scholarly journals Humidity-Sensitive, Demand-Controlled Ventilation Applied to Multiunit Residential Building—Performance and Energy Consumption in Dfb Continental Climate

Energies ◽  
2020 ◽  
Vol 13 (24) ◽  
pp. 6669
Author(s):  
Jerzy Sowa ◽  
Maciej Mijakowski
Keyword(s):  
Energy Consumption ◽  
Energy Savings ◽  
Residential Buildings ◽  
Residential Building ◽  
Primary Energy ◽  
Controlled Ventilation ◽  
Carbon Dioxide Concentrations ◽  
Demand Controlled Ventilation ◽  
Continental Climate ◽  
Ventilation Systems

Humidity-sensitive, demand-controlled ventilation systems have been in use for many years in regions with oceanic climates. Some attempts have been made to apply this technology in Poland, which has a continental climate. This article evaluates the performance and energy consumption of such a system when applied in an eight-floor, multiunit, residential building, i.e., the virtual reference building described by the National Energy Conservation Agency (NAPE), Poland. Simulations using the computer program CONTAM were performed for the whole heating season based upon the climate in Warsaw. Besides passive stack ventilation, that served as a reference, two ventilation systems were studied: one standard and one “hybrid” system with additional roof fans. This study confirmed that the application of humidity-sensitive, demand-controlled ventilation in multiunit residential buildings in a continental climate (Dfb) led to significant energy savings (up to 11.64 kWh/m2 of primary energy). However, the operation of the system on higher floors was found to be ineffective. Ensuring consistent operation of the system on all floors required supplementary fans. The introduction of a hybrid mode reduced carbon dioxide concentrations by approximately 32% in the units located in the upper part of the building. The energetic effect in such cases depends strongly on the electricity source. In the case of the national energy grid, savings of primary energy would be relatively low, i.e., 1.07 kWh/m2, but in the case of locally produced renewable energy, the energy savings would be equal to 5.18 kWh/m2.

scholarly journals Humidity-Sensitive Demand-Controlled Ventilation Applied to Multi-Unit Residential Building – Performance and Energy Consumption in Dfb Continental Climate

2020 ◽  
Author(s):  
Jerzy Sowa ◽  
Maciej Mijakowski
Keyword(s):  
Energy Consumption ◽  
Energy Use ◽  
Energy Savings ◽  
Residential Buildings ◽  
Ventilation System ◽  
Residential Building ◽  
Primary Energy ◽  
Controlled Ventilation ◽  
Demand Controlled Ventilation ◽  
Continental Climate

A humidity-sensitive demand-controlled ventilation system is known for many years. It has been developed and commonly applied in regions with an oceanic climate. Some attempts were made to introduce this solution in Poland in a much severe continental climate. The article evaluates this system's performance and energy consumption applied in an 8-floor multi-unit residential building, virtual reference building described by the National Energy Conservation Agency NAPE, Poland. The simulations using the computer program CONTAM were performed for the whole hating season for Warsaw's climate. Besides passive stack ventilation that worked as a reference, two versions of humidity-sensitive demand-controlled ventilation were checked. The difference between them lies in applying the additional roof fans that convert the system to hybrid. The study confirmed that the application of demand-controlled ventilation in multi-unit residential buildings in a continental climate with warm summer (Dfb) leads to significant energy savings. However, the efforts to ensure acceptable indoor air quality require hybrid ventilation, which reduces the energy benefits. It is especially visible when primary energy use is analyzed.

scholarly journals HVAC Energy Saving Strategies for Public Buildings Based on Heat Pumps and Demand Controlled Ventilation

Energies ◽  
2021 ◽  
Vol 14 (17) ◽  
pp. 5541
Author(s):  
Alessandro Franco ◽  
Lorenzo Miserocchi ◽  
Daniele Testi
Keyword(s):  
Energy Consumption ◽  
Energy Savings ◽  
Control Strategies ◽  
Residential Buildings ◽  
Heat Pumps ◽  
Air Conditioning System ◽  
Controlled Ventilation ◽  
Climatic Control ◽  
Educational Structures ◽  
Demand Controlled Ventilation

The paper analyzes and compares the perspectives for reducing the energy consumption associated to the operation of Heating Ventilation and Air Conditioning system for climatic control of large-size non-residential buildings. Three different control strategies are considered comparing the use of boiler and heat pumps as heating systems and analyzing the use of demand-controlled ventilation, operating on the effective occupancy of the building. The control strategies are applied to two different educational buildings with shapes representative of typical educational structures. The results of the analysis show how the energy consumption can be reduced up to 70%, shifting from the actual values of the energy intensity of over 300 kWh/m2 for year to values of less than 100 kWh/m2 per year. The significance of the energy savings achieved in such different buildings has led to the identification of a possible benchmark for HVAC systems in the next future years which could help reach the environmental targets in this sector.

scholarly journals Towards Sustainable Energy Retrofitting, a Simulation for Potential Energy Use Reduction in Residential Buildings in Palestine

Energies ◽  
2021 ◽  
Vol 14 (13) ◽  
pp. 3876
Author(s):  
Sameh Monna ◽  
Adel Juaidi ◽  
Ramez Abdallah ◽  
Aiman Albatayneh ◽  
Patrick Dutournie ◽  
...  
Keyword(s):  
Energy Consumption ◽  
Energy Use ◽  
Energy Savings ◽  
Residential Buildings ◽  
Residential Building ◽  
Simulation Models ◽  
Water Heating ◽  
Heating And Cooling ◽  
Space Cooling ◽  
Cooling Loads

Since buildings are one of the major contributors to global warming, efforts should be intensified to make them more energy-efficient, particularly existing buildings. This research intends to analyze the energy savings from a suggested retrofitting program using energy simulation for typical existing residential buildings. For the assessment of the energy retrofitting program using computer simulation, the most commonly utilized residential building types were selected. The energy consumption of those selected residential buildings was assessed, and a baseline for evaluating energy retrofitting was established. Three levels of retrofitting programs were implemented. These levels were ordered by cost, with the first level being the least costly and the third level is the most expensive. The simulation models were created for two different types of buildings in three different climatic zones in Palestine. The findings suggest that water heating, space heating, space cooling, and electric lighting are the highest energy consumers in ordinary houses. Level one measures resulted in a 19–24 percent decrease in energy consumption due to reduced heating and cooling loads. The use of a combination of levels one and two resulted in a decrease of energy consumption for heating, cooling, and lighting by 50–57%. The use of the three levels resulted in a decrease of 71–80% in total energy usage for heating, cooling, lighting, water heating, and air conditioning.

Application of Water-Cooled Air-Conditioning for High-Rise Residential Buildings

2010 ◽  
Author(s):  
Hua Chen ◽  
Qianqian Di
Keyword(s):  
Energy Consumption ◽  
Empirical Model ◽  
Energy Savings ◽  
Residential Buildings ◽  
Residential Building ◽  
Energy Performance ◽  
Operation Performance ◽  
Air Conditioners ◽  
High Rise ◽  
Set Up

To improve the applicability of water-cooled air-conditioners in the domestic sector, the development of a prediction model for energy performance analysis is needed. This paper addressed the development of an empirical model for predicting the operation performance and the annual energy consumption for the use of water-cooled air-conditioners. An experimental prototype was set up and tested in an environmental chamber in validating the empirical model. The predictions compared well with the experimental results. Furthermore, a high-rise residential building whole-year energy consumption simulation on applications of water-cooled air conditioners in South china was also analyzed. The results show 20.4% energy savings over air-cooled units while the increase in water-side consumption is 31.1%. The overall energy savings were estimated at 16.2% when including the additional water costs.

scholarly journals Selection of Favourable Concept of Energy Retrofitting Solution for Social Housing in the Czech Republic Based on Economic Parameters, Greenhouse Gases, and Primary Energy Consumption

2019 ◽  
Vol 11 (22) ◽  
pp. 6482
Author(s):  
Katerina Sojkova ◽  
Martin Volf ◽  
Antonin Lupisek ◽  
Roman Bolliger ◽  
Tomas Vachal
Keyword(s):  
Energy Consumption ◽  
Greenhouse Gas Emissions ◽  
Greenhouse Gas ◽  
Residential Buildings ◽  
Residential Building ◽  
Primary Energy ◽  
Primary Energy Consumption ◽  
Building Stock ◽  
Gas Emissions ◽  
Residential Building Stock

Energy retrofitting of existing building stock has significant potential for the reduction of energy consumption and greenhouse gas emissions. Roughly half of the CO2 emissions from Czech building stock are estimated to be allocated to residential buildings. Approximately one-third of the Czech residential building stock have already been retrofitted, but retrofitting mostly takes place in large cities due to greater income. A favourable concept for the mass retrofitting of residential building stock, affordable even in low-income regions, was of interest. For a reference building, multi-criteria assessment of numerous retrofitting measures was performed. The calculation involved different building elements, materials, solutions, and energy-efficiency levels in combination with various heating systems. The assessment comprised environmental impact, represented by operational and embodied primary energy consumption and greenhouse gas emissions, and investment and operational costs using the annuity method. Analysis resulted in the identification of favourable retrofitting measures and showed that complex building retrofitting is advantageous from both a cost and an environmental point of view. The environmental burden could be decreased by approximately 10–30% even without photovoltaic installation, and costs per year could be decreased by around 40%.

Economic Potentials of Energy-Efficient Residential Building Envelope Retrofitting in Turkey

2019 ◽  
pp. 728-755
Author(s):  
M. Mustafa Erdoğdu ◽  
Coşkun Karaca ◽  
Ali Kurultay
Keyword(s):  
Energy Consumption ◽  
Thermal Resistance ◽  
Energy Efficient ◽  
Building Materials ◽  
Energy Savings ◽  
Residential Buildings ◽  
Residential Building ◽  
Economic Benefits ◽  
Building Envelope ◽  
Heat Transfers

The amount of energy consumption in the residential buildings has a very significant share with nearly 30 percent in the total amount of energy consumption. Therefore, residential sector is identified in this chapter as being one of the areas with a large potential for energy savings. Inefficient dwelling construction and design methods are widely used in Turkey and only about five percent of residential buildings are insulated. Concerning the importance and immediate need in Turkey for energy-efficient residential building retrofitting, this chapter identifies economic benefits of such retrofitting by particularly focusing on heat transfers by conductivity, where the rate can be determined by surface size, thermal resistance of the building materials and their thickness.

scholarly journals Towards climate resilient residential buildings: learning from traditional typologies

2021 ◽  
Vol 2042 (1) ◽  
pp. 012146
Author(s):  
D Mohaibesh ◽  
S Monna ◽  
H Qadi ◽  
R Sokkar
Keyword(s):  
Energy Consumption ◽  
Rural Areas ◽  
Architectural Design ◽  
Energy Savings ◽  
Residential Buildings ◽  
Vernacular Architecture ◽  
Residential Building ◽  
Design Strategies ◽  
Heating And Cooling ◽  
Proposed Model

Abstract Climate-resilient buildings in Palestine can play an important role in a more sustainable residential building sector. This paper aims at evaluating the effects of adopting architectural design strategies and material technologies from vernacular architecture to create a new climate-resilient building. The paper targets single houses as these represent the majority of residential buildings in suburban and rural areas, and are similar to the vernacular architecture in size and functionality. The EDSL Tas simulation tool was used to assess the thermal performance and energy savings in the proposed model compared with traditional houses and modern typical houses, in two different climatic zones. The proposed climate-resilient house has materials and design strategies derived from vernacular architecture, in addition to the use of thermal insulation. The results show that the proposed house is more climate-resilient compared to modern houses. In cold winter and hot summer climates, the proposed model presents a total annual heating and cooling energy consumption of 59% less than typical modern houses, and 5% more than old buildings. In hot arid summer and warm winter climates, the proposed house presents a total annual heating and cooling energy consumption of 58% less than a modern typical house and 8% more than the traditional house.

Economic Potentials of Energy-Efficient Residential Building Envelope Retrofitting in Turkey

2016 ◽  
pp. 340-367
Author(s):  
M. Mustafa Erdoğdu ◽  
Coşkun Karaca ◽  
Ali Kurultay
Keyword(s):  
Energy Consumption ◽  
Thermal Resistance ◽  
Energy Efficient ◽  
Building Materials ◽  
Energy Savings ◽  
Residential Buildings ◽  
Residential Building ◽  
Economic Benefits ◽  
Building Envelope ◽  
Heat Transfers

The amount of energy consumption in the residential buildings has a very significant share with nearly 30 percent in the total amount of energy consumption. Therefore, residential sector is identified in this chapter as being one of the areas with a large potential for energy savings. Inefficient dwelling construction and design methods are widely used in Turkey and only about five percent of residential buildings are insulated. Concerning the importance and immediate need in Turkey for energy-efficient residential building retrofitting, this chapter identifies economic benefits of such retrofitting by particularly focusing on heat transfers by conductivity, where the rate can be determined by surface size, thermal resistance of the building materials and their thickness.

Saving Primary Energy Consumption Through Exergy Analysis of Combine Distillation and Power Plant

2012 ◽  
Vol 9 (2) ◽  
pp. 65
Author(s):  
Alhassan Salami Tijani ◽  
Nazri Mohammed ◽  
Werner Witt
Keyword(s):  
Energy Consumption ◽  
Power Plant ◽  
Heat Pump ◽  
Heat Recovery ◽  
Energy Savings ◽  
Primary Energy ◽  
Heat Pumps ◽  
Saturated Steam ◽  
Distillation Unit ◽  
Primary Energy Consumption

Industrial heat pumps are heat-recovery systems that allow the temperature ofwaste-heat stream to be increased to a higher, more efficient temperature. Consequently, heat pumps can improve energy efficiency in industrial processes as well as energy savings when conventional passive-heat recovery is not possible. In this paper, possible ways of saving energy in the chemical industry are considered, the objective is to reduce the primary energy (such as coal) consumption of power plant. Particularly the thermodynamic analyses ofintegrating backpressure turbine ofa power plant with distillation units have been considered. Some practical examples such as conventional distillation unit and heat pump are used as a means of reducing primary energy consumption with tangible indications of energy savings. The heat pump distillation is operated via electrical power from the power plant. The exergy efficiency ofthe primary fuel is calculated for different operating range ofthe heat pump distillation. This is then compared with a conventional distillation unit that depends on saturated steam from a power plant as the source of energy. The results obtained show that heat pump distillation is an economic way to save energy if the temperaturedifference between the overhead and the bottom is small. Based on the result, the energy saved by the application of a heat pump distillation is improved compared to conventional distillation unit.

Sign in / Sign up

Export Citation Format

Share Document