Biodiesel Production from Selected Used Cooking Oils and Animal Fats and Its Implementation

2016 ◽  
Vol 9 (3) ◽  
pp. 1-6
Author(s):  
A. Hossain ◽  
Mohammed AlEissa
Catalysts ◽  
2021 ◽  
Vol 11 (9) ◽  
pp. 1121
Author(s):  
Mohammed Salaheldeen ◽  
Abdalbasit Adam Mariod ◽  
Mohamed Kheireddine Aroua ◽  
S. M. Ashrafur Rahman ◽  
Manzoore Elahi M. Soudagar ◽  
...  

Triglycerides are the main constituents of lipids, which are the fatty acids of glycerol. Natural organic triglycerides (viz. virgin vegetable oils, recycled cooking oils, and animal fats) are the main sources for biodiesel production. Biodiesel (mono alkyl esters) is the most attractive alternative fuel to diesel, with numerous environmental advantages over petroleum-based fuel. The most practicable method for converting triglycerides to biodiesel with viscosities comparable to diesel fuel is transesterification. Previous research has proven that biodiesel–diesel blends can operate the compression ignition engine without the need for significant modifications. However, the commercialization of biodiesel is still limited due to the high cost of production. In this sense, the transesterification route is a crucial factor in determining the total cost of biodiesel production. Homogenous base-catalyzed transesterification, industrially, is the conventional method to produce biodiesel. However, this method suffers from limitations both environmentally and economically. Although there are review articles on transesterification, most of them focus on a specific type of transesterification process and hence do not provide a comprehensive picture. This paper reviews the latest progress in research on all facets of transesterification technology from reports published by highly-rated scientific journals in the last two decades. The review focuses on the suggested modifications to the conventional method and the most promising innovative technologies. The potentiality of each technology to produce biodiesel from low-quality feedstock is also discussed.


2018 ◽  
Vol 29 (5) ◽  
pp. 732-741 ◽  
Author(s):  
Farah Halek ◽  
Ali Kavousi-Rahim

Biodiesel is a renewable energy resource consisting of the alkyl monoesters of fatty acids obtained from vegetable oils, waste cooking oils, or animal fats. Biodiesel has been noticed recently as an alternative to fossil fuels. Previous studies have shown that biodiesel produces less pollutants compared to diesel fuel. Biodiesel fuel increases the emission of NOx exceptionally. Recently, it has been found that antioxidant addition to biodiesel is a solution to solve the problem. The purpose of this research is to study the effect of antioxidants addition on the emissions of CO, HC, and NOx from biodiesel fuel. Exhaust emissions of an agriculture diesel engine were studied using biodiesel blend with a 500 ppm propyl gallate (PrG) (propyl-3,4,5-trihydroxybenzoate) and butylated hydroxy anisole (BhA) (2-tert-butyl-4-methoxyphenol) as two major antioxidants. Biodiesel used in this research was prepared through NaOH catalyzed transesterification of a waste cooking oil that originally was taken from sunflower oil, with the assistance of ultrasonic homogenizer. After biodiesel production, five blends including neat diesel, B10, B20, B20 + 500 ppm PrG, and B20+ 500 ppm BhA were used as fuel and the emitted gases were analyzed. The results of this work demonstrated that the addition of antioxidants has no significant effect on lowering CO emission, as well as lowering HC; but the addition of antioxidants results in more efficient reduction of NOx emission from diesel exhaust. In general, BhA showed better results compared to PrG.


Energies ◽  
2019 ◽  
Vol 12 (23) ◽  
pp. 4408 ◽  
Author(s):  
Ramos ◽  
Dias ◽  
Puna ◽  
Gomes ◽  
Bordado

Energy security and environmental concerns, related to the increasing carbon emissions, have prompted in the last years the search for renewable and sustainable fuels. Biodiesel, a mixture of fatty acids alkyl esters shows properties, which make it a feasible substitute for fossil diesel. Biodiesel can be produced using different processes and different raw materials. The most common, first generation, biodiesel is produced by methanolysis of vegetable oils using basic or acid homogeneous catalysts. The use of vegetable oils for biodiesel production raises serious questions about biodiesel sustainability. Used cooking oils and animal fats can replace the vegetable oils in biodiesel production thus allowing to produce a more sustainable biofuel. Moreover, methanol can be replaced by ethanol being totally renewable since it can be produced by biomass fermentation. The substitution of homogeneous catalyzed processes, nowadays used in the biodiesel industry, by heterogeneous ones can contribute to improve the biodiesel sustainability with simultaneous cost reduction. From the existing literature on biodiesel production, it stands out that several strategies can be adopted to improve the sustainability of biodiesel. A literature review is presented to underline the strategies allowing to improve the biodiesel sustainability.


Catalysts ◽  
2019 ◽  
Vol 9 (1) ◽  
pp. 71 ◽  
Author(s):  
Michele Casiello ◽  
Lucia Catucci ◽  
Francesco Fracassi ◽  
Caterina Fusco ◽  
Amelita Laurenza ◽  
...  

A new protocol for biodiesel production is proposed, based on a binary ZnO/TBAI (TBAI = tetrabutylammonium iodide) catalytic system. Zinc oxide acts as a heterogeneous, bifunctional Lewis acid/base catalyst, while TBAI plays the role of phase transfer agent. Being composed by the bulk form powders, the whole catalyst system proved to be easy to use, without requiring nano-structuration or tedious and costly preparation or pre-activation procedures. In addition, due to the amphoteric properties of ZnO, the catalyst can simultaneously promote transesterification and esterification processes, thus becoming applicable to common vegetable oils (e.g., soybean, jatropha, linseed, etc.) and animal fats (lard and fish oil), but also to waste lipids such as cooking oils (WCOs), highly acidic lipids from oil industry processing, and lipid fractions of municipal sewage sludge. Reusability of the catalyst system together with kinetic (Ea) and thermodynamic parameters of activation (ΔG‡ and ΔH‡) are also studied for transesterification reaction.


2020 ◽  
pp. 149-159
Author(s):  
Jatinder Kataria ◽  
Saroj Kumar Mohapatra ◽  
Amit Pal

The limited fossil reserves, spiraling price and environmental impact due to usage of fossil fuels leads the world wide researchers’ interest in using alternative renewable and environment safe fuels that can meet the energy demand. Biodiesel is an emerging renewable alternative fuel to conventional diesel which can be produced from both edible and non-edible oils, animal fats, algae etc. The society is in dire need of using renewable fuels as an immediate control measure to mitigate the pollution level. In this work an attempt is made to review the requisite and access the capability of the biodiesel in improving the environmental degradation.


Catalysts ◽  
2020 ◽  
Vol 10 (4) ◽  
pp. 427 ◽  
Author(s):  
Muhammad Awais ◽  
Sa’ed A Musmar ◽  
Faryal Kabir ◽  
Iram Batool ◽  
Muhammad Asif Rasheed ◽  
...  

Biodiesel is a renewable fuel usually produced from vegetable oils and animal fats. This study investigates the extraction of oil and its conversion into biodiesel by base-catalyzed transesterification. Firstly, the effect of various solvents (methanol, n-hexane, chloroform, di-ethyl ether) on extraction of oil from non-edible crops, such as R. communis and M. azedarach, were examined. It was observed that a higher concentration of oil was obtained from R. communis (43.6%) as compared to M. azedarach (35.6%) by using methanol and n-hexane, respectively. The extracted oils were subjected to NaOH (1%) catalyzed transesterification by analyzing the effect of oil/methanol molar ratio (1:4, 1:6, 1:8 and 1:10) and varying temperature (20, 40, 60 and 80 °C) for 2.5 h of reaction time. M. azedarach yielded 88% and R. communis yielded 93% biodiesel in 1:6 and 1:8 molar concentrations at ambient temperature whereas, 60 °C was selected as an optimum temperature, giving 90% (M. azedarach) and 94% (R. communis) biodiesel. The extracted oil and biodiesel were characterized for various parameters and most of the properties fulfilled the American Society for Testing and Materials (ASTM) standard biodiesel. The further characterization of fatty acids was done by Gas Chromatography/Mass Spectrometer (GC/MS) and oleic acid was found to be dominant in M. azedarach (61.5%) and R. communis contained ricinoleic acid (75.53%). Furthermore, the functional groups were analyzed by Fourier Transform Infrared Spectroscopy. The results suggested that both of the oils are easily available and can be used for commercial biodiesel production at a cost-effective scale.


2018 ◽  
Vol 8 (1) ◽  
pp. 121-127 ◽  
Author(s):  
Tanzer Eryilmaz

In this study, the methyl ester production process from neutralized waste cooking oils is optimized by using alkali-catalyzed (KOH) single-phase reaction. The optimization process is performed depending on the parameters, such as catalyst concentration, methanol/oil ratio, reaction temperature and reaction time. The optimum methyl ester conversion efficiency was 90.1% at the optimum conditions of 0.7 wt% of potassium hydroxide, 25 wt% methanol/oil ratio, 90 min reaction time and 60°C reaction temperature. After the fuel characteristics of the methyl ester obtained under optimum conditions were determined, the effect on engine performance, CO and NOx emissions of methyl ester was investigated in a diesel engine with a single cylinder and direct injection. When compared to diesel fuel, engine power and torque decreased when using methyl ester, and specific fuel consumption increased. NOx emission increases at a rate of 18.4% on average through use of methyl ester.


Author(s):  
Gerald Kafuku ◽  
Makme Mbarawa ◽  
Man Kee Lam ◽  
Keat Teong Lee

Fatty acid methyl esters (biodiesel), prepared from transesterification of vegetable oils or animal fats, have gained great importance in substituting petroleum based diesel for combating environmental problems and higher diesel prices. Moringa oleifera fatty acids are among the newly investigated potentials for biodiesel production in recent years. In getting rid of soap formation and thus large waste washing water from biodiesel produced from homogenous catalysts, the use of heterogeneous catalysts is currently preferred due to easily separation and purification of the final products. In this study, biodiesel was produced from moringa oleifera oil using sulfated tin oxide enhanced with SiO2 (SO42−/SnO2−SiO2) as super acid solid catalyst. The experimental design was done using design of experiment (DoE), specifically, response surface methodology based on three-variable central composite design (CCD) with alpha (α) = 2. The reaction parameters in the optimization process were reaction temperature (60°C to 180°C), reaction period (1 to 3 hrs) and methanol to oil ratio (1:6 to 1:24 mol/mol). It was observed that the yield up to 84wt% of moringa oleifera methyl esters can be obtained with reaction conditions of 150°C temperature, 150 minutes reaction time and 1:19.5 methanol to oil ratio, while catalyst concentration and agitation speed are kept at 3wt% and 350 rpm respectively.


2019 ◽  
Vol 11 (8) ◽  
pp. 248
Author(s):  
Francirose Shigaki ◽  
Ludhanna Marinho Veras ◽  
Elane Tyara de Jesus Siqueira ◽  
José Roberto Brito Freitas ◽  
Mayanna Karlla Lima Costa ◽  
...  

Part of the energy consumed in the world comes from limited sources, which eventually are expected to be depleted. The search for alternative sources to meet energy needs is crucial. Biodiesel derived from vegetable oils and animal fats stands out as a biodegradable and renewable alternative source of energy. Sunflower is among the top four oil crops produced worldwide, and Brazil has a high production potential for this crop. This study aimed to identify the sunflower genotypes with the highest potential for biodiesel production in the Pre-amazon region of Brazil, where the advance of agricultural frontier represents an important role on biodiesel production. This study was conducted over 2 years of observations. The following genotypes were used: M734 (T), Helio358, EMBRAPA 122, and BRS G 35. The following parameters were assessed: initial flowering date (IFD), physiological maturity date (PMD), plant height (PH), grain yield (YIELD), thousand achene weight (TAW), and oil content (%OC). The climatic conditions of each experimental period were distinctive and directly affected the results obtained. The genotype Embrapa 122 showed the best performance regarding yield and was recommended for the pre-Amazon region of Brazil as the best adapted genotype to the local environmental conditions.


Sign in / Sign up

Export Citation Format

Share Document