Ferromagnetic Behavior of Pd- and Pt-Based Alloys

Author(s):  
R. E. Parra ◽  
A. C. González
2020 ◽  
Vol 16 (4) ◽  
pp. 655-666
Author(s):  
Mona Rekaby

Objective: The influence of Manganese (Mn2+) and Cobalt (Co2+) ions doping on the optical and magnetic properties of ZnO nanoparticles was studied. Methods: Nanoparticle samples of type ZnO, Zn0.97Mn0.03O, Zn0.96Mn0.03Co0.01O, Zn0.95Mn0.03 Co0.02O, Zn0.93Mn0.03Co0.04O, and Zn0.91Mn0.03Co0.06O were synthesized using the wet chemical coprecipitation method. Results: X-ray powder diffraction (XRD) patterns revealed that the prepared samples exhibited a single phase of hexagonal wurtzite structure without any existence of secondary phases. Transmission electron microscope (TEM) images clarified that Co doping at high concentrations has the ability to alter the morphologies of the samples from spherical shaped nanoparticles (NPS) to nanorods (NRs) shaped particles. The different vibrational modes of the prepared samples were analyzed through Fourier transform infrared (FTIR) measurements. The optical characteristics and structural defects of the samples were studied through Photoluminescence (PL) spectroscopy. PL results clarified that Mn2+ and Co2+ doping quenched the recombination of electron-hole pairs and enhanced the number of point defects relative to the undoped ZnO sample. Magnetic measurements were carried out at room temperature using a vibrating sample magnetometer (VSM). (Mn, Co) co-doped ZnO samples exhibited a ferromagnetic behavior coupled with paramagnetic and weak diamagnetic contributions. Conclusion: Mn2+ and Co2+ doping enhanced the room temperature Ferromagnetic (RTFM) behavior of ZnO. In addition, the signature for antiferromagnetic ordering between the Co ions was revealed. Moreover, a strong correlation between the magnetic and optical behavior of the (Mn, Co) co-doped ZnO was analyzed.


2009 ◽  
Vol 1199 ◽  
Author(s):  
Ricardo Martinez ◽  
Ashok Kumar ◽  
Ratnakar Palai ◽  
Ram S. Katiyar

AbstractAsymmetric superlattices (SLs) with ferromagnetic La0.7Sr0.3MnO3 (LSMO) and ferroelectric Ba0.7Sr0.3TiO3 (BST) as constitutive layers were fabricated on conducting LaNiO3 (LNO) coated (001) oriented MgO substrates using pulsed laser deposition (PLD). The crystallinity, ferroelectric and magnetic properties of the SLs were studied over a wide range of temperatures and frequencies. The structure exhibited ferromagnetic behavior at 300K, and ferroelectric behavior over a range of temperatures between 100K and 300K. The dielectric response as a function of frequency obeys normal behavior below 300 K, whereas it follows Maxwell–Wagner model at elevated temperatures. The effect of ferromagnetic LSMO layers on ferroelectric properties of the SL indicated strong influence of the interfaces. The asymmetric behavior of ferroelectric loop and the capacitance-voltage relationship suggest development of a built field in the SLs due to high strain across the interfaces.


2016 ◽  
Vol 34 (4) ◽  
pp. 905-915 ◽  
Author(s):  
M. Rahmoune ◽  
A. Chahed ◽  
A. Amar ◽  
H. Rozale ◽  
A. Lakdja ◽  
...  

AbstractIn this work, first-principles calculations of the structural, electronic and magnetic properties of Heusler alloys CoMnYAl, CoMnYGa and CoMnYIn are presented. The full potential linearized augmented plane waves (FP-LAPW) method based on the density functional theory (DFT) has been applied. The structural results showed that CoMnYZ (Z = Al, Ga, In) compounds in the stable structure of type 1+FM were true half-metallic (HM) ferromagnets. The minority (half-metallic) band gaps were found to be 0.51 (0.158), 0.59 (0.294), and 0.54 (0.195) eV for Z = Al, Ga, and In, respectively. The characteristics of energy bands and origin of minority band gaps were also studied. In addition, the effect of volumetric and tetragonal strain on HM character was studied. We also investigated the structural, electronic and magnetic properties of the doped Heusler alloys CoMnYGa1−xAlx, CoMnYAl1−xInx and CoMnYGa1−xInx (x = 0, 0.25, 0.5, 0.75, 1). The composition dependence of the lattice parameters obeys Vegard’s law. All alloy compositions exhibit HM ferromagnetic behavior with a high Curie temperature (TC).


2020 ◽  
Vol 15 (1) ◽  
Author(s):  
Chih-Yung Yang ◽  
Shu-Meng Yang ◽  
Yu-Yang Chen ◽  
Kuo-Chang Lu

Abstract In this study, self-catalyzed β-FeSi2 nanowires, having been wanted but seldom achieved in a furnace, were synthesized via chemical vapor deposition method where the fabrication of β-FeSi2 nanowires occurred on Si (100) substrates through the decomposition of the single-source precursor of anhydrous FeCl3 powders at 750–950 °C. We carefully varied temperatures, duration time, and the flow rates of carrier gases to control and investigate the growth of the nanowires. The morphology of the β-FeSi2 nanowires was observed with scanning electron microscopy (SEM), while the structure of them was analyzed with X-ray diffraction (XRD) and transmission electron microscopy (TEM). The growth mechanism has been proposed and the physical properties of the iron disilicide nanowires were measured as well. In terms of the magnetization of β-FeSi2, nanowires were found to be different from bulk and thin film; additionally, longer β-FeSi2 nanowires possessed better magnetic properties, showing the room-temperature ferromagnetic behavior. Field emission measurements demonstrate that β-FeSi2 nanowires can be applied in field emitters.


2014 ◽  
Vol 28 (06) ◽  
pp. 1450045 ◽  
Author(s):  
Arbab Mohammad Toufiq ◽  
Fengping Wang ◽  
Qurat-ul-Ain Javed ◽  
Yan Li

In this paper, single crystalline 1D tetragonal MnO 2 pen-type nanorods were synthesized by varying the dwell time through a facile hydrothermal route at a reaction temperature of 250°C. X-ray diffraction (XRD) and transmission electron microscopy (TEM) studies showed that the diameter of MnO 2 nanorods decreases from 460 nm to 250 nm with the increase in hydrothermal reaction time from 5 h to 15 h. Field-emission scanning electron microscopy (FESEM) and TEM studies revealed the evolution of improved surface morphology of MnO 2 nanorods that are prepared with longer hydrothermal reaction time. The magnetic properties of the products were evaluated using vibrating sample magnetometer (VSM) at room temperature, which showed that the as-prepared samples exhibit weak ferromagnetic behavior. The effect of diameter on the magnetization values was observed and discussed in detail.


2021 ◽  
Vol 317 ◽  
pp. 119-124
Author(s):  
Sabiu Said Abdullahi ◽  
Garba Shehu Musa Galadanci ◽  
Norlaily Mohd Saiden ◽  
Josephine Ying Chyi Liew

The emergence of Dilute Magnetic Semiconductors (DMS) with a potentials for spintronic application have attracted much researches attention, special consideration has been given to ZnO semiconductor material due to its wide band gap of 3.37 eV, large exciting binding energy of 60 meV, moreover, its ferromagnetic behavior at room temperature when doped with transition metals. MxZn1-xO (M = Fe or Ni) nanoparticles were synthesized by microwave assisted synthesis method calcined at 600°C. The structural, morphological and magnetic properties of these nanoparticles were studied using X-ray Diffraction (XRD), Field Emission Scanning Electron Microscopy (FESEM) and Vibrating Sample Magnetometer (VSM) respectively. Single phase Wurtzite hexagonal crystal structure was observed for the undoped and Fe doped ZnO nanoparticles with no any impurity, whereas Ni doped ZnO nanoparticles shows the formation of NiO impurities. The magnetic measurement reveals a diamagnetic behavior for the undoped ZnO meanwhile a clear room temperature ferromagnetism was observed for both Fe and Ni doped ZnO. Fe doped ZnO present a high saturation magnetization compared to Ni doped ZnO. However, Ni doped ZnO present high coercivity. The research was confirmed that Fe doped ZnO material will be good material combination for spintronic applications.


2018 ◽  
Vol 16 (0) ◽  
pp. 406-410
Author(s):  
Taisei Ide ◽  
Koki Fujiwara ◽  
Tatsuya Hashimoto ◽  
Kouhei Kanda ◽  
Daiki Aihara ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document