A Study of Modeling Perception in a First-Time Modeling Class

Author(s):  
Huseyin Ergin ◽  
Isaac L. Walling ◽  
Kate P. Rader ◽  
D. Joshua Dobbs
Keyword(s):  
2021 ◽  
Vol 9 ◽  
Author(s):  
Andrea Maggi ◽  
Dominik Garmatter ◽  
Sebastian Sager ◽  
Martin Stoll ◽  
Kai Sundmacher

A chemical plant layout for the production of syngas from renewable power, H2O and biogas, is presented to ensure a steady productivity of syngas with a constant H2-to-CO ratio under time-dependent electricity provision. An electrolyzer supplies H2 to the reverse water-gas shift reactor. The system compensates for a drop in electricity supply by gradually operating a tri-reforming reactor, fed with pure O2 directly from the electrolyzer or from an intermediate generic buffering device. After the introduction of modeling assumptions and governing equations, suitable reactor parameters are identified. Finally, two optimal control problems are investigated, where computationally expensive model evaluations are lifted viaparareal and necessary objective derivatives are calculated via the continuous adjoint method. For the first time, modeling, simulation, and optimal control are applied to a combination of the reverse water-gas shift and tri-reforming reactor, exploring a promising pathway in the conversion of renewable power into chemicals.


Author(s):  
Y. Amirian ◽  
A. Khodadadi

The consecutive linear [Formula: see text]-out-of-[Formula: see text]-from-[Formula: see text]:F system consists of [Formula: see text] linear ordered components and the consecutive circular [Formula: see text]-out-of-[Formula: see text]-from-[Formula: see text]:F system consists of [Formula: see text] circular ordered components. In this paper, we suggest, for the first time, modeling and exact reliability for these models. The linear system fails if and only if there exists a [Formula: see text]-order statistic of [Formula: see text]-consecutive [Formula: see text] [Formula: see text] of components in the failed state, [Formula: see text], [Formula: see text]; and the circular system fails if and only if there exists a [Formula: see text]-order statistic of [Formula: see text]-consecutive [Formula: see text] [Formula: see text] of components in the failed state, [Formula: see text], [Formula: see text]. In this paper, we designed an innovative algorithm to obtain the exact reliability for an extensive class of consecutive linear and circular systems. In continuation, there are the MATLAB Programs of exact reliability for consecutive linear and circular systems. In the following, we applied comparative and numerical results and calculated the exact reliability of this strategic systems. Finally, we calculated the exact reliability for two real-world practical examples.


Author(s):  
Vladimir A. Mazilov ◽  
Yuriy N. Slepko

Introduction. The paper represents the analysis of the ability to teach within the context of the study of the phenomenon of giftedness and psychological structure of a teacher’s professional activities. The objective of the paper is to analyze key areas of the development of the concept of teacher giftedness. This approach allows to describe the basic qualities of the efficient pedagogical activity at the stage of training teachers at higher school. Materials and Methods. Description of key areas of the concept of pedagogical giftedness is based on the ability theory, proposed by V. D. Shadrikov. At the same time, modeling processes of goal-oriented development of pedagogical giftedness is based on a set of modern research psychological methods of structuralfunctional analysis allowing for prediction of properties of the pedagogical system of a teacher, which has such characteristics as varying degrees of success. Organizational methods (first of all, comparative) open up possibilities for assessing the effectiveness of giftedness-in-training development at different stages of teacher training – pre-university, undergraduate and post-graduate. The choice of empirical methods is substantiated by the results of theoretically modeling the structure and ways of development of pedagogical giftedness at the stage of professional self-determination at school, under conditions of educational and independent professional activity. Out of interpretative methods, the most significant (in the context of planned results) are genetic, structural and functional methods . Results. Based on the analysis of the theory of abilities, taking into account the progress in the activitybased approach, a new understanding of the object of psychological sciences as the inner personal world, the methodological validity of the concept of goal-oriented development of pedagogical gift under conditions of teacher training is substantiated. The results obtained make it possible to get a fresh look at the problem of the teacher’s professionally valuable qualities and translate its solution from analytical to systemic research methodology. In the concept proposed by the authors first time ever, the phenomenon of giftedness is considered within the context of its formation in teacher college student, while the subject of the bulk of contemporary research is the object of pedagogical influence. Discussion and Conclusion. The practical application of the study results can significantly modernize the process of teacher training in pedagogical colleges and universities. They will be useful for the teaching staff of pedagogical universities, secondary vocational education institutions, and departments of continuing education.


Author(s):  
J. Chakraborty ◽  
A. P. Sinha Hikim ◽  
J. S. Jhunjhunwala

Although the presence of annulate lamellae was noted in many cell types, including the rat spermatogenic cells, this structure was never reported in the Sertoli cells of any rodent species. The present report is based on a part of our project on the effect of torsion of the spermatic cord to the contralateral testis. This paper describes for the first time, the fine structural details of the annulate lamellae in the Sertoli cells of damaged testis from guinea pigs.One side of the spermatic cord of each of six Hartly strain adult guinea pigs was surgically twisted (540°) under pentobarbital anesthesia (1). Four months after induction of torsion, animals were sacrificed, testes were excised and processed for the light and electron microscopic investigations. In the damaged testis, the majority of seminiferous tubule contained a layer of Sertoli cells with occasional spermatogonia (Fig. 1). Nuclei of these Sertoli cells were highly pleomorphic and contained small chromatinic clumps adjacent to the inner aspect of the nuclear envelope (Fig. 2).


Author(s):  
M. Rühle ◽  
J. Mayer ◽  
J.C.H. Spence ◽  
J. Bihr ◽  
W. Probst ◽  
...  

A new Zeiss TEM with an imaging Omega filter is a fully digitized, side-entry, 120 kV TEM/STEM instrument for materials science. The machine possesses an Omega magnetic imaging energy filter (see Fig. 1) placed between the third and fourth projector lens. Lanio designed the filter and a prototype was built at the Fritz-Haber-Institut in Berlin, Germany. The imaging magnetic filter allows energy-filtered images or diffraction patterns to be recorded without scanning using efficient area detection. The energy dispersion at the exit slit (Fig. 1) results in ∼ 1.5 μm/eV which allows imaging with energy windows of ≤ 10 eV. The smallest probe size of the microscope is 1.6 nm and the Koehler illumination system is used for the first time in a TEM. Serial recording of EELS spectra with a resolution < 1 eV is possible. The digital control allows X,Y,Z coordinates and tilt settings to be stored and later recalled.


Author(s):  
Z.L. Wang ◽  
J. Bentley ◽  
R.E. Clausing ◽  
L. Heatherly ◽  
L.L. Horton

Microstructural studies by transmission electron microscopy (TEM) of diamond films grown by chemical vapor deposition (CVD) usually involve tedious specimen preparation. This process has been avoided with a technique that is described in this paper. For the first time, thick as-grown diamond films have been examined directly in a conventional TEM without thinning. With this technique, the important microstructures near the growth surface have been characterized. An as-grown diamond film was fractured on a plane containing the growth direction. It took about 5 min to prepare a sample. For TEM examination, the film was tilted about 30-45° (see Fig. 1). Microstructures of the diamond grains on the top edge of the growth face can be characterized directly by transmitted electron bright-field (BF) and dark-field (DF) images and diffraction patterns.


Author(s):  
Shou-kong Fan

Transmission and analytical electron microscopic studies of scale microstructures and microscopic marker experiments have been carried out in order to determine the transport mechanism in the oxidation of Ni-Al alloy. According to the classical theory, the oxidation of nickel takes place by transport of Ni cations across the scale forming new oxide at the scale/gas interface. Any markers deposited on the Ni surface are expected to remain at the scale/metal interface after oxidation. This investigation using TEM transverse section techniques and deposited microscopic markers shows a different result,which indicates that a considerable amount of oxygen was transported inward. This is the first time that such fine-scale markers have been coupled with high resolution characterization instruments such as TEM/STEM to provide detailed information about evolution of oxide scale microstructure.


Author(s):  
Yimei Zhu ◽  
J. Tafto

The electron holes confined to the CuO2-plane are the charge carriers in high-temperature superconductors, and thus, the distribution of charge plays a key role in determining their superconducting properties. While it has been known for a long time that in principle, electron diffraction at low angles is very sensitive to charge transfer, we, for the first time, show that under a proper TEM imaging condition, it is possible to directly image charge in crystals with a large unit cell. We apply this new way of studying charge distribution to the technologically important Bi2Sr2Ca1Cu2O8+δ superconductors.Charged particles interact with the electrostatic potential, and thus, for small scattering angles, the incident particle sees a nuclei that is screened by the electron cloud. Hence, the scattering amplitude mainly is determined by the net charge of the ion. Comparing with the high Z neutral Bi atom, we note that the scattering amplitude of the hole or an electron is larger at small scattering angles. This is in stark contrast to the displacements which contribute negligibly to the electron diffraction pattern at small angles because of the short g-vectors.


Author(s):  
S.J. Krause ◽  
W.W. Adams

Over the past decade low voltage scanning electron microscopy (LVSEM) of polymers has evolved from an interesting curiosity to a powerful analytical technique. This development has been driven by improved instrumentation and in particular, reliable field emission gun (FEG) SEMs. The usefulness of LVSEM has also grown because of an improved theoretical and experimental understanding of sample-beam interactions and by advances in sample preparation and operating techniques. This paper will review progress in polymer LVSEM and present recent results and developments in the field.In the early 1980s a new generation of SEMs produced beam currents that were sufficient to allow imaging at low voltages from 5keV to 0.5 keV. Thus, for the first time, it became possible to routinely image uncoated polymers at voltages below their negative charging threshold, the "second crossover", E2 (Fig. 1). LVSEM also improved contrast and reduced beam damage in sputter metal coated polymers. Unfortunately, resolution was limited to a few tenths of a micron due to the low brightness and chromatic aberration of thermal electron emission sources.


2020 ◽  
Vol 5 (2) ◽  
pp. 463-478
Author(s):  
Elizabeth Crais ◽  
Melody Harrison Savage

Purpose The shortage of doctor of philosophy (PhD)–level applicants to fill academic and research positions in communication sciences and disorders (CSD) programs calls for a detailed examination of current CSD PhD educational practices and the generation of creative solutions. The intended purposes of the article are to encourage CSD faculty to examine their own PhD program practices and consider the perspectives of recent CSD PhD graduates in determining the need for possible modifications. Method The article describes the results of a survey of 240 CSD PhD graduates and their perceptions of the challenges and facilitators to completing a PhD degree; the quality of their preparation in research, teaching, and job readiness; and ways to improve PhD education. Results Two primary themes emerged from the data highlighting the need for “matchmaking.” The first time point of needed matchmaking is prior to entry among students, mentors, and expectations as well as between aspects of the program that can lead to students' success and graduation. The second important matchmaking need is between the actual PhD preparation and the realities of the graduates' career expectations, and those placed on graduates by their employers. Conclusions Within both themes, graduate's perspectives and suggestions to help guide future doctoral preparation are highlighted. The graduates' recommendations could be used by CSD PhD program faculty to enhance the quality of their program and the likelihood of student success and completion. Supplemental Material https://doi.org/10.23641/asha.11991480


Sign in / Sign up

Export Citation Format

Share Document