The Road to a Robust and Affordable SiC Power MOSFET Technology

This article provides a detailed study of performance and reliability issues and trade-offs in silicon carbide (SiC) power MOSFETs. The reliability issues such as threshold voltage variation across devices from the same vendor, instability of threshold voltage under positive and negative gate bias, long-term reliability of gate oxide, screening of devices with extrinsic defects by means of gate voltage, body diode degradation, and short circuit withstand time are investigated through testing of commercial devices from different vendors and two-dimensional simulations. Price roadmap and foundry models of SiC MOSFETs are discussed. Future development of mixed-mode CMOS circuits with high voltage lateral MOSFETs along with 4−6× higher power handling capability compared to silicon circuits has been described.

New Trends in Lithium Niobate: From Bulk to Nanocrystals

The recent Special Issue on lithium niobate (LiNbO3) is dedicated to Prof. Schirmer and his topics and contains nineteen papers, out of which seven review various aspects of intrinsic and extrinsic defects in single crystals, thin films, and powdered phases; six present brand-new results of basic research, including two papers on Li(Nb,Ta)O3 mixed crystals; and the remaining six are related to various optical and/or thin film applications.

Visible Light Driven Photocatalytic Decolorization and Disinfection of Water Employing Reduced TiO2 Nanopowders

Defect-engineering of TiO2 can have a major impact on its photocatalytic properties for the degradation of persisting and non-biodegradable pollutants. Herein, a series of intrinsic and extrinsic defects are induced by post annealing of crystalline TiO2 under different reducing atmospheres. A detailed optoelectronic characterization sheds light on the key characteristics of the defect-engineered TiO2 nanopowders that are linked to the photocatalytic performance of the prepared photocatalysts. The photodegradation of a model dye, malachite green, as well as the inactivation of bacterial endospores of the Geobacillus stearothermophilus species were studied in the presence of the developed catalysts under visible light illumination. Our results indicate that a combination of certain defects is necessary for the improvement of the photocatalytic process for water purification and disinfection under visible light.

Study of Chemical and Physical Characterization of the Natural Dolomite of Ain Mlila-Algeria

Dolomite is one of the commonest minerals that abound in the formation of a number of geological conditions. And it is found in abundance in eastern Algeria, especially Ain Mlila-Wilaya of Oum El Bouaghi-Algeria. The analyzed sample of raw dolomite has been by various physical-chemical techniques. The constituents of these carbonates are Ca, Mg, C, O, Al, Si, Fe, Ba, F, and Sr, analysis by XRD, and Raman, show that in addition to CaMg(CO3)2, we may have calcium carbonate. The Photoluminescence analysis characterizes the intrinsic and extrinsic defects of this carbonate. Differential thermal analysis reveals the different transformations of this mineral during heating. Indeed several stages including the elimination of water, the departure of CO2, the formation of MgO, and finally the formation of CaO.

Intrinsic and extrinsic defects build a novel mechanoluminescent phosphor Na2MgGeO4:Mn2+

Intrinsic oxygen vacancy and cationic substitution defects construct a novel mechanoluminescent material.

N-Type Mg3Sb2-xBix Alloys as Promising Thermoelectric Materials

N-type Mg3Sb2-xBix alloys have been extensively studied in recent years due to their significantly enhanced thermoelectric figure of merit (zT), thus promoting them as potential candidates for waste heat recovery and cooling applications. In this review, the effects resulting from alloying Mg3Bi2 with Mg3Sb2, including narrowed bandgap, decreased effective mass, and increased carrier mobility, are summarized. Subsequently, defect-controlled electrical properties in n-type Mg3Sb2-xBix are revealed. On one hand, manipulation of intrinsic and extrinsic defects can achieve optimal carrier concentration. On the other hand, Mg vacancies dominate carrier-scattering mechanisms (ionized impurity scattering and grain boundary scattering). Both aspects are discussed for Mg3Sb2-xBix thermoelectric materials. Finally, we review the present status of, and future outlook for, these materials in power generation and cooling applications.