scholarly journals Self-ignition temperature of the dust accumulations for sunflower and wood powders

2022 ◽  
Vol 354 ◽  
pp. 00012
Author(s):  
Maria Prodan ◽  
Andrei Szollosi-Moța ◽  
Vasilica Irina Nălboc ◽  
Niculina Sonia Șuvar ◽  
Adrian Jurca

Spontaneous combustion is a phenomenon that results from the heating of combustible organic powders by slow oxidation and which occurs through the air passage (created by an air depression) through the mass of dust. The oxidation phenomenon of combustible powders represents their reaction with atmospheric oxygen resulting in products of carbon dioxide, carbon oxide, water and other gases whose content depends on the temperature at which the oxidation takes place. The self-ignition of combustible dusts depends on their chemical composition, the properties of component substances, on the particle size and geometry of the material mass and, last but not least, on the temperature of the environment. Due to global worries of sustainability in construction engineering the trend is to use ecofriendly organic waste to various purposes as in construction materials. The challenge is that by using this kind of materials one should ensure the safety related to the process of such organic materials which are known to have combustible properties. The purpose of this work is to present the self-ignition behavior of combustible dusts such as sunflower and wood by means of drying tests under constant temperature conditions.

Fire Safety ◽  
2021 ◽  
Vol 38 ◽  
pp. 32-37
Author(s):  
V. Tovarianskyi ◽  
I. Adolf ◽  
V. Petrovskyi

Formulation of the problem. Most of the fabrics used in the technological processes of garment enterprises are classified as combustible materials and are part of the fire load, which threatens the outbreak and rapid spread of fires in the premises of garment factories. Therefore, it is important to study the indicators of the fire hazard of fabrics to identify the most dangerous of them, as well as to increase the efficiency of fire safety at sewing enterprises.The purpose of the work is to obtain the dependences of the values of ignition and self-ignition temperatures of cotton fabrics on the composition of cotton.Results. It was found that the crushed 100% cotton fabric flamed best, and the worst − solid polyester as a fabric without cotton. The lowest value of the temperature at which ignition was observed was 215°C for cotton (100%, shredded fabric), and if this value is reduced - there were failures, which are caused in particular by the fact that at lower temperatures flammable vapours are no formed in concentrations sufficient for combustion. It was found that the ignition / spontaneous combustion temperatures for a solid sample of the fabric with a composition of 100% cotton are 235°C/420°C, and for a solid sample of the fabric with a composition of 100% polyester − 360°C/500°C, respectively. Ignition / spontaneous com-bustion temperatures for finely divided fabrics are 8,5%/4,78% (cotton fabric) and 2.8%/6% (polyester) lower than the values obtained for whole fabrics.Results. According to the results of the analysis of the most common fabrics (table 1) used in garment enterprises. Identified that the biggest fire hazard is inherent containing cotton. The lowest ignition temperature is observed for cotton (100% shredded fabric) and is 215°C, which is 1,63 times less than the ignition temperature of polyester (0% cotton, shredded fabric). The lowest self-ignition temperature is also observed for cotton (100% shredded fabric) and is 400°C, which is 1,18 less than the self-ignition temperature of polyester (0% cotton, shredded fabric).


2017 ◽  
Vol 114 (15) ◽  
pp. E3091-E3100 ◽  
Author(s):  
Rogier Braakman ◽  
Michael J. Follows ◽  
Sallie W. Chisholm

Metabolism mediates the flow of matter and energy through the biosphere. We examined how metabolic evolution shapes ecosystems by reconstructing it in the globally abundant oceanic phytoplankterProchlorococcus. To understand what drove observed evolutionary patterns, we interpreted them in the context of its population dynamics, growth rate, and light adaptation, and the size and macromolecular and elemental composition of cells. This multilevel view suggests that, over the course of evolution, there was a steady increase inProchlorococcus’ metabolic rate and excretion of organic carbon. We derived a mathematical framework that suggests these adaptations lower the minimal subsistence nutrient concentration of cells, which results in a drawdown of nutrients in oceanic surface waters. This, in turn, increases total ecosystem biomass and promotes the coevolution of all cells in the ecosystem. Additional reconstructions suggest thatProchlorococcusand the dominant cooccurring heterotrophic bacterium SAR11 form a coevolved mutualism that maximizes their collective metabolic rate by recycling organic carbon through complementary excretion and uptake pathways. Moreover, the metabolic codependencies ofProchlorococcusand SAR11 are highly similar to those of chloroplasts and mitochondria within plant cells. These observations lead us to propose a general theory relating metabolic evolution to the self-amplification and self-organization of the biosphere. We discuss the implications of this framework for the evolution of Earth’s biogeochemical cycles and the rise of atmospheric oxygen.


2013 ◽  
Vol 634-638 ◽  
pp. 3688-3695 ◽  
Author(s):  
Yang Xiao ◽  
Shu Gang Li ◽  
Jun Deng ◽  
Xu Wang

In China, as popularizing the technology of fully mechanized top-coal mining and increasing the strength and depth of mining, the gutter-up gob can be formed. But the work of fire preventing and extinguishing for its coal spontaneous combustion is more complexity and difficulty. In this paper, based on geology parameters and mining practice for 93up12 fully mechanized top-coal caving face in Nantun coalmine, the form and character of gutter-up gob are analyzed. According to the hidden danger of high temperature for spontaneous combustion in the gob, we adopt the comprehension technologies of fire extinguishing and preventing which include sealing air-leakage, grouting, and injecting compound gel with fly-ash, foam of retarding oxidation, liquid carbon dioxide, and gas of nitrogen. By putting in practice the pre-controlling technology in gutter-up gob and monitoring data of target gases, it obtains a good effect and ensures the safety in production of the fully-mechanized top-coal caving face.


Author(s):  
Leonid Vogman ◽  
Evgeny Prostov ◽  
Dmitry Dolgikh

По предшествующей (1989 г.) и новой (2018 г.) методикам определены условия теплового самовозгорания отработанного активного угля марки СКД. Новая методика, в отличие от предшествующей, учитывает кинетику процесса, позволяет рассчитывать условия самовозгорания для различных реальных геометрических форм и размеров горючих материалов при их хранении и транспортировании. Результаты расчетов могут быть использованы при прогнозировании и для предотвращения пожаров при хранении и транспортировании твердых дисперсных горючих веществ и материалов. Например, выполненные расчеты условий теплового самовозгорания отработанного активного угля марки СКД при транспортировании в вагонах-хопперах размерами 2,64  2,112  13,37 м, смонтированных на железнодорожных платформах, по территории России (с учетом максимальной летней температуры 40 °С), показали, что самовозгорания произойти не может. Исследование условий теплового самовозгорания отработанного активного угля марки СКД проводилось в соответствии с методикой, представленной в ГОСТ 12.1.044-2018.Analysis of fire properties of active coal of various grades shows that only for two of 11 grades of active coal (AP-14 and B) there was experimentally obtained the ignition temperature and there were defined the conditions for thermal self ignition. For other 9 grades no information is available. These data are not available for active waste coal of SKD grade. The self-heating arising in coal stacks initially can be General, i.e. over the whole stack volume including the surface layer of 0,3-0,5 m thick, but in process of temperature increase the centre moves insight the embankment where heat accumulates. The temperature growth in the centre is very slow and can be preserved or even reduced, for example, when pulling coal from the stack or when it is ventilated. At the temperature values above 50-60 °C the rate of coal self-heating in the stack can increase. This temperature is called a critical temperature. The main cause of spontaneous combustion of coals in piles or stacks is their ability to oxidize and adsorb vapours and gases even at low temperatures. In this case, oxidation process is slow and little heat is released. The formation of source of coal self-ignition in piles and stacks is associated primarily with the possible contact of the combustion source with air flows as well as with favourable conditions of heat accumulation inside coal deposits. For example, as for coal there are given observations on the combustion source origin on the stack slopes mainly at the height of 0,5-1 m from the base and at the depth of 0,5 m from the surface. If the stack is heterogeneous in density and size of the pieces, the self-ignition sources can arise in other places where smaller coal fractions with the lowest density are concentrated. Heat removal from the sources of spontaneous combustion is mainly due to the size of the stack (embankment) and heat removal by air flows. In large accumulations of coal, where heat transfer to the environment is difficult, spontaneous combustion occurs. Air flows can form as a result of temperature and material density gradients, as well as of air mass movement. The tendency of coals to spontaneous combustion in stacks and embankments is different. The greater the yield of combustible gases and vapours formed during the thermal-oxidative destruction of coal, the higher the dispersion (specific surface area), the lower the density inside the material mass and the greater the moisture content and pyrite in it, the higher is this tendency. The study of the conditions of thermal spontaneous combustion of waste active coal of SKD grade was carried out in accordance with the methodology, presented in GOST 12.1.044-2018, which takes into account the kinetics of the oxidation process of the investigated substance (material). It allows to calculate the conditions of spontaneous combustion for various real geometric shapes and sizes of combustible materials during their storage and transportation. The results of experimental studies as well as calculations of kinetic parameters such as the critical temperature of self-ignition, the critical size and time of induction for waste active SKD brand carbon showed that in real conditions of storage and transportation of this substance, taking into account the upper range limit of climatic air temperature drop of 40 °C, spontaneous combustion will not occur. For example, transportation in hopper cars of railway platforms, provided that the product fills the specified in the calculations shape and size of the hopper car, is fireproof and cannot lead to spontaneous combustion in transit.


2020 ◽  
Vol 143 ◽  
pp. 01029
Author(s):  
Anna Doroshenko

Currently, artificial neural networks (ANN) are used to solve the following complex problems: pattern recognition, speech recognition, complex forecasts and others. The main applications of ANN are decision making, pattern recognition, optimization, forecasting, data analysis. This paper presents an overview of applications of ANN in construction industry, including energy efficiency and energy consumption, structural analysis, construction materials, smart city and BIM technologies, structural design and optimization, application forecasting, construction engineering and soil mechanics.


2018 ◽  
Vol 18 (13) ◽  
pp. 9283-9295 ◽  
Author(s):  
Yu Hoshina ◽  
Yasunori Tohjima ◽  
Keiichi Katsumata ◽  
Toshinobu Machida ◽  
Shin-ichiro Nakaoka

Abstract. Atmospheric oxygen (O2) and carbon dioxide (CO2) variations in the North Pacific were measured aboard a cargo ship, the New Century 2 (NC2), while it cruised between Japan and the United States between December 2015 and November 2016. A fuel cell analyzer and a nondispersive infrared analyzer were used for the measurement of O2 and CO2, respectively. To achieve parts-per-million precision for the O2 measurements, we precisely controlled the flow rates of the sample and reference air introduced into the analyzers and the outlet pressure. A relatively low airflow rate (10 cm3 min−1) was adopted to reduce the consumption rate of the reference gases. In the laboratory, the system achieved measurement precisions of 3.8 per meg for δ(O2 ∕ N2), which is commonly used to express atmospheric O2 variation, and 0.1 ppm for the CO2 mole fraction. After the in situ observation started aboard NC2, we found that the ship's motion caused false wavy variations in the O2 signal with an amplitude of more than several tens of ppm and a period of about 20 s. Although we have not resolved the problem at this stage, hourly averaging considerably suppressed the variation associated with ship motion. Comparison between the in situ observation and flask sampling of air samples aboard NC2 showed that the averaged differences (in situ–flask) and the standard deviations (±1σ) are −2.8 ± 9.4 per meg for δ(O2 ∕ N2) and −0.02 ± 0.33 ppm for the CO2 mole fraction. We compared 1 year of in situ data for atmospheric potential oxygen (APO; O2 +1.1×CO2) obtained from the broad middle-latitude region (140∘ E–130∘ W, 29∘ N–45∘ N) with previous flask sampling data from the North Pacific. This comparison showed that longitudinal differences in the seasonal amplitude of APO, ranging from 51 to 73 per meg, were smaller than the latitudinal differences.


Sign in / Sign up

Export Citation Format

Share Document