scholarly journals Design of an advanced hot box-cold box with full climatic control to test heat, air and moisture transport through real scale building elements

2020 ◽  
Vol 172 ◽  
pp. 19008
Author(s):  
David Daems ◽  
Antoine Tilmans ◽  
Timo De Mets ◽  
Xavier Loncour

A versatile hot box-cold box test facility called HAMSTER enables to evaluate the energy and hygrothermal performance of up to 3m high, 3m wide and 3.6m deep building test elements including walls, flat or pitched roofs and floors. This equipment allows for the precise measurement of thermal performance according to standards. It also allows for the study of heat, air and moisture phenomena taking place in building elements under realistic climatic conditions including the effects of rain, sun or wind. Interior and exterior climates are simulated in, respectively, the hot and cold chambers by controlling the temperature, relative humidity, pressure difference between both chambers, infra-red or solar simulator heating and water spraying in the cold chamber. Critical issues that have been solved during the design and construction phases in order to reach both the required performances and the versatility of the test facility are discussed.

Water ◽  
2020 ◽  
Vol 12 (6) ◽  
pp. 1538 ◽  
Author(s):  
V. A. Tzanakakis ◽  
A. N. Angelakis ◽  
N. V. Paranychianakis ◽  
Y. G. Dialynas ◽  
G. Tchobanoglous

Crete, located in the South Mediterranean Sea, is characterized by long coastal areas, varied terrain relief and geology, and great spatial and inter-annual variations in precipitation. Under average meteorological conditions, the island is water-sufficient (969 mm precipitation; theoretical water potential 3284 hm3; and total water use 610 hm3). Agriculture is by far the greatest user of water (78% of total water use), followed by domestic use (21%). Despite the high average water availability, water scarcity events commonly occur, particularly in the eastern-south part of the island, driven by local climatic conditions and seasonal or geographical mismatches between water availability and demand. Other critical issues in water management include the over-exploitation of groundwater, accounting for 93% of the water used in agriculture; low water use efficiencies in the farms; limited use of non-conventional water sources (effluent reuse); lack of modern frameworks of control and monitoring; and inadequate cooperation among stakeholders. These deficiencies impact adversely water use efficiency, deteriorate quality of water resources, increase competition for water and water pricing, and impair agriculture and environment. Moreover, the water-limited areas may display low adaptation potential to climate variability and face increased risks for the human-managed and natural ecosystems. The development of appropriate water governance frameworks that promote the development of integrated water management plans and allow concurrently flexibility to account for local differentiations in social-economic favors is urgently needed to achieve efficient water management and to improve the adaptation to the changing climatic conditions. Specific corrective actions may include use of alternative water sources (e.g., treated effluent and brackish water), implementation of efficient water use practices, re-formation of pricing policy, efficient control and monitoring, and investment in research and innovation to support the above actions. It is necessary to strengthen the links across stakeholders (e.g., farmers, enterprises, corporations, institutes, universities, agencies, and public authorities), along with an effective and updated governance framework to address the critical issues in water management, facilitate knowledge transfer, and promote the efficient use of non-conventional water resources.


2016 ◽  
Vol 10 (8) ◽  
pp. 1123-1131 ◽  
Author(s):  
Lorenzo Zeni ◽  
Vahan Gevorgian ◽  
Robb Wallen ◽  
John Bech ◽  
Poul Ejnar Sørensen ◽  
...  

2020 ◽  
Vol 33 (3) ◽  
pp. 653-659
Author(s):  
VICTORIA ROSSMARY SANTACRUZ OVIEDO ◽  
CIPRIANO RAMON ENCISO-GARAY ◽  
ERNESTO ISAAC GARCIA FIGUEREDO

ABSTRACT Strawberry plant yields improve if they accumulate a certain number of cold hours, which does not occur naturally under tropical and subtropical climatic conditions. This study evaluated the agronomic characteristics of potted transplants from 14 strawberry genotypes that had been subjected to vernalization treatment prior to planting in the field. The transplants were stored in a cold chamber at 5°C for 576 h. The genotypes used in the experiment were Camino Real, Festival, Florida Eliane, Sweet Charliefp, Sweet Charlie, Dover, IAC Guaraní, Corea, Early Bright, and hybrid clones Dover × Rosalinda1 Dover × Rosalinda4, Dover × Oso Grande, Dover × Esplendida, and Dover × Aichi. The 14 genotypes in the control group received no vernalization treatment. Each experimental unit consisted of 15 plants. A randomized complete blocks experimental design was used with a 14 × 2 factorial arrangement and three repetitions. Subjecting the strawberry transplants to the vernalization treatment had a significant effect on the total number of fruits per plant and total and commercial yield of fruits per plant, but there was no significant interaction between the factors and the evaluated yield and growth characteristics. Dover × Oso Grande, Florida Eliane, Camino Real, and Festival produced the greatest numbers of large fruits per plant. Vernalizing strawberry transplants increased the yield and the number of medium and small sized fruits per plant. The results showed that vernalization is a technique that could be used in tropical climate conditions to improve strawberry cultivation productivity.


2021 ◽  
Vol 13 (3) ◽  
pp. 1195
Author(s):  
Ravijanya Chippagiri ◽  
Hindavi R. Gavali ◽  
Rahul V. Ralegaonkar ◽  
Mike Riley ◽  
Andy Shaw ◽  
...  

Under the India “Housing for all” scheme, 20 million urban houses have to be constructed by 2022, which requires the rate of construction to be around 8000 houses/day. Previous results by the team show that present design methods for affordable buildings and structures in India need improvement. The challenges are the disposal of solid waste generated from agro-industrial activities and the energy peak demand in extremely hot and cold seasons. The development of bio-based urban infrastructure which can adapt to the climatic conditions has been proposed. Inclusion of sustainable materials such as agro-industrial by-products and insulation materials has resulted in effective environmental sustainability and climate change adaptability. Precast components are highlighted as a suitable solution for this purpose as well as to fulfil the need of mass housing. India has a lesser record in implementing this prefab technology when compared to a global view. For the first time, a novel and sustainable prefab housing solution is tested for scale-up using industrial waste of co-fired blended ash (CBA) and the results are presented here. A model house of real scale measuring 3 × 3 × 3 m3 was considered as a base case and is compared with 17 other combinations of model house with varying alignment of prefab panels. Comparison was made with commercially available fly ash brick and CBA brick with a conventional roof slab. A simulation study was conducted regarding cost and energy analysis for all the 18 cases. Various brick and panel compositions with CBA for housing were tried and the superior composition was selected. Similarly, 18 model houses of real scale were simulated, with different combinations of walls made of bricks or panels and different building orientations, to check the impact on energy peak cooling and cost. Results show that peak cooling load can be reduced by six times with bio-based prefab panels. Prefab construction can be considered for mass housing ranging above 100 housing units, each consisting of an area of 25 m2.


2021 ◽  
Vol 14 (4) ◽  
Author(s):  
Faisal Alqahtani ◽  
Mohammed Khalil

AbstractGeochemical data and their various approaches are useful to evaluate the climatic control on the depositional environments. This study aims to evaluate the paleoweathering and plaeoclimate condition that have controls on the depositional environments of the Miocene to Pliocene siliciclastic sequence at Al-Rehaili area, north of Jeddah. To achieve this aim, selected sandstone samples were geochemically (major and trace elements analysis) and petrographically examined. The results of these analyses reveal that the examined sandstones were deposited in non-marine (fluvial/alluvial-lacustrine) environments and suffered from weak to intermediate chemical weathering and intense physical induration under semi-arid to semi-humid climatic conditions.


2011 ◽  
Vol 6 (3) ◽  
Author(s):  
P. K. Sharma ◽  
T. Inoue ◽  
K. Kato ◽  
H. Ietsugu ◽  
K. Tomita ◽  
...  

A real scale hybrid constructed wetland (CW) system (656 m2), with a configuration of VFA-VFB-HF beds constructed in series is operating since November 2006 in northern Hokkaido, Japan. The system was experimented to assess its capability in purifying 4.5 m3d−1 of high strength milking parlor wastewater under colder climate. Annual mean air temperature at site was recorded as 6.4 oC (extremes vary as -22.8 oC at lowest and 30.6 oC at highest). From the monthly sampling from November 2006 to January 2010, average loading and removal rates of TSS, CODcr, BOD5, TN and TP were 5.4 g m−2 d−1 (98%), 30.3 g m−2 d−1 (88%), 11.5 g m 2 d−1 (89%), 1.2 g m−2 d−1 (76.4%) and 0.2 g m−2 d−1 (76%). System did not stop for a single day, efficiently worked even during snow covered periods and was tolerant to the load fluctuations.


2009 ◽  
Vol 7 (1) ◽  
pp. 43-55 ◽  
Author(s):  
Todor Vacev ◽  
Srdjan Kisin ◽  
Slobodan Rankovic

In the paper is presented experimental analysis of an original type of node joint for a steel space truss. The joint sample was loaded by spatial set of forces that simulate real condition of the structure with eight balanced member forces (4 chord and 4 diagonal members), up to structure failure. It was realized in a specially designed test facility. Tested node joint samples were made in real scale, according to the model originated after FE analysis and optimization. Basic idea was to construct and test a node joint that can be made in average technology conditions, without special tools and requirements. Besides, results of a stress-strain FE analysis are presented and comparison of the two analyses is given for the most critical regions of the node joint. Values of measured and calculated strains across model samples and characteristic measuring points are presented.


2018 ◽  
Vol 4 (1) ◽  
pp. 183
Author(s):  
Suriani Ngah Abdul Wahab ◽  
Md Yusof Hamid

This paper presents mould prevention strategies that should be applied in the library buildings. Library constructed in tropical climatic conditions must be moisture controlled from fungi or mould growth on any potential material. In order to identify the magnitude and the causes for mould growth, comprehensive research was carried out within three libraries in Malaysia universities. Aspergillus, Penicillium, Stachybotrys's and fungal had been identified as a common mould growth found. Thus, the growth of mould on the building elements such as walls and floors carpets, books, air conditioning parts of the surrounding library areas will be inevitable unless prevention strategies applied.  Four strategies have been identified as possible mould prevention strategies in the library building.


2003 ◽  
Vol 2 (1) ◽  
Author(s):  
A. L. Martins ◽  
A. M. F. Lourenço ◽  
P. H. Andrade Jr. ◽  
V. Silva Jr. ◽  
P. R. C. Silva ◽  
...  

This paper summarizes the results of two sets of experimental tests performed at PETROBRAS real scale test facility aiming the evaluation of solids return times in aerated fluid drilling. The effect of the following parameters was studied: liquid and gas injection rates, particle diameter and depth. Results indicate that the gas has a major effect in accelerating the liquid phase, which would be responsible for carrying the particles to the surface. The concept of effective liquid velocity coupled with an adequate procedure for particle sedimentation velocity calculation reproduced the experimental results adequately.


Sign in / Sign up

Export Citation Format

Share Document