scholarly journals The Optimized Energy Saving of a Refrigerating Chamber

Energies ◽  
2019 ◽  
Vol 12 (10) ◽  
pp. 1887
Author(s):  
Whei-Min Lin ◽  
Chung-Yuen Yang ◽  
Ming-Tang Tsai ◽  
Hong-Jey Gow
Keyword(s):  
Power Consumption ◽  
Energy Saving ◽  
Control Strategy ◽  
Average Power ◽  
Coefficient Of Performance ◽  
Refrigeration System ◽  
Switching Loss ◽  
Binary Coding ◽  
Average Power Consumption ◽  
Effectiveness And Efficiency

This paper proposes a control strategy for the energy saving of refrigerating chambers. Combining binary coding and proteome reorganization, the binary proteome algorithm (BPA) is proposed to solve this problem. The refrigeration system model is firstly established based on the performance data of compressors and temperature measurements of each refrigerating chamber. The objective function is an averaged coefficient of performance (COP), which considers the switching loss of the compressors, power consumption of the compressors, and refrigerating capacity of the chambers. The control strategy is defined as an optimization problem with constraints to avoid the ineffective operation of a refrigeration system for improving the COP. BPA is adopted to solve the control strategy for optimizing energy saving. The effectiveness and efficiency of the BPA are demonstrated using a real system, and the results are compared with the original control strategy. Results show that the average power consumption drops from 115.92 kW to 108.82 kW, and the average COP value rises from 1.92 to 2.03. The proposed control strategy is feasible, robust, and more effective in energy-saving problems. Other than energy saving, the proposed control strategy also has the benefits of reducing the evaporator frost formation, which allows the products to avoid chill damage.

Performance Comparison among Heat Pump Water Heaters Working with R32, R134a and the Mixture of R32/R134a

2012 ◽  
Vol 512-515 ◽  
pp. 1295-1298
Author(s):  
De Feng Ding ◽  
Shi Jie Liu ◽  
Chao Yu Zheng ◽  
Wen Sheng Yu ◽  
Wu Chen
Keyword(s):  
Power Consumption ◽  
Heat Pump ◽  
Average Power ◽  
Input Power ◽  
Performance Comparison ◽  
Coefficient Of Performance ◽  
Water Heater ◽  
Heat Pump Water Heater ◽  
Discharge Temperature ◽  
Average Power Consumption

A general air-source heat pump water heater originally designed to work with R134a was reconstructed as experimental rig for performance studies on systems using different refrigerants including R32, R134a and the mixture of R32/R134a which mass ratio is 1:5. Experimental results showed that the power consumption of the heat pump water heater charged individually with R32 would greatly exceed the system’s original pre-set maximum input power. When the leaving water temperature was increased from 18°C to 58°C, the average discharge temperature of the heat pump charged with R32/R134a mixture was 13.6% higher than that with R134a. The average power consumption of the heat pump with R134a was 253.5W less than that with R32/R134a mixture. However, the average COP (Coefficient of Performance) obtained by that with R32/R134a mixture was 0.83 higher than that with R134a.

scholarly journals Experimental Study of Hybrid Solar Air Conditioning System in Iraq

2018 ◽  
Vol 24 (10) ◽  
pp. 32 ◽  
Author(s):  
Ahmed Abd Mohammed ◽  
Raed Ayad Abduljabbar
Keyword(s):  
Experimental Study ◽  
Power Consumption ◽  
Ambient Temperature ◽  
Storage Tank ◽  
Air Conditioning ◽  
Average Power ◽  
Coefficient Of Performance ◽  
Air Conditioning System ◽  
Average Power Consumption ◽  
Average Coefficient

In this paper, an experimental study of the thermal performance for hybrid solar air conditioning system was carried out, to investigate system suitability for the hot climate in Iraq. The system consists of vapor compression unit combined with evacuated tube solar collector and liquid storage tank. A three-way valve was installed after the compressor to control the direction flow of the refrigerant, either to the storage tank or directly to the condenser. The performance parameters were collected by data logger to display and record in the computer by using LabVIEW software. The results show that the average coefficient of performance of hybrid solar air conditioning system (R=1) was about 2.42 to 2.77 and the average power consumption was about 1.1 to 1.12 kW when the ambient temperature was about 34.2 to 39.7 ˚C, while the average coefficient of performance of conventional system (R=0) was about 3.23 and the average power consumption was about 1 kW when the ambient temperature was about 30.8 to 34.3 ˚C. It can be concluded that the use of the hybrid solar system in Iraq with its current form could not be saved electricity.  

scholarly journals A Novel Cross-Latch Shift Register Scheme for Low Power Applications

2020 ◽  
Vol 11 (1) ◽  
pp. 129
Author(s):  
Po-Yu Kuo ◽  
Ming-Hwa Sheu ◽  
Chang-Ming Tsai ◽  
Ming-Yan Tsai ◽  
Jin-Fa Lin
Keyword(s):  
Power Consumption ◽  
Supply Voltage ◽  
Electrical Power ◽  
Average Power ◽  
Leakage Power ◽  
Shift Register ◽  
Cmos Process ◽  
Average Power Consumption ◽  
Simulation Results ◽  
Layout Area

The conventional shift register consists of master and slave (MS) latches with each latch receiving the data from the previous stage. Therefore, the same data are stored in two latches separately. It leads to consuming more electrical power and occupying more layout area, which is not satisfactory to most circuit designers. To solve this issue, a novel cross-latch shift register (CLSR) scheme is proposed. It significantly reduced the number of transistors needed for a 256-bit shifter register by 48.33% as compared with the conventional MS latch design. To further verify its functions, this CLSR was implemented by using TSMC 40 nm CMOS process standard technology. The simulation results reveal that the proposed CLSR reduced the average power consumption by 36%, cut the leakage power by 60.53%, and eliminated layout area by 34.76% at a supply voltage of 0.9 V with an operating frequency of 250 MHz, as compared with the MS latch.

Designing of Low-Power High-Speed Noise Immune CNTFET 1-Trit Unbalanced Ternary Subtractor

2021 ◽  
Author(s):  
Yogesh Shrivastava ◽  
Tarun Kumar Gupta
Keyword(s):  
Power Consumption ◽  
High Speed ◽  
Noise Analysis ◽  
Average Power ◽  
Noise Margin ◽  
Average Power Consumption ◽  
Effect Transistor ◽  
Power Delay Product ◽  
Static Noise ◽  
Made In

Ternary logic has been demonstrated as a superior contrasting option to binary logic. This paper presents a ternary subtractor circuit in which the input signal is converted into binary. The proposed design is implemented using Carbon Nanotube Field Effect Transistor (CNTFET), a forefront innovation. A correlation has been made in the proposed design on parameters like Power-Delay Product (PDP), Energy Delay Product (EDP), average power consumption, delay and static noise margin. Every one of these parameters is obtained by simulating the circuits on the HSPICE simulator. The proposed design indicates an improvement of 60.14%, 59.34%, 74.98% and 84.28%, respectively, in power consumption, delay, PDP and EDP individually in correlation with recent designs. The increased carbon nanotubes least affect the proposed subtractor design. In noise analysis, the proposed design outperformed all the existing designs.

scholarly journals A CMOS-Thyristor Based Temperature Sensor with +0.37 °C/−0.32 °C Inaccuracy

Micromachines ◽  
2020 ◽  
Vol 11 (2) ◽  
pp. 124 ◽  
Author(s):  
Jing Li ◽  
Yuyu Lin ◽  
Siyuan Ye ◽  
Kejun Wu ◽  
Ning Ning ◽  
...  
Keyword(s):  
Power Consumption ◽  
Temperature Sensor ◽  
Current Source ◽  
Average Power ◽  
Bias Current ◽  
Cmos Process ◽  
Linear Temperature ◽  
Temperature Characteristics ◽  
Period Ratio ◽  
Average Power Consumption

This paper describes a voltage controlled oscillator (VCO) based temperature sensor. The VCOs are composed of complementary metal–oxide–semiconductor (CMOS) thyristor with the advantage of low power consumption. The period of the VCO is temperature dependent and is function of the transistors’ threshold voltage and bias current. To obtain linear temperature characteristics, this paper constructed the period ratio between two different-type VCOs. The period ratio is independent of the temperature characteristics from current source, which makes the bias current generator simplified. The temperature sensor was designed in 130 nm CMOS process and it occupies an active area of 0.06 mm2. Based on the post-layout simulation results, after a first-order fit, the sensor achieves an inaccuracy of +0.37/−0.32 °C from 0 °C to 80 °C, while the average power consumption of the sensor at room temperature is 156 nW.

scholarly journals Performance of AODV Protocol for H-MANETs

2019 ◽  
pp. 271-276
Author(s):  
Pallepati Vasavi ◽  
G Raja Ramesh
Keyword(s):  
Power Consumption ◽  
Performance Metrics ◽  
Fluid Dynamic ◽  
Average Power ◽  
Dynamic Environment ◽  
Initial Energy ◽  
Network Simulator ◽  
Average Delay ◽  
Average Power Consumption ◽  
New Research

As per need of recent applications, new research aspects related to scalability, heterogeneity, and power consumption have been arisen. These problems are supposed to be fixed for better utilization of MANETs. MANET nodes interact through multi-hop routing. AODV is a commonly used on-demand protocol for routing in MANETs. In the existing literature, AODV has been analyzed a number of times but heterogeneity of the nodes has not been addressed. Heterogeneity may be defined as diversity among the nodes in resources or capability. The environment is usually heterogeneous in case of constraint fluid dynamic environment of MANET. In this paper we are analyzing the routing performance as well as energy efficient behavior of AODV routing protocol in both homogeneous and heterogeneous MANETs (H-MANETs), using performance parameters like ratio of delivered packets, throughput, average delay, average power consumption, energy of alive nodes, etc. Heterogeneity has been introduced in terms of different initial energy for all the nodes, unlike the homogeneous scenario. The simulation work has been done using network simulator (NS-2). This work will be helpful to get insight of effects of heterogeneity on energy efficiency and other performance metrics of AODV.

Sign in / Sign up

Export Citation Format

Share Document