scholarly journals Performance of Fly Ash and Copper Slag based Geopolymer Concrete

2016 ◽  
Vol 9 (2) ◽  
Author(s):  
K. Mahendran ◽  
N. Arunachelam
Keyword(s):  
Fly Ash ◽  
Copper Slag ◽  
Geopolymer Concrete

scholarly journals Characteristics of Blended Geopolymer Concrete Using Ultrafine Ground Granulated Blast Furnace Slag and Copper Slag

2020 ◽  
Vol 44 (6) ◽  
pp. 433-439
Author(s):  
Vijayasarathy Rathanasalam ◽  
Jayabalan Perumalsami ◽  
Karthikeyan Jayakumar
Keyword(s):  
Blast Furnace ◽  
Fly Ash ◽  
Sodium Hydroxide ◽  
Blast Furnace Slag ◽  
Copper Slag ◽  
Fine Aggregate ◽  
Geopolymer Concrete ◽  
Strength Performance ◽  
Granulated Blast Furnace Slag ◽  
Furnace Slag

This paper presents the properties of blended geopolymer concrete manufactured using fly ash and ultrafine Ground Granulated Blast Furnace Slag (UFGGBFS), along with the copper slag (CPS) as replacement of fine aggregate (crushed stone sand). Various parameters considered in this study include different sodium hydroxide concentrations (10M, 12M and 14M); 0.35 as alkaline liquid to binder ratio; 2.5 as sodium silicate to sodium hydroxide ratio and cured in ambient curing condition. Further, geopolymer concrete was manufactured using fly ash as the prime source material which is replaced with UFGGBFS (0%, 5%, 10% and 15%). Copper slag has been used as replacement of fine aggregate in this study. Properties of the fresh manufactured geopolymer concrete were studied by slump test. Compressive strength of the manufactured geopolymer concrete was tested and recorded after curing for 3, 7 and 28 days. Microstructure Characterization of Geopolymer concrete specimens was done by Scanning Electron Microscope (SEM) analysis. Experimental results revealed that the addition of UFGGBFS resulted in an increased strength performance of geopolymer concrete. Also, this study demonstrated that the strength of geopolymer concrete increased with an increase in sodium hydroxide concentration. SEM results revealed that the addition of UFGGBFS resulted in a dense structure.

scholarly journals Mechanical and Microstructural Properties of Copper Slag Based Blended Geopolymer Concrete

2021 ◽  
Author(s):  
Vijayasarathy RATHANASALAM ◽  
Jayabalan PERUMALSAMI ◽  
Karthikeyan JAYAKUMAR
Keyword(s):  
Fly Ash ◽  
Mechanical Characterization ◽  
Copper Slag ◽  
Fine Aggregate ◽  
Geopolymer Concrete ◽  
X Ray Diffraction ◽  
X Ray ◽  
Granulated Blast Furnace Slag ◽  
Mechanical And Microstructural Properties ◽  
Furnace Slag

This work presents a novel way to examine the characteristics of fly ash, copper slag (CPS) along with the addition of Ultrafine Ground Granulated Blast Furnace Slag (UFGGBFS) based Geopolymer Concrete (GPC) for various molarities (10M, 12M and 14M). In GPC, fly ash was replaced with UFGGBFS (5 %, 10 % and 15 %) and copper slag was used as fine aggregate. Mechanical Characterization such as split tensile, flexural strength, workability and water absorption were conducted . GPC characterization and microstructural behaviour was studied  by examining X-ray diffraction (XRD) and Scanning Electron Microscopy (SEM). From experimental results this study concludes that with a rise in molarity of GPC, along with incorporation of UFGGBFS, improved the performance, densification and strength of GPC.

scholarly journals An Experimental Study on Fibre Reinforced Geopolymer Concrete Composites- Glass Fibre, Copper Slag

2018 ◽  
Vol 7 (3.34) ◽  
pp. 433
Author(s):  
J Asanammal Saral ◽  
S Gayathri ◽  
M Tamilselvi ◽  
B Raghul Raj
Keyword(s):  
Mechanical Properties ◽  
Tensile Strength ◽  
Fly Ash ◽  
Volume Fraction ◽  
Glass Fibers ◽  
Thermal Power ◽  
Copper Slag ◽  
Fine Aggregate ◽  
Geopolymer Concrete ◽  
Split Tensile Strength

The major problem of the world is facing today is environmental pollution. It is well known that for the production of 1-ton of cement consumes more energy and exhibit 0.8-ton of CO2 .On the other hand Fly ash is a residue from the combustion of pulverized coal from the flue gases of thermal power plant. Recently, the fly ash is not effectively used and a large part of it is disposed in landfill. Due to this problem the various researchers have sort for a new binder to minimize the consumption of OPC. This study evaluates the strength of geopolymer concrete having fly ash as the major binding material and the sand a fine aggregate was replaced with copper slag of 40%  and glass fiber to enhance the mechanical properties have been presented. This paper analyses on the mechanical properties of eopolymer concrete composites such as compressive strength, split tensile strength and water absorption in heat curing at 60˚C for 24 hrs in hot air oven. Glass fibers were added in the mix in the volume fraction of 0.5%, 1.0%, 1.5% and 2.0% volume of the concrete. The influence of fiber content in terms of volume fraction on the compressive, split tensile strength of geopolymer concrete is presented. The result shows the elevated performance of the properties exhibited by the geopolymeric concrete with and without fibres.

THE EFFECT OF FLY ASH IN GEOPOLYMER CONCRETE POLES – A THRIVING SOLID WASTE DISPOSAL MEASURE FOR ECO-FRIENDLY ENVIRONMENT

2018 ◽  
Vol 8 (2) ◽  
pp. 7
Author(s):  
R. THENMOZHI ◽  
VADIVEL T.SENTHIL ◽  
S. MUTHURAMALINGAM ◽  
V. PADMAPRIYA ◽  
◽  
...  
Keyword(s):  
Fly Ash ◽  
Solid Waste ◽  
Waste Disposal ◽  
Geopolymer Concrete ◽  
Solid Waste Disposal

Utilization of Industrial Waste Copper Slag and Fly Ash in Concrete

2014 ◽  
Vol 3 (3) ◽  
pp. 25-33
Author(s):  
Jagmeet Singh ◽  
◽  
Jaspal Singh ◽  
Manpreet Kaur ◽  
◽  
...  
Keyword(s):  
Fly Ash ◽  
Industrial Waste ◽  
Copper Slag

scholarly journals Practical Prediction Models of Tensile Strength and Reinforcement-Concrete Bond Strength of Low-Calcium Fly Ash Geopolymer Concrete

Polymers ◽  
2021 ◽  
Vol 13 (6) ◽  
pp. 875
Author(s):  
Chenchen Luan ◽  
Qingyuan Wang ◽  
Fuhua Yang ◽  
Kuanyu Zhang ◽  
Nodir Utashev ◽  
...  
Keyword(s):  
Tensile Strength ◽  
Fly Ash ◽  
Bond Strength ◽  
Prediction Models ◽  
Splitting Tensile Strength ◽  
Geopolymer Concrete ◽  
Structural Factors ◽  
Test Results ◽  
Portland Cement Concrete ◽  
Low Calcium

There have been a few attempts to develop prediction models of splitting tensile strength and reinforcement-concrete bond strength of FAGC (low-calcium fly ash geopolymer concrete), however, no model can be used as a design equation. Therefore, this paper aimed to provide practical prediction models. Using 115 test results for splitting tensile strength and 147 test results for bond strength from experiments and previous literature, considering the effect of size and shape on strength and structural factors on bond strength, this paper developed and verified updated prediction models and the 90% prediction intervals by regression analysis. The models can be used as design equations and applied for estimating the cracking behaviors and calculating the design anchorage length of reinforced FAGC beams. The strength models of PCC (Portland cement concrete) overestimate the splitting tensile strength and reinforcement-concrete bond strength of FAGC, so PCC’s models are not recommended as the design equations.

Influence of red mud on performance enhancement of fly ash-based geopolymer concrete

2021 ◽  
Vol 6 (4) ◽  
Author(s):  
Ramamohana Reddy Bellum ◽  
Chava Venkatesh ◽  
Sri Rama Chand Madduru
Keyword(s):  
Fly Ash ◽  
Red Mud ◽  
Performance Enhancement ◽  
Geopolymer Concrete

scholarly journals Behavior of Quarry Rock Dust, Fly Ash and Slag Based Geopolymer Concrete Columns Reinforced with Steel Fibers under Eccentric Loading

2021 ◽  
Vol 11 (15) ◽  
pp. 6740
Author(s):  
Rana Muhammad Waqas ◽  
Faheem Butt
Keyword(s):  
Fly Ash ◽  
Concrete Cover ◽  
Steel Fibers ◽  
Structural Behavior ◽  
Partial Replacement ◽  
Geopolymer Concrete ◽  
Fiber Reinforced ◽  
Conventional Concrete ◽  
Source Materials ◽  
Rock Dust

Geopolymer concrete, also known as an earth-friendly concrete, has been under continuous study due to its environmental benefits and a sustainable alternative to conventional concrete construction. The supplies of many source materials, such as fly ash (FA) or slag (SG), to produce geopolymer concrete (GPC) may be limited; however, quarry rock dust (QRD) wastes (limestone, dolomite, or silica powders) formed by crushing rocks appear virtually endless. Although significant experimental research has been carried out on GPC, with a major focus on the mix design development, rheological, durability, and mechanical properties of the GPC mixes; still the information available on the structural behavior of GPC is rather limited. This has implications in extending GPC application from a laboratory-based technology to an at-site product. This study investigates the structural behavior of quarry-rock-dust-incorporated fiber-reinforced GPC columns under concentric and eccentric loading. In this study, a total of 20 columns with 200 mm square cross-section and 1000 mm height were tested. The FA and SG were used as source materials to produce GPC mixtures. The QRD was incorporated as a partial replacement (20%) of SG. The conventional concrete (CC) columns were prepared as the reference specimens. The effect of incorporating quarry rock dust as a replacement of SG, steel fibers, and loading conditions (concentric and eccentric loading) on the structural behavior of GPC columns were studied. The test results revealed that quarry rock dust is an adequate material that can be used as a source material in GPC to manufacture structural concrete members with satisfactory performance. The general performance of the GPC columns incorporating QRD (20%) is observed to be similar to that of GPC columns (without QRD) and CC columns. The addition of steel fibers considerably improves the loading capacity, ductility, and axial load–displacement behavior of the tested columns. The load capacities of fiber-reinforced GPC columns were about 5–7% greater in comparison to the CC columns. The spalling of concrete cover at failure was detected in all plain GPC columns, whereas the failure mode of all fiber-reinforced GPC columns is characterized with surface cracking leading to disintegration of concrete cover.

Sign in / Sign up

Export Citation Format

Share Document