scholarly journals Selection of sowing date and biofertilization as alternatives to improve the yield and profitability of the F68 rice variety

2020 ◽  
Vol 38 (1) ◽  
pp. 61-72
Author(s):  
Yeison Mauricio Quevedo-Amaya ◽  
José Isidro Beltrán-Medina ◽  
José Álvaro Hoyos-Cartagena ◽  
John Edinson Calderón-Carvajal ◽  
Eduardo Barragán-Quijano

Multiple factors influence rice yield. Developing management practices that increase crop yield and an efficient use of resources are challenging to modern agriculture. Consequently, the aim of this study was to evaluate biological nitrogen fixation and bacterial phosphorous solubilization (biofertilization) practices with the selection of the sowing date. Three sowing dates (May, July and August) were evaluated when interacting with two mineral nutrition treatments using a randomized complete block design in a split-plot arrangement. Leaf carbon balance, leaf area index, interception and radiation use efficiency, harvest index, dry matter accumulation, nutritional status, and yield were quantified. Results showed that the maximum yield was obtained in the sowing date of August. Additionally, yield increased by 18.92% with the biofertilization treatment, reaching 35.18% of profitability compared to the local production practice. High yields were related to a higher carbon balance during flowering, which was 11.56% and 54.04% higher in August than in July and May, respectively, due to a lower night temperature. In addition, a high efficient use of radiation, which in August was 17.56% and 41.23% higher than in July and May, respectively, contributed to obtain higher yields and this behavior is related to the selection of the sowing date. Likewise, a rapid development of the leaf area index and an optimum foliar nitrogen concentration (>3%) were observed. This allowed for greater efficient use of radiation and is attributed to the activity of nitrogen-fixing and phosphate solubilizing bacteria that also act as plant growth promoters.

2010 ◽  
Vol 2010 ◽  
pp. 1-7 ◽  
Author(s):  
H. Arnold Bruns ◽  
Hamed K. Abbas

Four glyphosate resistant corn (Zea maysL.) hybrids, a glufosinate-ammonium resistant hybrid, and a conventional atrazine resistant hybrid gown at Stoneville, MS in 2005, 2006, and 2007 with furrow irrigation were treated with their respective herbicides and their growth, yield, and mycotoxin incidence were compared with untreated cultivated plots. Leaf area index (LAI) and dry matter accumulation (DMA) were collected on a weekly basis beginning at growth stage V3 and terminating at anthesis. Crop growth rates (CRGs) and relative growth rates (RGRs) were calculated. Plots were later harvested, yield and yield component data collected, and kernel samples analyzed for aflatoxin and fumonisin. Leaf area index, DMA, CRG, and RGR were not different among the herbicide treated plots and from those that were cultivated. Curves for LAI and DMA were similar to those previously reported. Aflatoxin and fumonisin were relatively low in all plots. Herbicide application or the lack thereof had no negative impact on the incidence of kernel contamination by these two mycotoxins. Herbicides, especially glyphosate on resistant hybrids, have no negative effects on corn yields or kernel quality in corn produced in a humid subtropical environment.


2017 ◽  
Vol 5 (4) ◽  
pp. 423-429 ◽  
Author(s):  
Mohan Mahato ◽  
Bishnu Bilas Adhikari

A field experiment was conducted under humid subtropical agro-climatic condition of Nepal during rainy season of 2014. The experiment was laid out in to two factor Randomized Complete Block Design with  three replications consisting three drought tolerant rice varieties (Sukhadhan-4, Sukhadhan-5 and Radha-4) and four planting geometry (15 cm × 10 cm, 15 cm × 15 cm, 20 cm × 15 cm and 20 cm × 20 cm). The results revealed that the highest plant height and maximum leaf area index was recorded in planting geometry 15 cm × 10 cm in all growth stages. Whereas, planting geometry 20 cm × 15 cm produced the maximum number of tiller m-2 in all growth stage.  While planting geometry 20 cm × 15 cm and 20 cm × 20 cm produced statistically similar crop growth rate and dry matter accumulation in all stage of growth. Regarding the varieties, Sukhadhan- 4 showed highest plant height up to 75 DAT and plant height was statistically similar to Radha - 4 in 60 and 75 DAT. But maximum number of tiller m-2, leaf area index, crop growth rate and dry matter accumulation were recorded in Sukhadhan – 5 varieties. Int. J. Appl. Sci. Biotechnol. Vol 5(4): 423-429


Author(s):  
Rupinder Kaur Jassal ◽  
Harmeet Singh

An experiment was conducted at Punjab Agricultural University, Ludhiana during 2015 and 2016 to study the effect of priming, different seed rate on growth and seed yield of soybean planted under bed and flat method. The study was planned in factorial split plot design, keeping two planting techniques (flat sowing and bed sowing) and two seed priming treatments ( non primed seeds and 100 ppm GA3 primed seeds) in main plot and three seed levels ( 50, 62.5 and 75 kg ha-1) in sub plot. The objective of the study was to evaluate the effect of seed priming on growth and productivity under different planting techniques with the use of varying seed rates. The results revealed that growth attributes viz. emergence count, plant height, dry matter accumulation, leaf area index and photosynthetic active radiation interception (%) was significantly higher under bed planting technique as compared to flat sowing method. The pooled seed yield was increased by 15.6 % in bed planted soybean crop as compared to flat planted crop. Soybean seeds primed with 100 ppm GA3 recorded significant results in all the growth parameters. Primed seed recorded increase in yield 15.3 % than non primed seeds. Seed rate of 62.5 kg ha-1 recorded significantly higher emergence count, plant height, dry matter accumulation, leaf area index and photosynthetic active radiation interception (%) which was statistically similar in results with 75 kg ha-1 seed rate in both the two years. Pooled seed yield of 62.5 kg ha-1seed rate was 4.61 % higher than 75 kg ha-1 and 12.6 % than 50 kg ha-1 seed rate.


1981 ◽  
Vol 96 (1) ◽  
pp. 167-186 ◽  
Author(s):  
D. W. Lawlor ◽  
W. Day ◽  
A. E. Johnston ◽  
B. J. Legg ◽  
K. J. Parkinson

SUMMARYThe effects of water deficit on growth of spring barley were analysed under five irrigation treatments. One crop was irrigated at weekly intervals from emergence throughout the growing season, and one was not irrigated at all after emergence. Soil water deficits in the other treatments were allowed to develop early, intermediate or late in the crop's development.Weekly irrigation produced a crop with a large leaf area index (maximum value 4) and maintained green leaf and awns throughout the grain-filling period. Early drought decreased leaf area index (maximum value 2) by slowing expansion of main-stem leaves and decreasing the number and growth of tiller leaves. Leaf senescence was also increased with drought. Drought late in the development of ears and leaves and during the grain-filling period caused leaves and awns to senesce so that the total photosynthetic areas decreased faster than with irrigation. Photosynthetic rate per unit leaf area was little affected by drought so total dry-matter production was most affected by differences in leaf area.Early drought gave fewer tillers (550/m2) and fewer grains per ear (18) than did irrigation (760 tillers/m2 and 21 grains per ear). Late irrigation after drought increased the number of grains per ear slightly but not the number of ears/m2. Thus at the start of the grain-filling period crops which had suffered drought early had fewer grains than irrigated (9·5 and 18·8 × 103/m2 respectively) or crops which suffered drought later in development (14 × 103/m2).During the first 2 weeks of filling, grains grew at almost the same rate in all treatments. Current assimilate supply was probably insufficient to provide this growth in crops which had suffered drought, and stem reserves were mobilized, as shown by the decrease in stem mass during the period. Grains filled for 8 days longer with irrigation and were heavier (36–38 mg) than without irrigation (29–30 mg). Drought throughout the grainfilling period after irrigation earlier in the season resulted in the smallest grains (29 mg).Grain yield depended on the number of ears, the number of grains per ear and mass per grain. Early drought decreased tillering and tiller ear production and the number of grains that filled in each ear. Late drought affected grain size via the effects on photosynthetic surface area.Drought decreased the concentrations of phosphorus, potassium and magnesium in the dry matter of crops, and irrigation after drought increased them. Concentration of nitrogen was little affected by treatment. Possible mechanisms by which water deficits and nutrient supply affect crop growth and yield are discussed.


1986 ◽  
Vol 78 (1) ◽  
pp. 47-53 ◽  
Author(s):  
S. C. Mason ◽  
D. E. Leihner ◽  
J. J. Vorst ◽  
E. Salazar

2016 ◽  
pp. 111-115
Author(s):  
Éva Vincze ◽  
Péter Pepó

We made plant physiology examinations in Arkaso winter oilseed rape hybrid substance: relative chlorophyll content (SPAD) and leaf area index (LAI) measurements. The experiment was set in University of Debrecen Agricultural Sciences Center at Látóképi Experimental Station in four replications, in two different sowing times (I. sowing date on 08/22/2014 and II. sowing date on 09/09/2014 sowing againhappened because of the incomplete germination in the second subtance 01/10/2014) Three different plant density 200, 350 and 500 thousand ha-1, under the same nutrient supply, 45 cm row spacing. The experiment was green crop of winter wheat. The relative chlorophyll content (SPAD) and leaf area index (LAI) measurements were made in seven different times. We measured the maximum value of chlorophyll content in the first sowing time at 500, and the second sowing time at 350 thousand ha-1 plant density. The measurement results proved that there was a linear relationship between the number of plants and the LAI. The maximum leaf area index values we measured in both the sowing time at 500 thousand ha-1 reached.


2015 ◽  
pp. 5-10
Author(s):  
Enikő Bene ◽  
Mihály Sárvári

  Our sowing date experiment took place in the Demonstration Garden of Institution of Plant Sciences, Agricultural Center of University of Debrecen, in 2012–2014. The thesis contains data of test year 2014. Our purpose, besides several other examinations, was to observe how sowing date influences leaf area index and activity of photosynthesis of maize hybrids, and how those factors affect fruiting. In the experiment we monitored the change of the leaf area index and the photosynthesis of hybrids with four different growing seasons. Based on the results, it can be concluded that most of the examined hybrids reached their smallest leaf area with the third sowing date and with the highest yield results. Hybrid Da Sonka had the largest leaf area (4.10 m2 m-2), and hybrid DKC 4590 produced the highest yield (13.16 t ha-1) with the third sowing date. During testing the photosynthetic capacity, the extremely high performance of the youngest plants with the third sowing date is outstanding, which can be explained by the different ripening periods. Examination of the correlation between the photosynthetic capacity and the yield, by linear regression analysis, also proves that photosynthesis has a determinative role in fruiting. The results obtained confirm that not only the environmental and agricultural factors in the growing season have effect on the yield, but also other factors like the leaf area index and the photosynthesis are determinative parameters, and all those factors together, modifying effects of each other, develop average yields.


2020 ◽  
Vol 203 ◽  
pp. 02008
Author(s):  
Baifeng Cang ◽  
Hao Jiang ◽  
Rong Ma ◽  
Yunzhe Li ◽  
Jingjing Cui ◽  
...  

In order to study the application of light and simplified cultivation mode in straw returning field. In the experiment, two treatments of straw returning and non-straw returning were used under the light simplified cultivation mode, and the differences of tiller number, dry matter accumulation, leaf area index, chlorophyll and yield were studied. Field cultivation experiments were carried out with Jihong 9 and Jinongda 138. The results showed that the yields of Jihong 9 and Jinongda138 straw returning to the field under the light and simplified cultivation mode were 2.00% and 3.63% higher than those under the non-straw returning mode. The total grain number in the yield components increased by 3.35% and 11.60% respectively. Dry matter increased by 19.70% and 7.66% in mature period. The leaf area index (LAI) and SPAD value in the later period of straw returning were higher than those in the non-straw returning, and the number of effective tillers was lower. Light and simplified cultivation can be used as a new mode of rice high-yield cultivation under straw returning, which improves the total grain number, leaf area index, SPAD value and dry matter in the later stage, and increases rice yield. The yield advantage of Jinongda 138 under straw returning (SJ138) is more significant.


Biologija ◽  
2016 ◽  
Vol 62 (1) ◽  
Author(s):  
Raouf Seyed Sharifi ◽  
Ali Namvar

Crop phenology is one of the most important aspects of crop yield determination and it is essential to predicting physiological responses under varying field conditions. In order to evaluate plant density and intra-row spacing effects on phenology, dry matter accumulation, and leaf area index of maize in second cropping, a factorial experiment based on randomized complete block design was conducted at the research farm of the University of Mohaghegh Ardabili. Experimental factors were: plant population at three levels (7, 9, and 11 plants m–2) with three levels of intra-row spacing (45, 60, and 75 cm). The results showed that the maximum plant height (179.07  cm), total dry matter (592  g  m–2) in 83–91 days after sowing, days to 50% anthesis (45 days), days to 50% silking (50 days), LAI (4.07) in 63–70 days after sowing were observed in the plots with 11 plants m–2 and intra-row spacing of 45 cm. Based on the results, it was concluded that application of 11 plants m–2 with row spacing of 45 cm can be recommended for profitable maize production.


Sign in / Sign up

Export Citation Format

Share Document