Global climate change is one of the major threats facing the world today and can be due to increased atmospheric concentrations of greenhouse gases (GHGs), such as carbon dioxide (CO2). There is also an immediate need to reduce CO2 emissions, and one of the potential solutions for reducing CO2 emissions is carbon capture and storage (CCS). This work investigated the performance assessment of kaolinite and activated carbon (AC) adsorbent for CO2 capture. In particular, the effect of operating parameters such as temperature, bed height, inlet gas flow rate etc. on CO2 adsorption behaviour of the adsorbents was also investigated. Extensive research on the development of adsorbents that can adsorb large amounts of CO2 with low energy consumption has recently been carried out. In CO2 adsorption technology, the challenge is to develop an adsorbent that is not only non-toxic, eco-friendly, and cost-effective, but also has the potential to extract CO2 gas from a mixed gas stream selectively and effectively. Due to the possibility of a potential adsorbent due to its low cost, rich natural abundance and high mechanical and chemical stability, this study proposes kaolinite. As the presence of clay minerals in soils serves as a pollutant collector to enhance the atmosphere, kaolinite has the potential to be an efficient adsorbent for CO2 capture. Kaolinite was investigated as an adsorbent in this research to confirm if it is suitable for CO2 capture. Kaolinite/activated carbon composite adsorbents were synthesized. Sugarcane bagasse was used in preparing the activated carbon (AC). ZnCl2 was impregnated onto sugarcane bagasse during the preparation of activated carbon (AC) to improve the physical properties (surface area, pore size and pore volume) and the CO2 adsorption capacity of the activated carbon (AC) adsorbent developed. The materials were characterized and tested for CO2 adsorption (activated carbon and kaolinite). BET, FTIR and SEM studies were used to classify the adsorbents for their surface area and pore properties, functional groups, and surface morphology, respectively. BET analysis was conducted and the pore volume, pore size and surface area of the adsorbent materials were reported. Functional groups were actively present in the adsorption process. This was verified using FTIR spectroscopy. The kaolinite adsorbent was not feasible for CO2 capture. BET, SEM, and custom-built CO2 adsorption equipment have confirmed this. In contrast to literature, the CO2 adsorption capacity of kaolinite was low. This is due to the fact that kaolinite used in this study is not suitable as adsorbent for CO2 capture as they exhibited a low CO2 adsorption capacity. The results obtained in this study show that temperature, bed height and inlet gas flow rate influenced the adsorption behaviour of activated carbon (AC), kaolinite and kaolinite/activated carbon composite adsorbent during CO2 capture. At 30 0C, activated carbon (AC) exhibited an adsorption capacity of 28.97 mg CO2/g, the highest capacity among all the adsorbents tested. Kaolinite-activated carbon composite adsorbent offered CO2 adsorption capacities of 18.54 mg CO2/g. Kaolinite provides the lowest capacity of 12.98 mg CO2/g. In conclusion, this research verified that CO2 adsorption with kaolinite and activated carbon is favoured at low temperatures, low operating CO2 flowrates and high column bed height.
Water-based synthesis of zeolitic imidazolate framework-8 for CO2 capture