Applications of Light and Electron Microscopic Techniques in Liposome Research

2007 ◽  
pp. 145-153 ◽  
Author(s):  
A. Yekta Ozer
Keyword(s):  
Electron Microscopic ◽  
Microscopic Techniques

Polarity Determination in Sphalerite and Wurtzite Structures

1990 ◽  
Vol 48 (2) ◽  
pp. 500-501
Author(s):  
Stuart McKernan ◽  
C. Barry Carter
Keyword(s):  
Opposite Polarity ◽  
Single Domain ◽  
Polar Material ◽  
Electron Microscopic ◽  
Dynamical Interaction ◽  
X Ray ◽  
Polarity Determination ◽  
The Absolute ◽  
Microscopic Techniques

The determination of the absolute polarity of a polar material is often crucial to the understanding of the defects which occur in such materials. Several methods exist by which this determination may be performed. In bulk, single-domain specimens, macroscopic techniques may be used, such as the different etching behavior, using the appropriate etchant, of surfaces with opposite polarity. X-ray measurements under conditions where Friedel’s law (which means that the intensity of reflections from planes of opposite polarity are indistinguishable) breaks down can also be used to determine the absolute polarity of bulk, single-domain specimens. On the microscopic scale, and particularly where antiphase boundaries (APBs), which separate regions of opposite polarity exist, electron microscopic techniques must be employed. Two techniques are commonly practised; the first [1], involves the dynamical interaction of hoLz lines which interfere constructively or destructively with the zero order reflection, depending on the crystal polarity. The crystal polarity can therefore be directly deduced from the relative intensity of these interactions.

Techniques For The Preparation of Tissue Samples Containing Injectable Polymer Microcapsules

1985 ◽  
Vol 43 ◽  
pp. 710-711
Author(s):  
G.E. Visscher ◽  
R. L. Robison ◽  
G. J. Argentieri
Keyword(s):  
Drug Delivery ◽  
Drug Delivery Systems ◽  
Gastrocnemius Muscle ◽  
Degradation Process ◽  
Delivery Systems ◽  
Tissue Reaction ◽  
Electron Microscopic ◽  
Tissue Samples ◽  
Injectable Polymer ◽  
Microscopic Techniques

The use of various bioerodable polymers as drug delivery systems has gained considerable interest in recent years. Among some of the shapes used as delivery systems are films, rods and microcapsules. The work presented here will deal with the techniques we have utilized for the analysis of the tissue reaction to and actual biodegradation of injectable microcapsules. This work has utilized light microscopic (LM), transmission (TEM) and scanning (SEM) electron microscopic techniques. The design of our studies has utilized methodology that would; 1. best characterize the actual degradation process without artifacts introduced by fixation procedures and 2. allow for reproducible results.In our studies, the gastrocnemius muscle of the rat was chosen as the injection site. Prior to the injection of microcapsules the skin above the sites was shaved and tattooed for later recognition and recovery. 1.0 cc syringes were loaded with the desired quantity of microcapsules and the vehicle (0.5% hydroxypropylmethycellulose) drawn up. The syringes were agitated to suspend the microcapsules in the injection vehicle.

Ultrastructural Immunocytochemistry of Five Rat Pituitary Adenomas

1980 ◽  
Vol 38 ◽  
pp. 724-725
Author(s):  
D. J. McComb ◽  
N. Ryan ◽  
E. Horvath ◽  
K. Kovacs ◽  
E. Nagy ◽  
...  
Keyword(s):  
Pituitary Adenomas ◽  
Pituitary Tumors ◽  
Electron Microscopic ◽  
Electron Microscopic Immunocytochemistry ◽  
Transmission Electron ◽  
Rat Pituitary ◽  
Radiation Induced ◽  
Group 5 ◽  
Group 2 ◽  
Microscopic Techniques

Conventional light and electron microscopic techniques failed to clarify the cellular composition and derivation of spontaneous and induced, intrasellar and transplanted pituitary adenomas in rats (1). In the present work, electron microscopic immunocytochemistry was applied to evaluate five adenohypo-physial tumors using a technique described by Moriarty and Garner (2). Spontaneously occurring pituitary adenomas (group 1) were harvested from aging female Long-Evans rats. R-Amsterdam rats were treated with 2 x 1.0 mg estrone acetate (HogivaI) s.c. weekly for 6 months. Pituitary adenomas in excess of 30 mg were removed from these animals to make up the tumors of group 2. Groups 3 and 4 consisted of estrogen-induced autonomous transplan¬ted pituitary tumors MtT.WlO and MtT.F4. Group 5 was a radiation-induced transplanted autonomous pituitary tumor MtT.W5. The tumors of groups 3,4 and 5 were allowed to proliferate in host rats 6-8 weeks prior to removal for processing. Tissue was processed for transmission electron microscopy (glutaraldehyde fixation, OsO4 postfixation and epoxy resin embedding), and electron microscopic immunocytochemistry (3% paraformaldehyde fixation and Araldite embedding).

Release and Recycling of the Readily Releasable Vesicle Population in a Synapse Possessing No Reserve Population

2007 ◽  
Vol 97 (6) ◽  
pp. 4048-4057 ◽  
Author(s):  
J. H. Koenig ◽  
Kazuo Ikeda
Keyword(s):  
High Frequency ◽  
Active Zone ◽  
Neuromuscular Junctions ◽  
Recycling Rate ◽  
Spontaneous Release ◽  
Electron Microscopic ◽  
Single Action ◽  
Active Zones ◽  
Evoked Activity ◽  
Microscopic Techniques

We previously demonstrated that the tergotrochanteral muscle (TTM) of Drosophila is innervated by unique synapses that possess a small readily releasable/recycling vesicle population (active zone population), but not the larger reserve vesicle population observed at other neuromuscular junctions in this animal. Using light and electron microscopic techniques and intracellular recording from the G1 muscle fiber of the TTM, the release and recycling characteristics of the readily releasable/recycling population were observed without any possible contribution from a reserve population. Our results indicate 1) the total number of vesicles in synapses presynaptic to the G1 fiber correlates with the total number of quanta that can be released onto this fiber; 2) the number of quanta released by a single action potential onto the G1 fiber is about one half the number of morphologically “docked” vesicles in active zones onto the G1, and this ratio decreases in a partially depleted state; 3) the recycling rate at 1-Hz stimulation, a frequency that does not cause any depression, is 0.24 recycled vesicle/active zone/s; and 4) normal-appearing spontaneous release occurs from the active zone vesicle population and, unlike synapses that possess a reserve population, the frequency of this release is reduced after high-frequency evoked activity.

Effect of Bonding Pressure on Transient Liquid Phase Bonding Joint Microstructure and Properties of T91/12Cr2MoWVTiB

2010 ◽  
Vol 97-101 ◽  
pp. 107-110 ◽  
Author(s):  
Si Jie Chen ◽  
Si Jing Guo ◽  
Feng Liang
Keyword(s):  
Liquid Phase ◽  
Transient Liquid Phase ◽  
Optical Microscope ◽  
Isothermal Solidification ◽  
Transient Liquid Phase Bonding ◽  
Bonded Joints ◽  
Electron Microscopic ◽  
Bonding Pressure ◽  
Scanning Electron Microscopic ◽  
Microscopic Techniques

T91/12Cr2MoWVTiB was bonded by transient liquid phase bonding process with different pressures, one commercial FeNiCrSiB was used as the interlayer. The microstructure and components distribution of the bonded joints were examined by optical microscope and scanning electron microscopic techniques. Furthermore, the properties of the joints were also tested. The results indicate that with the increase of the pressure – from 2 MPa to 6 MPa – the microstructures and mechanical properties were improved, and more similar to those base alloys. A theoretical study also revealed that the isothermal solidification complication time can be shorter, because the maximum liquid width was reduced with the existence of pressure.

scholarly journals Self-assembled Möbius strips with controlled helicity

2020 ◽  
Vol 11 (1) ◽  
Author(s):  
Guanghui Ouyang ◽  
Lukang Ji ◽  
Yuqian Jiang ◽  
Frank Würthner ◽  
Minghua Liu
Keyword(s):  
Morphological Analysis ◽  
Molecular Level ◽  
Synthetic Methods ◽  
Complex Structures ◽  
Single Edge ◽  
Electron Microscopic ◽  
Single Side ◽  
Self Assembled ◽  
Theoretical Simulations ◽  
Microscopic Techniques

AbstractDifferent from molecular level topology, the development of supramolecular topology has been limited due to a lack of reliable synthetic methods. Here we describe a supramolecular strategy of accessing Möbius strip, a fascinating topological object featured with only a single edge and single side. Through bending and cyclization of twisted nanofibers self-assembled from chiral glutamate amphiphiles, supramolecular nano-toroids with various twist numbers were obtained. Electron microscopic techniques could clearly identify the formation of Möbius strips when twist numbers on the toroidal fibers are odd ones. Spectroscopic and morphological analysis indicates that the helicity of the Möbius strips and nano-toroids stems from the molecular chirality of glutamate molecules. Therefore, M- and P-helical Möbius strips could be formed from L- and D-amphiphiles, respectively. Our experimental results and theoretical simulations may advance the prospect of creating chiral topologically complex structures via supramolecular approach.

scholarly journals ULTRASTRUCTURE AND CALCIUM TRANSPORT IN CRUSTACEAN MUSCLE MICROSOMES

1971 ◽  
Vol 48 (1) ◽  
pp. 49-60 ◽  
Author(s):  
R. J. Baskin
Keyword(s):  
Freeze Drying ◽  
Calcium Uptake ◽  
Membrane Thickness ◽  
Electron Microscopic ◽  
Thin Sections ◽  
Crustacean Muscle ◽  
Thin Sectioning ◽  
Critical Point Drying ◽  
Freeze Etching ◽  
Microscopic Techniques

Fragmented sarcoplasmic reticulum (FSR) from crustacean muscle was examined following preparation by a variety of electron microscopic techniques. The 30–40 A particles which appeared on the outer surface of FSR vesicles following negative staining were not observed following preparation by freeze-drying, freeze-etching, thin sectioning, or critical-point drying. Crustacean FSR exhibited high values of calcium uptake and extensive nodular formation in the presence of oxalate. 80–90 A diameter membrane particles were seen in freeze-etch preparations of both intact lobster muscle and FSR vesicles. Thin sections of FSR vesicles revealed a membrane thickness of 60–70 A. The membrane appeared to be triple layered, each layer having a thickness of 20–25 A.

The development of the aleurone layer in canola (Brassica napus)

1993 ◽  
Vol 71 (9) ◽  
pp. 1193-1201 ◽  
Author(s):  
Edwin P. Groot ◽  
Lawrence A. Van Caeseele
Keyword(s):  
Image Analysis ◽  
Electron Microscope ◽  
Brassica Napus ◽  
Cell Walls ◽  
Cell Layer ◽  
Aleurone Layer ◽  
Electron Microscopic ◽  
Aleurone Cells ◽  
Mature Seeds ◽  
Microscopic Techniques

The presence of the aleurone layer in developing seeds of Brassica napus becomes apparent about 22 days after pollination when examined with light and electron microscopic techniques. Prior to aleurone differentiation, the endosperm cellularizes centripetally to form characteristic columns of cells. The pigmented cell layer of the inner integument, which is present in dark-hulled seeds of Brassica, is just external to the aleurone. The first characteristic structures that become apparent inside the aleurone are spherosomes formed by the coalescence of small oil droplets. Shortly thereafter, the cell walls of the aleurone become markedly thickened relative to the surrounding cells. The aleurone cells of mature seeds contain lipid and protein reserves but lack starch. Development of the aleurone layer occurs first near the adaxial area and proceeds until the micropylar area finally differentiates. Endosperm chloroplasts have a characteristic lens shape when viewed in section with the electron microscope. They appear to congregate around a nucleus along with a small amount of cytoplasm causing an astroid-shaped aggregation of cytoplasm in the majority of endosperm cells but only transiently in the aleurone. DNA fluorometry and image analysis showed that aleurone nuclei are triploid; therefore the aleurone layer is derived from the endosperm. Key words: aleurone layer, endosperm, seed development, ploidy, anatomy, Brassica napus.

Sign in / Sign up

Export Citation Format

Share Document