Improvement of Barrier Soil Properties with Fly Ash to Minimize Desiccation Shrinkage

2012 ◽  
Vol 7 ◽  
pp. 1-11 ◽  
Author(s):  
Agapitus A. Amadi
Keyword(s):  
Fly Ash ◽  
Hydraulic Conductivity ◽  
Water Content ◽  
Dry Weight ◽  
Shrinkage Strain ◽  
Volumetric Shrinkage ◽  
Unit Weight ◽  
British Standard ◽  
Fine Grained ◽  
Dry Unit Weight

Barrier Systems Built with Fine Grained Soils Frequently Loose their Hydraulic Integrity due to Desiccation Cracking either during Construction or Shortly Thereafter. Moreover, Typical Specifications for the Construction of Compacted Soil Liners and Covers Require that the Soil Be Compacted Wet of Optimum Water Contents to Achieve the Lowest Possible Hydraulic Conductivity, a Condition that Results in High Desiccation Shrinkage Values. however, such Soils Can Be Treated with Fly Ash to Maintain Low and Tolerable Desiccation Shrinkage Strains. in this Study, Volumetric Shrinkage Strains of Representative Fine Grained Soil Containing 0 – 20% Fly Ash by Dry Weight of Soil Compacted with the British Standard Light (BSL), West African Standard (WAS) and British Standard Heavy, (BSH) Compaction Efforts at Moisture Contents Ranging from 10 – 20% Were Evaluated. Measurements Indicate that Volumetric Shrinkage Strain Decreased with Higher Fly Ash Content and that Fly Ash Effectively Reduced the Shrinkage of Untreated Soil Prepared Wet of Optimum from 4.4 – 7.7% to Values Well below the 4% Threshold. the Measured Shrinkage Strains Were Related to Water Content and Dry Unit Weight on the Dry Unit Weight – Moulding Water Content Curve in what Is Referred to as Acceptable Zone. Data Points within the Acceptable Zone Represent Test Results with Shrinkage Strain ≤ 4% which Ensures Compaction Efficiency. this Study Therefore Established that Fly Ash Application and Appropriate Regulation of the Moulding Water Content Are Feasible Means of Reducing the Risk of Barrier Soil Damage by Shrinkage Cracks while still Realizing Very Low Hydraulic Conductivity and Adequate Strength.

Compressive strength behavior of fine-grained frozen soils

1990 ◽  
Vol 27 (4) ◽  
pp. 472-483 ◽  
Author(s):  
Harsha Wijeweera ◽  
Ramesh C. Joshi
Keyword(s):  
Compressive Strength ◽  
Water Content ◽  
Yield Stress ◽  
Constant Strain Rate ◽  
Unit Weight ◽  
Total Water Content ◽  
Total Water ◽  
Frozen Soils ◽  
Fine Grained ◽  
Dry Unit Weight

Constant strain-rate (0.01/s) uniaxial compression-strength tests were conducted on more than 200 saturated samples of six fine-grained frozen soils at temperatures between −5 and −17 °C. Saturated soil samples containing total water contents between 15% and 105% were prepared using a consolidation apparatus specially designed for this purpose. The effect of dry unit weight, total water content, temperature, and soil type on the behavior of peak compressive strength was studied. Test results indicate the peak compressive strength of fine-grained soils is sensitive to changes in the dry unit weight and the total water content. The temperature dependence of the peak compressive strength is represented by a simple power law. An empirical formula has been developed to predict the peak compressive strength of fine-grained frozen soils at a particular temperature using index properties, specific surface area, particle-size distribution, and dry unit weight. A linear relationship exists between the peak compressive stress and the yield stress. Key words: peak compressive strength, yield stress, frozen soils, fine-grained soils, dry unit weight, failure strain, temperature, total water content, slurry consolidation.

Compressibility and hydraulic conductivity of a chemically treated expansive clay

2001 ◽  
Vol 38 (1) ◽  
pp. 154-160 ◽  
Author(s):  
Zalihe Nalbantoglu ◽  
Erdil Riza Tuncer
Keyword(s):  
Fly Ash ◽  
Hydraulic Conductivity ◽  
Expansive Soil ◽  
Dry Weight ◽  
Pozzolanic Reaction ◽  
Exchange Capacity ◽  
Expansive Clay ◽  
Preconsolidation Pressure ◽  
Few Data ◽  
Published Research

The paper presents a series of laboratory tests and evaluates the effect of lime and fly ash on the compressibility and hydraulic characteristics of an expansive soil in Cyprus. The tests were performed at different percentages of lime (0–7%) and fly ash (15 and 25%) by dry weight of soil, and additional tests were also performed on soils treated with 15% fly ash plus 3% lime. Previously published research reveals that few data are available concerning the compressibility and hydraulic conductivity of lime-treated soils. The results of this study indicate an increase in the vertical effective yield stress (apparent preconsolidation pressure) and a decrease in the compressibility characteristics of the treated soils. Moreover, unlike some of the findings in the literature, higher hydraulic conductivity values were obtained with time. This finding has been substantiated by the reduced cation exchange capacity (CEC) values, which indicate that the pozzolanic reaction causes the soils to become more granular in nature, resulting in higher hydraulic conductivity.Key words: cementation, compressibility, fly ash, hydraulic conductivity, lime.

Lateritic Soil Treated with Waste Wood Ash As Liner in Landfill Construction

2019 ◽  
Vol 25 (2) ◽  
pp. 127-139 ◽  
Author(s):  
Johnson R. Oluremi ◽  
Adrian O. Eberemu ◽  
Stephen T. Ijimdiya ◽  
Kolawole J. Osinubi
Keyword(s):  
Compressive Strength ◽  
Hydraulic Conductivity ◽  
Unconfined Compressive Strength ◽  
Wood Ash ◽  
Engineering Properties ◽  
Volumetric Shrinkage ◽  
Lateritic Soil ◽  
Waste Wood ◽  
K Value ◽  
British Standard

ABSTRACTInherent variability in engineering properties of lateritic soil in relation to its plasticity, permeability, strength, workability, and natural moisture content, has made it an unpredictable material for use in civil engineering works, resulting in the need for its treatment by stabilization. A lateritic soil classified as A-6(6) and CL, according to American Association of State Highway and Transportation Officials and Unified Soil Classification System of ASTM (2011), was treated with up to 10 percent waste wood ash (WWA). Compaction was carried out using four energies, namely, reduced British Standard light, British Standard light (BSL), West African Standard, and British Standard heavy, on samples, which were then examined for hydraulic conductivity, volumetric shrinkage, and unconfined compressive strength as major criteria for use as liner and for the development of acceptable zones. Specimens with 4 percent WWA content compacted with a minimum BSL energy satisfied the maximum hydraulic conductivity (k) value of 1 × 10−9 m/s, maximum volumetric shrinkage strain of 4 percent, and minimum unconfined compressive strength value of 200 kN/m2 required for use as liner in engineered landfills. The overall acceptable zone was enlarged for up to 4 percent WWA content, thereby accommodating higher moulding water content, but the minimum compactive effort required to achieve it became reduced. The beneficial treatment of lateritic soil with up to 4 percent WWA will perform satisfactorily as liner and covers in waste containment application and will minimize the pollution and environmental impact of wood waste disposal.

scholarly journals Evaluations of the effects of soil properties and electrical conductivity on the water content reflectometer calibration for landfill cover soils

2017 ◽  
Vol 12 (No. 1) ◽  
pp. 10-17 ◽  
Author(s):  
K. Kim ◽  
J. Sim ◽  
T.-H. Kim
Keyword(s):  
Electrical Conductivity ◽  
Soil Properties ◽  
Water Content ◽  
Clay Content ◽  
Liquid Limit ◽  
Time Domain Reflectometry ◽  
Volumetric Water Content ◽  
Unit Weight ◽  
Landfill Cover ◽  
Dry Unit Weight

This study presents soil-moisture calibrations using low-frequency (15–40 MHz) time domain reflectometry (TDR) probe, referred to as water content reflectometer (WCR), for measuring the volumetric water content of landfill cover soils, developing calibrations for 28 different soils, and evaluating how WCR calibrations are affected by soil properties and electrical conductivity. A 150-mm-diameter PVC cell was used for the initial WCR calibration. Linear and polynomial calibrations were developed for each soil. Although the correlation coefficients (R<sup>2</sup>) for the polynomial calibration are slightly higher, the linear calibrations are accurate and pragmatic to use. The effects of soil electrical conductivity and index properties were investigated using the slopes of linear WCR calibrations. Soils with higher electrical conductivity had lower calibration slopes due to greater attenuation of the signal during transmission in the soil. Soils with higher electrical conductivity tended to have higher clay content, organic matter, liquid limit, and plasticity index. The effects of temperature and dry unit weight on WCR calibrations were assessed in clayey and silty soils. The sensor period was found to increase with the temperature and density increase, with greater sensitivity in fine-textured plastic soils. For typical variations in temperature, errors in volumetric water content on the order of 0.04 can be expected for wet soils and 0.01 for drier soils if temperature corrections are not applied. Errors on the order of 0.03 (clays) and 0.01 (silts) can be expected for typical variations in dry unit weight (± 2 kN/m<sup>3</sup>).

scholarly journals Geotechnical Properties of Soft Marine Soil at Chan May Port, Vietnam

2021 ◽  
Vol 1 (2) ◽  
Author(s):  
Thi Nu NGUYEN ◽  
Thanh Duong NGUYEN ◽  
Truong Son BUI
Keyword(s):  
Shear Strength ◽  
Water Content ◽  
Void Ratio ◽  
Soft Soil ◽  
Field Investigation ◽  
Liquid Limit ◽  
Geotechnical Properties ◽  
Unit Weight ◽  
Dry Unit Weight ◽  
Marine Soil

Soft marine soil deposit is distributed under the sea with many special properties. This type ofsoil is rarely researched in Vietnam because of the difficult geotechnical investigation under the sea level.In this paper, the experimental laboratories were performed to investigate the geotechnical properties ofsoft marine soil at Chan May port, Vietnam. The field investigation results indicate that the thickness ofsoft soil varies from a few meters to more than ten meters. Soft soil has a high value of water content,void ratio, and compressibility and a low value of shear strength. The compression index has a goodrelationship with water content, liquid limit, and dry unit weight. The unit weight, shear strength, and preconsolidationpressure increase with the increase of depth. These results show that the soil in the studyarea is unfavorable for construction activities.

scholarly journals Effect of Fluid Chemistry on the Consolidation and Hydraulic Conductivity of Sand-Clay Liners

2021 ◽  
Vol 13 (20) ◽  
pp. 11213
Author(s):  
Muawia Dafalla
Keyword(s):  
Hydraulic Conductivity ◽  
Saline Water ◽  
Dry Weight ◽  
Coastal Zones ◽  
Clay Liners ◽  
Clay Liner ◽  
Fine Grained ◽  
Fluid Media ◽  
Liner Surface ◽  
Inorganic Chemical

The clay swelling potential of sand-clay liners exposed to saline water or specific chemicals can influence their hydraulic conductivity and other consolidation properties. The effect of saline water or chemicals on the sand-clay liners was thus studied and evaluated. The consolidation characteristics of the sand-clay liner can be different when tested under different fluid media. Bentonite and cement grouts are chemicals that have a significant effect on the sand-clay liners. Cement and bentonite can be used to seal off the openings within the liner to repair a defect or a malfunction. In this study, Al-Qatif clay was used to form a sand-clay liner when mixed with fine-grained sand (clay is 20% by dry weight). Soil samples extracted from this liner were exposed to inorganic chemical solutions. NaCl and CaCl2 solutions with concentration ranges of 0.1%, 0.5%, and 1.5% were used. Acidic water with pH values of 4, 5, and 6 was similarly used as fluid media. The effects of NaCl, CaCl2, and water with different acidity on the consolidation characteristics and hydraulic conductivity were obtained and compared to those of the distilled water. The effects of grout materials containing bentonite (1%, 2%, and 3% by weight) and cement (2.5%, 5%, and 7.5% by weight) were also investigated. The addition of bentonite grout to the liner surface was found to improve its hydraulic conductivity. The cement effect on the compressibility was found to be very significant. The findings of this study can serve as a guide for selecting parameters in the design and assessment of sand-clay liners in semi-arid regions and coastal zones.

scholarly journals Hydraulic characteristics of plow pan constructed sandy paddy soil by adding fly ash

2021 ◽  
pp. 993-1002
Author(s):  
Yang Wei ◽  
Nan Lu ◽  
Bo Yan ◽  
Gang Li
Keyword(s):  
Fly Ash ◽  
Hydraulic Conductivity ◽  
Water Content ◽  
Paddy Soil ◽  
Storage Capacity ◽  
Water Storage ◽  
Saturated Hydraulic Conductivity ◽  
Wetting Front ◽  
Movement Rate ◽  
Water Storage Capacity

The feasibility of mixing fly ash to sandy soil to build the artificial plow pan of paddy soil in the Yellow River beach was explored. Water infiltration characteristics, saturated hydraulic conductivity, saturated water content and water storage capacity of the artificial plow pan were measured by using laboratory column tests. The results showed that under the same bulk density, when the amount of fly ash increased, the movement rate of the plow pan wetting front, the infiltration rate and the saturated hydraulic conductivity were decreased, then the water content and water storage of the soil layer increased. When the application amount of the fly ash was the same, and when the compaction weight decreased, the wetting front movement rate and saturated hydraulic conductivity increased and the soil water content and water storage capacity decreased. Mixing of fly ash with sand at a ratio of 1:3 (by weight) was found to be ideal for making an artificial of plow pan having bulk density of 1.7 g/cm3. Bangladesh J. Bot. 50(3): 993-1002, 2021 (September) Special  

Sign in / Sign up

Export Citation Format

Share Document