Energy Recovery from Wood Pellets and Waste Mulching Film with Minimization of Harmful Byproducts via Thermochemical Conversion with CO2 Agent

2021 ◽  
pp. 131459
Author(s):  
Chanyeong Park ◽  
Seonho Lee ◽  
Jechan Lee
Fuel ◽  
2020 ◽  
Vol 279 ◽  
pp. 118536 ◽  
Author(s):  
Leonel J.R. Nunes ◽  
Liliana M.E.F. Loureiro ◽  
Letícia C.R. Sá ◽  
Hugo F.C. Silva

2017 ◽  
Vol 28 (5-6) ◽  
pp. 598-607 ◽  
Author(s):  
Hafiz Sana ◽  
Sumaira Kanwal ◽  
Javaid Akhtar ◽  
Naseer Sheikh ◽  
Shahid Munir

The use of high-sulfur Pakistani coals can cause serious problems of slagging and fouling in thermochemical conversion reactors along with environmental issues like acid rain, etc. In this study, a pre-combustion technique, namely heavy media separation, is employed for the cleaning of low-grade Pakistani coal. Six crushed coal samples of different particle sizes were individually subjected to heavy media solutions of ZnCl2 of different specific gravities. It was found that the sample with a particle size of −6.25+4 mm at specific gravity of 1.4 produced the optimum float product as clean coal, showing 83.53% yield of clean coal with 1.24% ash and 1.0% sulfur contents. An overall reduction of 91.68% in ash and 86.11% sulfur contents was obtained. Moreover, up to 19.3% enhancement of gross calorific value was achieved. The resultant clean coal can be used in various energy recovery schemes in Pakistan such as coal-fired power plants and cement industries.


2020 ◽  
Vol 10 (13) ◽  
pp. 4601
Author(s):  
Manuel Jesús Hermoso-Orzáez ◽  
Roberta Mota-Panizio ◽  
Luis Carmo-Calado ◽  
Paulo Brito

The recovery of urban waste is a social demand and a measure of the energy-environmental sustainability of cities and regions. In particular, waste of electrical origin, waste of electrical and electronic materials (WEEE) can be recovered with great success. The plastic fraction of these wastes allows their gasification mixed with biomass, and the results allow for producing syngas with a higher energy potential. This work allows for obtaining energy from the recovery of obsolete materials through thermochemical conversion processes of the plastic waste from the disassembly of the luminaires by mixing the said plastic waste in different proportions with the biomass of crop residues (olive). The gasification tests of these mixtures were carried out in a downstream fixed-bed drown daft reactor, at temperatures of approximately 800 °C. The results demonstrate the applied technical and economic feasibility of the technology by thermal gasification, for the production of LHV (Low Heating Value) syngas with highest power energy (more than 5 MJ/m3) produced in mixtures of up to 20% of plastic waste. This study was complemented with the economic-financial analysis. This research can be used as a case study for the energy recovery through gasification processes of plastic waste from luminaires (WEEE), mixed with agricultural biomass that is planned to be carried out on a large scale in the Alentejo (Portugal), as a solution applied in circular economy strategies.


Author(s):  
Laleet Jawale ◽  
N. L. Panwar ◽  
B. L. Salvi ◽  
Sudhir Jain ◽  
Deepak Sharma ◽  
...  

Fossilfuel requirement is the necessity for fulfilling the global energy needs, which is increasing day by day due to this it will drain in future. Bio-energy became as one of the vital alternatives to replace fossil fuel. Thermochemical conversion of biomass for obtaining the bioenergy is getting more popular in the recent time. In the present study, slow pyrolysis is used for bio-energy production from the waste biomass available in the form of crop residues of Groundnut Shell (GS), Chana Straw (CS) and Wheat Straw (WS) using the developed continuous biochar production system (Pratap Kiln) to produce biochar. An energy recovery system consisting of cooling chamber was developed to recover the bio-oil from the waste flue gas (syngas). The pyrolysis of selected biomass was carried out at 450°C and residence time of about 4 min. The yield of biochar and bio-oil and syngas properties were determined. The maximum biochar yield was found in CS feedstock as 35% followed by WS and GS, i.e. 33% and 29%, respectively. The bio-oil recovery in GS, CS and WS was 31%, 26% and 30% respectively, whereas the syngas production was 40%, 39% and 37% respectively.


Recycling ◽  
2020 ◽  
Vol 5 (2) ◽  
pp. 12 ◽  
Author(s):  
Leonel J. R. Nunes ◽  
Liliana M. E. F. Loureiro ◽  
Letícia C. R. Sá ◽  
Hugo F.C. Silva

The demand for new sources of energy is one of the main quests for humans. At the same time, there is a growing need to eliminate or recover a set of industrial or agroforestry waste sources. In this context, several options may be of interest, especially given the amounts produced and environmental impacts caused. Olive pomace can be considered one of these options. Portugal, as one of the most prominent producers of olive oil, therefore, also faces the problem of dealing with the waste of the olive oil industry. Olive pomace energy recovery is a subject referenced in many different studies and reports since long ago. However, traditional forms of recovery, such as direct combustion, did not prove to be the best solution, mainly due to its fuel properties and other characteristics, which cause difficulties in its storage and transportation as well. Torrefaction and pyrolysis can contribute to a volume reduction, optimizing storage and transportation. In this preliminary study, were carried out torrefaction and pyrolysis tests on olive pomace samples, processed at 300 °C, 400 °C, and 500 °C, followed by laboratory characterization of the materials. It was verified an improvement in the energy content of the materials, demonstrating that there is potential for the use of these thermochemical conversion technologies for the energy recovery of olive pomace.


2021 ◽  
Vol 9 (6) ◽  
pp. 106362
Author(s):  
Nahyeon Lee ◽  
Junghee Joo ◽  
Kun-Yi Andrew Lin ◽  
Jechan Lee

Fire ◽  
2021 ◽  
Vol 4 (3) ◽  
pp. 33
Author(s):  
Leonel J. R. Nunes ◽  
Mauro A. M. Raposo ◽  
Catarina I. R. Meireles ◽  
Carlos J. Pinto Gomes ◽  
Nuno M. C. Almeida Ribeiro

The accumulation of biomass fuels resulting from the growth of heliophilous shrubs and small tree species at the edge of forests and on scrub and pasture lands contributes to the increased risk of rural fires in Mediterranean climate regions. This situation has been managed with a set of legislative measures launched with the objective of promoting cleaning and the control of these species. Areas of scrub and pasture already constitute the largest part of the annually burnt area in Portugal, resulting in high-intensity fires. In the present study, shrubs and small tree species were characterized in the laboratory. Thermogravimetric, chemical and calorimetric analyses for the evaluation of the potential for the energy recovery of the selected species were carried out. It was observed that energetic valorization (i.e., to enhance the value by planned actions) of these species is difficult because they present high levels of ash and metals, becoming prone to the occurrence of fouling and slagging phenomena. Thus, the creation of value chains that justify the incorporation of these materials becomes very difficult, except if used in non-certified, small-scale and locally based processes. The possibility of recovery through thermochemical conversion processes, such as torrefaction, pyrolysis or gasification, must be studied so that more efficient and feasible recovery alternatives can be found, allowing for the creation of value chains for these residual materials to promote their sustainable management and, thus, mitigate the risk of rural fires occurring.


2019 ◽  
Vol 23 (6) ◽  
pp. 17-21 ◽  
Author(s):  
O.V. Marchenko ◽  
S.V. Solomin ◽  
A.N. Kozlov

This paper is devoted to the selection and justification the development directions of technology for the effective use of wood waste by their thermochemical conversion as part of gas-generating power plants with improved environmental characteristics. A comparison was made of the electric energy cost obtained by the use of various types of fuel (gas, diesel fuel, coal, wood chips and wood pellets). An economic comparison of single- and multi-stage gasification of woody biomass has been performed. It is shown that a more promising technology for processing biomass is three-stage gasification due to higher process efficiency. The features of the experimental gas-generating unit under development with three-stage gasification of woody biomass, which allows producing a generator gas with a minimum amount of tar, are considered.


Sign in / Sign up

Export Citation Format

Share Document