Edge Water Production Mechanism and Water Control Measures for Fracture-Porous Carbonate Gas Field

Author(s):  
Ming Li ◽  
Peng-Yu Chen ◽  
Chun-Qiu Guo ◽  
Hong-Jun Wang
2012 ◽  
Vol 616-618 ◽  
pp. 870-876
Author(s):  
Zong Yu Li ◽  
Ai Zhang ◽  
Shi Sheng Xu ◽  
Yun Feng He

This paper takes Yakela-dalaoba edge water and the Luntai basal water condensate gas reservoir for example, analyzes the condensate gas reservoir of edge-water or basal-water production characteristics, water production law in development process, and summarizes the three kinds of type water production of condensate gas reservoir, and put forward water control countermeasures specific to different water production type. Set up four edge-water or basal-water breakthrough models of gas condensate wells and the corresponding control measures, and being applied to the water control of Ya-Da gas condensate wells water gradually and the control effect is remarkable. Through the research of water production law and control countermeasures in Ya-Da condensate gas reservoir, provide significant development guidance for the other condensate gas reservoir which contains water.


2010 ◽  
Vol 50 (1) ◽  
pp. 567 ◽  
Author(s):  
Minou Rabiei ◽  
Ritu Gupta ◽  
Yaw Peng Cheong ◽  
Gerardo A. Sanchez Soto

Despite the advances in water shutoff technologies, the lack of an efficient diagnostic technique to identify excess water production mechanisms in oil wells is preventing these technologies being applied to deliver the desired results, which costs oil companies a lot of time and money. This paper presents a novel integrated approach for diagnosing water production mechanisms by extracting hidden predictive information from water-oil ratio (WOR) graphs and integrating it with static reservoir parameters. Two common types of excess water production mechanism (coning and channelling) were simulated where a wide range of cases were generated by varying a number of reservoir parameters. Plots of WOR against oil recovery factor were used to extract the key features of the WOR data. Tree-based ensemble classifiers were then applied to integrate these features with the reservoir parameters and build classification models for predicting the water production mechanism. Our results show high rates of prediction accuracy for the range of WOR variables and reservoir parameters explored, which demonstrate the efficiency of the proposed ensemble classifiers. Proactive water control procedures based on proper diagnosis obtained by the proposed technique would greatly optimise oil productivity and reduce the environmental impacts of the unwanted water.


1991 ◽  
Vol 23 (1-3) ◽  
pp. 85-91 ◽  
Author(s):  
Ho Kin-chung

The water quality in the 12 priority watercourses of Hong Kong was appraised in respect of the various environmental control measures being undertaken. It was noted that water quality in Lam Tsuen River had been significantly improved since 1983. This is attributed to recent resumption of unsewered lands for town development, training of river basin to increase flow, and declaration of the catchment as a “Water Control Zone” under the Water Pollution Control Ordinance. In contrast with the other heavily polluted watercourses to which little abatement measures were implemented, the water qualities of Shing Mun River and Tuen Mun River were slightly upgraded because of the efforts to rectify unauthorized industrial discharges back to foul sewer and provision of interceptors and sewers to villages. The 10 year Livestock Waste Control Scheme enforced on 24 June 1989 was found in parallel with BOD and suspended solids decrease in watercourses. To assess its effectiveness, however, a longer term monitoring is required to get a conclusive result.


2012 ◽  
Vol 17 (5) ◽  
pp. 604-614 ◽  
Author(s):  
Allen P. Davis ◽  
Robert G. Traver ◽  
William F. Hunt ◽  
Ryan Lee ◽  
Robert A. Brown ◽  
...  

2006 ◽  
Vol 72 (4) ◽  
pp. 2428-2438 ◽  
Author(s):  
Vincent Thomas ◽  
Katia Herrera-Rimann ◽  
Dominique S. Blanc ◽  
Gilbert Greub

ABSTRACT Free-living amoebae (FLA) are ubiquitous organisms that have been isolated from various domestic water systems, such as cooling towers and hospital water networks. In addition to their own pathogenicity, FLA can also act as Trojan horses and be naturally infected with amoeba-resisting bacteria (ARB) that may be involved in human infections, such as pneumonia. We investigated the biodiversity of bacteria and their amoebal hosts in a hospital water network. Using amoebal enrichment on nonnutrient agar, we isolated 15 protist strains from 200 (7.5%) samples. One thermotolerant Hartmannella vermiformis isolate harbored both Legionella pneumophila and Bradyrhizobium japonicum. By using amoebal coculture with axenic Acanthamoeba castellanii as the cellular background, we recovered at least one ARB from 45.5% of the samples. Four new ARB isolates were recovered by culture, and one of these isolates was widely present in the water network. Alphaproteobacteria (such as Rhodoplanes, Methylobacterium, Bradyrhizobium, Afipia, and Bosea) were recovered from 30.5% of the samples, mycobacteria (Mycobacterium gordonae, Mycobacterium kansasii, and Mycobacterium xenopi) were recovered from 20.5% of the samples, and Gammaproteobacteria (Legionella) were recovered from 5.5% of the samples. No Chlamydia or Chlamydia-like organisms were recovered by amoebal coculture or detected by PCR. The observed strong association between the presence of amoebae and the presence of Legionella (P < 0.001) and mycobacteria (P = 0.009) further suggests that FLA are a reservoir for these ARB and underlines the importance of considering amoebae when water control measures are designed.


SPE Journal ◽  
2020 ◽  
pp. 1-15
Author(s):  
Gang Li ◽  
Lifeng Chen ◽  
Meilong Fu ◽  
Lei Wang ◽  
Yadong Chen ◽  
...  

Summary Horizontal wells that are completed with slotted liners often suffer from a severe water-production problem, which is detrimental to oil recovery. It is because the annulus between the slotted liners and wellbore cannot be fully filled with common hydrogels with poor thixotropy, which determines the ultimate hydrogel filling shape in the annulus. This paper presents a novel hydrogel with high thixotropy to effectively control water production in horizontal wells. This study is aimed at evaluating the thixotropic performance, gelation time, plugging performance, and degradation performance. The thixotropic performance of the new hydrogel was also investigated by measuring its rheological properties and examining its microstructures. It was found that the new hydrogel thickened rapidly after shearing. Its thixotropic recovery coefficient was 1.747, which was much higher than those of traditional hydrogels. The gelation time can be controlled in the range of 2 to 8 hours by properly adjusting the concentrations of the framework material, crosslinker, and initiator. The hydrogel could be customized for mature oil reservoirs, at which it was stable for more than 90 days. A series of laboratory physical modeling tests showed that the breakthrough pressure gradient and the plugging ratio of the hydrogel in sandpacks were higher than 9.5 MPa/m and 99%, respectively. At the same time, it was found that the hydrogel has good degradation properties; the viscosity of the hydrogel breaking solution was 4.22 mPa·s. Freeze-etching scanning-electron-microscopy examinations indicated that the hydrogel had a uniform grid structure, which can be broken easily by shear and restored quickly. This led to the remarkable thixotropic performance. The formation of a metastable structure caused by the electrostatic interaction and coordination effect was considered to be the primary reason for the high thixotropy. The successful development of the new thixotropic hydrogel not only helps to control water production from the horizontal wells, but also furthers the thixotropic theory of hydrogel. This study also provides technical guidelines for further increasing the thixotropies of drilling fluids, fracturing fluids, and other enhanced-oil-recovery polymers that are commonly used in the petroleum industry.


2012 ◽  
Vol 594-597 ◽  
pp. 2590-2597
Author(s):  
Liang Zhang ◽  
Yi Zuo Shi ◽  
Chang Hui Yan ◽  
Xiao Xiong Wu ◽  
Pan Zhao ◽  
...  

In block one of Tahe oil field, the Triassic Lower Oil Formation sand with a low-amplitude anticline has a characteristic of bottom water reservoir and a uniform oil/water contact, bottom water is energetic, natural water drive, rock and fluid depletion drive. With the continuous development, oilfield has entered high water cut stage, bottom water coning is significant, oil well has rising of the water content and production decline. Summarized influencing factors of water production and water production mode in block one of Tahe oil field. According to water production factors of oil well, we draw four kinds of water production mode: water production mode of tectonic position, water production mode of poor fault-sealing prediction, water production mode of developed into inter-layers, water production mode of high specific inflow segments. Putting forward four kinds of water production mode provide a theoretical basis to control measures for high yield water of later oil well.


2012 ◽  
Vol 616-618 ◽  
pp. 844-849
Author(s):  
Gang Du ◽  
Mei Peng Ren ◽  
Yang Fei Yu ◽  
Xiang Fang Li ◽  
Ya Qi Zhang ◽  
...  

In order to reduce the chance of wellflow and prevent well blowout accident that gets out of control in Xinjiang oilfield, considering the statistical data of the factors that influence the drilling blowout, a model of evaluating drilling blowout risk to Xinjiang oilfield drilling and geological environment based on fuzzy mathematics is established. The drilling blowout risk of each oilfield area in Xinjiang oilfield area has been ranked, and the result indicates that both the nanyuan piedmont tectonic exploratory development area and the kelameili gas field are the highest drilling blowout risk areas. This paper suggests that the well control ranking management should be implemented in the Xinjiang Oilfield. Various well control measures should be made according to different drilling blowout risk, and the risk ranking of drilling blowout should be included in well control design.


2021 ◽  
Vol 5 (1) ◽  
pp. 1-12
Author(s):  
Shabibi M

Excess water production is one of the limiting factors in oil recycling, which reduces production efficiency and leaves a lot of costs. In this paper, water control methods were investigated in order to find the best way to control excess water production. For this propos first, a real model was made using the history match of one of Iran's oil fields that produced excess water because of canalization and different simulation scenarios for gel treatment have been investigated. In the study of more scenarios, comparing the water production in the early times and later injecting the gel, the percentage of water production for injection in the early times has been further reduced. When the gel is injected for a fixed period of 6 months in the production and injection wells The best results for lowering the rate of production water are obtained when the gel is injected simultaneously into the injection and production well, which reduces the water production rate by 12,000 barrels, and the best oil production efficiency for when simultaneous injection is performed in the production and injection well. The best treatment method is injection of high concentration gel in the early stages of water production and it's better to inject gel in deeper wells.


Sign in / Sign up

Export Citation Format

Share Document