PEPPER SEED TREATMENT FOR LOW-TEMPERATURE GERMINATION

1984 ◽  
Vol 64 (2) ◽  
pp. 387-393 ◽  
Author(s):  
JOHN O’SULLIVAN ◽  
W. J. BOUW
Keyword(s):  
Low Temperature ◽  
Seed Treatment ◽  
Room Temperature ◽  
Slight Reduction ◽  
Salt Solutions ◽  
Untreated Seed ◽  
Capsicum Annum ◽  
Treated Seed ◽  
Surface Drying ◽  
Temperature Time

Low-temperature germination and emergence of pepper (Capsicum annum L.) seed was accelerated by imbibition in salt (KNO3 + K3PO4∙H2O) and PEG solutions at 20 °C. Salt-treated seed had a faster rate of germination and emergence than PEG-treated seed. The stimulating effect of salt solutions on germination was most marked at 12.5 °C. At this temperature, time to 50% germination was up to 14 days less for treated seed than for untreated seed. Similar effects were noted on emergence at 17.5/7.5 °C and 20/10 °C, day/night temperatures. Imbibed seed emerged up to 6 days earlier than untreated seed. The concentration of the salt solution determined the duration of the treatment period. Surface drying the seed at room temperature for 1 day prior to sowing resulted in only a slight reduction on advancement of rate of germination and emergence. Drying followed by storage for up to 21 days did not markedly reduce the beneficial effect on germination and emergence of seeds imbibed in a 1.5% solution, but, for seeds imbibed in water or dilute salt solutions, most of the effect on stimulating germination and emergence was lost by drying for 7 days.Key words: Capsicum annum, osmoconditioning, KNO3 + K3PO4∙H2O, polyethylene glycol, germination, emergence

Seed quality as influenced by seed invigouration treatments in pigeonpea [Cajanus Cajan (L.) Millsp.]

2017 ◽  
Author(s):  
Ashok Kumar ◽  
R. C. Puniya ◽  
Axay Bhuker ◽  
Rupesh Sharma ◽  
Renu Devi
Keyword(s):  
Superoxide Dismutase ◽  
Cajanus Cajan ◽  
Room Temperature ◽  
Seed Quality ◽  
Good Seed ◽  
Untreated Seed ◽  
Negative Effect ◽  
Surface Drying ◽  
Sowing Seed ◽  
Hydration And Dehydration

Pre- sowing treatments viz, 50ppm GA3, 2% CaCl2, 0.5% KNO3, Hydration (2h) and drying at room temperature >25 0C and surface drying, and hydration- dehydration (2h) + Thiram dressing @ 0.25% were applied to two seed lots (marginal and good) of two cultivars of pigeonpea i.e. Paras and Manak and untreated seed lot was taken as control. The results revealed that various pre sowing invigouration treatments enhanced the standard germination of both the seed lots. However, the improvement in marginal seed lot (L2) was more than good seed lot (L1). Among the treatments, hydration and dehydration + thiram @ 0.25 percent were found most effective (6.0%) for enhancing in germination. Similarly, irrespective of the priming treatments among the cultivars Paras performed better under field conditions than Manak. irrespective of the cultivars, and seed lots pre-sowing seed treatments namely GA3 (50ppm), cold hydration and cold hydration + 0.25% thiram showed improvement in germination and seed quality attributes, whereas remaining treatments showed negative effect. It was revealed also that variety Manak showed good enzyme activity (DHA, catalase, peroxide and superoxide dismutase) than the Paras. And among seed lots (Table 4) lot L1 showed good enzyme activities than lot L21

scholarly journals Seed Treatment with Phosphonate (AG3) Suppresses Pythium Damping-off of Cucumber Seedlings

Plant Disease ◽  
2006 ◽  
Vol 90 (4) ◽  
pp. 459-464 ◽  
Author(s):  
P. A. Abbasi ◽  
G. Lazarovits
Keyword(s):  
Seed Treatment ◽  
Sandy Loam ◽  
Cost Effective ◽  
Controlled Environment ◽  
Damping Off ◽  
Untreated Seed ◽  
Cucumis Sativus L ◽  
Muck Soil ◽  
Treated Seed ◽  
Loam Soil

A formulation of phosphonate (AG3) was tested as a seed treatment for the control of Pythium damping-off of cucumber (Cucumis sativus L.) plants under controlled environment and field conditions. Cucumber seed were treated by soaking for 10 min in phosphonate solution. They were then planted into peat-based mix or sandy-loam soil mixed with Pythium aphanidermatum or P. ultimum inoculum or into muck soil naturally infested with P. irregulare, P. ultimum, and other Pythium spp. Under growth-room conditions, phosphonate seed treatment provided more than 80% control of damping-off in all infested substrates tested. Effective disease control was obtained even when treated seed were stored for 5 weeks and up to 18 months prior to planting. In microplots containing naturally infested muck soil, phosphonate seed treatment decreased the percentage of diseased cucumber plants and increased total fresh weights compared with untreated seed and phosphonate post-planting drench. In field-plot tests 6 weeks after planting treated seed in Pythium-infested muck soil, cucumber stands were 63% compared with 18% in the control, which had no phosphonate exposure, and 53% in the post-planting drench. Tests for potential phytotoxicity in the greenhouse showed that radish and bok choy germination was reduced by phosphonate treatment but corn, cucumber, soybean, sugar beet, tomato, and wheat were not affected. Phosphonate seed treatment is a cost-effective way of protecting cucumber plants from Pythium damping-off.

FUNGICIDE SEED TREATMENT OF RYEGRASSES TO IMPROVE SEEDLING ESTABLISHMENT AND INCREASE FORAGE YIELDS

1982 ◽  
pp. 139-143
Author(s):  
R.E. Falloon
Keyword(s):  
Seedling Establishment ◽  
Seed Treatment ◽  
Dry Matter ◽  
Untreated Seed ◽  
Routine Treatment ◽  
Treated Seed ◽  
Field Plots ◽  
Forage Yields

Treatment of seed of four ryegrass cultivars (Lolium spp.) with captan or thiram before sowing increased herbage yields from field plots 3 months after sowing by 33% (Ruanui), 51% (Manawa), 51% (Paroa) and 104% (Moata). Herbage yields and numbers of established plants were closely correlated. A second trial measured yield of Ruanui during 12 months following sowing. Captan seed treatment increased dry matter by 51% at conventional seeding rates (17.5 kg/ ha). Dry matter from plots sown with captan treated seed at 2.2 kg/ha did not differ from that from plots sown with untreated seed at 17.5 kg/ ha. Routine treatment of ryegrass seed to improve seedling establishment is strongly recommended.

Sowing Method and Seed Treatment Effects on Jack Pine Direct Seeding

1988 ◽  
Vol 5 (4) ◽  
pp. 237-240
Author(s):  
Laird Van Damme
Keyword(s):  
Seed Treatment ◽  
Laboratory Tests ◽  
Jack Pine ◽  
Germination Capacity ◽  
Untreated Seed ◽  
Seed Sources ◽  
Thunder Bay ◽  
Treated Seed ◽  
Better Than ◽  
Upper Slope

Abstract Jack pine seed from local seed sources received six treatment combinations by Hilleshog AB of Sweden as follows: (1) control, no treatment, (2) pelleting, (3) coloring, (4) pelleting and coloring, (5) coloring and scenting, and (6) pelleting, coloring and scenting. Laboratory tests performed by Hilleshog AB, a Swedish agriculture seed treating company that pelleted the test seed, showed pelleting to slow the rate of germination, but germination capacity was greater than 90% after 21 days for all treatments. Treated seed were factorially combined with hand and mechanical sowing methods with Bracke scarification in May 1984 on a sandy jack pine site west of Thunder Bay. Another treatment consisted of manually made pyramidal impressions from a corrugated pallet, which compacted the upper-mid-slope region of the scalp. This treatment, randomized within the 2 × 6 factorial design was then hand sown with untreated seed. Percentage of stocked scalps 2 months after germination showed hand sowing to be superior to machine sowing (45% vs 36%). Hand-sown untreated seed performed slightly better than treated seed (58% vs 32%-49%), but differences between seed treatments were not significant when sown by machine. Best results were obtained from untreated seed sown onto the upper slope of a Bracke scalp stabilized by the corrugated pallet (79%). Microsite stabilization appears critical for successful stocking of jack pine and merits further study toward scarification machinery modification. North. J. Appl. For. 5:237-240, December 1988.

Bulk standards for low-temperature biological x-ray microanalysis

1984 ◽  
Vol 42 ◽  
pp. 282-283
Author(s):  
P. Echlin ◽  
M. McKoon ◽  
E.S. Taylor ◽  
C.E. Thomas ◽  
K.L. Maloney ◽  
...  
Keyword(s):  
Phase Separation ◽  
Low Temperature ◽  
Analytical Method ◽  
Salt Solutions ◽  
Absolute Concentration ◽  
Cooling Process ◽  
X Ray ◽  
The Absolute ◽  
Analytical Procedures ◽  
Electrical Conductors

Although sections of frozen salt solutions have been used as standards for x-ray microanalysis, such solutions are less useful when analysed in the bulk form. They are poor thermal and electrical conductors and severe phase separation occurs during the cooling process. Following a suggestion by Whitecross et al we have made up a series of salt solutions containing a small amount of graphite to improve the sample conductivity. In addition, we have incorporated a polymer to ensure the formation of microcrystalline ice and a consequent homogenity of salt dispersion within the frozen matrix. The mixtures have been used to standardize the analytical procedures applied to frozen hydrated bulk specimens based on the peak/background analytical method and to measure the absolute concentration of elements in developing roots.

Survival of mouse blastocysts after low-temperature preservation under high pressure

2004 ◽  
Vol 52 (4) ◽  
pp. 479-487 ◽  
Author(s):  
Cs. Pribenszky ◽  
M. Molnár ◽  
S. Cseh ◽  
L. Solti
Keyword(s):  
Phase Transition ◽  
Hydrostatic Pressure ◽  
Low Temperature ◽  
High Hydrostatic Pressure ◽  
Room Temperature ◽  
Freezing Point ◽  
Significant Loss ◽  
Embryo Cryopreservation ◽  
Subzero Temperatures ◽  
Survival Capacity

Cryoinjuries are almost inevitable during the freezing of embryos. The present study examines the possibility of using high hydrostatic pressure to reduce substantially the freezing point of the embryo-holding solution, in order to preserve embryos at subzero temperatures, thus avoiding all the disadvantages of freezing. The pressure of 210 MPa lowers the phase transition temperature of water to -21°C. According to the results of this study, embryos can survive in high hydrostatic pressure environment at room temperature; the time embryos spend under pressure without significant loss in their survival could be lengthened by gradual decompression. Pressurisation at 0°C significantly reduced the survival capacity of the embryos; gradual decompression had no beneficial effect on survival at that stage. Based on the findings, the use of the phenomena is not applicable in this form, since pressure and low temperature together proved to be lethal to the embryos in these experiments. The application of hydrostatic pressure in embryo cryopreservation requires more detailed research, although the experience gained in this study can be applied usefully in different circumstances.

Photophysical properties of N719 and Z907 dyes, benchmark sensitizers for dye-sensitized solar cells, at room and low temperature

2021 ◽  
Vol 23 (10) ◽  
pp. 6182-6189
Author(s):  
Dariusz M. Niedzwiedzki
Keyword(s):  
Solar Cells ◽  
Low Temperature ◽  
Optical Spectroscopy ◽  
Room Temperature ◽  
Photophysical Properties ◽  
Dye Sensitized Solar Cells ◽  
Time Resolved ◽  
Dye Sensitized ◽  
Sensitized Solar Cells

Photophysical properties of N719 and Z907, benchmark Ru-dyes used as sensitizers in dye-sensitized solar cells, were studied by static and time-resolved optical spectroscopy at room temperature and 160 K.

Transition Insulator-Metal and Antiferromagnetic-Paramagnetic Cu Doped in La0.47Ca0.53MnO3

2015 ◽  
Vol 1123 ◽  
pp. 73-77 ◽  
Author(s):  
Yohanes Edi Gunanto ◽  
K. Sinaga ◽  
B. Kurniawan ◽  
S. Poertadji ◽  
H. Tanaka ◽  
...  
Keyword(s):  
High Resolution ◽  
Low Temperature ◽  
Magnetic Structure ◽  
Room Temperature ◽  
Paramagnetic Phase ◽  
Perovskite Manganites ◽  
Antiferromagnetic Phase ◽  
Temperature Transition ◽  
Cu Doping ◽  
Metal State

The study of the perovskite manganites La0.47Ca0.53Mn1-xCuxO3 with x = 0, 0.06, 0.09, and 0.13 has been done. The magnetic structure was determined using high-resolution neutron scattering at room temperature and low temperature. All samples were paramagnetic at room temperature and antiferromagnetic at low temperature. Using the SQUID Quantum Design, the samples showed that the doping of the insulating antiferromagnetic phase La0.47Ca0.53MnO3 with Cu doping resulted in the temperature transition from an insulator to metal state, and an antiferromagnetic to paramagnetic phase. The temperature transition from an insulator to metal state ranged from 23 to 100 K and from 200 to 230 K for the transition from an antiferromagnetic to paramagnetic phase.

Sign in / Sign up

Export Citation Format

Share Document