Biogeochemical characterization of soils affected by more than 100 years of lead mining activity.

Author(s):  
José María Esbrí ◽  
Sara Gallego ◽  
JuanAntonio Campos ◽  
Fabrice Martin-Laurent ◽  
Jesus Peco ◽  
...  

<p>Mining has an adverse effect on soil quality as it is a source of heavy metal environmental pollution with direct consequences on its ecosystem services, especially those related to microbial activity. The magnitude and diversity of the impact produced by pollution is linked to the complexity and diversity of mining processes that share the same mining area. The soil will be modified, not only in the physicochemical characteristics but also physical alterations of varied typology will occur. All these changes and alterations related to mining activity are accompanied by changes in the composition, diversity and activity of soil microorganisms..<br>A study was carried out on a mine site showing variable degrees of contaminations with metals, to estimate the impact of mining works on the geochemistry of soils, and the activity and diversity of soil microorganisms.  The aim is to characterize the level of disturbance on the “soil health” due to the presence of different metals, related physicochemical factors, and typology of the wastes affecting the soil. Besides, the process of bacterial colonization of the wastes has been also subject of interest to our work.<br>The selected study area was originally a lead-silver mine. Later, a mineral treatment plant was established in the area in order to recover Zn from the primary gangue dumps. In addition spills of olive mill residues were later deposited in the area. Four composite samples from the five distinct sites differing in their characteristics were selected: tailings, dumps, olive mill residues, contaminated soil and reference soil. A range of various analyses was done on these samples including pH, electrical conductivity, organic matter, multi-elemental contents, enzymatic activity and bacterial biodiversity (16S rRNA amplicon sequencing).<br>Selected sampling sites have contrasted physicochemical characteristics: acidic pH was observed in dumps (3.8 in average) and neutral in tailings and soils (~6); highest conductivity was recorded in dumps (2282 microS cm-1 in average) and lowest in soils (62 microS cm-1 in average); the highest organic matter value was measured in soils amended with olive mill residues (60% in average). Heavy metals were detected in higher concentrations in dumps and olive mill residues than in tailings or soils. It is noteworthy in dump samples the maximum concentrations of metals reach 6.8% with significant amounts of Zn, Cu, Sb, Hg, Ni, Co and Mn. Highest enzymatic activities were measured in contaminated and non-contaminated soils, while lowest values were obtained in dumps and tailings soils, in accordance with the concentration of metal measured in the matrix. Next generation sequencing analysis of 16S rRNA amplicon lead to the discrimination on the different sites sampled according to bacterial composition and diversity. Most abundant bacterial phyla were Proteobacteria, Actinobacteria, Chloroflexi, Acidobacteria, Gemmatimonadetes, Bacteriodetes, TM7, Firmicutes, Cyanobacteria and Verrucomicrobia.<br>As a conclusion, we have found evidences of the intense affection of the metal pollution to the microbiological biodiversity, particularly that related with the presence of high Pb concentrations.</p>

Soil Research ◽  
2011 ◽  
Vol 49 (4) ◽  
pp. 287 ◽  
Author(s):  
V. Gonzalez-Quiñones ◽  
E. A. Stockdale ◽  
N. C. Banning ◽  
F. C. Hoyle ◽  
Y. Sawada ◽  
...  

Since 1970, measurement of the soil microbial biomass (SMB) has been widely adopted as a relatively simple means of assessing the impact of environmental and anthropogenic change on soil microorganisms. The SMB is living and dynamic, and its activity is responsible for the regulation of organic matter transformations and associated energy and nutrient cycling in soil. At a gross level, an increase in SMB is considered beneficial, while a decline in SMB may be considered detrimental if this leads to a decline in biological function. However, absolute SMB values are more difficult to interpret. Target or reference values of SMB are needed for soil quality assessments and to allow ameliorative action to be taken at an appropriate time. However, critical values have not yet been successfully identified for SMB. This paper provides a conceptual framework which outlines how SMB values could be interpreted and measured, with examples provided within an Australian context.


2015 ◽  
Vol 46 (4) ◽  
pp. 291-335 ◽  
Author(s):  
M. Pivokonsky ◽  
J. Naceradska ◽  
I. Kopecka ◽  
M. Baresova ◽  
B. Jefferson ◽  
...  

2020 ◽  
Vol 10 (24) ◽  
pp. 9002
Author(s):  
Thao Thi Nguyen ◽  
Seong Nam Nam ◽  
Jeill Oh

This study investigated the impact of effluent organic matter (EfOM) from wastewater effluent on the properties of organic matter in receiving water and the efficiency of its removal using photocatalysis. The organic matter is characterized using fluorescence excitation-emission matrices coupled with parallel factor analysis (EEM-PARAFAC), UV-Vis spectroscopy, and dissolved organic carbon (DOC) measurements. The experiments are conducted with water samples that were collected from upstream waters (used as a source of dissolved organic matter (DOM)), wastewater effluent (a source of EfOM), and waters downstream of a wastewater treatment plant, and with upstream water and wastewater effluent being mixed at different ratios in the lab (DOM/EfOM). EEM-PARAFAC analysis identifies three components: a humic-like component (C1), a tyrosine-like component (C2), and a terrestrial-like humic component (C3). When compared to DOM, EfOM has a higher specific ultraviolet absorbance at 254 nm (SUVA254), a higher fluorescence index (FI), and more abundant humic-like components. As the EfOM contribution increased, an increase in both humic-like components and a simultaneous decrease in the protein-like components are observed. The photocatalytic degradation of the organic matter using simulated solar irradiation with ZnO as a catalyst is examined. The removal efficiency of photocatalysis is calculated using the DOC, UV absorbance at 254 nm (UV254), and the maximum fluorescence intensity (Fmax) of the PARAFAC components. After 120 min of irradiation, the removal efficiency of photocatalysis differs between the DOM, EfOM, and EfOM-impacted samples due to the change in the properties of the organic matter in the source water. The photocatalytic degradation of organic matter follows pseudo-first-order kinetics, with the DOC and UV254 exhibiting a lower removal efficiency with the increasing contribution of EfOM, which indicated that EfOM has a potentially negative impact on the performance of drinking water treatment. The removal of PARAFAC components follows the order C3 > C1 > C2, indicating that humic-like components are preferentially removed when compared to protein-like components under sunlight irradiation.


2013 ◽  
Vol 13 (1) ◽  
pp. 74-88
Author(s):  
Juan Carlos García Prieto ◽  
Patricia Pérez Galende ◽  
Juan Manuel Cachaza Silverio ◽  
Manuel García Roig

This study reports a procedure for the evaluation and comparison of the adsorption and filtration capacities of commercial activated carbons in the treatment of drinking water and the design and operation of a pilot plant to simulate the behavior of fast open filters made of granular activated carbon. The milestone of this experimental work was to determine the adsorption and filtration capacities and the physicochemical properties of five commercial activated carbons with a view to determining which activated carbon might replace the open sand filters of the drinking water treatment plant (DWTP) of the city of Salamanca (western Spain). Compliance with the requirements and physicochemical characteristics stipulated in the EN 12915 European standard for the different activated carbons tested was analyzed, and studies of the prewashing and behavior of the carbons operating in the filters were performed. In this sense, filtration tests to study the saturation of the bed, the variations in pressure drop and the performance of the removal of organic matter in suspension were carried out. Furthermore, the optimal time and rate of the countercurrent washing of the filters and the expansion of the filter bed were evaluated. In the adsorption assays, the specific surface area, porosity, useful lifetime and capacity of adsorption of the dissolved organic matter –especially humic acids, the major precursors of water chlorination by-products – of the activated carbons were determined. The results not only provided an overview of the actual behavior of different types of commercial activated carbons from their initial installation up to the end of their useful life, but also permitted optimization of the filtration and adsorption processes that could lead to the corresponding economic savings and energy reduction in the use of such activated carbon filter-adsorbers.


2019 ◽  
Vol 2019 ◽  
pp. 1-8 ◽  
Author(s):  
Saïda Mouhoun-Chouaki ◽  
Arezki Derridj ◽  
Djaber Tazdaït ◽  
Rym Salah-Tazdaït

Discharging of untreated municipal solid wastes (MSWs) onto land is very widespread in developing countries. The compounds contained in MSW cause a harmful effect to human and environment. Hence, an assessment of the extent of their local impact is of great interest to figure out the pollution they cause. Therefore, this study aimed at evaluating the effects of discharge of solid wastes on soil quality within the landfill of Ain-El-Hammam municipality (Algeria). To achieve this, different soil physicochemical parameters were considered: granulometry, electrical conductivity, pH, organic matter content, and heavy metal concentration. The results indicated the influence of the MSW on the physicochemical characteristics of the soil by enhancing the organic matter content of soil (4.53%) and increasing heavy metal content (Cu, Zn, Cd, Pb, Ni, and Cr), which is a clear indication of the level of pollution they are generating.


Antibiotics ◽  
2021 ◽  
Vol 10 (2) ◽  
pp. 146 ◽  
Author(s):  
Matteo Cuccato ◽  
Selene Rubiola ◽  
Diana Giannuzzi ◽  
Elena Grego ◽  
Paola Pregel ◽  
...  

In poultry production, gut microbiota (GM) plays a pivotal role and influences different host functions related to the efficiency of production performances. Antimicrobial (AM) use is one of the main factors affecting GM composition and functions. Although several studies have focused their attention on the role of AMs as growth promoters in the modulation of GM in broilers, the consequences of higher AM concentrations administered during prophylactic treatments need to be better elucidated. For this purpose, 16S rRNA gene sequencing was performed to evaluate the impact of different prophylactic AM protocols on the composition and diversity of the broiler GM. Diversity analysis has shown that AM treatment significantly affects alpha diversity in ileum and beta diversity in both ileum and caecum. In ileal samples, the Enterobacteriaceae family has been shown to be particularly affected by AM treatments. AMs have been demonstrated to affect GM composition in broiler. These findings indicate that withdrawal periods were not enough for the restoral of the original GM. Further studies are needed for a better elucidation of the negative effects caused by an altered GM in broilers.


2001 ◽  
Vol 1 (4) ◽  
pp. 253-263 ◽  
Author(s):  
I. Baudin ◽  
C. Campos ◽  
J.M. Laîne

At the end of 1997, an innovative membrane-adsorption process was integrated at the Vigneux-sur-Seine water treatment plant in the southeast suburbs of Paris, France. This hybrid process consisted of the application of powdered activated carbon (PAC) upstream of ultrafiltration (UF) membranes and recycled to a floc blanket reactor (FBR) after membrane backwashes (FBR-PAC/UF process). This process was designed to mitigate seasonal episodes of micropollutants (pesticides and taste and odors) and to reduce the content of natural organic matter responsible for disinfectant and disinfection by-products. An intensive monitoring campaign of the plant effluent and ten sites in the distribution system was conducted two years before (1996-1997) and two years after (1998-1999) the start up of the PAC/UF process to characterize the impact of this treatment on the water quality of the distributed water. The objective of this paper is to illustrate the positive impact of the PAC/UF process on the organic and biological water quality of the Vigneux-sur-Seine distribution system. Thus, the combination of coagulation and adsorption in the FBR-PAC/UF process resulted in a TOC concentration lower than 0.7 mg/l, BDOC values lower than the detection limit (<0.2 mg/l) and total trihalomethanes concentrations below 10 μg/l. This reduction in organic content results in a reduction of the chlorine consumption by the water produced, which translates in the maintenance of higher chlorine residuals throughout the distribution system while using the same chlorine doses at the plant (0.3 mg/l).


2020 ◽  
Vol 25 (2) ◽  
pp. 327-338 ◽  
Author(s):  
Alefsi David Sanchez-Reinoso ◽  
Edgar Alvaro Ávila-Pedraza ◽  
Hermann Restrepo

The objective of this review is to show in a general way how biochar (BC) can be obtained and its effects on the physicochemical properties of soils and physiological behavior of cultivated plants. BC is a product rich in carbon that comes from the pyrolysis of biomass, generally of vegetable origin. BC is obtained by the decomposition of organic matter exposed to temperatures between 200-900 ºC in an atmosphere with low oxygen availability (pyrolysis), which can be slow, intermediate or fast. Depending on the biomass and the temperature used in its production, BC can contain high levels of elements such as carbon, nitrogen, oxygen, hydrogen, sulfur, among others. The main sources to produce biochar are forest, agroindustrial and manure residues. BC quality and physical-chemical characteristics will depend not only on the type of waste or plant material for production, but also on the plant photosynthetic apparatus. The high carbon contents present in organic matter, which are more resistant to biological and chemical decomposition, are stabilized by the pyrolysis process. When incorporated into the soil, BC remains stable for longer periods of time and is not volatilized into the atmosphere; this allows BC to be considered as an important compound for the mitigation of the impacts of polluting substances. Additionally, it has been found that BC application improves the physicochemical characteristics of the soil, including fertility. This improvement generates positive responses in the physiological behavior of cultivated plants such as the increase of germination, accumulation of dry matter, photosynthetic rate, yield and quality of the harvested organ. BC use opens important doors for the sustainable management of agriculture in Colombia. It can be considered in production systems exposed to heavy metals such as vegetables and perennial species, in order to reduce the impact of these substances on human health.


Sign in / Sign up

Export Citation Format

Share Document