scholarly journals Evaluation of Electrochromic Properties of Polypyrrole/Poly(methylene blue) Layer Doped by Polysaccharides

Sensors ◽  
2021 ◽  
Vol 22 (1) ◽  
pp. 232
Author(s):  
Vilma Ratautaite ◽  
Raimonda Boguzaite ◽  
Migle Beatrice Mickeviciute ◽  
Lina Mikoliunaite ◽  
Urte Samukaite-Bubniene ◽  
...  
Keyword(s):  
Methylene Blue ◽  
Indium Tin Oxide ◽  
Alkaline Media ◽  
Acidic Media ◽  
Electrochromic Properties ◽  
Xanthine Derivatives ◽  
Glass Slides ◽  
Absorbance Changes ◽  
Relationship Of

Polypyrrole (Ppy) and poly(methylene blue) (PMB) heterostructure (Ppy-PMB) was electrochemically formed on the indium tin oxide (ITO) coated glass slides, which served as working electrodes. For electropolymerization, a solution containing pyrrole, methylene blue, and a saccharide (lactose, sucrose, or heparin) that served as dopant was used. The aim of this study was to compare the effect of the saccharides (lactose, sucrose, and heparin) on the electrochromic properties of the Ppy-PMB layer. AFM and SEM have been used for the analysis of the surface dominant features of the Ppy-PMB layers. From these images, it was concluded that the saccharides used in this study have a moderate effect on the surface morphology. Electrochromic properties were analyzed with respect to the changes of absorbance of the layer at two wavelengths (668 nm and 750 nm) by changing the pH of the surrounding solution and the potential between +0.8 V and −0.8 V. It was demonstrated that the highest absorbance changes are characteristic for all layers in the acidic media. Meanwhile, the absorbance changes of the layers were decreased in the more alkaline media. It was determined that the Ppy-PMB layers with heparin as a dopant were more mechanically stable in comparison to the layers doped with lactose and sucrose. Therefore, the Ppy-PMB layer doped with heparin was selected for the further experiment and it was applied in the design of electrochromic sensors for the determination of three xanthine derivatives: caffeine, theobromine, and theophylline. A linear relationship of ΔA (∆A = A+0.8V – A−0.8V) vs. concentration was determined for all three xanthine derivatives studied. The largest change in optical absorption was observed in the case of theophylline determination.

STEM and ELS Observation of Early Oxide Formation on the Surface of Cr Thin Films

1980 ◽  
Vol 38 ◽  
pp. 412-413
Author(s):  
Fumio Watari ◽  
J. M. Cowley
Keyword(s):  
Thin Films ◽  
Optical System ◽  
Room Temperature ◽  
Oxide Formation ◽  
Initial Nucleation ◽  
Diffraction Patterns ◽  
Relationship Of ◽  
Multiple Twinning ◽  
Moderately High Temperature

STEM coupled with the optical system was used for the investigation of the early oxidation on the surface of Cr. Cr thin films (30 – 1000Å) were prepared by evaporation onto the polished or air-cleaved NaCl substrates at room temperature and 45°C in a vacuum of 10−6 Torr with an evaporation speed 0.3Å/sec. Rather thick specimens (200 – 1000Å) with various preferred orientations were used for the investigation of the oxidation at moderately high temperature (600 − 1100°C). Selected area diffraction patterns in these specimens are usually very much complicated by the existence of the different kinds of oxides and their multiple twinning. The determination of the epitaxial orientation relationship of the oxides formed on the Cr surface was made possible by intensive use of the optical system and microdiffraction techniques. Prior to the formation of the known rhombohedral Cr2O3, a thin spinel oxide, probably analogous to γ -Al203 or γ -Fe203, was formed. Fig. 1a shows the distinct epitaxial growth of the spinel (001) as well as the rhombohedral (125) on the well-oriented Cr(001) surface. In the case of the Cr specimen with the (001) preferred orientation (Fig. 1b), the rings explainable by spinel structure appeared as well as the well defined epitaxial spots of the spinel (001). The microdif fraction from 20A areas (Fig. 2a) clearly shows the same pattern as Fig. Ia with the weaker oxide spots among the more intense Cr spots, indicating that the thickness of the oxide is much less than that of Cr. The rhombohedral Cr2O3 was nucleated preferably at the Cr(011) sites provided by the polycrystalline nature of the present specimens with the relation Cr2O3 (001)//Cr(011), and by further oxidation it grew into full coverage of the rest of the Cr surface with the orientation determined by the initial nucleation.

Calculating the aerodynamics of vertical axis wind turbines

2012 ◽  
Vol 34 (3) ◽  
pp. 169-184 ◽  
Author(s):  
Hoang Thi Bich Ngoc
Keyword(s):  
Wind Turbine ◽  
Incidence Angle ◽  
Vertical Axis ◽  
Rotor Blades ◽  
Vertical Axis Wind Turbine ◽  
Horizontal Axis Wind Turbine ◽  
Velocity Triangle ◽  
Relationship Of ◽  
The Relationship

Vertical axis wind turbine technology has been applied last years, very long after horizontal axis wind turbine technology. Aerodynamic problems of vertical axis wind machines are discussible. An important problem is the determination of the incidence law in the interaction between wind and rotor blades. The focus of the work is to establish equations of the incidence depending on the blade azimuth, and to solve them. From these results, aerodynamic torques and power can be calculated. The incidence angle is a parameter of velocity triangle, and both the factors depend not only on the blade azimuth but also on the ratio of rotational speed and horizontal speed. The built computational program allows theoretically selecting the relationship of geometric parameters of wind turbine in accordance with requirements on power, wind speed and installation conditions.

Tire Treadwear — A Comprehensive Evaluation of the Factors: Generic Type, Aspect Ratio, Tread Pattern, and Tread Composition Part I: Introduction and Details on the Organization of the Program

1986 ◽  
Vol 14 (4) ◽  
pp. 201-218 ◽  
Author(s):  
A. G. Veith
Keyword(s):  
Aspect Ratio ◽  
Comprehensive Evaluation ◽  
Test Method ◽  
Interactive Effects ◽  
Data Analyses ◽  
Main Effect ◽  
Systematic Determination ◽  
Relationship Of ◽  
The Relationship

Abstract This four-part series of papers addresses the problem of systematic determination of the influence of several tire factors on tire treadwear. Both the main effect of each factor and some of their interactive effects are included. The program was also structured to evaluate the influence of some external-to-tire conditions on the relationship of tire factors to treadwear. Part I describes the experimental design used to evaluate the effects on treadwear of generic tire type, aspect ratio, tread pattern (groove or void level), type of pattern (straight rib or block), and tread compound. Construction procedures and precautions used to obtain a valid and functional test method are included. Two guiding principles to be used in the data analyses of Parts II and III are discussed. These are the fractional groove and void concept, to characterize tread pattern geometry, and a demonstration of the equivalence of wear rate for identical compounds on whole tread or multi-section tread tires.

Spectrophotometric study of the acid-base and optical properties of the 5-bromo and 5-chloro derivatives of 2-(2-pyridylazo)-5-(diethylamino)phenol (BrPADAP, ClPADAP) and their complexation equilibria with zinc(II) ions

1982 ◽  
Vol 47 (10) ◽  
pp. 2676-2691 ◽  
Author(s):  
Miroslav Macka ◽  
Vlastimil Kubáň
Keyword(s):  
Equilibrium Constants ◽  
Spectrophotometric Study ◽  
Graphical Analysis ◽  
Alkaline Media ◽  
Acid Base ◽  
Ethanol Medium ◽  
Triton X ◽  
Mixed Water ◽  
Derivatives Of

The optical and acid-base characteristics of BrPADAP and ClPADAP were studied in mixed water-ethanol and water-DMF media and in 10% ethanol medium in the presence of cationic, anionic and nonionic tensides. The composition, optical characteristics, molar absorption coefficients and equilibrium constants of the ML and ML2 complexes with zinc(II) ions were found by graphical analysis and numerical interpretation of the absorbance curves by the modified SQUAD-G program. Optimal conditions were found for the spectrophotometric determination of Zn(II) in the presence of 0.1% Triton X-100 or 1% Brij 35 in alkaline media with pH = 6.5-10. BrPADAP and ClPADAP are the most sensitive reagents (ε = 1.3-1.6 . 105 mmol-1 cm2 at 557 and 560 nm, respectively) for the determination of zinc with high colour contrast of the reaction (Δλ = 104 nm) and selectivity similar to that for the other N-heterocyclic azodyes (PAN, PAR, etc.).

Mn-Mo-O Catalysts for Methanol Oxidation. I. Preparation and Characterization of the Catalysts

1992 ◽  
Vol 57 (12) ◽  
pp. 2529-2538 ◽  
Author(s):  
Krasimir Ivanov ◽  
Penka Litcheva ◽  
Dimitar Klissurski
Keyword(s):  
Methanol Oxidation ◽  
Solution Concentration ◽  
Alkaline Media ◽  
Acidic Media ◽  
Chemical Methods ◽  
X Ray ◽  
Ph Values ◽  
Precipitate Composition

Mn-Mo-O catalysts with a different Mo/Mn ratio have been prepared by precipitation. The precipitate composition as a function of solution concentration and pH was studied by X-ray, IR, thermal and chemical methods. Formation of manganese molybdates with MnMoO4.1.5H2O, Mn3Mo3O12.2.5H2O, and Mn3Mo4O15.4H2O composition has been supposed. It is concluded that pure MnMoO4 may be obtained in both acid and alkaline media, the pH values depending on the concentration of the initial solutions. The maximum Mo/Mn ratio in the precipitates is 1.33. The formation of pure Mn3Mo4O15.4H2O is possible in weakly acidic media. This process is favoured by increasing the concentration of initial solutions.

Sorption of Cadmium and Lead by Chelating Ion Exchangers Ostsorb OXIN, Ostsorb DETA, and Ostsorb DTTA

1994 ◽  
Vol 59 (6) ◽  
pp. 1311-1318 ◽  
Author(s):  
Ladislav Svoboda ◽  
Petr Vořechovský
Keyword(s):  
Ionic Strength ◽  
Aqueous Solutions ◽  
Sodium Perchlorate ◽  
Exchange Capacity ◽  
Chloride Ions ◽  
Point Of View ◽  
Alkaline Media ◽  
Ion Exchangers ◽  
Acidic Media ◽  
Cadmium And Lead

The properties of cellulose chelating ion exchangers Ostsorb have been studied in the sorption of cadmium and lead from aqueous solutions. The Cd(II) and Pb(II) ions are trapped by the Ostsorb OXIN and Ostsorb DETA ion exchangers most effectively in neutral and alkaline media but at these conditions formation of stable hydrolytic products of both metals competes with the exchange equilibria. From this point of view, Ostsorb DTTA appears to be a more suitable sorbent since it traps the Pb(II) and Cd(II) ions in acidic media already. Chloride ions interfere with the sorption of the two metals by Ostsorb DTTA whereas the ionic strength adjusted by the addition of sodium perchlorate does not affect the exchange capacity of this ion exchanger.

Sign in / Sign up

Export Citation Format

Share Document