scholarly journals Degradation of Plasticized Poly(1-chloroethylene) Waterproofing Membranes used as a Building Material

2021 ◽  
Vol 68 (2) ◽  
pp. 494-504
Author(s):  
Gregor Kravanja ◽  
Andrej Ivanič ◽  
Samo Lubej

In the present work, both unused plasticized poly(1-chloroethylene) membranes and membranes taken from a flat roof area were comprehensively analysed. First, tensile strength and elongation at breaking points were determined, followed by measurements of wettability. Secondly, morphological changes were analysed using scanning electron microscopy (SEM). To study chemical changes in aged membranes, Fourier transform infrared spectroscopy (FTIR) analysis in the attenuated total reflection mode (ATR) was used. Finally, thermogravimetric analysis and differential scanning calorimetry (TGA-DSC) were performed simultaneously to study thermal degradation. The results show obvious changes in the mechanical, physical and chemical properties of membranes caused by plasticizer loss. Surface microstructure becomes stiffer, which leads to contractions and the prevalence of voids. In cross-sectional area, average thickness values decrease. Due to the degradation of the plasticized waterproofing membranes, the roofing area had to be completely replaced.

2012 ◽  
Vol 554-556 ◽  
pp. 2112-2115
Author(s):  
Hui Li ◽  
Xuan Wang ◽  
Yong Zhu ◽  
Qin Ren

Amber and copal belong to the natural resin, which are similar and transitional in the physical and chemical properties. The artificial heat-pressurized treatment is contributed to the polymerization of the natural copal, and turns into green, yellow-green and deep orange-yellow copal. It is very difficult to identify amber from the heat- pressurized treatment copal only based on the gemological parameters.The thermal behavior of amber and the copal before and after heat-pressurized treatment were analyzed by means of differential scanning calorimetry (DSC), Fourier transform infrared spectroscopy(FTIR) and nuclear magnetic resonance(NMR). The results show that amber exists an evident endothermic peak around 123~132°C, and copal reveals an obvious endothermic peak at about 174~178°C, and the heat pressurized treatment copal occurs a clear exothermic peak around 150~152°C. The differences between endothermic or exothermic transition and peak position reveal occurring thermal oxidation or the bond breaking or the melting, which are of great significance in the identification.


2014 ◽  
Vol 67 (7) ◽  
pp. 1037 ◽  
Author(s):  
Bingcheng Hu ◽  
Xinghui Jin ◽  
Huanqing Jia ◽  
Zuliang Liu ◽  
Chunxu Lv

A series of energetic salts based on 1,2-dinitroguanidine were successfully synthesised and fully characterised using 1H NMR, 13C NMR, and IR spectroscopy, mass spectrometry, elemental analysis, and differential scanning calorimetry. The results show that all the salts possess higher detonation properties (detonation pressures and velocities ranging from 24.8 to 30.3 GPa and 7665 to 8422 m s–1, respectively) than those of trinitrotolouene (TNT, 2,4,6-trinitromethylbenzene). The thermal stability and thermal kinetic parameters were also investigated to give a better understanding of the physical and chemical properties of these energetic salts.


2018 ◽  
Vol 15 (5) ◽  
pp. 296 ◽  
Author(s):  
Bo Ruan ◽  
Pingxiao Wu ◽  
Huimin Wang ◽  
Liping Li ◽  
Langfeng Yu ◽  
...  

Environmental contextInteractions between microbes and minerals can influence geochemical reactions, and hence are of fundamental importance in natural environmental processes. We investigate the effects of Sphingomonas sp. on the structure and physicochemical properties of montmorillonite, a common clay mineral, and determine how this interaction influences the biodegradation of phenanthrene. The findings have profound impact on the clay-modulated biodegradation of organic compounds in the environment. AbstractWe investigate the effect of Sphingomonas sp. GY2B on the structure and physicochemical properties of montmorillonite (Mt). The simultaneous biodegradation of a polycyclic aromatic hydrocarbon compound, phenanthrene, was also monitored. After interaction with bacteria for 2 days, the increases of the specific surface area (SSA) and micropore volume, differences of the thermogravimetric analysis and differential scanning calorimetry (TGA-DSC) patterns and the morphological changes revealed modification of the physicochemical properties and mineral surface. Although the interlayer spacing of Mt remained unchanged, the appearance and shift of several vibration peaks in the Fourier transform infrared (FTIR) spectra confirmed the structural changes of Mt arising from bacterial activities. Concentrations of the major elements of montmorillonite changed greatly in the aqueous solution, especially Si, Al, Fe and Ca. Based on the analyses of X-ray diffraction (XRD) and FTIR, these changes were mainly ascribed to the formation of precipitates and minerals in the biotic experiment. Changes in the release rate of different elements also substantiated that the GY2B strain has a considerable impact on the dissolution of montmorillonite. Additionally, a preferential release of Si and the 27Al and 29Si cross-polarisation magic-angle spinning nuclear magnetic resonance (CP/MAS NMR) spectra of bacteria-untreated samples demonstrated that tetrahedral sheets were preferentially destroyed and octahedral sheets in montmorillonite were dissolved. These results showed that microorganisms can greatly affect the physical and chemical properties of clay minerals in the clay-modulated biodegradation of hydrophobic organic contaminants. This study provides valuable insight into the clay-modulated microbial remediation of organic pollutants in the environment.


2014 ◽  
Vol 937 ◽  
pp. 70-73
Author(s):  
Di Wu ◽  
Jun Zhang ◽  
Xing Wang Wen ◽  
Hui Ling Liu

Sewage sludge was tested as component for producing glass-ceramics with the addition of analytic reagent CaO to solve the sewage sludge disposal problems. The effect of alkalinity (Ak=mCaO/mSiO2) on the characteristics of the glass-ceramics was investigated. Differential scanning calorimetry (DSC) and X-ray diffraction (XRD) were used to investigate thermal behavior and crystalline phase of the samples. It was found that the degree and characteristics of crystals in vitrified sludge significantly correlate to the alkalinity of the raw materials. The glass-ceramics with Ak = 0.36 possessed the best physical and chemical properties.


2002 ◽  
Vol 67 (12) ◽  
pp. 1899-1910 ◽  
Author(s):  
Alexander Pleska ◽  
Iva Klichová ◽  
Jindřich Pytela

A method for functionalization of hydroxy-terminated polybutadiene with 2-sulfanylethan-1-ol (2-mercaptoethanol) leading to a controlled increase in the OH functionality of the polymer was developed. The polybutadiene used contained about 65% of unsaturation in the form of 1,2-vinyl groups. The reaction was carried out without using volatile solvents. The radical addition of 2-sulfanylethan-1-ol on the polymer proceeded quantitatively and the products were free of the mercaptan odour. A series of functionalized polybutadienes were synthesized and characterized by their physical and chemical properties. The differential scanning calorimetry and thermogravimetric analysis measurements revealed that the functionalization improves the stability of the polybutadiene to thermooxidation. The obtained polymers were used for the preparation of polyurethane elastomers. The effect of the increased functionality of the polybutadiene on mechanical properties, thermal behavior and hydrolytic resistance of the elastomers was assessed.


Processes ◽  
2020 ◽  
Vol 8 (5) ◽  
pp. 501 ◽  
Author(s):  
Marwa Souissi ◽  
Ramzi Khiari ◽  
Wafa Haddar ◽  
Mounir Zaag ◽  
Nizar Meksi ◽  
...  

PET/PTT bicomponent filaments yarn is produced by two polymers: the polyethylene terephthalate (PET) and the polytrimethylene terephtalate (PTT) extruded side by side. This yarn is known for its high mechanical properties in particular elasticity and elastic recovery. However, differences between physical and chemical properties of the two components make the dyeing step of this yarn complicated. The aim of this work is the development of a dyeing process for bicomponent filaments without altering their physical and chemical properties. Different techniques such as SEM, FTIR, and differential scanning calorimetry (DSC) were used to characterize the studied yarn. For dyeing, three different disperse dyes CI Disperse Red 167.1, CI Disperse Yellow 211, and CI Disperse Red 60 with different energy classes were studied. The influence of dyeing conditions in particular dyeing temperature, pH of dye bath, dyeing time, and carrier concentration in the dye bath was evaluated. Responses analyzed are color strength (K/S), colorimetric coordinates and color fastness of samples dyed with studied dyes. In addition, the stability of elasticity and elastic recovery of bicomponent filament fabrics after the dyeing process has been also verified and proved.


1964 ◽  
Vol 20 (1) ◽  
pp. 57-74 ◽  
Author(s):  
Joseph R. Williamson

Morphological changes associated with mobilization of lipid were studied in epididymal adipose tissue from fasted and from alloxan diabetic rats. In both groups of animals a decrease in lipid content was accompanied by the formation of complex frond-like cytoplasmic processes and of loops and folds of basement membrane which extended from cell surfaces. These changes, evident after 1 day of fasting, increased in magnitude with increasing weight loss. As the lipid content of the cell decreased further, lipid-cytoplasmic interfaces became irregular and convoluted. Cytoplasmic microvesicles were prominent and appeared to be greatly increased in number. Rosette-like structures composed of microvesicles were observed in both lipid-depleted fat cells and endothelium. The interpretation of these changes and their physiological significance are discussed in terms of the physical and chemical properties of lipids and lipid metabolism. It is postulated that microvesicles may represent the mechanism of transport of free fatty acids in fat cells and in endothelium. Hypotheses are proposed and illustrated schematically for the mode of formation of microvesicular rosettes, for the mobilization and uptake of lipids by fat cells, and for the transport of lipids through endothelium.


2010 ◽  
Vol 643 ◽  
pp. 61-68 ◽  
Author(s):  
Ana Cecília Diniz Viana ◽  
Maria Guiomar de Azevedo Bahia ◽  
Vicente Tadeu Lopes Buono

The aim of this study was to characterize metallurgical properties and the dimensions of three types of rotary NiTi endodontic instruments and to establish a correlation between these characteristics and the flexibility of the instruments. Their chemical composition and constitution were characterized by energy dispersive spectroscopy (EDX) and X-ray diffraction (XRD). Transformation temperatures were assessed by means of differential scanning calorimetry (DSC). Computer software was used to analyse images of the longitudinal and transverse sections for determining instrument diameter and cross-sectional area at 3mm from the tip. The flexibility of the instruments was evaluated in bending tests performed according to the ISO 3630-1 specification, in which the instruments are clamped at 3mm from their tip and bent by 45° along their longitudinal axis. The values of bending moment at 45° were correlated with instrument diameter and cross-sectional area at 3mm from the tip. The results of EDX, XRD and DSC showed that physical and chemical properties of the materials differed slightly among the files analyzed. A direct relationship was found between bending moment and the geometric characteristics of the instruments. Resistance to bending of NiTi root canal instruments depended on their geometrical shapes and metallurgical properties, but the cross-sectional configuration can be seen as an important parameter affecting this property.


2020 ◽  
Vol 12 (1) ◽  
pp. 105-117
Author(s):  
Pratim KUMAR ◽  
Puran Chandra JOSHI

In the present paper, thermal decomposition and crystal researches of synthesized potassium sulphamate (PS) and potassium dinitramide (KDN) crystals were studied using differential scanning calorimetry/ thermal gravimetry (DSC/TG) and scanning electron microscope (SEM) techniques, respectively. Initially, PS crystals were synthesized using sulphamic acid and potassium hydroxide pellets. Afterwards, PS crystals were used for synthesizing potassium dinitramide (KDN) crystals by the nitration of PS in sulfuric and nitric acid mixture. One sample of PS was used for studying DSC/TG curves, while three samples of KDN crystals were used for the studying DSC/TG curves. The three samples of KDN crystals which were used in the present studies are, a) stored KDN (1 month), b) stored KDN (2 months), and c) washed KDN. All the obtained DSC/TG curves of three KDN crystals are dissimilar to each other, and the probable reasons for this dissimilarity are discussed in the manuscript. For further clarifications, TG curve of KN was compared with the TG curves of three samples of KDN used in the present study. It was observed that, while storage, KDN slowly converts into KN with some rate which gradually changes the physical and chemical properties of KDN.


MRS Advances ◽  
2020 ◽  
Vol 5 (62) ◽  
pp. 3227-3237
Author(s):  
Daniel Espinosa-Olivares ◽  
Emilio Bucio

AbstractTo contribute to the development of new alternatives in the area of polymers for biomedical applications, the surface modification of a cotton gauze grafted with a N-vinylcaprolactam (NVCL) by ionizing gamma radiation was developed, in to provide it with more physical and chemical properties. To verify that the grafting was successful, the samples were analyzed and characterized by attenuated total reflectance, by Fourier transform infrared spectroscopy, differential scanning calorimetry, and thermogravimetric analysis. The grafted samples showed greater hydrophilicity and affinity with drugs, as well as a critical solution temperature between 33 and 40 °C; therefore, this material was implemented as administrator of AgNPs in controlled doses, thus obtaining a material with greater absorption, anti-inflammatory and with antimicrobial characteristics.


Sign in / Sign up

Export Citation Format

Share Document