Potensi Tempurung Kelapa Sebagai Pembangkit Listrik Dengan Menggunakan Termoelektrik Generator

Around 35% of the total utilization of coconuts at this time is still not fully utilized. Thermoelectric is a technology that converts heat energy directly into electrical energy or converts electrical energy into heating and cooling energy. Data retrieval using two multimeters and an electric thermometer, data collection was carried out for 2 minutes. From the test results, this tool can produce an average voltage of 10.05 Volt for 200gram coconut shells, an average current of 0.99 Ampere and an average power of 13.84 Watts and can fully charge the battery up to 3 hours 33 minutes, while for 300 grams produces an average voltage of 10.59 Volts for 300gram coconut shells, an average current of 0.995 Ampere and an average power of 13.56 Watts and the battery can be fully charged in about 3 hours 36 minutes, while a coconut shell weighing 400 grams can produces an average voltage of 10.94 Volts, an average current of 1 Ampere and an average power of 13.70 Watts and the battery can be fully charged in about 3 hours 30 minutes. The more coconut shells used for combustion, the hotter the temperature and the faster the voltage and current are obtained, but with a note that the maximum temperature limit of the thermoelectric is T not more than 200o C. Keywords: Coconut Shell, Thermoelectric, Electrical Energy.

Numerical study on the dynamic performance of combined sensible-latent heat packed-bed thermocline tank

Thermal energy storage (TES) using thermocline technology with phase change materials (PCMs) is a promising technique for peak shaving operation in cogeneration units. One of the disadvantages of this connotation is the use of the highly-cost PCM capsules in a water tank. To circumvent this issue, a new thermocline tank connotation is proposed. The tank is packed with a mixture of solid filler pills and PCMs capsules, forming a multi-layer packed-bed system. A transient concentric-dispersion model is developed to assess the dynamic performance of a solid-PCM multi-layer packed-bed (SPMLPB) tank. The influences of the PCMs volume fraction (VF) and the charge and discharge dimensionless cut-off temperatures criterion on the dynamic performance have been investigated. The results show that the VF of PCMs influences the system's behavior, both in terms of energy storage and release. As the PCMs volume fraction increases from 10% to 40%, the amount of energy storage, energy release, and latent utilization ratio increased by 82.65%, 73.94%, and 55%, respectively, while the exergy overall efficiency falls by 6.3%. Besides, increasing both the charge and discharge cut-off temperatures (ST*ch/ST*dish) enhances the total utilization ratio and energy recovered. As ST*ch increases from 0.27 to 0.7, total utilization ratio and energy recovered increased by 63.63% and 28.67% respectively by maintains ST*dish = 0.26.

Multiobjective Programming Strategy of Small- and Medium-Sized Microenterprise Credit Based on Random Factors

In this paper, we select eight indicators from the aspects of an enterprise’s bill transaction information, namely, whether the enterprise’s loan is in breach of contract, effective invoice rate, total utilization rate of price and tax, negative invoice rate, strength of enterprise, coefficient of variation, flow efficiency of assets, and influence of upstream and downstream enterprises; then, we construct an evaluation index system. According to different industries, different categories, and the impact of random factors, we divide the types of enterprises into 10 categories. Then, we use three kinds of Poisson random numbers to carry out numerical simulation on the total price and tax of enterprises in different industries under the influence of COVID-19.

Cost–Benefit Analysis of Associated Gas Flaring in the Niger – Delta Area of Nigeria (a case study of 1958 – 2004

CT: Associated gas flaring has been revealed as a significant contributor to the warming of the local climateof the communities where these flare stacks are located. Associated gas flaring has also been revealed as a major casualfactor to the degradation of the environment, air pollution and consequent health effects of the inhabitants of these hostcommunities. This study goes a step further to assess the economic benefit of total utilization of associated gas as an antedote to these problems as it is been argued that flaring this gas is cheaper than total utilization. The research uses as its casestudy the Niger – Delta region of Nigeria a West African country with 1958- 2004 been the years under review. The studyadopted the Cost – Benefit approach/ Method of analysis as well as relied on secondary face to face interview. Results fromthe study revealed that the economic benefit of total utilization of associated gas far outweighs the cost of flaring associatedgas. Results from the study also reveal that if Nigeria had utilized the associated gas from crude oil exploitation from 1958-2004; the country would be $32 billion richer. This is without the estimation of the multiplier effect of reinvesting thesemonies. The research further reveals that the country requires another Liquefied Natural Gas (LNG) plant 1.4 times thecapacity of the Bonny LNG plant to totally processthese associated gases for onward utilization. In the light of theserevelations the study recommends a strategic legal framework for the formulation of an act for the operation and governance of the Nigerian Liquefied Natural Gas (NLNG) be put in place by the government as this is a major bottleneck to the development of the sector. Also in the development of strategic plans and policy guidelines for the enactment of the act, the host communities should be in full participation. This is to ensure transparency and equity which will further result in total cooperation and compliance by all stakeholders. Furthermore, the study recommends a time frame be set for routine review of the plans and policy guidelines so as to update lapses for further and future development. Keywords: Cost – Benefit Analysis, Gas flaring, Total Utilization, Non Utilization, Utilization Economic Cost

Increase and Change in the Pattern of Antibiotic Use in Serbia (2010–2019)

The aim of this study was to determine and describe trends in antibiotics utilization in Serbia over a ten-year period. Data were retrieved from publicly available annual reports (2010–2019). The results were expressed as Defined Daily Dose (DDD) per 1000 inhabitants per day (DID). All calculations were performed using the DDD values for the 2020 Anatomical Therapeutic Chemical/Defined Daily Dose (ATC/DDD) version for each year of the study, to account for the DDD changes during the study period. Antibiotics were classified using the WHO Access, Watch, Reserve (AWaRe) classification. Total utilization of antibacterials for systemic use increased from 17.25 DID in 2010 to 28.65 DID in 2019. A statistically significant increasing trend in the use of the Watch category antibiotics was observed. A tendency towards use of broad-spectrum antibiotics, apparent by a statistically significant increase in the rate of utilization of broad-spectrum macrolides, quinolones and third-generation cephalosporins vs. narrow-spectrum ones, as well as a significant increasing trend in the use of quinolones was identified. Total antibiotic utilization was found to be well above the European average. Several specific problem areas were identified, which requires further efforts to improve antibiotic prescribing. The present study provides the information needed to facilitate antibiotic stewardship in Serbia further and proposes specific interventions to optimize antibiotic use in Serbia.

Oxidation of a Mixture of Polyaromatic Hydrocarbons by a Mixed Culture of Hydrocarbon-Oxidizing Microorganisms

The possibility of biochemical oxidation of polyaromatic hydrocarbon mixtures (PAHs) by the mixed culture of hydrocarbon-oxidizing microorganisms (HOM) in a liquid medium and soil was investigated. The mixed HOM culture was represented by Pseudomonas stutzeri, Pseudomonas putida, Bacillus cereus, and Arthrobacter globiformis genera. It was shown that during HOM cultivation of the microorganisms under study in the liquid medium their number increases from 0.25·104 to 11·108 CFU/ml, which is accompanied by an increase in their oxygenase activity. All PAHs identified were subjected to oxidation from 11.3 to 100%. The results of experiments on biodegradation of PAHs under natural conditions have shown that for 60 days the total utilization of oil products in soils was on the average 65% of the initial contamination. This suggests the prospects for the use of the mixed HOM culture under study for effective biodegradation of PAHs polluting soil and waste waters.

High Offset Stems are Protective of Dislocation in High Risk Total Hip Arthroplasty

Background: Spinal stiffness has been shown to increase risk of dislocation due to impingement and instability. Increasing anteversion of the acetabular component has been suggested to prevent dislocation, but little has been discussed in terms of femoral or global offset restoration. The purpose of this study is to quantify dislocation rates after primary THA using standard versus high offset femoral components and to determine how differences in offset affect impingement-free range of motion in a stiff spine cohort using a novel impingement model. Methods: 12,365 patients undergoing THA from 2016-2018 were retrospectively reviewed to determine dislocation rates and utilization of standard versus high offset stems. For 50 consecutive patients with spinal stiffness, a CT-based computer software impingement modeling system assessed bony or prosthetic impingement during simulated range of motion. The model was run 5 times for each patient with varying offsets. Range of motion was simulated in each scenario to determine the degree at which impingement occurred. Results: There were 51 dislocations for a 0.41% dislocation rate. Total utilization of high offset stems in the entire cohort was 49%. Of those patients who sustained a dislocation, 49 (96%) utilized a standard offset stem. The impingement modeling demonstrated 5 degrees of added range of motion until impingement for every 1mm offset increase. Conclusion: In the impingement model, high offset stems facilitated greater ROM before bony impingement and resulted in lower dislocation rates. In the setting of high-risk THA due to spinal stiffness, surgeons should consider the use of high-offset stems and pay attention to offset restoration.