scholarly journals Impact of metallic potassium post-deposition treatment on epitaxial Cu(In,Ga)Se2

2021 ◽  
pp. 139002
Author(s):  
Evandro Martin Lanzoni ◽  
Omar Ramírez ◽  
Himanshu Phirke ◽  
Amala Elizabeth ◽  
Harry Mönig ◽  
...  
Keyword(s):  
Post Deposition ◽  
Metallic Potassium

scholarly journals Impact of Surface Treatments and Post-Deposition Annealing Upon Interfacial Property of ALD-Al₂O₃ on a-Plane GaN

2020 ◽  
Vol 8 ◽  
pp. 970-975 ◽  
Author(s):  
Yanni Zhang ◽  
Jincheng Zhang ◽  
Zhuangzhuang Hu ◽  
Zhaoqing Feng ◽  
Hepeng Zhang ◽  
...  
Keyword(s):  
Surface Treatments ◽  
Interfacial Property ◽  
Post Deposition Annealing ◽  
Post Deposition

scholarly journals Control of Structural and Magnetic Properties of Polycrystalline Co2FeGe Films via Deposition and Annealing Temperatures

Nanomaterials ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 1229
Author(s):  
Andrii Vovk ◽  
Sergey A. Bunyaev ◽  
Pavel Štrichovanec ◽  
Nikolay R. Vovk ◽  
Bogdan Postolnyi ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
Spin Transfer Torque ◽  
Spin Transfer ◽  
Post Deposition Annealing ◽  
Structure Variation ◽  
Annealing Temperatures ◽  
Damping Parameter ◽  
Soft Ferromagnetic ◽  
Thin Polycrystalline ◽  
Post Deposition

Thin polycrystalline Co2FeGe films with composition close to stoichiometry have been fabricated using magnetron co-sputtering technique. Effects of substrate temperature (TS) and post-deposition annealing (Ta) on structure, static and dynamic magnetic properties were systematically studied. It is shown that elevated TS (Ta) promote formation of ordered L21 crystal structure. Variation of TS (Ta) allow modification of magnetic properties in a broad range. Saturation magnetization ~920 emu/cm3 and low magnetization damping parameter α ~ 0.004 were achieved for TS = 573 K. This in combination with soft ferromagnetic properties (coercivity below 6 Oe) makes the films attractive candidates for spin-transfer torque and magnonic devices.

scholarly journals Two-dimensional or passivation treatment: the effect of Hexylammonium post deposition treatment on 3D halide perovskite-based solar cells

2021 ◽  
Author(s):  
Stav Rahmany ◽  
Lioz Etgar
Keyword(s):  
Solar Cells ◽  
Power Conversion Efficiency ◽  
Conversion Efficiency ◽  
Power Conversion ◽  
Perovskite Solar Cells ◽  
Two Dimensional ◽  
Theoretical Limit ◽  
Halide Perovskite ◽  
Passivation Treatment ◽  
Post Deposition

Much effort has been made to push the power conversion efficiency of perovskite solar cells (PSCs) towards the theoretical limit. Recent studies have shown that post deposition treatment of barrier...

Properties of Sputter Deposited ZnO Films Co-doped with Lithium and Phosphorus

2013 ◽  
Vol 1494 ◽  
pp. 77-82
Author(s):  
T. N. Oder ◽  
A. Smith ◽  
M. Freeman ◽  
M. McMaster ◽  
B. Cai ◽  
...  
Keyword(s):  
Rf Magnetron Sputtering ◽  
Zno Films ◽  
X Ray Diffraction ◽  
X Ray ◽  
Sapphire Substrates ◽  
Hall Effect Measurements ◽  
Sputter Deposited ◽  
P Type ◽  
Post Deposition ◽  
Co Doped

ABSTRACTThin films of ZnO co-doped with lithium and phosphorus were deposited on sapphire substrates by RF magnetron sputtering. The films were sequentially deposited from ultra pure ZnO and Li3PO4 solid targets. Post deposition annealing was carried using a rapid thermal processor in O2 and N2 at temperatures ranging from 500 °C to 1000 °C for 3 min. Analyses performed using low temperature photoluminescence spectroscopy measurements reveal luminescence peaks at 3.359, 3.306, 3.245 eV for the co-doped samples. The x-ray diffraction 2θ-scans for all the films showed a single peak at about 34.4° with full width at half maximum of about 0.17°. Hall Effect measurements revealed conductivities that change from p-type to n-type over time.

Characterization of the order-annealing response of nanostructured iron-palladium based ferromagnetic thin-films

2001 ◽  
Vol 703 ◽  
Author(s):  
Huiping Xu ◽  
Adam T. Wise ◽  
Timothy J. Klemmer ◽  
Jörg M. K. Wiezorek
Keyword(s):  
Thin Films ◽  
Grain Growth ◽  
Room Temperature ◽  
Si Substrate ◽  
Ferromagnetic Thin Films ◽  
Precipitation Reactions ◽  
Post Deposition ◽  
Xrd And Tem ◽  
Iron Palladium

ABSTRACTA combination of XRD and TEM techniques have been used to characterize the response of room temperature magnetron sputtered Fe-Pd thin films on Si-susbtrates to post-deposition order-annealing at temperatures between 400-500°C. Deposition produced the disordered Fe-Pd phase with (111)-twinned grains approximately 18nm in size. Ordering occurred for annealing at 450°C and 500°C after 1.8ks, accompanied by grain growth (40-70nm). The ordered FePd grains contained (111)-twins rather than {101}-twins typical of bulk ordered FePd. The metallic overlayers and underlayers selected here produced detrimental dissolution (Pt into Fe-Pd phases) and precipitation reactions between Pd and the Si substrate.

Sign in / Sign up

Export Citation Format

Share Document