scholarly journals Influence of Longitudinal Fin Tubes Arrangement in LNG Ambient Air Vaporizers on the Wind Load

Energies ◽  
2022 ◽  
Vol 15 (2) ◽  
pp. 405
Author(s):  
Filip Lisowski ◽  
Edward Lisowski

The article presents the results of computational fluid dynamics (CFD) analysis of the wind action on liquefied natural gas (LNG) ambient air vaporizers (AAVs). A study concerning AAV with a 6 × 6 tubes array is presented to demonstrate how the distribution of longitudinal finned tubes and wind direction affect the average load and wind pressure acting on the vaporizer structure. The main goal of the study is to estimate the wind load on the structure and wind pressure on individual tubes depending on the pitch of the tubes arrangement. The above parameters are crucial for the strength analysis of the vaporizer structure. The derived analysis results provide important data on the variation of pressure on individual tubes, wind velocity inside AVV structure and indicate a significant increase in the average wind load acting on the structure for a wind direction of 45 degrees compared to a perpendicular direction.

2008 ◽  
Vol 400-402 ◽  
pp. 935-940 ◽  
Author(s):  
Ying Ge Wang ◽  
Zheng Nong Li ◽  
Bo Gong ◽  
Qiu Sheng Li

Heliostat is the key part of Solar Tower power station, which requires extremely high accuracy in use. But it’s sensitive to gust because of its light structure, so effect of wind load should be taken into account in design. Since structure of heliostat is unusual and different from common ones, experimental investigation on rigid heliostat model using technology of surface pressure mensuration to test 3-dimensional wind loads in wind tunnel was conducted. The paper illustrates distribution and characteristics of reflector’s mean and fluctuating wind pressure while wind direction angle varied from 0° to 180° and vertical angle varied from 0° to 90°. Moreover, a finite element model was constructed to perform calculation on wind-induced dynamic response. The results show that the wind load power spectral change rulers are influenced by longitudinal wind turbulence and vortex and are related with Strouhal number; the fluctuating wind pressures between face and back mainly appear positive correlation, and the correlation coefficients at longitudinal wind direction are smaller than those at lateral direction; the fluctuating wind pressures preferably agree with Gaussian distribution at smaller vertical angle and wind direction angle. The wind-induced response and its spectrums reveal that: when vertical angle is small, the background responsive values of reflector’s different parts are approximately similar; in addition, multi-phased resonant response occurring at the bottom. With the increase of , airflow separates at the near side and reunites at the other, as produces vortex which enhances dynamic response at the upper part.


2021 ◽  
Vol 323 ◽  
pp. 00021
Author(s):  
Filip Lisowski ◽  
Edward Lisowski

Ambient air vaporizers, depending on their efficiency, can be up to several meters high. Therefore, they can have a large outside surface area exposed to the wind. Forced air flow through the vaporizer structure have a beneficial effect on improving heat transfer from the environment. On the other hand, if the vaporizer is placed in the region of significant wind velocities, the wind forces acting on the structure can be considerable. This paper presents CFD analysis of air flow through the structure of the ambient air vaporizer with a 6 x 6 finned tube array. The effect of changing wind direction on the wind pressure and wind velocity distributions is investigated.


Energies ◽  
2022 ◽  
Vol 15 (1) ◽  
pp. 280
Author(s):  
Filip Lisowski ◽  
Edward Lisowski

The use of cryogenic liquefied gasses in industry is constantly increasing both for process purposes and for power supply needs. The liquefied natural gas (LNG) is stored at cryogenic temperature and its immediate use in gaseous form requires its evaporation. The heat needed to cause a phase change is usually delivered by means of vaporizers. This paper presents a numerical analysis of the influence of the fins number and frost accumulated within the fins surface on the heat transferred through the aluminum finned tubes of LNG ambient air vaporizers. The calculations were carried out applying finite element thermal analysis within Ansys software as well as using an analytical approach. As a result, the heat rate per unit length of the finned tube was obtained. The results were compared for different numbers of longitudinal fins both without frost and for total frosting of the tubes.


Author(s):  
Ji Hyeon Kim ◽  
Hae-Sung Lee

<p>This paper proposes a general procedure for evaluating a nominal value of wind velocity for a wind load- governed limit state to secure a target reliability index during the design life of a structure. The nominal value of wind velocity, referred to as a basic wind velocity, and wind load factor should be determined so that the factored wind load effect secures a target reliability index for a wind load-governed limit state. In this study, the analytical form of the return period of the basic wind velocity is expressed as a function of the target reliability index, wind load factor, and statistical parameters of wind pressure, which are derived as linear functions of the coefficient of wind velocity. The proposed approach is applied to the Korean Highway Bridge Design Code-Cable supported Bridge, which specifies the design life of a structure as 100- and 200-year.</p>


2021 ◽  
Vol 97 (5) ◽  
pp. 31-39
Author(s):  
V.S. KUZNETSOV ◽  
◽  
A.A. SHURUSHKIN ◽  

The features of the effect of wind on a prismatic-type building with different methods of determining the coefficient of wind pressure along the height are considered. The study was carried out on the basis of studying the main provisions of regulatory documents governing design and development activities in the Russian Federation, as well as current publications of domestic and foreign scientists, corresponding to research in this area. The research method is structural and analytical analysis using the correlation dependences of the factors under study. Analytical dependencies for determining the wind forces for various methods of assigning the wind load coefficient along the height of the building and their graphic interpretation are given. The work is based on the provisions of domestic building codes and relevant information contained in other domestic and foreign sources. For prismatic buildings with a height of up to 80 meters, there are areas where the forces from the main wind load significantly depend on the method of its determination. The conducted research indicates the ambiguity used in the practice of designing the parameters of the wind load, allowing the possibility of excess or underloading of structures or individual elements.


2011 ◽  
Vol 71-78 ◽  
pp. 3605-3609
Author(s):  
De Zhi Liang ◽  
Min Huang

In recent years, as the portal frame’s height toward higher and the span toward wider, the influence of wind vibration becomes more and more prominent among the portal frame structure. In the design of the portal frame, there are many different opinions on whether considering the impact of the vertical wind vibration to the portal frame. This paper taking a true engineering as an example, using finite element software to establish the solid model of the portal frame structure, selecting the junction of purlin and roof as a node of imposing vertical fluctuating wind load, we made numerical simulation analysis of vertical wind vibration. The simulation results will be compared with data of the internal forces and deformation under the average wind pressure. The results showed that: vertical wind vibration has a prominent effect to the portal frame and should be considered in the design.


2015 ◽  
Vol 8 (10) ◽  
pp. 4347-4367 ◽  
Author(s):  
G. Guyot ◽  
C. Gourbeyre ◽  
G. Febvre ◽  
V. Shcherbakov ◽  
F. Burnet ◽  
...  

Abstract. Clouds have an important role in Earth's radiative budget. Since the late 1970s, considerable instrumental developments have been made in order to quantify cloud microphysical and optical properties, for both airborne and ground-based applications. Intercomparison studies have been carried out in the past to assess the reliability of cloud microphysical properties inferred from various measurement techniques. However, observational uncertainties still exist, especially for droplet size distribution measurements and need to be reduced. In this work, we discuss results from an intercomparison campaign, performed at the Puy de Dôme in May 2013. During this campaign, a unique set of cloud instruments was operating simultaneously in ambient air conditions and in a wind tunnel. A Particle Volume Monitor (PVM-100), a Forward Scattering Spectrometer Probe (FSSP), a Fog Monitor (FM-100), and a Present Weather Detector (PWD) were sampling on the roof of the station. Within a wind tunnel located underneath the roof, two Cloud Droplet Probes (CDPs) and a modified FSSP (SPP-100) were operating. The main objectives of this paper are (1) to study the effects of wind direction and speed on ground-based cloud observations, (2) to quantify the cloud parameters discrepancies observed by the different instruments, and (3) to develop methods to improve the quantification of the measurements. The results revealed that all instruments showed a good agreement in their sizing abilities, both in terms of amplitude and variability. However, some of them, especially the FM-100, the FSSP and the SPP, displayed large discrepancies in their capability to assess the magnitude of the total number concentration of the cloud droplets. As a result, the total liquid water content can differ by up to a factor of 5 between the probes. The use of a standardization procedure, based on data of integrating probes (PVM-100 or visibilimeter) and extinction coefficient comparison substantially enhanced the instrumental agreement. During this experiment, the total concentration agreed in variations with the visibilimeter, except for the FSSP, so a corrective factor can be applied and it ranges from 0.44 to 2.2. This intercomparison study highlights the necessity to have an instrument which provides a bulk measurement of cloud microphysical or optical properties during cloud ground-based campaigns. Moreover, the FM and FSSP orientation was modified with an angle ranging from 30 to 90° angle with wind speeds from 3 to 7 m s−1. The results show that the induced number concentration loss is between 29 and 98 % for the FSSP and between 15 and 68 % for the FM-100. In particular, FSSP experiments showed strong discrepancies when the wind speed was lower than 3 m s−1 and/or when the angle between the wind direction and the orientation of the instruments is greater than 30°. An inadequate orientation of the FSSP towards the wind direction leads to an underestimation of the measured effective diameter.


2011 ◽  
Vol 94-96 ◽  
pp. 535-538
Author(s):  
Zhi Xiang Yin ◽  
Cheng Jie Zhang

The influence of the wind coefficient distribution on coal reservoirs for coal gangue is very important to its wind-resistance design. Take a real coal reservoir in Ordos for example, the wind pressure is numerically simulated with the help of Fluent Software. Because of the coal gangue piples, the average wind coefficient absolute obviously reduced under most of the wind directions, but the local area on the surface and leeward side the average wind coefficient absolute will increase significantly under the certain wind directions. Anyhow, the coal gangue is important to the wind pressure distributions of the coal reservoir and can't ignore its effect in the actual engineering design and should be given more attention.


Sign in / Sign up

Export Citation Format

Share Document