scholarly journals Effects of combined treatment of cadmium and oxytetracycline on the terrestrial isopod Porcellio leavis

2022 ◽  
Vol 82 ◽  
Author(s):  
W. Mohammad ◽  
T. Mohammed ◽  
K. A. El-Wakeil ◽  
M. M. Hassan

Abstract The influence of pharmaceutical residues and heavy metals on living organisms has received global attention. The present study assessed the interactive effect of antibiotic residues and heavy metals in soil, as contaminated food with cadmium (Cd) and oxytetracycline (OTC) on the isopod Porcellio leavis. It was fed on fresh plant leaves contaminated with different concentrations of cadmium, Cd+OTC1000 ppm, Cd+OTC2000 ppm and Cd+OTC3000 ppm for 4 weeks. The changes in the feeding patterns, protein, lipid peroxidation (LPO), catalase activity (CAT), and total free amino acids (TFAA) were recorded. There were significant differences in the obtained results where Cd reduced the egestion ratio (ER) however, OTC enhanced this ratio. Biochemical analysis illustrated that combination between OTC and Cd inhibits the toxic effects of Cd at low concentration (1000 ppm), while at high concentration (3000 ppm) raise the toxicity. Detailed studies are required for further understanding of the interaction between OTC and heavy metals, and also its impact on soil animals and for improving soil risk evaluation.

2003 ◽  
pp. 85-89
Author(s):  
Kamilla Taraczközi

The soil constitutes the basis of the food chain. To keep soil conditions in a good trim is very important, it’s part of the sustainable development and of producing food supply harmless to health.In some cases, soil productivity is the only important part, qualitative requirements or economical characteristics can improve it. The soil is threatened by two danger factors: the soil degradation and the soil pollution. The accumulation of different harmful and/or toxic substances in the soil is well known. Heavy metals constitute a part of it. Metals in the soil and in the soil-solution are balanced. This balance depends on the type of the metal, on the pH, on the cation-band capacity of the soil, on the redox relations and the concentration of cations in the soil.To be able to handle the metal contamination of the soil, it is important to estimate the form, the possible extension and the concentration of metals.Of course, the different types of soils have different physical-chemical, biological and buffer capacity, they can moderate or reinforce the harmful effects of heavy metals. To draw general conclusion of the dispersion and quantitative relations on the metals originated from different contamination sources is hard, because in some emissive sources contamination is limited in small areas but on a high level, some others usually expand on larger areas, and as a result of equal dispersion, the contamination’s level is lower.Heavy metals – unlike alkali ions – strongly bond to organic materials, or infiltrate in a kelát form. Their outstanding characteristic is the tendency to create metal-complex forms. Kelats take part in the uptaking and transportation of heavy metals. Heavy metals exert their effects mostly as enzyme-activators.The metals cannot degrade in an organic way, they accumulate in living organisms, and they can form toxic compounds through biochemical reactions.Lot of the heavy metals accumulate on the boundaries of the abiotic systems (air/soil, water/sediment), when physical or chemical parameters change, and this influences their remobilization.Human activity plays a great part in heavy metal mobilization, results in the human origin of most biochemical process of metals.To understand the toxic influence of accumulated metals of high concentration, their transportation from soils to plants or their damage in human health, must clearly defined and investigated.For effective protection against soil pollution, the types and levels of harmful pollution to soil must identified, regarding legal, technical and soil-science aspects, preferable in a single way. Difficulties in this area mean that toxicity depends on loading, uptake, soil characteristics and living organisms (species, age, condition etc.), furthermore, local and economic conditions considerably differ.


2018 ◽  
Vol 19 (1) ◽  
pp. 296-302 ◽  
Author(s):  
TATYANA G. KRUPNOVA ◽  
IRINA V. MASHKOVA ◽  
ANASTASIYA M. KOSTRYUKOVA ◽  
NIKITA O. EGOROV ◽  
SVETLANA V. GAVRILKINA

Krupnova TG, Mashkova IV, Kostryukova AM, Egorov NO, Gavrilkina SV. 2018. Bioconcentration of heavy metals in aquatic macrophytes of South Urals region lakes. Biodiversitas 19: 296-302. This paper studies bioconcentration of heavy metals in macrophytes. High concentration of heavy metal compounds in the lakes of South Ural is natural. Moreover, some of the South Ural lakes are polluted by heavy metals that get into the water together with partly treated sewage of ferrous and non-ferrous industries as well as mining. The paper analyzes similarities and differences of macrophyte communities in six lakes: Bolshoye Miassovo, Bolshoy Ishkul, Bolshoy Tatkul, Argayash, Savelkul, Baraus. In our research, we determined species diversity for each lake. Potamogeton lucens L. and Lemna minor L. were found in all the studied lakes, and the concentrations of heavy metals were studied in their leaves. Such metals as Fe, Mn, Cu, Zn were found in macrophytes. We obtained a metal ratio Mn <Fe<Cu<Zn in plant leaves. High accumulation of Fe, Cu, Zn was observed in Lemna while Mn accumulates equally. Metals bioconcentration factors (BCFs) were calculated


Author(s):  
MdDidarul Islam, Ashiqur Rahaman, Aboni Afrose

This study was based on determining concentration of essential and toxic heavy metal in coconut water available at a local Hazaribagh area in Dhaka, Bangladesh. All essential minerals, if present in the drinking water at high concentration or very low concentration, it has negative actions. In this study, fifteen samples and eight heavy metals were analyzed by Atomic Absorption Spectroscopy (AAS) method which was followed by wet ashing digestion method. The concentration obtained in mg/l were in the range of 0.3 to 1.5, 7.77 to 21.2, 0 to 0.71, 0 to 0.9, 0 to 0.2, 0.9 to 17.3, 0.1 to 0.9, 0 to 0.9 and 0 to 0.7 for Fe, Ni, Cu, Cd, Cr, Zn, Pb and Se respectively. From this data it was concluded that any toxic heavy metals like Cd, Cr, Pb and Ni exceed their toxicity level and some essential nutrients were in low concentration in those samples. 


2017 ◽  
Vol 1 ◽  
pp. 264
Author(s):  
Md Didarul Islam ◽  
Ashiqur Rahaman ◽  
Fahmida Jannat

This study was based on to determine the concentration of macro and micro nutrients as well as toxic and nontoxic heavy metals present in the chicken feed available in Dhaka city of Bangladesh. All macro nutrients, if present in the feed at high concentration have some adverse effect, at the same time if this nutrient present in the feed at low concentration this have some adverse effect too. So that this nutrient level should be maintained at a marginal level. On the other side toxic heavy metals if present in the feed at very low concentration those can contaminate the total environment of the ecosystem. In this study six brand samples (starter, grower, finisher and layer) which was collected from different renowned chicken feed formulation industry in Bangladesh. Those samples were prepared for analysis by wet ashing and then metals were determined by Atomic Absorption Spectroscopy. It was found that 27.7 to 68.4, 57.3 to 121.9, 0.21 to 4.1, 0.32 to 2.1, 0.11 to 1.58, 0.28 to 2.11 and 0.28 to 1.78 for zinc, iron, copper, mercury, cadmium, nickel and cobalt respectively. It was found that essential macro and micro nutrients were present in the feed in low concentration on the other side mercury was present in high concentration in the feed samples.


2017 ◽  
Vol 68 (9) ◽  
pp. 2006-2009
Author(s):  
Marioara Nicula ◽  
Nicolae Pacala ◽  
Isidora Radulov ◽  
Mirela Ahmadi ◽  
Dorel Dronca ◽  
...  

In living organisms lead is classified as potential toxic metal, and in high concentration can produce intoxication with the alteration of some vital organs, especially liver and kidney. In aquatic environment lead can be absorbed by fishes and other organisms, with different distribution in various tissues. Our aim of experiment was to verify and demonstrate the protective effect of lyophilized garlic and chlorella against bioaccumulation of lead in fishes living in aquatic environment deliberated polluted with lead. Thus, lyophilized garlic and chlorella administrated as supplements in fodder for fishes (Carassius gibelio) diminished the antagonistic effect of lead against zinc in all tested tissues: liver, kidney, heart, brain, ovary, testis, muscles myotome � epaxial, skin � with scales, gills, and intestine.


Plants ◽  
2021 ◽  
Vol 10 (5) ◽  
pp. 841
Author(s):  
Marina Burachevskaya ◽  
Saglara Mandzhieva ◽  
Tatiana Bauer ◽  
Tatiana Minkina ◽  
Vishnu Rajput ◽  
...  

The presence of heavy metals in the soil could impose serious problems on soil-plant systems due to the accumulation of heavy metals in plants. Even vital elements such as Cu and Zn have a toxic effect in the case of excessive intake by living organisms. The present work aimed to investigate the content of loosely bound (exchangeable, complexed, and specifically sorbed) compounds of Cu and Zn and their availability to spring barley (Hordeum sativum distichum) in contaminated Haplic Chernozem soil under the conditions of a model experiment (five approximate permissible concentrations (APC) and 10 APC of metal). Changes in the bioavailability of the metals upon application of carbon sorbents were observed. An increase in loosely bound metal compounds has been shown under conditions of soil contamination with metals (up to 57% of the total content). The increase in the availability of Cu in the soil was mainly due to the formation of complexed metal forms with organic matter (up to 17%). The availability of Zn was found to be associated with an increase in exchangeable (up to 21%) and specifically sorbed compounds (up to 27%). Granular activated carbon (GAC) and biochar have high sorption properties. A decrease in the content of loosely bound compounds of metals was established, especially in the most mobile forms such as exchangeable and complexed forms. The introduction of sorbents into the soil opened up a new venue for binding heavy metals in situ, eventually leading to a decrease in their bioavailability. The inactivation of Cu and Zn in the soil upon the application of sorbents led to a decrease in metal absorption by spring barley. The highest efficiency of biochar application was established at a dose of 2.5% and 5% in soil contaminations of 5 APC and 10 APC of Cu or Zn. The efficiency of the use of sorbents was more influenced by the dose of application than by the type of sorbent. There was no significant difference between biochar and GAC. Stabilization and inactivation of metals may improve soil fertility and plant growth.


2012 ◽  
Vol 610-613 ◽  
pp. 3252-3256
Author(s):  
Mei Qin Chen ◽  
Feng Ji Wu

Acid mine drainage (AMD) has properties of extreme acidification, quantities of sulfate and elevated levels of soluble heavy metals. It was a widespread environmental problem that caused adverse effects to the qualities of ground water and surface water. In the past decades, most of investigations were focused on the heavy metals as their toxicities for human and animals. As another main constitution of AMD, sulfate ion is nontoxic, yet high concentration of sulfate ion can cause many problems such as soil acidification, metal corrosion and health problems. More attention should be paid on the sulfate ion when people focus on the AMD. In the paper, sulfate removal mechanisms include adsorption, precipitation, co-precipitation and biological reduction were analyzed and summarized. Meanwhile, the remediation technologies, especially the applications of them in China were also presented and discussed.


2017 ◽  
Vol 76 (4) ◽  
pp. 776-784 ◽  
Author(s):  
Mijia Zhu ◽  
Jun Yao ◽  
Zhonghai Qin ◽  
Luning Lian ◽  
Chi Zhang

Wastewater produced from polymer flooding in oil production features high viscosity and chemical oxygen demand because of the residue of high-concentration polymer hydrolysed polyacrylamide (HPAM). In this study, steel slag, a waste from steel manufacturing, was studied as a low-cost adsorbent for HPAM in wastewater. Optimisation of HPAM adsorption by steel slag was performed with a central composite design under response surface methodology (RSM). Results showed that the maximum removal efficiency of 89.31% was obtained at an adsorbent dosage of 105.2 g/L, contact time of 95.4 min and pH of 5.6. These data were strongly correlated with the experimental values of the RSM model. Single and interactive effect analysis showed that HPAM removal efficiency increased with increasing adsorbent dosage and contact time. Efficiency increased when pH was increased from 2.6 to 5.6 and subsequently decreased from 5.6 to 9.3. It was observed that removal efficiency significantly increased (from 0% to 86.1%) at the initial stage (from 0 min to 60 min) and increased gradually after 60 min with an adsorbent dosage of 105.2 g/L, pH of 5.6. The adsorption kinetics was well correlated with the pseudo-second-order equation. Removal of HPAM from the studied water samples indicated that steel slag can be utilised for the pre-treatment of polymer-flooding wastewater.


Sign in / Sign up

Export Citation Format

Share Document