scholarly journals Investigation of Band Tailing in Sputtered ZnO:Al Thin Films Regarding Structural Properties and Impurities

2014 ◽  
Vol 1699 ◽  
Author(s):  
Steffi Schönau ◽  
Florian Ruske ◽  
Sebastian Neubert ◽  
Bernd Rech
Keyword(s):  
Thin Films ◽  
Band Gap ◽  
Pure Aluminum ◽  
Growth Conditions ◽  
Band Gap Energy ◽  
Absorption Feature ◽  
Spectral Absorption ◽  
Spectral Absorption Coefficient ◽  
Additional Absorption ◽  
Band Tailing

ABSTRACTThin films of pure aluminum doped ZnO and with addition of nitrogen, oxygen and hydrogen have been prepared by magnetron sputtering. The spectral absorption coefficient close to the band gap energy has been determined by spectrophotometry and analyzed regarding band tailing and creation of defect bands. We found, that an improvement of Raman crystallinity under O2- rich growth conditions is not accompanied by a suppression of band tailing as expected. An additional absorption feature evolves for layers grown in N2 containing atmosphere. Doping with hydrogen attenuates sub-band gap absorption.

Stability Investigation in the Optical Properties of Thermally Evaporated Ge5Se95-x Znx Thin Films

2015 ◽  
Vol 7 (3) ◽  
pp. 1923-1930
Author(s):  
Austine Amukayia Mulama ◽  
Julius Mwakondo Mwabora ◽  
Andrew Odhiambo Oduor ◽  
Cosmas Mulwa Muiva ◽  
Boniface Muthoka ◽  
...  
Keyword(s):  
Thin Films ◽  
Band Gap ◽  
Optical Band Gap ◽  
Thermal Evaporation ◽  
Optical Transition ◽  
Bulk Material ◽  
Band Gap Energy ◽  
Optical Absorbance ◽  
Gap Energy ◽  
Constituent Elements

 Selenium-based chalcogenides are useful in telecommunication devices like infrared optics and threshold switching devices. The investigated system of Ge5Se95-xZnx (0.0 ≤ x ≤ 4 at.%) has been prepared from high purity constituent elements. Thin films from the bulk material were deposited by vacuum thermal evaporation. Optical absorbance measurements have been performed on the as-deposited thin films using transmission spectra. The allowed optical transition was found to be indirect and the corresponding band gap energy determined. The variation of optical band gap energy with the average coordination number has also been investigated based on the chemical bonding between the constituents and the rigidity behaviour of the system’s network.

Fabrication and Photoelectrochemical Characterization of Fe, Co, Ni and Cu-Doped TiO2 Thin Films

2013 ◽  
Vol 764 ◽  
pp. 266-283 ◽  
Author(s):  
Ibram Ganesh ◽  
Rekha Dom ◽  
P.H. Borse ◽  
Ibram Annapoorna ◽  
G. Padmanabham ◽  
...  
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Metal Ions ◽  
Band Gap ◽  
Metal Ion ◽  
Band Gap Energy ◽  
Chemical Compositions ◽  
Gap Energy ◽  
Glass Substrates ◽  
Photoelectrochemical Characterization

Different amounts of Fe, Co, Ni and Cu-doped TiO2 thin films were prepared on fluorine doped tin oxide (FTO) coated soda-lime glass substrates by following a conventional sol-gel dip-coating technique followed by heat treatment at 550 and 600°C for 30 min. These thin films were characterized for photo-current, chronoamperometry and band-gap energy values. The chemical compositions of metals-doped TiO2 thin films on FTO glass substrates were confirmed by XPS spectroscopic study. The metal-ions doped TiO2 thin films had a thickness of <200 nm="" optical="" transparency="" of="">80%, band-gap energy of >3.6 eV, and a direct band-to-band energy transition. The photoelectrochemical (PEC) studies revealed that all the metal-ions doped TiO2 thin films exhibit n-type semi-conducting behavior with a quite stable chronoamperometry and photo-currents that increase with the increase of applied voltage but decrease with the dopant metal-ion concentration in the thin film. Furthermore, these thin films exhibited flat-band potentials amenable to water oxidation reaction in a PEC cell. The 0.5 wt.% Cu-doped TiO2 thin film electrode exhibited an highest incident photon-to-current conversion efficiency (IPCE) of about 21%.

Band gap tuning and p to n-type transition in Mn-doped CuO nanostructured thin films

2022 ◽  
Vol 43 (1) ◽  
pp. 012801
Author(s):  
R. Rahaman ◽  
M. Sharmin ◽  
J. Podder
Keyword(s):  
Thin Films ◽  
Band Gap ◽  
Spray Pyrolysis Technique ◽  
Band Gap Energy ◽  
Dielectric Constants ◽  
X Rays ◽  
Electron Effective Mass ◽  
Mn Doping ◽  
Type Transition ◽  
Mn Doped

Abstract Here we discuss the synthesis of copper (II) oxide (CuO) and manganese (Mn)-doped CuO thin films varying with 0 to 8 at% Mn using the spray pyrolysis technique. As-deposited film surfaces comprised of agglomerated spherical nanoparticles and a semi-spongy porous structure for 4 at% Mn doping. Energy dispersive analysis of X-rays confirmed the chemical composition of the films. X-ray diffraction spectra showed a polycrystalline monoclinic structure with the predominance of the ( 11) peak. Optical band gap energy for direct and indirect transitions was estimated in the ranges from 2.67–2.90 eV and 0.11–1.73 eV, respectively. Refractive index and static dielectric constants were computed from the optical spectra. Electrical resistivity of CuO and Mn-doped CuO (Mn:CuO) thin films was found in the range from 10.5 to 28.6 Ω·cm. The tiniest electron effective mass was calculated for 4 at% Mn:CuO thin films. P to n-type transition was observed for 4 at% Mn doping in CuO films. Carrier concentration and mobility were found in the orders of 1017 cm–3 and 10–1 cm2/(V·s), respectively. The Hall coefficient was found to be between 9.9 and 29.8 cm3/C. The above results suggest the suitability of Mn:CuO thin films in optoelectronic applications.

scholarly journals Effect of thickness on the optical properties of Gaas thin films

2013 ◽  
Vol 37 (1) ◽  
pp. 83-91 ◽  
Author(s):  
Chitra Das ◽  
Jahanara Begum ◽  
Tahmina Begum ◽  
Shamima Choudhury
Keyword(s):  
Thin Films ◽  
Dielectric Constant ◽  
Refractive Index ◽  
Band Gap ◽  
Optical Band Gap ◽  
Visible Region ◽  
Solar Spectrum ◽  
Band Gap Energy ◽  
Optical Parameters ◽  
Gap Energy

Effect of thickness on the optical and electrical properties of gallium arsenide (GaAs) thin films were studied. The films of different thicknesses were prepared by vacuum evaporation method (~10-4 Pa) on glass substrates at a substrate temperature of 323 K. The film thickness was measured in situ by a frequency shift of quartz crystal. The thicknesses were 250, 300 and 500 nm. Absorption spectrum of this thin film had been recorded using UV-VIS-NIR spectrophotometer in the photon wavelength range of 300 - 2500 nm. The values of some important optical parameters of the studied films (absorption coefficient, optical band gap energy and refractive index; extinction co-efficient and real and imaginary parts of dielectric constant) were determined using these spectra. Transmittance peak was observed in the visible region of the solar spectrum. Here transmittance showed better result when thicknesses were being increased. The optical band gap energy was decreased by the increase of thickness. The refractive index increased by increasing thickness while extinction co-efficient and real and imaginary part of dielectric constant decreased. DOI: http://dx.doi.org/10.3329/jbas.v37i1.15684 Journal of Bangladesh Academy of Sciences, Vol. 37, No. 1, 83-91, 2013

Preparation and characterization of V2O5 doped SiO2-TiO2 thin films

2012 ◽  
Vol 2 (1) ◽  
Author(s):  
Marek Nocuń ◽  
Sławomir Kwaśny
Keyword(s):  
Thin Films ◽  
Band Gap ◽  
Photoelectron Spectroscopy ◽  
Sol Gel ◽  
Dip Coating ◽  
Band Gap Energy ◽  
Tio2 Thin Films ◽  
Glass Substrates ◽  
Gel Technique

AbstractIn our investigation, V doped SiO2/TiO2 thin films were prepared on glass substrates by dip coating sol-gel technique. Chemical composition of the samples was studied by X-ray photoelectron spectroscopy (XPS). Transmittance of the samples was characterized using UV-VIS spectrophotometry. Subsequently band-gap energy (Eg) was estimated for these films. Powders obtained from sols were characterized by FTIR spectroscopy. It was found that vanadium decreases optical band gap of SSiO2/TiO2 films.

Optical Detection of Band Gap Variations Due to Ordering in Ga0.47In0.53As on InP

1992 ◽  
Vol 281 ◽  
Author(s):  
D. J. Arent ◽  
K. A. Bertness ◽  
Sarah R. Kurtz ◽  
M. Bode ◽  
J. M. Olson
Keyword(s):  
Band Gap ◽  
Atmospheric Pressure ◽  
Room Temperature ◽  
Energy Gap ◽  
Growth Conditions ◽  
Band Gap Energy ◽  
Optical Energy Gap ◽  
Lower Growth ◽  
Transmission Electron ◽  
High Resolution Images

ABSTRACTA reduction in the optical energy gap of more than 65 meV has been observed in In0.53Ga0.47 As grown on (100) InP by atmospheric pressure metalorganic vapor phase epitaxy. The band gap energies were deduced from room temperature photocurrent spectroscopic measurements, accounting for differences in composition and strain. Spontaneous CuPt type ordering of In and Ga atoms on the (111) subplanes of the InGaAs2 was confirmed by transmission electron microscopy. Superlattice signatures in the transmission micrographs were observed only for samples with associated reduced band gap energies, and were confirmed by visible double periodicity in high resolution images. In0.53Ga0.47 As was grown under a variety of conditions, some which promoted ordering. In general, lower growth temperatures and moderate (∼4 μ/hr) growth rates promoted a greater degree of ordering and reduction of the band gap energy. The influence of growth conditions on the ordered structure is considered within the context of current theories.

Effect of Nb doping on morphology, crystal structure, optical band gap energy of TiO2 thin films

2014 ◽  
Vol 14 (3) ◽  
pp. 421-427 ◽  
Author(s):  
Deuk Yong Lee ◽  
Ju-Hyun Park ◽  
Young-Hun Kim ◽  
Myung-Hyun Lee ◽  
Nam-Ihn Cho
Keyword(s):  
Crystal Structure ◽  
Thin Films ◽  
Band Gap ◽  
Optical Band Gap ◽  
Band Gap Energy ◽  
Tio2 Thin Films ◽  
Gap Energy ◽  
Nb Doping

Particle size-band gap energy-catalytic properties relationship of PSE-CVD-derived Fe3O4 thin films

2018 ◽  
Vol 93 ◽  
pp. 427-435 ◽  
Author(s):  
Patrick Mountapmbeme Kouotou ◽  
Achraf El Kasmi ◽  
Ling-Nan Wu ◽  
Muhammad Waqas ◽  
Zhen-Yu Tian
Keyword(s):  
Thin Films ◽  
Particle Size ◽  
Band Gap ◽  
Catalytic Properties ◽  
Band Gap Energy ◽  
Gap Energy ◽  
Relationship Of

scholarly journals Processing and Study of Optical and Electrical Properties of (Mg, Al) Co-Doped ZnO Thin Films Prepared by RF Magnetron Sputtering for Photovoltaic Application

Materials ◽  
2020 ◽  
Vol 13 (9) ◽  
pp. 2146 ◽  
Author(s):  
Chayma Abed ◽  
Susana Fernández ◽  
Selma Aouida ◽  
Habib Elhouichet ◽  
Fernando Priego ◽  
...  
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Magnetron Sputtering ◽  
Band Gap ◽  
Rf Magnetron Sputtering ◽  
Band Gap Energy ◽  
Thin Layers ◽  
Working Pressure ◽  
Hall Effect Measurements ◽  
Diffraction Patterns

In this study, high transparent thin films were prepared by radio frequency (RF) magnetron sputtering from a conventional solid state target based on ZnO:MgO:Al2O3 (10:2 wt %) material. The films were deposited on glass and silicon substrates at the different working pressures of 0.21, 0.61, 0.83 and 1 Pa, 300 °C and 250 W of power. X-ray diffraction patterns (XRD), atomic force microscopy (AFM), UV-vis absorption and Hall effect measurements were used to evaluate the structural, optical, morphological and electrical properties of thin films as a function of the working pressure. The optical properties of the films, such as the refractive index, the extinction coefficient and the band gap energy were systematically studied. The optical band gap of thin films was estimated from the calculated absorption coefficient. That parameter, ranged from 3.921 to 3.655 eV, was hardly influenced by the working pressure. On the other hand, the lowest resistivity of 8.8 × 10−2 Ω cm−1 was achieved by the sample deposited at the lowest working pressure of 0.21 Pa. This film exhibited the best optoelectronic properties. All these data revealed that the prepared thin layers would offer a good capability to be used in photovoltaic applications.

Sign in / Sign up

Export Citation Format

Share Document