Reduction of adsorbable organically bound halogens (AOX) formation at near-neutral pH chlorine dioxide bleaching of softwood kraft pulp

Holzforschung ◽  
2020 ◽  
Vol 74 (6) ◽  
pp. 597-604
Author(s):  
Sara Starrsjö ◽  
Olena Sevastyanova ◽  
Peter Sandström ◽  
Juha Fiskari ◽  
Maria Boman ◽  
...  
Keyword(s):  
Chlorine Dioxide ◽  
High Selectivity ◽  
Bicarbonate Buffer ◽  
Neutral Ph ◽  
Elemental Chlorine ◽  
Pulp Viscosity ◽  
Softwood Kraft Pulp ◽  
New Type ◽  
Adsorbable Organically Bound Halogens

AbstractRecently, a new type of bleaching sequence, Elemental Chlorine Free (ECF) light with one D stage, has been developed. It combines the efficiency and high selectivity of chlorine dioxide (ClO2) bleaching with more environmental friendly oxygen based bleaching chemicals. This work examines the effect of pH on the formation of adsorbable organically bound halogens (AOX) in an intermediate D stage – a single ClO2 stage at the middle of an ECF light bleaching sequence. Carbon dioxide (CO2) is used to generate a bicarbonate buffer in situ, stabilizing the pH during the bleaching. Near-neutral pH is hypothesized to decrease the formation of strongly chlorinating species, so that the AOX formation is reduced. The results indicate that a near-neutral pH D stage can reduce the AOX content in the effluents with up to 30%. The ISO brightness was unchanged to a lower ClO2 consumption. The pulp viscosity was slightly higher after near-neutral pH D stage, but to its disadvantage a lesser delignification and removal of HexA was obtained. The degradation of HexA correlated well with the AOX, affirming earlier theories that HexA has a major impact on the AOX formation. The higher amounts of residual HexA and lignin resulted in more thermal yellowing of the pulps bleached with a near-neutral pH D stage.

Optimization of elemental chlorine-free bleaching for a softwood kraft pulp • part 2: economic analysis of chemical and steam consumption

TAPPI Journal ◽  
2010 ◽  
Vol 9 (9) ◽  
pp. 47-53 ◽  
Author(s):  
BRIAN N. BROGDON
Keyword(s):  
Chlorine Dioxide ◽  
Previous Investigation ◽  
Kraft Pulp ◽  
Energy Costs ◽  
Alkaline Extraction ◽  
Stage Versus ◽  
Kraft Pulps ◽  
Steam Consumption ◽  
Elemental Chlorine ◽  
Softwood Kraft Pulp

Our previous investigation [1] re-analyzed the data from Basta and co-workers (1992 TAPPI Pulping Conference) to demonstrate how oxidative alkaline extraction can be augmented and how these changes affect chlorine dioxide consumption with elemental chlorine-free (ECF) sequences. The current study manipulates extraction delignification variables to curtail bleaching costs with a conventional U.S. Southern softwood kraft pulp. The economic advantages of ~0.35% to 0.65% H2O2 peroxide reinforcement in a 70°C (EOP)-stage versus 90°C (EO)-stage are predisposed to the brightness targets, to short or long bleach sequences, and to mill energy costs. Minimized bleaching costs are generally realized when a 90°C (EO) is employed in D0(EO)D1 bleaching, whereas a 70°C (EOP) is economically advantageous for D0(EOP)D1E2D2 bleaching. The findings we disclose here help to clarify previous ECF optimization studies of conventional softwood kraft pulps.

Optimization of elemental chlorine-free bleaching for a softwood kraft pulp – part 1: impact of oxidative extraction on chlorine dioxide stoichiometry

TAPPI Journal ◽  
2010 ◽  
Vol 9 (8) ◽  
pp. 27-35 ◽  
Author(s):  
BRIAN N. BROGDON
Keyword(s):  
Decision Making ◽  
Chlorine Dioxide ◽  
Kraft Pulp ◽  
Alkaline Extraction ◽  
Pulp Bleaching ◽  
Elemental Chlorine ◽  
Kraft Pulp Bleaching ◽  
Softwood Kraft Pulp ◽  
Chemical Usage ◽  
Minimize Costs

The present investigation meticulously analyzes how oxidative alkaline extraction can be augmented through process changes, and how these augmentations can be leveraged to optimize chlorine dioxide usage with elemental chlorine-free (ECF) sequences for a conventional softwood kraft pulp. Bleaching data from Basta and co-workers (1992 TAPPI Pulping Conference) are re-examined and re-interpreted in this study. We determined that ~60% to 65% of the overall ClO2 charge should be applied in the D0-stage. Peroxide addition to an (EOP) can replace 0.6 to 2.5 Kg. ClO2 per Kg H2O2. Boosting the (EO) temperature to 80°C is equivalent to a 70°C (EOP) with 0.25% to 0.30% H2O2,whereas a 90°C (EO) is equivalent to 0.50% – 0.75% H2O2 in a 70°C (EOP). The stoichiometric bleaching data from this study can guide decision-making for lowering chemical usage and minimize costs to reach target brightness levels with three- and five-stage sequences.

Elemental chlorine-free bleaching of North American hardwood kraft pulps: Evaluation of oxidant-reinforced extraction variables on overall bleaching optimization

TAPPI Journal ◽  
2013 ◽  
Vol 12 (10) ◽  
pp. 33-41 ◽  
Author(s):  
BRIAN N. BROGDON
Keyword(s):  
Response Surface ◽  
Chlorine Dioxide ◽  
North American ◽  
Yield Loss ◽  
Alkaline Extraction ◽  
Kraft Pulps ◽  
Pulp Bleaching ◽  
Response Surface Models ◽  
Elemental Chlorine ◽  
Surface Models

This investigation evaluates how higher reaction temperatures or oxidant reinforcement of caustic extraction affects chlorine dioxide consumption during elemental chlorine-free bleaching of North American hardwood pulps. Bleaching data from the published literature were used to develop statistical response surface models for chlorine dioxide delignification and brightening sequences for a variety of hardwood pulps. The effects of higher (EO) temperature and of peroxide reinforcement were estimated from observations reported in the literature. The addition of peroxide to an (EO) stage roughly displaces 0.6 to 1.2 kg chlorine dioxide per kilogram peroxide used in elemental chlorine-free (ECF) bleach sequences. Increasing the (EO) temperature by Δ20°C (e.g., 70°C to 90°C) lowers the overall chlorine dioxide demand by 0.4 to 1.5 kg. Unlike what is observed for ECF softwood bleaching, the presented findings suggest that hot oxidant-reinforced extraction stages result in somewhat higher bleaching costs when compared to milder alkaline extraction stages for hardwoods. The substitution of an (EOP) in place of (EO) resulted in small changes to the overall bleaching cost. The models employed in this study did not take into account pulp bleaching shrinkage (yield loss), to simplify the calculations.

Application of pure, thermostable, alkali-tolerant xylanase in bleaching of oxygen-delignified pine kraft pulp

TAPPI Journal ◽  
2015 ◽  
Vol 14 (11) ◽  
pp. 689-694
Author(s):  
QINGZHI MA ◽  
QI WANG ◽  
CHU WANG ◽  
NIANJIE FENG ◽  
HUAMIN ZHAI
Keyword(s):  
Intrinsic Viscosity ◽  
Chlorine Dioxide ◽  
High Purity ◽  
Kraft Pulp ◽  
Alkaline Media ◽  
Industrial Scale ◽  
Elemental Chlorine ◽  
Effect Of Oxygen ◽  
Alkaline Tolerant ◽  
Ecf Bleaching

The effect of oxygen (O2)-delignified pine kraft pulp pretreatment by high-purity, thermostable, and alkaline-tolerant xylanases on elemental chlorine free (ECF) bleaching of O2-delignification kraft pulp was studied. The study found that xylanase pretreatment preserved the intrinsic viscosity and yield of O2-delignified pulp while causing about 7% of delignification with high delignification selectivity. The xylanases with high purity, higher thermostability (75°C~80°C) in highly alkaline media (pH 8.0~9.5) could be applied on an industrial scale. Pulp pretreatment by the high-purity, thermostable, and alkaline tolerant xylanases could improve pulp brightness or reduce the chlorine dioxide (ClO2) consumption. In a D0ED1D2 bleaching sequence using the same amount of ClO2, the xylanase-pretreated pulp obtained a higher brightness (88.2% vs. 89.7% ISO) at the enzyme dose of 2 U/g pulp; or for the same brightness as control (88.2% ISO), the ClO2 dosage in the D0 stage was reduced by 27%, which represents a 16% savings in total ClO2 used for bleaching.

scholarly journals Engineered Phage Endolysin Eliminates Gardnerella Biofilm without Damaging Beneficial Bacteria in Bacterial Vaginosis Ex Vivo

Pathogens ◽  
2021 ◽  
Vol 10 (1) ◽  
pp. 54
Author(s):  
Christine Landlinger ◽  
Lenka Tisakova ◽  
Vera Oberbauer ◽  
Timo Schwebs ◽  
Abbas Muhammad ◽  
...  
Keyword(s):  
Bacterial Vaginosis ◽  
Bactericidal Activity ◽  
High Selectivity ◽  
Ex Vivo ◽  
Vaginal Microbiome ◽  
Wild Type ◽  
Wild Type Enzyme ◽  
Promising Alternative ◽  
First Time

Bacterial vaginosis is characterized by an imbalance of the vaginal microbiome and a characteristic biofilm formed on the vaginal epithelium, which is initiated and dominated by Gardnerella bacteria, and is frequently refractory to antibiotic treatment. We investigated endolysins of the type 1,4-beta-N-acetylmuramidase encoded on Gardnerella prophages as an alternative treatment. When recombinantly expressed, these proteins demonstrated strong bactericidal activity against four different Gardnerella species. By domain shuffling, we generated several engineered endolysins with 10-fold higher bactericidal activity than any wild-type enzyme. When tested against a panel of 20 Gardnerella strains, the most active endolysin, called PM-477, showed minimum inhibitory concentrations of 0.13–8 µg/mL. PM-477 had no effect on beneficial lactobacilli or other species of vaginal bacteria. Furthermore, the efficacy of PM-477 was tested by fluorescence in situ hybridization on vaginal samples of fifteen patients with either first time or recurring bacterial vaginosis. In thirteen cases, PM-477 killed the Gardnerella bacteria and physically dissolved the biofilms without affecting the remaining vaginal microbiome. The high selectivity and effectiveness in eliminating Gardnerella, both in cultures of isolated strains as well as in clinically derived samples of natural polymicrobial biofilms, makes PM-477 a promising alternative to antibiotics for the treatment of bacterial vaginosis, especially in patients with frequent recurrence.

ATP depletion and mitochondrial functional loss during ischemia in slow and fast heart-rate hearts

1990 ◽  
Vol 259 (6) ◽  
pp. H1759-H1766 ◽  
Author(s):  
W. Rouslin ◽  
C. W. Broge ◽  
I. L. Grupp
Keyword(s):  
Mitochondrial Function ◽  
Atp Depletion ◽  
Mitochondrial Atpase ◽  
Small Contribution ◽  
Bicarbonate Buffer ◽  
Tissue Ph ◽  
Atp Production ◽  
Dog Heart ◽  
Rat Hearts

In the present study, isolated dog and rat hearts were perfused in the Langendorff mode with Krebs bicarbonate buffer in the absence and presence of 10(-5) M oligomycin. The perfusion protocols employed allowed tissue pH to drop during subsequent ischemic incubations essentially as it would in blood-perfused hearts. Tissue pH, ATP, lactate, and mitochondrial respiratory function were measured during the course of subsequent zero-flow ischemic incubations. The adenosinetriphosphatase (ATPase) activities attributable to both mitochondrial and nonmitochondrial ATPases in sonicated heart homogenates and the actomyosin ATPase in isolated cardiac myofibrils were measured in both species. Consistent with earlier results with a different model in which tissue pH was buffered during the ischemic incubations [W. Rouslin, J. L. Erickson, and R. J. Solaro. Am. J. Physiol. 250 (Heart Circ. Physiol. 19): H503-H508, 1986], the inhibition of the mitochondrial ATPase in situ by oligomycin markedly slowed both tissue ATP depletion and the loss of mitochondrial function during ischemia in the dog. However, oligomycin had only a very small and transient effect on ATP depletion and mitochondrial function in the rat. This was apparently so because of the fivefold higher rate of glycolytic ATP production as well as the nearly threefold higher total nonmitochondrial ATPase activity of ischemic rat compared with ischemic dog heart. These results suggest that although the inhibition of the mitochondrial ATPase makes a major contribution to ATP conservation in ischemic dog heart, it makes only a very small contribution in rat.

Sign in / Sign up

Export Citation Format

Share Document