A New Type of Coprometer for Laboratory and Field Use

1953 ◽  
Vol 85 (6) ◽  
pp. 227-230 ◽  
Author(s):  
G W. Green ◽  
W. R. Henson

It is often desirable to establish the relationship between the amount of feeding of an insect and the prevailing meteorological conditions. With colonial insects, especially, it is difficult to determine visually whether members of a colony are feeding heavily, moderately, or lightly. If periodic measurements of frass drop are made, more reliable information may be obtained, for such measurements have proved to be reliable indicators of the intensity of feeding (Gornitz (1933); Monro (1935; Morris (1949), and Taranukha (1937)).


Author(s):  
O. A. Zadorozhna ◽  
T. P. Shyianova ◽  
M.Yu. Skorokhodov

Seed longevity of 76 spring barley gene pool samples (Hordeum vulgare L. subsp. distichon, convar. distichon: 56 nutans Schubl., two deficience (Steud.) Koern., two erectum Rode ex Shuebl., two medicum Koern.; convar. nudum (L.) A.Trof.: one nudum L. та subsp. vulgare: convar. vulgare: nine pallidum Ser., three rikotense Regel.; convar. coeleste (L.) A.Trof.: one coeleste (L.) A.Trof.) from 26 countries, 11 years and four places of reproduction was analyzed. Seeds with 5–8% moisture content were stored in chamber with unregulated and 4oC temperature. The possibility of seed storage under these conditions for at least 10 years without significant changes in germination has been established. The importance of meteorological conditions in the formation and ripening of seeds for their longevity is confirmed. The relationship between the decrease of barley seeds longevity and storage conditions, amount of rainfall, temperature regime during the growing season of plants is discussed.



2016 ◽  
Vol 2016 ◽  
pp. 1-17 ◽  
Author(s):  
Songlin Yue ◽  
Yanyu Qiu ◽  
Pengxian Fan ◽  
Pin Zhang ◽  
Ning Zhang

Analogue material with appropriate properties is of great importance to the reliability of geomechanical model test, which is one of the mostly used approaches in field of geotechnical research. In this paper, a new type of analogue material is developed, which is composed of coarse aggregate (quartz sand and/or barite sand), fine aggregate (barite powder), and cementitious material (anhydrous sodium silicate). The components of each raw material are the key influencing factors, which significantly affect the physical and mechanical parameters of analogue materials. In order to establish the relationship between parameters and factors, the material properties including density, Young’s modulus, uniaxial compressive strength, and tensile strength were investigated by a series of orthogonal experiments with hundreds of samples. By orthogonal regression analysis, the regression equations of each parameter were obtained based on experimental data, which can predict the properties of the developed analogue materials according to proportions. The experiments and applications indicate that sodium metasilicate cemented analogue material is a type of low-strength and low-modulus material with designable density, which is insensitive to humidity and temperature and satisfies mechanical scaling criteria for weak rock or soft geological materials. Moreover, the developed material can be easily cast into structures with complex geometry shapes and simulate the deformation and failure processes of prototype rocks.



2012 ◽  
Vol 614-615 ◽  
pp. 64-68
Author(s):  
Tuo Wang ◽  
Feng Wu ◽  
Jin Hua Fei ◽  
Ming Fang Liu

Thermo-acoustic refrigerator is a new type of engine, which is based on the thermo-acoustic effect. A new model which expresses as an ellipse in pressure-volume diagram is established to investigate the thermodynamic performance of an actual thermo-acoustic refrigeration micro-cycle. The demarcation points of endothermic processes and exothermic processes in the actual micro-cycle are found. The analytic expressions of the dimensionless cooling load and the coefficient of performance (COP) are deduced. The relationship between the dimensionless cooling load and the COP are investigated by numerical examples. The results show that the dimensionless cooling load is a monotonically increasing function of the COP and the pressure amplitude.



2017 ◽  
Vol 16 (2) ◽  
pp. 117-131 ◽  
Author(s):  
Veronika Bocsi ◽  
Hajnalka Fényes ◽  
Valéria Markos

In this article, the motives for voluntary work and work values in higher education contexts are examined in a cross-border region in Central Eastern Europe. Our goal is to find out what kind of relationship exists between different types of volunteering and work values among young people. In the theoretical section, we deal with the definition of volunteering in the education system, the types of and motives for students’ volunteering, and finally, the relationship between the work values and voluntary work of students. In the empirical section, we created cluster groups based on students’ motives for volunteering, and we examined differences among countries. Then we revealed the factor structure of the work values of students and analyzed the relationship between cluster groups and factors with variance analysis. Five cluster groups were identified: “careerists with postmodern features,” “unmotivated,” “highly motivated,” “volunteers in an anti-volunteering climate,” and a “helping new type volunteers” group. There were only slight differences among countries, as most respondents are characterized by mixed motivations. An interesting result is that the most frequent group is “the volunteers in an anti-volunteering climate” in all the countries examined, especially in Ukraine, so the culture of volunteering is not popular enough in this region of Central Eastern Europe. Regarding the relationship between work values and volunteering, we have found that these two fields (work values and volunteering) are closely related.



2019 ◽  
Vol 28 (3) ◽  
pp. 41
Author(s):  
Aneta Michalska-Warias

<p>The paper discusses the concept of a terrorist threat in the light of Article 115 § 20 of the Polish Criminal Code. The author stresses the relationship between this term and the punishable threat described in the special part of the Criminal Code. The conducted analysis leads to the conclusion that the terrorist threat must be treated as a special type of the punishable threat and, as a result, many real terrorist threats may not meet the criteria of a forbidden act, e.g. because of the lack of an individualised victim. As a result, there appear serious doubts as to whether Polish criminal law meets the requirements of EU law referring to the criminalisation of terrorist threats and, therefore, the introduction of a new type of offence of a terrorist threat and some changes in Article 115 § 20 and Article 115 § 12 of the Criminal Code have been proposed.</p>



Author(s):  
S. Malathi, Et. al.

In this paper we introduce a new type of neighbourhoods, namely, t-neighbourhoods in trigonometric topological spaces and study their basic properties. Also, we discuss the relationship between neighbourhoods and t-neighbourhoods. Further, we give the necessary condition for t-neighbourhoods in trigonometric topological spaces.  .



2009 ◽  
Vol 37 (1/2) ◽  
pp. 43-81
Author(s):  
Patrizia Calefato

This paper focuses on the semiotic foundations of sociolinguistics. Starting from the definition of “sociolinguistics” given by the philosopher Adam Schaff, the paper examines in particular the notion of “critical sociolinguistics” as theorized by the Italian semiotician Ferruccio Rossi-Landi. The basis of the social dimension of language are to be found in what Rossi-Landi calls “social reproduction” which regards both verbal and non-verbal signs. Saussure’s notion of langue can be considered in this way, with reference not only to his Course of General Linguistics, but also to his Harvard Manuscripts.The paper goes on trying also to understand Roland Barthes’s provocative definition of semiology as a part of linguistics (and not vice-versa) as well as developing the notion of communication-production in this perspective. Some articles of Roman Jakobson of the sixties allow us to reflect in a manner which we now call “socio-semiotic” on the processes of transformation of the “organic” signs into signs of a new type, which articulate the relationship between organic and instrumental. In this sense, socio-linguistics is intended as being sociosemiotics, without prejudice to the fact that the reference area must be human, since semiotics also has the prerogative of referring to the world of non-human vital signs.Socio-linguistics as socio-semiotics assumes the role of a “frontier” science, in the dual sense that it is not only on the border between science of language and the anthropological and social sciences, but also that it can be constructed in a movement of continual “crossing frontiers” and of “contamination” between languages and disciplinary environments.



2017 ◽  
Vol 10 (1) ◽  
pp. 35-43
Author(s):  
Filip Havlíček ◽  
Martin Kuča

AbstractThis article deals with the relationship between humans and waste in the Bronze Age. Based on selected examples of waste management strategies from the European Bronze Age, it presents an overview of different strategies. In comparison with the preceding Stone Age, a new type of material began to appear: metal. The process involved in producing metal objects, however, brought with it the appearance of a specific type of waste material that is indelibly linked to the production of metal. This article also deals with the significance of ritualized social activities in the Bronze Age, which materialized in waste and waste management strategies.



2012 ◽  
Vol 512-515 ◽  
pp. 377-381 ◽  
Author(s):  
Jin Rong Lu ◽  
Yang Zhou ◽  
Yong Zheng ◽  
Shi Bo Li ◽  
Zhen Ying Huang ◽  
...  

In this paper, a new type of Ti3SiC2/Cu composites with the volume fractions of 30% Ti3SiC2 particle was prepared by hot pressing and vacuum sintering respectively. The effects of sintering temperature and holding time on the density, resistance and Vickers hardness of Cu-30vol%Ti3SiC2 composite were investigated. The results show that the mechanical properties of the composites prepared by hot pressing are better than that prepared by vacuum sintering. The relative densities of Cu-30vol% Ti3SiC2 composites are rather high in suitable sintering conditions. It achieved 100% for the composites prepared by hot pressing at 930°C for 2h, and 98.4% for the composites prepared by vacuum sintering at 1250°C for 1h. At the same time, the maximum Vickers hardness reached 1735MPa at 900°C by hot pressing. The resistance and Vickers hardness of the composites decreased with an increase in sintering temperature, whereas the density increased. Scanning electron microscope (SEM) and energy-dispersive spectroscopy (EDS) were used to observe the microstructure of the composites. The relationship between microstructure and mechanical properties was discussed.



2021 ◽  

Djalkiri are “footprints" – ancestral imprints on the landscape that provide the Yolŋu people of eastern Arnhem Land with their philosophical foundations. This book describes how Yolŋu artists and communities keep these foundations strong, and how they have worked with museums to develop a collaborative, community-led approach to the collection and display of their artwork. It includes contributions from Yolŋu elders and artists as well as Indigenous and non-Indigenous historians and curators. Together they explore how the relationship between communities and museums has changed over time. From the early 20th century, anthropologists and other collectors acquired artworks and objects and took photographs in Arnhem Land that became part of collections at the University of Sydney. Later generations of Yolŋu have sought out these materials and, with museum curators, proposed a new type of relationship, based on a deeper respect for Yolŋu intellectual frameworks and a commitment to their central role in curation. This book tells some of their stories.



Sign in / Sign up

Export Citation Format

Share Document