scholarly journals Factors affecting N -nitrosodimethylamine formation from poly(diallyldimethyl-ammonium chloride) degradation during chloramination

2018 ◽  
Vol 5 (8) ◽  
pp. 180025 ◽  
Author(s):  
Siying Tan ◽  
Shaojie Jiang ◽  
Xiaoyu Li ◽  
Qiuhong Yuan
Keyword(s):  
Natural Organic Matter ◽  
Orthogonal Experiment ◽  
Critical Factor ◽  
Orthogonal Experiment Design ◽  
Factors Affecting ◽  
Human Carcinogen ◽  
Ph Values ◽  
Diallyldimethylammonium Chloride ◽  
Low Concentrations ◽  
Effects Of Ph

Poly(diallyldimethylammonium chloride) (polyDADMAC) has been shown to be an important precursor of the probable human carcinogen N -nitrosodimethylamine (NDMA) when in contact with chloramine. In this study, we conducted an orthogonal experiment design to evaluate the effects of pH values, ammonia, bromide, natural organic matter (NOM) and monochloramine dosages on the formation of NDMA from polyDADMAC during chloramination. Meanwhile, single-factor experiments of pH, bromide and NOM prove the results of orthogonal experiment. The results supported that pH was the most critical factor affecting NDMA formation from polyDADMAC during chloramination, and the highest NDMA formation from polyDADMAC occurred at pH near 7 due to released DMA from polyDADMAC degradation and the critical importance of low concentrations of dichloramine in water. In the presence of excess bromide, the NDMA formation was enhanced significantly at all different pH values owing to bromochloramine, which has higher electronegativity of the brominated nitrogen atom than monochloramine or dichloramine. The NDMA formation from polyDADMAC in the presence of NOM was 41.7% lower than NDMA formation in the absence of NOM. The overwhelming majority of NDMA formation from polyDADMAC under simulated conditions was lower than the current advisory levels (i.e. 9 ng l −1 in Ontario, 10 ng l −1 in California).

scholarly journals Evaluation of influencing factors on the adaptability of ICD completion technology

2021 ◽  
Vol 261 ◽  
pp. 02071
Author(s):  
Guohui Zhang ◽  
Liangchuan Li ◽  
Rong Chen ◽  
Peng Wang ◽  
Guowen Zhang ◽  
...  
Keyword(s):  
Comprehensive Evaluation ◽  
Design Method ◽  
Orthogonal Experiment ◽  
Horizontal Wells ◽  
Water Production ◽  
Water Control ◽  
Orthogonal Experiment Design ◽  
Factors Affecting ◽  
Well Completion ◽  
Main Index

After years of research and practice, ICD well completion technology has become a relatively mature completion technology, and has been successfully applied in hundreds of horizontal Wells abroad. However, due to many factors affecting ICD effect, mature evaluation methods have not been completely established. At present, the main index of ICD water control development effect is to balance inflow profile and inhibit water production, and the evaluation factors involve reservoir, process and equipment structure. This paper summarizes the factors influencing the effects of ICD, using orthogonal experiment design method to carry on the comprehensive evaluation, and puts forward the corresponding Suggestions

PARAMETER OPTIMIZATION AND EXPERIMENTAL RESEARCH ON THE HAMMER MILL 锤片式粉碎机参数优化与试验研究

2020 ◽  
pp. 341-350
Author(s):  
Di Wang ◽  
Changbin He ◽  
Haiqing Tian ◽  
Liu Fei ◽  
Zhang Tao ◽  
...  
Keyword(s):  
Moisture Content ◽  
Orthogonal Experiment ◽  
Electricity Consumption ◽  
Spindle Speed ◽  
Hammer Mill ◽  
Factors Affecting ◽  
Evaluation Indexes ◽  
Grain Moisture ◽  
Validation Experiment ◽  
Corn Grain

Low productivity and high electricity consumption are considered problems of the hammer mill, which is widely used in current feed production. In this paper, the mechanical properties of corn grain ground by a hammer mill were analysed, and the key factors affecting the performance of the hammer mill were determined. The single-factor experiment and three-factor, three-level quadratic regression orthogonal experiment were carried out with the spindle speed, corn grain moisture content and number of hammers as experimental factors and the productivity and electricity consumption per ton as evaluation indexes. The results showed that the order of influence on the productivity was spindle speed > corn grain moisture content > number of hammers and that the order of influence on the electricity consumption per ton was corn grain moisture content > spindle speed > number of hammers. The parameters were optimized based on the response surface method with the following results: the spindle speed was 4306 r/min, the corn grain moisture content was 10%, and the number of hammers was 24. The validation experiment was carried out with the optimal parameters’ combination. The productivity and electricity consumption per ton were 988.12 kg/h and 5.37 kW·h/t, respectively, which were consistent with the predicted results of the model.

Nitrogen Removal from Anaerobically-Treated Leachate

1984 ◽  
Vol 19 (1) ◽  
pp. 87-100
Author(s):  
D. Prasad ◽  
J.G. Henry ◽  
P. Elefsiniotis
Keyword(s):  
Nitrogen Removal ◽  
Air Flow ◽  
Operating Conditions ◽  
Air Flow Rate ◽  
Flow Rates ◽  
Anaerobic Filter ◽  
Ph Values ◽  
Wide Range ◽  
Ammonia Desorption ◽  
Effects Of Ph

Abstract Laboratory studies were conducted to demonstrate the effectiveness of diffused aeration for the removal of ammonia from the effluent of an anaerobic filter treating leachate. The effects of pH, temperature and air flow on the process were studied. The coefficient of desorption of ammonia, KD for the anaerobic filter effluent (TKN 75 mg/L with NH3-N 88%) was determined at pH values of 9, 10 and 11, temperatures of 10, 15, 20, 30 and 35°C, and air flow rates of 50, 120, and 190 cm3/sec/L. Results indicated that nitrogen removal from the effluent of anaerobic filters by ammonia desorption was feasible. Removals exceeding 90% were obtained with 8 hours aeration at pH of 10, a temperature of 20°C, and an air flow rate of 190 cm3/sec/L. Ammonia desorption coefficients, KD, determined at other temperatures and air flow rates can be used to predict ammonia removals under a wide range of operating conditions.

scholarly journals Stimulation of mitochondrial calcium ion efflux by thiol-specific reagents and by thyroxine. The relationship to adenosine diphosphate retention and to mitochondrial permeability

1979 ◽  
Vol 182 (2) ◽  
pp. 455-464 ◽  
Author(s):  
E J Harris ◽  
M Al-Shaikhaly ◽  
H Baum
Keyword(s):  
Thyroid Hormones ◽  
Calcium Ion ◽  
Adenine Nucleotides ◽  
Adenosine Diphosphate ◽  
Ruthenium Red ◽  
Reduced Form ◽  
Factors Affecting ◽  
Ph Values ◽  
Rat Heart Mitochondria ◽  
The Relationship

Respiring rat heart mitochondria were loaded with Ca2+ and then treated with Ruthenium Red. The factors affecting the subsequent Ca2+-efflux were studied. Addition of rotenone or antimycin led to a decline of efflux except at pH values above 7.2, provided the load was less than about 80 nmol per mg of protein. Oligomycin reversed the effect of the respiratory inhibitors. Independently of respiration, efflux was stimulated by the uncoupler trifluoromethyltetrachlorbenzimadazole, by mersalyl and by thyroid hormones. The stimulated efflux could be diminished by ADP, with Mg2+ as cofactor if efflux was rapid. With respiration in progress, efflux could be stimulated by N-ethylmaleimide and 5,5′-dithiobis-(2-nitrobenzoate). The effects of mersalyl and of thyroid hormones could be diminished with dithiothreitol. In the absence of stimulating agents, the Ca2+ efflux was proportional to the load up to some critical amount, this critical amount was decreased by the agents. Thyroxine and mersalyl caused not only loss of Ca2+, but also simultaneous, but not necessarily proportional, loss of internal adenine nucleotides. Both efflux rates were kept at a low value by bongkrekic acid added before the stimulating agent. It is concluded that Ca2+ efflux is a measure of a permeability controlled by the binding of ADP (an Mg2+) to the inner membrane, and that this in turn depends on the maintenance of certain thiol gropus in a reduced form by a reaction that uses NADH and ATP and the energy-linked transhydrogenase.

Effects of pH and ionic strength on the cation exchange capacity of soils with variable charge

Soil Research ◽  
1981 ◽  
Vol 19 (1) ◽  
pp. 93 ◽  
Author(s):  
GP Gillman
Keyword(s):  
Ionic Strength ◽  
Cation Exchange ◽  
Cation Exchange Capacity ◽  
Exchange Capacity ◽  
Surface Soils ◽  
Ph Values ◽  
Variable Charge ◽  
Effects Of Ph ◽  
Variable Charge Soils

The cation exchange capacity of six surface soils from north Queensland and Hawaii has been measured over a range of pH values (4-6) and ionic strength values (0.003-0.05). The results show that for variable charge soils, modest changes in electrolyte ionic strength are as important in their effect on caton exchange capacity as are changes in pH values.

Orthogonal Experiment Analysis of Mechanical Thermal Conductivity on Multi-Component Fillers

2013 ◽  
Vol 753-755 ◽  
pp. 2379-2382
Author(s):  
Shi Meng Xu ◽  
Run Bo Ma ◽  
Jian Hua Du ◽  
Jun Hong Liu ◽  
Qi Jin
Keyword(s):  
Mechanical Properties ◽  
Thermal Conductivity ◽  
Carbon Black ◽  
Orthogonal Experiment ◽  
Experiment Design ◽  
Rubber Composites ◽  
Orthogonal Experiment Design ◽  
Rubber Composite ◽  
Al Powder ◽  
Experiment Analysis

Filled the N330 carbon black, silica T80 carbon black and Al powder and Fe2O3 magnetic nanoparticles, the rubber composites on multi-component electromagnetic fillers were prepared according to orthogonal experiment analysis, and the preliminary experiment conclusions of the filler prescription designs were given; Based on the experiment design, the mechanical properties and thermal conductivity of the rubber composite were tested, and the testing results were analyzed by using variance analysis. Thus, the paper shows that the effects of N330 on rubber mechanical properties are significant, and the effects of Al powder on the rubber thermal conductivity are significant. Moreover, it is highly emphasized in this paper that the orthogonal experiment design must be carefully explored before the tests are executed.

Factors affecting the time of formation of the mouse blastocoele

Development ◽  
1977 ◽  
Vol 41 (1) ◽  
pp. 79-92
Author(s):  
Rosita Smith ◽  
Anne McLaren
Keyword(s):  
Cytochalasin B ◽  
Critical Factor ◽  
Cell Number ◽  
Experimental Manipulation ◽  
Factors Affecting ◽  
Elapsed Time ◽  
Developmental Age ◽  
Culture Formation

In normal mouse embryos developing in vivo, the first appearance of the blastocyst cavity was found to be associated more closely with developmental age, judged by cell number, than with chronological age, i.e. elapsed time since ovulation. When development was slowed by in vitro culture, formation of the blastocoele was delayed. However, cell number itself was not a critical factor, since the number of cells per embryo could be doubled or tripled or halved by experimental manipulation without substantially affecting the timing of blastocoele formation. Experiments in which one cell division was suppressed with cytochalasin-B, leading to tetraploidy, showed that the number of cell divisions since fertilization was also not critical. A possible role is suggested either for nucleocytoplasmic ratio, or for the number of nuclear or chromosomal divisions or DNA replications since fertilization, all of which increase during cleavage.

GROWTH RATES AND FERMENTATION PATTERNS OF LACTIC ACID BACTERIA ASSOCIATED WITH THE SAUERKRAUT FERMENTATION1

1971 ◽  
Vol 34 (11) ◽  
pp. 521-525 ◽  
Author(s):  
J. R. Stamer ◽  
B. O. Stoyla ◽  
B. A. Dunckel
Keyword(s):  
Lactic Acid ◽  
Lactic Acid Bacteria ◽  
Growth Rates ◽  
Leuconostoc Mesenteroides ◽  
Lactobacillus Brevis ◽  
Sensitive Species ◽  
Ph Values ◽  
Generation Times ◽  
Effects Of Ph ◽  
Early Phases

The effects of pH values and NaCl concentrations on the growth rates of five species of lactic acid bacteria commonly associated with the sauerkraut fermentation were determined in filter-sterilized cabbage juice. Growth rates of all cultures, with the exception of Pediococcus cerevisiae, were retarded by addition of salt, lower pH, or interaction of both pH and salt. Based upon lag and generation times, P. cerevisiae was the culture most tolerant to the pH and salt concentration employed, whereas Streptococcus faecalis was the most sensitive species. Of the heterofermentative cultures, Lactobacillus brevis was less subject to growth inhibition than Leuconostoc mesenteroides. Under conditions simulating those found during the initial phases of the sauerkraut fermentation (2.25% salt, pH 6.2), L. mesenteroides displayed the shortest lag and generation times of all cultures examined. This rapid growth rate coupled with a marked accelerated death rate may explain, in part, the reason this species is both the first to dominate and the first to die during the early phases of the sauerkraut fermentation. Although cabbage juice previously fermented by L. mesenteroides appears to inhibit growth of P. cerevisiae, it had no apparent inhibitory or stimulatory effects on the other cultures.

Sign in / Sign up

Export Citation Format

Share Document