scholarly journals Effects of ozone pretreatment on drying kinetics and quality of Granny Smith Apple dried in a fluidized bed dryer

Author(s):  
Sueli Rodrigues ◽  
Thatyane Vidal Fonteles ◽  
Ronnyely Braz Reis Do Nascimento ◽  
Fabiano Andre Narciso Fernandes

Fluidized bed drying is a method for controlled and mild drying of wetThis study aimed to evaluate the effects of ozone pretreatment on drying of green apple carried out in a fluidized bed dryer to determine drying kinetics and identify operating parameters for improved product quality. Results reveal that drying temperature in different levels affected water diffusivity and retention of bioactive compounds. The ozone pretreatment showed unexpected results since the pretreatment reduced the water difusivity and promoted an increase in the enzyme activity. The treatment time strongly afftected the final polyphenoloxidase and peroxidase activities. On the other hand, the ozone treatment resulted in lower color changes compared to non-ozone treated dried apples.Keywords: diffusivity; polyphenoloxidase; enzymatic browning; ozone.

REAKTOR ◽  
2011 ◽  
Vol 13 (3) ◽  
pp. 155 ◽  
Author(s):  
Abadi Jading ◽  
Eduard Tethool ◽  
Paulus Payung ◽  
Sarman Gultom

PHYSICOCHEMICAL CHARACTERISTICS OF SAGO STARCH OBTAINED FROM FLUIDIZED BED DRYING USING SOLAR AND BIOMASS POWERED CROSS FLOW FLUIDIZED BED DRYER. The research aim is to study the comparative quality of sago starch drying results using cross flow fluidized bed dryer powered by solar and biomass in conventional drying, particularly the chemical composition and physicochemical characteristics. This research was conducted through a drying phase of wet sago starch using a cross flow fluidized bed dryer, and drying in conventional as well as dried sago starch quality testing results are drying. The results of this study indicate that dry sago starch which has been drained by means of cross flow fluidized bed dryer has a chemical composition that does not vary much with starch which is dried by conventional drying, so that the dried sago starch produced by the dryer is very good. On the other hand the use of dryers is the more correct because the physicochemical properties of sago starch using a low drying temperature and drying time is short. Tujuan penelitian ini adalah mempelajari perbandingan kualitas pati sagu hasil pengeringan menggunakan alat pengering cross flow fluidized bed bertenaga surya dan biomassa dengan pengeringan secara konvensional, khususnya komposisi kimia dan karakteristik fisikokimia. Penelitian ini dilakukan melalui beberapa tahapan yaitu pengeringan pati sagu basah menggunakan alat pengering cross flow fluidized bed, pengeringan secara konvensional serta pengujian kualitas pati sagu kering hasil pengeringan. Hasil dari penelitian ini menunjukkan bahwa pati sagu kering yang telah dikeringkan dengan alat pengering cross flow fluidized bed memiliki komposisi kimia yang tidak berbeda jauh dengan pati yang dikeringkan dengan cara pengeringan secara konvensional, sehingga pati sagu kering yang dihasilkan oleh alat pengering tersebut sangat baik. Di sisi lain penggunaan alat pengering ini semakin memperbaiki sifat fisikokimia pati sagu sebab menggunakan suhu pengeringan yang rendah dan waktu pengeringan yang singkat.   Kata Kunci: pengering unggun terfluidakan; fisikokimia; pati sagu


2005 ◽  
Vol 66 (2) ◽  
pp. 267-271 ◽  
Author(s):  
Chalida Niamnuy ◽  
Sakamon Devahastin

Foods ◽  
2019 ◽  
Vol 8 (5) ◽  
pp. 147 ◽  
Author(s):  
Saheeda Mujaffar ◽  
Sheena Ramsumair

Pumpkin seeds are a major agricultural waste from the fresh-cut produce industry. The objective of this study was to investigate the drying behavior of untreated, whole pumpkin seeds in a fluidized bed dryer at 50–80 °C (2.87 m/s), with a view to producing a high-quality pumpkin powder from dried seeds. Seeds were dried at 50–80 °C to an average equilibrium moisture value of 0.035 to 0.006 g H2O/g DM (3.4 to 0.6% wb). Drying occurred in the falling rate period only and drying rate constants ranged from 0.0226 to 0.0900 1/min with corresponding diffusivity values for the first falling-rate period ranging from 4.68 to 18.63 × 10−10 m2/s. The activation energy (Ea)—for the first falling rate period was determined to be 43.9 kJ/mol. Of the nineteen thin layer models tested, the Alibas model could be successfully used as a general model to predict the Moisture Ratio (MR) data for all temperatures investigated. After drying, seeds were blended to produce powders, which were found to be high in fat, crude protein and fiber.


2008 ◽  
Vol 4 (6) ◽  
Author(s):  
Law Chung Lim ◽  
Wan Ramli Wan Daud

Advanced drying technology enables drying of rough rice and dedusting of rice husks to be carried out simultaneously in the same unit processor. This paper reports the efficiency of dedusting of rice husks in a two-stage inclined cross flow fluidized bed dryer and the drying kinetics of rough rice in a batch fluidized bed dryer as well as the conceptual design of a hybrid drying – dedusting unit processor. Experimental works had been carried out using rough rice (a Group D particle according to Geldart classification of powders) in a 2.5 m height two-stage inclined fluidized bed column of cross sectional area of 0.61m x 0.15m and a 3 m high batch fluidized bed dryer. The objectives of the study was to investigate the separation efficiency of dedusting of rice husks in the two-stage cross flow fluidized bed dryer and to study the drying kinetics of rough rice drying in the batch fluidized bed dryer. The experimental results showed that the dedusting separation efficiency at low superficial gas velocity gave unsatisfactory separation of merely 40% of rice husks. At higher superficial gas velocity, separation efficiency of rice husks as high as 93% was achieved. In addition, higher distributor inclination angle gave slightly improved separation efficiency. The drying kinetics showed that the residence time that is required to reduce the moisture content of rough rice to 18% (intermediate storage moisture content for second stage drying) is 3 minutes whereas the residence time that is required to reduce the moisture content to 13% (desirable final moisture content) is approximately 10 minutes regardless of the effect of kernel cracking. It was also found that higher drying temperatures gave higher drying rate. A conceptual design has been developed based on the results obtained in the studies. In order to maximize the heat utilization and to carry out two processes viz. dedusting and drying in one unit processor, it is suggested that drying – dedusting can be carried out in a multistage mode where drying is taken place at each stage while dedusting is taking place at the upper stage. This concept can be applied to a packed bed or a fluidized bed unit processor.


Author(s):  
Gholamreza Askari ◽  
Atefe Babaki ◽  
Zahra Emamdjomeh

In order to conserve cuminum cyminum L. during long storage periods, the drying kinetics of this seed undergoing microwave-assisted fluidized bed dryer at various microwave output power (300, 600 and 900w), air velocity (10, 15 and 20 m/s) and air temperatures (45, 55 and 65ᵒc) were studied. The main aim of this research is developing a mathematical model of mass transfer to investigate the microwave-assisted fluidized bed drying of cuminum cyminum L. seed. In this paper, we tried to discover a good model to evaluate moisture effective diffusivity (Deff). Keywords: cuminum cyminum L, microwave-assisted drying, mathematical modeling,


Author(s):  
Akash H. Mali ◽  
Aditya R. Nikam ◽  
Azam Z. Shaikh.

This artical also discusses about demostration of fluidized bed dryer with principle and application and other processing. This has lead to development of thechnology, process and equipments which not only reduce time but also increasing the output. A Fluidized bed dryer significantely reduce drying time, compared with vaccum dryer or tray dryer. In the pharmacutical industry, fluidized bed dryer are typically used for pellets drying, coating and granulation. Fluidized bed drying are very well known to yield high heat and mass transfer and hence adopted to many industrial drying process particularly pharmacy product. In this paper we show construction, working of the fluidized bed dryer. It work on the drying principle. It has several advantages and disadvantages.


Sign in / Sign up

Export Citation Format

Share Document