The physiological and proteomic characteristics of oilseed rape stem affect seed yield and lodging resistance under different planting densities and row spacing

Author(s):  
Jie Kuai ◽  
Xiaoyong Li ◽  
Jianli Ji ◽  
Zhen Li ◽  
Yan Xie ◽  
...  
1985 ◽  
Vol 27 (4) ◽  
pp. 472-478 ◽  
Author(s):  
I. Grant ◽  
W. D. Beversdorf

A 6 × 6 diallel cross was conducted in spring-planted oilseed rape (Brassica napus L.) in 1983 at Elora and Dundalk, Ontario. The F1 hybrids exhibited positive heterosis for seed yield, of up to 72%, over the higher-yielding parent in the hybrid crosses. Heterosis for 1000 seed weight, percent oil, plant height, and lodging resistance was nonsignificant; negative heterosis for percent protein was observed with some hybrids. Generally, the hybrids were intermediate to the parents in flowering date and physiological maturity. Specific combining ability was more important than general combining ability for seed yield, percent oil, percent protein, plant height (Dundalk), and lodging resistance (Elora); specific combining ability was as important as general combining ability for 1000 seed weight, physiological maturity, plant height (Elora), and lodging resistance (Dundalk). The cultivars 'Topas' and 'Regent' were the best general combiners for seed yield. The best specific combinations for seed yield heterosis, 'Westar' × 'Hanna', 'Regent' × 'Liné', and 'Regent' × 'D-1', exhibited average high-parent heterosis values of 50, 38, and 30%, respectively. The results demonstrated that considerable potential exists for producing high-yielding single-cross hybrids of oilseed rape. Commercial exploitation of this heterosis will depend on the successful development of suitable pollination control mechanisms.Key words: Brassica napus, oilseed rape, F1 hybrid, heterosis, combining ability.


2021 ◽  
Vol 9 ◽  
Author(s):  
M. O’Neill ◽  
G. J. Lanigan ◽  
P. D. Forristal ◽  
B. A. Osborne

Winter oilseed rape is traditionally established via plough-based soil cultivation and conventional sowing methods. Whilst there is potential to adopt lower cost, and less intensive establishment systems, the impact of these on greenhouse gas emissions have not been evaluated. To address this, field experiments were conducted in 2014/2015 and 2015/2016 to investigate the effects of 1) crop establishment method and 2) sowing method on soil greenhouse gas emissions from a winter oilseed rape crop grown in Ireland. Soil carbon dioxide, nitrous oxide and methane emission measurements were carried out using the static chamber method. Yield (t seed ha−1) and the yield-scaled global warming potential (kg CO2-eq. kg−1 seed) were also determined for each management practice. During crop establishment, conventional tillage induced an initially rapid loss of carbon dioxide (2.34 g C m−2 hr−1) compared to strip tillage (0.94 g C m−2 hr−1) or minimum tillage (0.16 g C m−2 hr−1) (p < 0.05), although this decreased to background values within a few hours. In the crop establishment trial, the cumulative greenhouse gas emissions were, apart from methane, unaffected by tillage management when sown at a conventional (125 mm) or wide (600 mm) row spacing. In the sowing method trial, cumulative carbon dioxide emissions were also 21% higher when plants were sown at 10 seeds m−2 compared to 60 seeds m−2 (p < 0.05). Row spacing width (125 and 750 mm) and variety (conventional and semi-dwarf) were found to have little effect on greenhouse gas emissions and differences in seed yield between the sowing treatments were small. Overall, management practices had no consistent effect on soil greenhouse gas emissions and modifications in seed yield per plant countered differences in planting density.


The results of scientific research are presented, which made it possible to develop less labor-intensive methods for selecting flax plants to grow original (updated) seeds. Studies have shown that a positive selection of tall plants of flax, compared with the accepted counterpart (control), increased seed yield 1.7-1.9 times. Moreover, plant homogeneity according to the main characteristics (height and fiber content in the stem) characterizing the varietal quality of grown seeds turned out to be at the control level. A negative selection, involving the removal of atypical plants, provided an increase in the output volume of seeds compared to the control by 3.9-4.1 times. This selection method did not reduce the varietal quality of seed material compared to the accepted analogue. With both selection methods, after combining typical plants, seeds with the same high germination rates were obtained (96-99 %). The breeding efficiency of the grown flax seeds using narrow-row sowing methods is shown. Studies have established that narrow-row sowing of seeds with a row-spacing of 7.5 and 6.25 cm compared with sowing by a wide-row method significantly increased their yield by 2.8-3.0 and 2.3-3.0 kg / ha, respectively. The greatest influence on the formation of seed yield in narrow-row sowing (6.25 cm) was exerted by the method of sowing, the part of which was 76.1 %. As the length of seed propagation of flax in creased (up to the uterine elite 2 years) in narrow-row sowing (6.25 cm) compared to broad-row, there was no decrease in quality indicators - germination and seed strength.


Agronomy ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 605
Author(s):  
Peder K. Schmitz ◽  
Hans J. Kandel

Planting date (PD), seeding rate (SR), relative maturity (RM) of cultivars, and row spacing (RS) are primary management factors affecting soybean (Glycine max (L.) Merr.) yield. The individual and synergistic effects of PD, SR, RM, and RS on seed yield and agronomic characteristics in North Dakota were herein investigated. Early and late PD, early and late RM cultivars, two SR (408,000 and 457,000 seed ha−1), and two RS (30.5 and 61 cm) were evaluated in four total environments in 2019 and 2020. Maximizing green canopy cover prior to the beginning of flowering improved seed yield. Individual factors of early PD and narrow RS resulted in yield increase of 311 and 266 kg ha−1, respectively. The combined factors of early PD, late RM, high SR, and narrow RS improved yield by 26% and provided a $350 ha−1 partial profit over conventional practices. Canopy cover and yield had relatively weak relationships with r2 of 0.36, 0.23, 0.14, and 0.21 at the two trifoliolate, four trifoliolate, beginning of flowering, and beginning of pod formation soybean growth stages, respectively. Producers in the most northern soybean region of the USA should combine early planting, optimum RM cultivars, 457,000 seed ha−1 SR, and 31 cm RS to improve yield and profit compared to current management practices.


2016 ◽  
Vol 118 (4) ◽  
pp. 655-665 ◽  
Author(s):  
C. L. Thomas ◽  
N. S. Graham ◽  
R. Hayden ◽  
M. C. Meacham ◽  
K. Neugebauer ◽  
...  

Author(s):  
Yirga Belay Kindeya ◽  
Dargie Girmay ◽  
Alem Atsbiha ◽  
Asefa Abadi ◽  
Asefa Abadi ◽  
...  

The experiment was conducted to characterize and evaluate mung bean accessions, to identify diseases, shattering, lodging resistant and suitable for combine harvesting. The accessions sown in a plot area of 2.1 m by 5 m with 1 m, 1.5m between plots and blocks keeping inter and intra row spacing of 40 cm and 10 cm, respectively. 73 entries along with two checks summing up 75 genotypes evaluated at field condition for their yield and yield components characters during 2019 main cropping season using augmented RCBD design without replication. R-software were used to analyze different characters including the descriptive statistics and SPSS20 used to analyze clustering. Mean of different traits days to maturity (76.46±11.21,), shattering(0.93±0.14), lodging (2.71±2.03), root length(21.±5.54), root volume(201.05±43.76), pods/plant (16.81±6.38), nodule number( 16.22±1.96), Seed yield(10.64±4.01), seeds/pod (11.77±2.80) and 100sw(3.26±0.97) was recoded. The accessions recorded different range of parameters; nodule number (0 to71.75), root length (8 cm to 34.5), shattering (0 to 100), lodging (0% to 1-10%), number of seeds/pod (7 to 23), hundred seed weight (1.8 to 3.26 gram), root volume (4.71 to 230.46 CM) respectively this big variation among accessions of different traits helps to promote breeding programme in mung bean. The seed yield of genotypes ranged from ZURD01(3.88) to ILRI6831(19.79) qtha-1. Days to maturity was ranged from 61(ARKEBE) to 103(MEND01) after emergence. Three maturity groups; early (61 to 69days), medium (71 to 79 days) and late maturing (81 to 103days). Mean yield performance; cluster one had the highest mean yield (16.31qtha-1) followed by cluster two (12.43 qtha-1), cluster three (9.8), cluster four (6.65 qtha-1) and cluster five (1.21 qtha-1) respectively. The genotypes grouped in to three clusters based on their maturity and cluster one had the highest mean maturity days (91.74) followed by cluster two (75.97) and cluster three (66.37) respectively. The early, medium and late maturing genotypes recommended for moisture stress (350-500mm), optimum (600-800 mm) and high rain fall (900-2000 mm) areas respectively according to annual rain fall of the agro ecologies. Genotypes with high nodule number, high yielding, diseases resistance, better root length, shattering and lodging resistance will be important for variety development for mechanization, commercial production and further breeding programme.


2021 ◽  
Vol 66 (1) ◽  
pp. 17-25
Author(s):  
Valiollah Rameeh ◽  
Maryam Niakan ◽  
Mohammad Mohammadi

The effects of four sulphur levels: S0, S1, S2 and S3, including 0, 12, 24 and 36 kg S ha-1, respectively, along with 115 kg N ha-1 were studied on yield-related traits of oilseed rape (Brassica napus L.). The significant variance of treatments was determined for plant height, yield component characters, seed yield and oil content. The sulphur application significantly increased most of the traits compared to the S0 level. The S3 (36 kg S ha-1) treatment led to the highest mean value of plant height (132 cm) which was classified with S2 (24 kg S ha-1) in the same statistical group. Sulphur had an increasing effect on pods per plant, and it ranged from 92 to 196 for S0 and S3 applications, respectively. S0 and S1 with 92 and 121 pods per plant were grouped in the same statistical group. In addition, S2, and S3 with 165 and 196 pods per plant showed no significant statistical difference. The sulphur application significantly increased seed yield compared to control (S0 level), and it ranged from 2744 to 3215 kg ha-1 in S0 and S3, respectively. The average oil contents of 45.69, 46.96, 47.46 and 49.53 % were detected for 0, 12, 24 and 36 kg S ha-1, respectively.


2021 ◽  
Vol 12 ◽  
Author(s):  
Laura Siles ◽  
Kirsty L. Hassall ◽  
Cristina Sanchis Gritsch ◽  
Peter J. Eastmond ◽  
Smita Kurup

Seed yield is a complex trait for many crop species including oilseed rape (OSR) (Brassica napus), the second most important oilseed crop worldwide. Studies have focused on the contribution of distinct factors in seed yield such as environmental cues, agronomical practices, growth conditions, or specific phenotypic traits at the whole plant level, such as number of pods in a plant. However, how female reproductive traits contribute to whole plant level traits, and hence to seed yield, has been largely ignored. Here, we describe the combined contribution of 33 phenotypic traits within a B. napus diversity set population and their trade-offs at the whole plant and organ level, along with their interaction with plant level traits. Our results revealed that both Winter OSR (WOSR) and Spring OSR (SOSR); the two more economically important OSR groups in terms of oil production; share a common dominant reproductive strategy for seed yield. In this strategy, the main inflorescence is the principal source of seed yield, producing a good number of ovules, a large number of long pods with a concomitantly high number of seeds per pod. Moreover, we observed that WOSR opted for additional reproductive strategies than SOSR, presenting more plasticity to maximise seed yield. Overall, we conclude that OSR adopts a key strategy to ensure maximal seed yield and propose an ideal ideotype highlighting crucial phenotypic traits that could be potential targets for breeding.


Sign in / Sign up

Export Citation Format

Share Document