xu ◽  
Wei Zeng ◽  
Chenxi Ling ◽  
Shuo Zhao ◽  
...  

2018 ◽  
Vol 18 (4) ◽  
pp. 369-376 ◽  
Author(s):  
Ho Jong Kim ◽  
Sang Wook Han ◽  
Ju Hwan Kim ◽  
Hyun Ook Seo ◽  
Young Dok Kim

Sign in / Sign up

Export Citation Format

Share Document