Role of calcium and cross bridges in determining rate of force development in frog muscle fibers

1997 ◽  
Vol 272 (5) ◽  
pp. C1664-C1671 ◽  
Author(s):  
P. A. Wahr ◽  
J. A. Rall

The influence of Ca2+ and force-generating cross bridges on the kinetics of force development was examined in skinned frog muscle fibers activated by photolytic release of Ca2+ from caged Ca2+ at 10 degrees C. Isometric force development was fit by a double exponential equation with rates of 44.4 s-1 (kc1) and 6.1 s-1 (kc2); kc1 was not significantly different from the rate of force development observed in intact fibers. Maximum activation by caged Ca2+ from preexisting submaximal force produced rates of contraction similar to those observed with maximum activation from zero force. Decreasing the Ca2+ level to an extent that resulted in 50% of maximum force development produced an approximately sevenfold decrease in kc1 and no change in kc2. Partial extraction of troponin C reduced kc1 only slightly (by 16%), whereas decreasing the number of force-generating cross bridges by vanadate did not decrease kc1. Neither treatment altered kc2. Thus the rate of force development increases dramatically with increases in Ca2+ level.

1988 ◽  
Vol 91 (6) ◽  
pp. 761-779 ◽  
Author(s):  
D M Warshaw ◽  
D D Rees ◽  
F S Fay

Force development in smooth muscle, as in skeletal muscle, is believed to reflect recruitment of force-generating myosin cross-bridges. However, little is known about the events underlying cross-bridge recruitment as the muscle cell approaches peak isometric force and then enters a period of tension maintenance. In the present studies on single smooth muscle cells isolated from the toad (Bufo marinus) stomach muscularis, active muscle stiffness, calculated from the force response to small sinusoidal length changes (0.5% cell length, 250 Hz), was utilized to estimate the relative number of attached cross-bridges. By comparing stiffness during initial force development to stiffness during force redevelopment immediately after a quick release imposed at peak force, we propose that the instantaneous active stiffness of the cell reflects both a linearly elastic cross-bridge element having 1.5 times the compliance of the cross-bridge in frog skeletal muscle and a series elastic component having an exponential length-force relationship. At the onset of force development, the ratio of stiffness to force was 2.5 times greater than at peak isometric force. These data suggest that, upon activation, cross-bridges attach in at least two states (i.e., low-force-producing and high-force-producing) and redistribute to a steady state distribution at peak isometric force. The possibility that the cross-bridge cycling rate was modulated with time was also investigated by analyzing the time course of tension recovery to small, rapid step length changes (0.5% cell length in 2.5 ms) imposed during initial force development, at peak force, and after 15 s of tension maintenance. The rate of tension recovery slowed continuously throughout force development following activation and slowed further as force was maintained. Our results suggest that the kinetics of force production in smooth muscle may involve a redistribution of cross-bridge populations between two attached states and that the average cycling rate of these cross-bridges becomes slower with time during contraction.


Author(s):  
Carlos Rodriguez-Lopez ◽  
Julian Alcazar ◽  
Jose Losa-Reyna ◽  
JuanManuel Carmona-Torres ◽  
Aurora Maria Cruz-Santaella ◽  
...  

AbstractThis study investigated the acute responses to volume-load-matched heavy-load (80% 1RM) versus light-load (40% 1RM) power-oriented resistance training sessions in well-functioning older adults. Using a randomized cross-over design, 15 volunteers completed each condition on a leg press. Neuromuscular (maximal isometric force and rate of force development) and functional performance (power during sit-to-stand test), lactate, and muscle damage biochemistry (creatine kinase, lactate dehydrogenase and C-reactive protein serum concentration) were assessed pre- and post-exercise. Performance declines were found after heavy-load (Cohen’s d effect size (d); maximal isometric force=0.95 d; rate of force development=1.17 d; sit-to-stand power =0.38 d, all p<0.05) and light-load (maximal isometric force=0.45 d; rate of force development=0.9 d; sit-to-stand power=1.17 d, all p<0.05), while lactate concentration increased only after light-load (1.7 d, p=0.001). However, no differences were found between conditions (all p>0.05). Both conditions increased creatine kinase the day after exercise (marginal effect=0.75 d, p<0.001), but no other blood markers increased (all, p>0.05). Irrespective of the load used, power training induced non-clinically significant decreases in sit-to-stand performance, moderate declines in maximal isometric force, but pronounced decreases in the rate of force development. Furthermore, the metabolic stress and muscle damage were minor; both sessions were generally well tolerated by well-functioning older adults without previous experience in resistance training.


1997 ◽  
Vol 273 (5) ◽  
pp. H2428-H2435 ◽  
Author(s):  
Thomas Wannenburg ◽  
Paul M. L. Janssen ◽  
Dongsheng Fan ◽  
Pieter P. De Tombe

We tested the hypothesis that the Frank-Starling relationship is mediated by changes in the rate of cross-bridge detachment in cardiac muscle. We simultaneously measured isometric force development and the rate of ATP consumption at various levels of Ca2+ activation in skinned rat cardiac trabecular muscles at three sarcomere lengths (2.0, 2.1, and 2.2 μm). The maximum rate of ATP consumption was 1.5 nmol ⋅ s−1 ⋅ μl fiber vol−1, which represents an estimated adenosinetriphosphatase (ATPase) rate of ∼10 s−1 per myosin head at 24°C. The rate of ATP consumption was tightly and linearly coupled to the level of isometric force development, and changes in sarcomere length had no effect on the slope of the force-ATPase relationships. The average slope of the force-ATPase relationships was 15.5 pmol ⋅ mN−1 ⋅ mm−1. These results suggest that the mechanisms that underlie the Frank-Starling relationship in cardiac muscle do not involve changes in the kinetics of the apparent detachment step in the cross-bridge cycle.


Author(s):  
Danny Lum ◽  
Abdul Rashid Aziz

Force–time characteristics obtained during isometric strength tests are significantly correlated to various sporting movements. However, data on the relationship between isometric force–time characteristics and sprint kayaking performance are lacking in the literature. Purpose: The purpose of the study was, therefore, to investigate the relationship between sprint kayaking performance with ergometer performance and measures from 3 isometric strength tests: isometric squat, isometric bench press, and isometric prone bench pull. Methods: A total of 23 sprint kayaking athletes performed all 3 tests, at 90° and 120° knee angles for isometric squat and at elbow angles for isometric bench press and isometric prone bench pull, and a 200-m sprint on-water to attain the fastest time-to-completion (OWTT) possible and on a kayak ergometer to attain the highest mean power (LABTT) possible. Results: There was a significant inverse correlation between OWTT and LABTT (r = −.90, P < .001). The peak forces achieved from all isometric strength tests were significantly correlated with time-to-completion for OWTT and mean power for LABTT (r = −.44 to −.88, P < .05 and .47 to .80, P < .05, respectively). OWTT was significantly correlated with the peak rate of force development during all isometric tests except for the isometric squat at a 120° knee angle (r = −.47 to −.62, P < .05). LABTT was significantly correlated with peak rate of force development from the isometric bench press and isometric prone bench pull (r = .64–.86, P < .01). Conclusion: Based on the observed strong correlations, the mean power attained during LABTT is a good predictor of OWTT time-to-completion. Furthermore, upper- and lower-body maximum strength and peak rate of force development are equally important for on-water and ergometer sprint kayaking performance.


1992 ◽  
Vol 73 (1) ◽  
pp. 71-74 ◽  
Author(s):  
B. M. Block ◽  
S. R. Barry ◽  
J. A. Faulkner

We hypothesized that methylxanthines, such as aminophylline, increase the power developed by submaximally activated frog skeletal muscles by increasing the force developed at any given velocity of shortening. Frog semitendinosus muscles were excised and tested at 20 degrees C in oxygenated control and aminophylline Ringer solutions. Force-velocity relationships were determined and power was calculated from muscles stimulated at frequencies of 80 and 300 Hz. The 300-Hz frequency of stimulation produced a maximum rate of force development. In 50 and 500 microM aminophylline, twitch force increased by 25 +/- 12 and 75 +/- 13%, respectively. Aminophylline did not affect maximum isometric force generation or the shortening velocity at any relative load. At 80-Hz stimulation and in the presence of 500 microM aminophylline, power increased by an average of 11% at 10 of 14 relative loads. At maximum frequencies of stimulation, aminophylline had no effect on any measured parameter. We conclude that aminophylline increases the power developed by submaximally activated frog muscles through an increase in the force generated particularly at the lower velocities of shortening.


1998 ◽  
Vol 275 (2) ◽  
pp. C375-C381 ◽  
Author(s):  
Y.-B. Sun ◽  
C. Caputo ◽  
K. A. P. Edman

The effects of 1,2-bis(2-aminophenoxy)ethane- N, N, N′, N′-tetraacetic acid (BAPTA) on force and intracellular Ca2+ transient were studied during isometric twitches and tetanuses in single frog muscle fibers. BAPTA was added to the bathing solution in its permeant AM form (50 and 100 μM). There was no clear correlation between the changes in force and the changes in Ca2+ transient. Thus during twitch stimulation BAPTA did not suppress the Ca2+ transient until the force had been reduced to <50% of its control value. At the same time, the peak myoplasmic free Ca2+concentration reached during tetanic stimulation was markedly increased, whereas the force was slightly reduced by BAPTA. The effects of BAPTA were not duplicated by using another Ca2+ chelator, EGTA, indicating that BAPTA may act differently as a Ca2+ chelator. Stiffness measurements suggest that the decrease in mechanical performance in the presence of BAPTA is attributable to a reduced number of active cross bridges. The results could mean that BAPTA, under the conditions used, inhibits the binding of Ca2+ to troponin C resulting in a reduced state of activation of the contractile system.


2020 ◽  
Vol 45 (9) ◽  
pp. 996-1006 ◽  
Author(s):  
Spyridon Methenitis ◽  
Thomas Mpampoulis ◽  
Polyxeni Spiliopoulou ◽  
George Papadimas ◽  
Constantinos Papadopoulos ◽  
...  

This study aimed to investigate the effect of 3 different eccentric-only power training volumes on muscle fiber type composition and power performance. Twenty-nine females were assigned into 3 groups and performed 10 weeks of either 3 (low volume), 6 (moderate volume), or 9 (high volume) sets/session of 4 fast-velocity eccentric-only half-squats against 70% of concentric 1-repetition maximum (1RM), followed by 3 maximum countermovement jumps (CMJs) after each set. Half-squat 1RM, CMJ height/power, maximum isometric force, rate of force development (RFD) and muscle fiber cross-sectional area (CSA) were increased in all groups (p = 0.001). Low-volume training induced higher increases in CMJ height/power and early RFD, compared with the moderate- and high-volume training programs (p < 0.001). Significant reductions in type IIx muscle fiber percentages and %CSAs were found after moderate- and high-volume training, with concomitant increases in type IIa fibers (p = 0.001). Significant correlations were found between the changes in type IIa and type IIx percentages, fiber CSA, %CSA, and the changes in performance (r: –0.787 to 0.792; p < 0.05). These results suggest that relatively large eccentric power training volumes may result in detrimental neuromuscular adaptations, minimal changes in early RFD, and a reduction of type IIx muscle fiber percentage. Novelty Low but not high volume of power training maintains type IIx muscle fibers. Early rate of force development increases after a low- or moderate-power training volume, but not after a high-power training volume. Training-induced changes in type IIx muscle fiber percentage is related with changes in early rate of force development.


Sign in / Sign up

Export Citation Format

Share Document