scholarly journals A water lily–inspired hierarchical design for stable and efficient solar evaporation of high-salinity brine

2019 ◽  
Vol 5 (7) ◽  
pp. eaaw7013 ◽  
Author(s):  
Ning Xu ◽  
Jinlei Li ◽  
Yang Wang ◽  
Chang Fang ◽  
Xiuqiang Li ◽  
...  
Keyword(s):  
Wastewater Treatment ◽  
Evaporation Rate ◽  
High Salinity ◽  
Energy Conversion Efficiency ◽  
Solute Concentration ◽  
High Energy ◽  
High Rate ◽  
Water Lily ◽  
Solar Absorbers ◽  
Metal Recycling

In recent years, interfacial solar vapor generation has shown great potential in realizing desalination and wastewater treatment with high energy conversion efficiency. However, high evaporation rate cannot be maintained because of the seemingly unavoidable fouling or salt accumulation on the solar absorbers. The degradation accelerates as the solute concentration increases. Here, we demonstrate a water lily–inspired hierarchical structure that enables efficient evaporation (~80% solar-to-vapor efficiency) out of high-salinity brine [10 weight % (wt %)] and wastewater containing heavy metal ions (30 wt %). More notably, neither decrease in evaporation rate nor fouling on absorbers was observed during the entire evaporation process until water and solute were completely separated. With the capabilities of stable and high-rate evaporation out of high-salinity brine and the effective separation of solute from water, it is expected that this technology can have direct implications in various fields such as wastewater treatment, sea-salt production, and metal recycling.

Oxygen Supply Method Using Gas-Permeable Film for Wastewater Treatment

1993 ◽  
Vol 28 (7) ◽  
pp. 243-250 ◽  
Author(s):  
Y. Suzuki ◽  
S. Miyahara ◽  
K. Takeishi
Keyword(s):  
Wastewater Treatment ◽  
Energy Consumption ◽  
Oxygen Transfer ◽  
Transfer Rate ◽  
Oxygen Supply ◽  
Oxygen Transfer Rate ◽  
High Energy ◽  
High Rate ◽  
N Removal ◽  
High Energy Consumption

Gas-permeable film can separate air and water, and at the same time, let oxygen diffuse from the air to the water through the film. An oxygen supply method using this film was investigated for the purpose of reducing energy consumption for wastewater treatment. The oxygen transfer rate was measured for the cases with or without biofilm, which proved the high rate of oxygen transfer in the case with nitrifying biofilm which performed nitrification. When the Gas-permeable film with nitrifying biofilm was applied to the treatment of wastewater, denitrifying biofilm formed on the nitrifying biofilm, and simultaneous nitrification and denitrification occurred, resulting in the high rate of organic matter and T-N removal (7 gTOC/m2/d and 4 gT-N/m2/d, respectively). However, periodic sloughing of the denitrifying biofilm was needed to keep the oxygen transfer rate high. Energy consumption of the process using the film in the form of tubes was estimated to be less than 40% of that of the activated sludge process.

EVALUATION OF BIOMETHANE YIELDS FROM HIGH-ENERGY ORGANIC WASTE AND SEWAGE SLUDGE: A PILOT STUDY FOR A WASTEWATER TREATMENT PLANT

2019 ◽  
Vol 18 (9) ◽  
pp. 2023-2034 ◽  
Author(s):  
Agnieszka A. Pilarska ◽  
Krzysztof Pilarski ◽  
Boguslawa Waliszewska ◽  
Magdalena Zborowska ◽  
Kamil Witaszek ◽  
...  
Keyword(s):  
Wastewater Treatment ◽  
Pilot Study ◽  
Sewage Sludge ◽  
Wastewater Treatment Plant ◽  
Organic Waste ◽  
Treatment Plant ◽  
High Energy

Rehabilitation and Upgrading of the Beni Suef City Wastewater Treatment Plant

1990 ◽  
Vol 22 (7-8) ◽  
pp. 131-138
Author(s):  
Ahmed Fadel
Keyword(s):  
Wastewater Treatment ◽  
Activated Sludge ◽  
Wastewater Treatment Plant ◽  
Treatment Plant ◽  
Primary Treatment ◽  
High Rate ◽  
Shock Load ◽  
Economic Evaluations ◽  
Activated Sludge Process ◽  
Trickling Filter

Many of Egypt's cities have existing treatment plants under operation that have been constructed before 1970. Almost all of these treatment plants now need rehabilitation and upgrading to extend their services for a longer period. One of these plants is the Beni Suef City Wastewater Treatment Plant. The Beni Suef WWTP was constructed in 1956. It has primary treatment followed by secondary treatment employing intermediate rate trickling filters. The BOD, COD, and SS concentration levels are relatively high. They are approximately 800, 1100, and 600 mg/litre, respectively. The Beni Suef city required the determination of the level of work needed for the rehabilitation and upgrading of the existing 200 l/s plant and to extend its capacity to 440 l/s at year 2000 A description of the existing units, their deficiencies and operation problems, and the required rehabilitation are presented and discussed in this paper. Major problems facing the upgrading were the lack of space for expansion and the shortage of funds. It was, therefore, necessary to study several alternative solutions and methods of treatment. The choice of alternatives was from one of the following schemes: a) changing the filter medium, its mode of operation and increasing the number of units, b) changing the trickling filter to high rate and combining it with the activated sludge process, for operation by one of several possible combinations such as: trickling filter-solids contact, roughing filter-activated sludge, and trickling filter-activated sludge process, c) dividing the flow into two parts, the first part to be treated using the existing system and the second part to be treated by activated sludge process, and d) expanding the existing system by increasing the numbers of the different process units. The selection of the alternative was based on technical, operational and economic evaluations. The different alternatives were compared on the basis of system costs, shock load handling, treatment plant operation and predicted effluent quality. The flow schemes for the alternatives are presented. The methodology of selecting the best alternative is discussed. From the study it was concluded that the first alternative is the most reliable from the point of view of costs, handling shock load, and operation.

Experiments on high rate effluent filtration in the Netherlands

1998 ◽  
Vol 38 (3) ◽  
pp. 127-134
Author(s):  
Jaap H. J. M. van der Graaf ◽  
Arjen F. van Nieuwenhuijzen
Keyword(s):  
Wastewater Treatment ◽  
The Netherlands ◽  
Suspended Solids ◽  
Practical Experience ◽  
High Rate ◽  
Treated Water ◽  
Low Concentrations ◽  
Wastewater Treatment Effluent

As yet, filtration of wastewater treatment effluent has not been practised in the Netherlands. The main objections were the expected high costs. In order to gain practical experience an investigation programme studied the applicability and optimization of effluent filtration. Especially multi-layer filtration with the addition of ironchloride seemed to be very effective. Very low concentrations of suspended solids and phosphorus were achieved, even at high filtration rates (up to 30 m/h). This leads to an impressive reduction of expected costs, down to Dfl. 0.02/m3 (treated water).

Current progress and performance improvement of Pt/C catalysts for fuel cells

2020 ◽  
Vol 8 (46) ◽  
pp. 24284-24306
Author(s):  
Xuefeng Ren ◽  
Yiran Wang ◽  
Anmin Liu ◽  
Zhihong Zhang ◽  
Qianyuan Lv ◽  
...  
Keyword(s):  
Fuel Cells ◽  
Fuel Cell ◽  
Energy Conversion ◽  
Performance Improvement ◽  
Electric Energy ◽  
Energy Conversion Efficiency ◽  
High Energy ◽  
Carnot Cycle ◽  
High Energy Conversion Efficiency ◽  
And Performance

Fuel cell is an electrochemical device, which can directly convert the chemical energy of fuel into electric energy, without heat process, not limited by Carnot cycle, high energy conversion efficiency, no noise and pollution.

scholarly journals In-Situ Annealed Ti3C2Tx MXene Based All-Solid-State Flexible Zn-Ion Hybrid Micro Supercapacitor Array with Enhanced Stability

2021 ◽  
Vol 13 (1) ◽  
Author(s):  
La Li ◽  
Weijia Liu ◽  
Kai Jiang ◽  
Di Chen ◽  
Fengyu Qu ◽  
...  
Keyword(s):  
High Energy ◽  
High Rate ◽  
High Energy Density ◽  
Electrochemical Performances ◽  
Integrated Electronics ◽  
Long Term Stability ◽  
Hybrid Supercapacitors ◽  
Portable Electronics

AbstractZn-ion hybrid supercapacitors (SCs) are considered as promising energy storage owing to their high energy density compared to traditional SCs. How to realize the miniaturization, patterning, and flexibility of the Zn-ion SCs without affecting the electrochemical performances has special meanings for expanding their applications in wearable integrated electronics. Ti3C2Tx cathode with outstanding conductivity, unique lamellar structure and good mechanical flexibility has been demonstrated tremendous potential in the design of Zn-ion SCs, but achieving long cycling stability and high rate stability is still big challenges. Here, we proposed a facile laser writing approach to fabricate patterned Ti3C2Tx-based Zn-ion micro-supercapacitors (MSCs), followed by the in-situ anneal treatment of the assembled MSCs to improve the long-term stability, which exhibits 80% of the capacitance retention even after 50,000 charge/discharge cycles and superior rate stability. The influence of the cathode thickness on the electrochemical performance of the MSCs is also studied. When the thickness reaches 0.851 µm the maximum areal capacitance of 72.02 mF cm−2 at scan rate of 10 mV s−1, which is 1.77 times higher than that with a thickness of 0.329 µm (35.6 mF cm−2). Moreover, the fabricated Ti3C2Tx based Zn-ion MSCs have excellent flexibility, a digital timer can be driven by the single device even under bending state, a flexible LED displayer of “TiC” logo also can be easily lighted by the MSC arrays under twisting, crimping, and winding conditions, demonstrating the scalable fabrication and application of the fabricated MSCs in portable electronics.

scholarly journals Oxygen-Deficient β-MnO2@Graphene Oxide Cathode for High-Rate and Long-Life Aqueous Zinc Ion Batteries

2021 ◽  
Vol 13 (1) ◽  
Author(s):  
Shouxiang Ding ◽  
Mingzheng Zhang ◽  
Runzhi Qin ◽  
Jianjun Fang ◽  
Hengyu Ren ◽  
...  
Keyword(s):  
Graphene Oxide ◽  
Manganese Oxides ◽  
Rate Capability ◽  
High Energy ◽  
Zinc Ion ◽  
Cycling Stability ◽  
High Rate ◽  
High Energy Density ◽  
Superior Performance ◽  
Long Life

AbstractRecent years have witnessed a booming interest in grid-scale electrochemical energy storage, where much attention has been paid to the aqueous zinc ion batteries (AZIBs). Among various cathode materials for AZIBs, manganese oxides have risen to prominence due to their high energy density and low cost. However, sluggish reaction kinetics and poor cycling stability dictate against their practical application. Herein, we demonstrate the combined use of defect engineering and interfacial optimization that can simultaneously promote rate capability and cycling stability of MnO2 cathodes. β-MnO2 with abundant oxygen vacancies (VO) and graphene oxide (GO) wrapping is synthesized, in which VO in the bulk accelerate the charge/discharge kinetics while GO on the surfaces inhibits the Mn dissolution. This electrode shows a sustained reversible capacity of ~ 129.6 mAh g−1 even after 2000 cycles at a current rate of 4C, outperforming the state-of-the-art MnO2-based cathodes. The superior performance can be rationalized by the direct interaction between surface VO and the GO coating layer, as well as the regulation of structural evolution of β-MnO2 during cycling. The combinatorial design scheme in this work offers a practical pathway for obtaining high-rate and long-life cathodes for AZIBs.

Wastewater treatment high rate algal ponds (WWT HRAP) for low-cost biofuel production

2015 ◽  
Vol 184 ◽  
pp. 202-214 ◽  
Author(s):  
Abbas Mehrabadi ◽  
Rupert Craggs ◽  
Mohammed M. Farid
Keyword(s):  
Wastewater Treatment ◽  
Low Cost ◽  
Biofuel Production ◽  
High Rate ◽  
High Rate Algal Ponds
Sign in / Sign up

Export Citation Format

Share Document